Ford Super Duty (1999-2016) :: Window Washer Works Intermittently Although Motor Is Fine?
Apr 2, 2017
So either these trucks have a super small window wash reservoir or there is something wrong with my truck. The window washer works just fine and then stops. The washer motor is still working but nothing coming out. I fill it up to the top again and suddenly it works just fine. The thing is that when I fill it up it only takes between 1 and 2 quarts of water. I'd imagine the recover probably holds close to a gallon so not sure why mine quits working and then is full after 1 to 2 quarts of water is added. Perhaps the pickup tube in mine is bent or something? No light or message on the dash...it just stops.
View 3 Replies
Advertisement
I have a 2011 F250 6.2 xlt 221k miles. I have an issue where my AC works sometimes and other times it doesn't work. On the occasion it will work kind of, meaning that it will blow cold for a few seconds (when the compressor clutch engages, but as soon as the clutch disengages I get warm air. My low pressure is at about 30psi and the high is about 140psi (seems low to me). When I bought the truck the a.c. didn't work at all. I pulled a vacuum and put the recommended 29oz of 134a in it. When it works its VERY cold. There doesn't seem to be any ryme or reason (temp, humidity, drive time) as to if it works or not. On occasion (not working) I have been able to turn off the a.c. for a couple minutes and when I turn it on it works.
View 14 Replies
My fan control went out yesterday (hot day with no A/C), It comes back on at times, but if it's on three it may only blow like it's on one. What I need to replace??
View 3 Replies
Over the last few years my power windows in my '99 Super Duty have started working intermittently. The problem seems to be with both the main controls on the drivers door and the control on the passenger door. Sometimes both of them have problems operating, sometimes just one. Does not make a lot of sense. Could I have bad switches or do I need to check something else?
Rowland '99 Ford Super Duty 7.3 Diesel Dually
View 14 Replies
2001 f350 blower motor for (A/C - Heater) works sometimes and sometimes does not.
View 5 Replies
Just bought a 2010 f250 and I noticed that the warning chime works intermittently. I think this speaker or whatever it is also makes the turn signal noise because that sometimes is silent also. Where this thing is?
View 1 Replies
My radio, power windows and map lights all at the same time work intermittently. I have changed the relay. No blown fuses. Sometimes they all work and then for no reason that I can tell, they all go off. right before they all come back on (which you never know when it will happen) I hear a click in our around the fuse panel.
View 1 Replies
My Blower motor is intermittently going on and off. After messing with it for a while it seems to stay on. Motor may be going out. Not real easy to change the blower motor on this 2008. Haynes manual says to take the 2008 and up trucks to the dealer.
2008 F250 4DR 5.4L
View 8 Replies
2011 F250 with hood mounted windshield washer nozzle. How do I remove the nozzle? In a campground with basic tools.
View 6 Replies
I have a 2005 F-250 6.0 Powerstroke.
My washer fluid pump is not working, it was a few weeks ago but now it is broken. The Owner's Manual only has the listing fuse 33 for "cluster, 4x4, wipers". It looks like some of the older models have an actual fuse for the "washer fluid pump". I checked fuse 33 under the dash and it is ok. What fuse controls the washer fluid pump?
The pump does not make noise when activated, so I'm starting at the fuse but I don't know what the hell is going on.
View 5 Replies
I have an 04 F250 and the driver side windshield washer doesn't spray on the windshield. It sprays a stream up high on the windshield. Is it possible to replace the spigot where the spray comes out? Is there another solution?
View 7 Replies
1999 F250 5.4l base work truck. My problem is wipers, washer do not function. It all started with my wipers staying on. I removed the fuse to stop them. When i put it back in nothing. I have bench tested all relays, checked fuses, put in a new mfs, put in a new/used gem, checked all wiring i can seem to find, refreshed grounds etc. I am starting to lose my mind with this thing.
I have gone through all of section A and B of these tests [URL] .... except for the NGS scan tool.
Tonight checked the pins at the central junction box relays to see what was going on. This is where things got interesting. i have constant power at pin 5 of the run/park relay. if i jump this to pin 3 the wipers run. Pin 5 of hi/lo and washer show no voltage, however show continuity to ground. pin 5 of run/park also shows continuity to ground.
With the key on I have 12v at pin 1 of the hi/lo, run/park, and washer sockets. when cycled through the switches show i have continuity to ground on pin 2 of all sockets as they should. However, when relays are in place they do not "click" over.
What am I missing here? As much as I'd hate to do it, I may end up just throwing a switch in to "jump" the run park relay for temporary single speed wipers.
View 3 Replies
My new to me, 2005 F-250 windshield washer nozzles don't work. I have replaced the windshield washer pump, cleaned out the washer fluid container and rubber filter screen, blew air through the lines and the passenger side nozzle barely sprays and the driver side nozzle does nothing at all. I guess I have clogged nozzles. What is the part number or place you bought them? Looked online and everything I can find is so generic.
View 14 Replies
My windshield washer has recently just sprayed up about a foot.
Will adding some vinegar to the fluid and see if it will unclog?
Or does this just mean that my pump is giving up?
'99 F250 SD V10
View 7 Replies
Last fall had one day for about three miles where wipers and washer wouldn't shut off. Now they won't stop at all. Thought the multi switch might be bad, removed whole switch and unhooked. Washer pump and wipers were still on and wouldn't shut off. Had to pull the fuse.
View 4 Replies
Filled up the windshield washer tank this morning and could not get the sprayer to work. Looked under the truck and it looks like all I put in is on the drive. Any one else had issues with 2011 F350 washer tanks?
View 3 Replies
I just picked up this truck and have found my first undisclosed problem. The A/C only works on MAX. If you turn to any other setting, regardless of selected temp, the air blows hot. And I mean full hot! I was thinking the control panel assembly is bad?
View 6 Replies
I have an F-250 Ford, 2006, 6.0 turbo-diesel. Started noticing that my heat only works while running at 70 mph or more and the turbo is at around 15-20 psi. Now that it has gotten cold it is definitely an issue. Truck does not overheat, I am not able to feel heat on the hose after control vlave and I do not feel any vacuum on the line (grey) to the control valve. I have checked for leaks, changed out the fill cap, checked anti-freeze level, pulled control valve just to verify its position when opened (which it seems to stay open). It's getting really cold in the cab of that truck now.
View 4 Replies
1999 F350 Crewcab 4x4 dually V10. Fan switch only works on High. All fuses and relays look Good. Is it a bad speed control switch? What can it be?
View 8 Replies
I have a 99 f350 super duty with a v10. I drove it Friday night, but it wouldn't start Saturday morning. It is turning over fine, just no start. I have no pressure at the fuel rail. The pump does its little key on run. I can hot wire the pump at the tank, and it pumps. It builds up pressure after the fuel filter. I found that out when I changed the fuel filter. Will the pressure regulator shut off the fuel to the rail?
View 9 Replies
1999 F250 SD V10 I recently replaced the in-tank fuel pump and filter. I operated the truck briefly after and everything was normal. I parked it with about 1/4 tank of new fuel and put it on a battery tender. It was parked in a garage on level ground in temperate weather(Southern Calif.). Two months later I tried to start it and it acted like it did when the fuel pump was bad. Cranked fine but no hint of starting. Could it be the fuel lines have become full of air and need purging through Schrader valve ? I haven't begun to troubleshoot but what to check other than pushing the fuel relay reset button.
View 5 Replies
