1999 f350 gas 4x4 . Truck runs fine. even passed inspection. However just recently my windshield wipers seem to work only sometimes. Right now won't come on at all. I checked the fuse.
View 3 RepliesMy windshield wipers aren't working. I can hear the relay click and I've checked the fuse. I found this ground wire, what it goes to?
View 1 RepliesSometimes when I start my truck (maybe 2-3x per week) my windshield wipers will wipe one time randomly. They're not on and haven't been on for days.
View 5 Replies2004 f250 wipers and fluid not working Done the usual stuff checked the fuses in the cab and the 15amp fuse is good and the 30 amp fuse is good. Is there something under the hood i should look at?
View 3 RepliesI have a 2003 F250 Lariat 6.0L Crew Cab. My wipers, radio and power windows don't work. I have painstakingly checked every one of the fuses to see if there was one or more blown. All were OK.
I removed the fuse panel under the dash and have disassembled it to look for obvious clues, burnt wires/heat damage etc. but everything looks fine. Have pushed all of the fuses in to make sure they were seated properly. No joy.
I recently replaced one of the back windows in my truck and had to detach the rear dome light and I remember one of the wires sparking. Where to start diagnosing this problem?
I have a F350 diesel which has recently had a new AC compressor, Now when I go to stop at a stop sign or slow down using brakes the wipers come on and swipe a time or two. I never noticed this before the new compressor was installed so I was wondering if something might have happened while installing compressor? Now I think stepping on the brakes makes the wipers come on, but not until the truck slows down and is just idling.
View 1 RepliesI've noticed lately that sometimes when I start the truck up that the wipers will cycle once. I do not have the courtesy wipe feature enabled and I'm pretty sure I'm not bumping the wiper/washer button. I like my truck but I've had more weird things go on with this truck than any other I've ever owned, I'm starting to think it's possessed. It's a 2013 F250XL with the 6.2 ....
View 14 RepliesAbout 2 weeks ago, my wipers just decided not to turn off anymore. While in the off position, they still work intermittently. about every 22 seconds, drives me nuts. Changed the relay. Didn't do squat.....
2011 F250 6.2 liter engine w/55,000 miles
Ok, so driving in intermittent rain the other day, I had the wiper on the slower of the 2 constant "on" positions. I pushed the sprayer (bugs) and went to turn the speed down, and the wipers stayed on.
Tried running the switch and sprayer through the on/off positions a few more times, still wouldn't go off. They WOULD go faster (fastest on setting) but not slower. (None of the intermittent settings.)
They also stayed on when the truck was off, only way to shut them off was to pull the large pink "main wiper" fuse, #106.
Any ways to trouble-shoot? Of just replace the whole switch/assembly? As far as I can tell everything else works as normal.
So I have a 99 F250SD, earlier this year my wipers started going on by themselves, switch didn't seem to effect them, wouldn't turn off with the switch but would with the ignition off. Then they stopped working all together along with the washer. Checked fuses and relays, put a new switch in and still no dice. When I move the switch the wiper/washer relays do not click at all.
I've tried tracing the wires but haven't been able to find any issues there. The gem is as clean and new looking as one made yesterday. Is there a pinout test I can run on the plug into the motor? or which color wires coming out of the fuse box to check? I'd really like to get this fixed so I can drive my truck this winter.
My 01 F-250's wipers would not shut off. As soon as the key was turned on they would come on. No delay but high and low only. Had to pull the fuse to drive it. I replaced the multi function switch as well as the relay with no fix. I did some reading on this problem and it is related to the "park" switch in the wiper motor itself. I took the black plastic cover off the motor which reveals the worm gear driving the plastic gear which acts as the switch.
The contacts for this switch are hard to get to as they are on the backside. I blew compressed air into every little crevice and removed most of the grease. I regreased and put it back together. Sure enough the wipers work just fine now. I am assuming the compressed air trick may be only temporary. Need to reveal the contacts for the park motor switch without destroying the plastic housing?
