Ford Super Duty (1999-2016) :: White Smoke Blowing - Codes P2452 And P1335
Sep 26, 2013
Recently have had a sct live wire extreme on my truck and ever since put it back to stock put the dpf back on its been blowing white smoke got a p2452 and p1335 code but when you turn the tuner back on and turn the dpf off no more white smoke and no codes ? What could be causing this? beyond confused ?? (the reason I took the tuner off is cuz I am sell the truck and the dealership wants it stock),
View 3 Replies
Advertisement
My truck is a 2005 6.0 with no after mods and has 73000 miles on it. It began to blow white smoke out exhaust. I changed out the egr valve and cooler. After putting back together it then blew white smoke ran it to clear out. This worked however once it warmed up it began to blow thick white smoke at 20 mph and clears up by the time it reached 30mph and white smoke shoots out at rapid acceleration. As well there is coolant leaking out under the truck from somewhere in the motor about in the center. I am looking to work on this myself as I have heard of owners taking it to shops and paying a lot of money for the prob to not get fixed.
View 7 Replies
I have a 2002 f250 powerstroke 7.3, while driving it smokes pure white smoke and feels like its loading up and will start shaking if I floor it, it will rev slowly popping like its loaded up then cleans out runs good for a 1/4 mile than same thing. My temp gauge stopped working and it just seemed to get worse. Stuck it on a scanner and it didn't have any codes but was saying the engine temp was -211f. I got a new sending unit didin't fix any of the problems.
View 14 Replies
I have a 2003 F250 that has recently started blowing white smoke. I replaced the EGR Valve but no luck.
View 3 Replies
I just replaced my up pipes, turbo pedestal O-ring, ICP, IPR, New O-rings in all my injectors and torqued to spec, new glow plugs, glow plug relay, oil loom wiring harness, new O-rings on oil cooler, oil filter, oil, and antifreeze. I have tried and tried on upwards of 50 or time to get it to turn over. A little white smoke came out and it sounded like it wanted to fire up, but only a few times. I have good batteries and a charger on it working along, 3-4 trys in 5-10 second burts or longer if it doesnt lose power every 30 -hr. oil is in HPOP too. 2001 F-350 7.3 auto 2wd 4dr longbed 329,611 ml..
View 8 Replies
2001 F250 5.4 with 160K miles. My wife "borrowed" my truck as she drove away, I saw white smoke coming out of the tailpipe. The kind you see in cold weather. Its was 75 degree in Texas this morning, so what could that be? There is antifreeze in the reservoir and I recently changed the oil and there was no water in it.
View 5 Replies
I have a 2008 Ford 250 diesel that is pouring out white smoke from the exhaust when it goes into "cleaning filter" mode. I really don't understand this because I have a dpf delete with a sct tuner. I thought with the tuner and delete the truck wouldn't go into filter cleaning mode. I contacted Ford and they said it was normal for white smoke to come from the exhaust during this process. What's going on maybe tuner is bad?
View 5 Replies
I have a 2006 f350 6.0l. I was driving home from work and all of a sudden I had no gas pedal. It would stumble and die with a bunch of white smoke out the tail. It also is not using the turbo at all no boost. I have a edge monitor and the engine codes it's kicking out are in the picture below. I have a warranty but the dealership that we bought it from and the closet ford dealer is 30-40 mins away and they don't currently have a diesel mechanic to work on it so I would have to go almost 1hr 20 mins to get to the next dealer. Will it hurt it to drive it that far?
View 2 Replies
The last couple weeks my excursion had started to have a stumble and smoke white ate the first startup or after I let it sit for a long time. I did get progressively worse. I noticed the hpop line to the driver side head was leaking from the fitting so I rebuilt the boss fitting and now it's not leaking but when I started it up this morning it did the same thing.
If I give it throttle it clears up pretty quickly but if I let it just idle it will put white for probably 5 minutes. I have no codes showing when I looked with the scanner I don't see any other oil leaks and I don't smell a fuel leak.
View 6 Replies
I have an 04 F250, stock. Two times within the last week I have noticed whiteish smoke coming out of the tailpipe and a diesel smell. Could this be the glow plugs going out and not burning the fuel, I have not changed them since owning the truck or something else.
View 14 Replies
During the winter, the truck would always start very hard. When it was trying to start it would pump out some white smoke. Now during the summer the truck will still start hard. At one point during the winter we were getting glow plug codes, now these have gone away that its warm. We did replace the glow plug control module, but that did not solve the hard start during the winter. We figured that there was a bad glow plug which is sorting out the rest. So we then figured the hard start issue would go away with the warmer weather but it has not.
View 3 Replies
Just bought a 02 f-250 7.3 with 115k miles. A couple days after I bought it I noticed a lot of white smoke on cold starts for about 20-30 sec at 50 degree temperature. So I tested the GPR which ended up being bad a replaced with the one that is double in size(name escapes me atm) and also did the 50 cent mod to keep the through-valve cover harness from losing connection since both sides were lose.
After that the temp warmed back up and it would only blow a "puff" of white smoke. The past two days it has gotten down to 30-32 and the truck has a rough time starting. Cranks fine but it's almost like it's getting choked or flooded then it will blow smoke for 3-4 minutes after it starts. The truck does have a FASS fuel system on it with stock injectors. Should I try to Ohm out the glow plugs again or where should I start trouble shooting?
View 3 Replies
I just recently purchased my 06 Ford F-250 it's got the 6.0 in it once I made a 6hr trip I've noticed once you warm it up and ride a little bit kill it let set for 30min or better and crank it up it blows white smoke for a min or two than on the way to work this morning my heater.