1999 F250 5.4l base work truck. My problem is wipers, washer do not function. It all started with my wipers staying on. I removed the fuse to stop them. When i put it back in nothing. I have bench tested all relays, checked fuses, put in a new mfs, put in a new/used gem, checked all wiring i can seem to find, refreshed grounds etc. I am starting to lose my mind with this thing.
I have gone through all of section A and B of these tests [URL] .... except for the NGS scan tool.
Tonight checked the pins at the central junction box relays to see what was going on. This is where things got interesting. i have constant power at pin 5 of the run/park relay. if i jump this to pin 3 the wipers run. Pin 5 of hi/lo and washer show no voltage, however show continuity to ground. pin 5 of run/park also shows continuity to ground.
With the key on I have 12v at pin 1 of the hi/lo, run/park, and washer sockets. when cycled through the switches show i have continuity to ground on pin 2 of all sockets as they should. However, when relays are in place they do not "click" over.
What am I missing here? As much as I'd hate to do it, I may end up just throwing a switch in to "jump" the run park relay for temporary single speed wipers.
2009 F250 lariat. While driving down the highway my wipers came on when stalk was in the off position. They would not shut off. Had to remove the relay to get them to shut off. Also, during middle of a sunny day the headlights would temporarily come on and shut off when it was in the automatic position. They would not come on if I put it in the off position though. Since both the wipers and high beams are part of the multifunction switch is it likely that the switch has gone bad vs. a more major issue with the computers. No other issues identified.
View 1 RepliesWipers/washers didn't work on 2003 f250. No blown fuses in system, supply fuses are 106 and 33, removed wipers and found no voltage on dk/grn wire of connector (fuse106). Turns out that the wire bundle had chafed a wire near the inner fender liner to the point that it cut the wire and broke the connection.
View 3 RepliesI have a 7.3l 02 f450. The wipers won't work on any low speeds and only on the fastest will they work. And if you switch it from the fastest to any other speeds, the wipers stop right where they are.
View 1 RepliesI have a 2008 f250 with 6.4. Was sitting my truck with key on and motor off listening to radio on lunch and my wipers came on by themselves. Switch was in off position and we're in slow speed. If I turn switch they wouldn't change speed til high position. Turned key off and back on and they came on still. Pulled 30 amp fuse in battery junction box to shut them off.
View 3 RepliesLast fall had one day for about three miles where wipers and washer wouldn't shut off. Now they won't stop at all. Thought the multi switch might be bad, removed whole switch and unhooked. Washer pump and wipers were still on and wouldn't shut off. Had to pull the fuse.
View 4 RepliesPer the instructions I used upfitter #4 and a 21k resistor. High idle works, slight delay and gradual ramp up to 1150 rpm, but why does the wiper turn on for just one wipe now at startup?
View 6 RepliesIMG 4396 - YouTube
What this sound is? Been to the dealer 3x already and they are throwing parts at it and each time telling me its fixed.
I didn't get the windshield replaced rusted the whole way across the top of the window. Now to fix it right need a new roof panel. This truck barely see snow if it does it gets washed underneath. gets waxed 5 times a year washed every 2 weeks if not sooner now a spot of rust anywhere else on the body. well the bottom of the tail gate but that was covered by a bedrug. But the windshield has me upset to say the least. Really would like to know if there is a problem there like ford not prepping the metal right since it was a new body style for that year.
View 10 RepliesI have no windshield wipers. Since i bought the truck ive fixed other issues but cannot figure out the issue with the wipers. Tested for power not sure if it's accurate but seems like there is power to the harness to the motor but not 100% positive.... Can it be the switch? Blinkers and rest on same switch still work but no ww. I also dont hear clicking from a solenoid like ive read on some research.. Fuses are all good pulled everyone out since they arent labeled with numbers next to them...im at such a stand still and cant drive the truck was screwed the other day when we got sun showers for nor reason and i was on a major highway.
View 6 Replies