View 2 Replies
Got a 99 V10 blowing a lot of oil out of the exhaust pipe, to the point where I could fog the neighborhood, cylinder number 10 had original spark plug dirt down in the hole know one wanted to clean it out so I did put new plug and coil now smokes a lot, also truck has 173559 miles, did a half diesel half used motor oil flush tonight, wanted to go for 15 minutes only made it to 14 to much smoke, will put fresh oil in tomorrow, what could be the problem, piston ring blow by, intake manifold leak, burning what I think is oil could be coolant, head gasket no bubbles in oil or antifreeze and antifreeze and or oil are not mixing. Is it easier to pull the heads off with pulling the motor which looks fairly easy or leave it in the truck.
View 2 Replies
I have a 03 250 5.4 with 160k. I just recently replaced #4&3 coil packs. Truck was running great again. Then a few days later the truck was running extremely rough and white smoke from the exhaust. I noticed the pcv valve was not all the way in(pretty much out) put it back in and ran fine for two days now running rough every now and then and the pcv valve is making a vibrating noise but stops if I pinch it slightly. I did replace the plugs a year ago.
View 14 Replies
04 F-250, blowing tons of smoke. I've replaced the ICP sensor, crankcase breather hose (it was broken at the clip), cleaned the turbo, and EGR valve. Any other ways before I take it to a shop to get bent?
View 1 Replies
I have just replaced the EGR cooler, Oil Cooler, professional turbo reconditioning, both dummy plug's and stand-pipe's, blue spring, fuel filters, oil changed, cleaned the EGR valve and intake manifold. I am in the process of doing a coolant flush when my issue occurred. I was on the road for about 10 minutes when I lost power and started blowing black smoke. I have normal power till about 45 mph then nothing. I can baby the truck up to 55-60 and then nothing and the whole time blowing black smoke.
I stomp on the pedal with no power. I hear the whine of the turbo. The truck idles and sounds fine. My SCT showed my oil and coolant temps within 15 degrees. I opened the hood and saw soot all over the top of the engine from the compressor to the EGR valve and all in the valley from valve cover to valve cover; but more so on the driver side to FICM. I obviously didn't connect something properly. I am just about to remove the intake manifold and reinstall, but before I do just wanted some input.
View 3 Replies
I bought a 2004 6.0L F-250 used a few weeks ago. There have been a few problems here and there that I have been competent enough to fix. I am now facing a problem of A: the truck not starting (I believe it was just a battery problem, charged and started fine). But also B: I have had a slightly frayed serpentine belt that I noticed a few days ago. After I got the truck running from my the no-start and driving it around the block I parked it and went inside. Came back out a few minutes later and I tried to start it. It hesitated a little bit but started with a loud whining noise and white smoke coming from the belt. Turned the engine off and saw on one of the bottom wheels (pulleys?) some residue that looked and smelled like burnt rubber. Is this just simply a need for a new belt?
View 5 Replies
I have a 06 6.0 Powerstroke 6 Speed every time I get on it or even try to get going I have no power and I have pure black smoke blowing out the exhaust somebody told me to change the fuel filters which I did which they were pretty nasty then after I did that I seem to still have the same problem so then they told me to check the EGR valve put injector cleaner in it to clean the injectors which I have not done a gr or injector cleaner yet just wanted to know, what it could be or what I can do to prevent the black smoke I have no power either...
View 1 Replies
My 2006 F-250 (6.0 Diesel) started blowing black smoke under acceleration yesterday. It has 181k miles on it now. No loss of power, no rough idle, no smoke unless there's a load on the engine like accelerating, but then it doesn't matter if it's 1500 or 3000RPM, just the higher the RPM the more smoke it blows from the exhaust, dark black.
The truck has ARP headstuds, no programmer. Replaced both batteries and the A/C system about 2 weeks ago. About 3000 miles ago it got new glow plugs & harnesses, new alternator, all fluids changed, new aftermarket EGR cooler, new EGR valve, new turbo & actuator, new EBP sensor, new HPOP incl pipes and IPR.
Trucks starts up just fine, runs normal, just yesterday going down the Freeway about 65mph I noticed it started smoking black going up a hill, then smoke went away going downhill... Now every time I accelerate it's smoking black. Taking off from a stop sign it made a little puff of white smoke then went back to black smoke, but that only happened once.
Where I should start looking? No codes so far. But I have an AutoXRay EZ-Scan 6000, what sensors do I need to look at?
View 7 Replies
Truck: 1999 Ford Truck F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F
Problem: Especially when it is cold outside . . . The truck takes forever to start and while doing so a ton of white/grey smoke comes out of the exhaust.
My starting schema: Turn the key on have the gas pedal pushed to the floor until the "wait to start" light goes out. Then, I turn the key off and back on while still pressing the gas pedal all the way down. When the "wait to start" light goes out again I remove my foot from the pedal and try to start it. I never leave it cranking for more than 5-7 seconds. If, after trying this process several times I will not push the pedal in at all. Also, sometimes I will leave the pedal pushed in while I am cranking it over.
The truck used to start after a couple of tries but lately it won't start at all, even after 20 tries. Sometimes it will spin up for a second as if the engine gets going but then just doesn't continue running. When it is warm out it will usually start after a few tries but doesn't seem normal to me. After I first bought the truck(used) it would start up within half a second after turning the key.This all started after I had to fix an o-ring that was damaged on the top/back of the motor that was dumping all my oil out of the top/back of the motor.
View 14 Replies
