Ford Super Duty (1999-2016) :: Weird Noise While Turning
Feb 26, 2015
Before I climb on the ground and go over the front (there is snow on the ground and I am still like 26 days from owning my first home and having a garage FINALLY.) Very recently the truck started to make a little low pop noise and you can feel it in the steering wheel a little bit, when I turn sharply, almost to the stop by not completely and it will start. Not dumb when it comes to vehicles, but new to these trucks so always good to ask for common problems first!
View 7 Replies
Advertisement
I bought this truck with 60,000 miles and have had about 3 months. I don't drive it very much but when I do I have noticed that when it sets for 4-5 days or longer the transmission makes a weird noise as you take off and does does shift into gear as it does when I use it ever day. The problem goes away very quickly (not even a 1/4 mile driving) and everything is fine after that. By the way I took it to the ford dealer who did a complete 60,000 mile service on it that was suppose to include changing the transmission fluid and filters-could they have screwed something up (I did not notice this issue until after the 60,000 mile service?).
View 7 Replies
So i have a weird smell from the rear end, and ive had it for like 2 months. when it first happened it was a sticking caliper so i replaced that, the passenger side. the passenger side wheel would get really hot but now there isnt heat on either side, it does smell stronger on the passenger side however. i wouldnt call this a burning smell, and to tell you the truth i have no clue what the smell is related to. maybe a burning rubber smell would be the closest i could put it at, if only i could transmit smells on the internet. im thinking it has something to do with the rear diff fluid, as when i checked it last it was really old nasty and gunky, it probably hasnt been changed in a long time before i got the truck. so i topped it off and decided i would drain the diff this weekend because i didnt have time last weekend.
View 13 Replies
Last couple drives I have noticed some front end noise on the left side. Back in May I also noticed grease all over behind the rotor. I believe this is the grease inserted via ABS hole into the unit bearing. I do not hear the needle bearing crunching while driving and did not here it in May either. I also attempted to move the unit-bearing up and down thinking the axle seal was toast but it seemed solid at the time.
Today I hear some noise while turning left which lead to the pictures below. Wet side is Driver side, dry side is passenger. Tomorrow morning I should have some time to take a look at this more in depth. Passenger needle bearing was changed last year and no issues since then......
View 14 Replies
I have a 2004 f250 with some front end troubles. When turning right once in a while it will make a hard CLUNK noise and then trying to drive down the street it drifts over to the left and I pull the wheel back to the right and when I turn the wheel it feels like I like theres something hitting somthing else in the front end. I have checked ball joints and tie rods and they are all nice and tight. Some stuff I have done that probably isn't related to my problem is shocks and sway bar end links. What this could be? Hopefully not the steering box!
View 7 Replies
I have an '08 F250 w/ a 6.4. A couple days ago I started getting a loud squeaking when I turn to the right. It only does it under speed, almost like it needs the weight transfer to make the sound. In addition it's only when I turn at a like 45 deg angle, I can turn less or more to make it stop. But it has gotten louder and louder.
View 1 Replies
I have a 2000 F250 SD with the V10 engine. The problem that I am having with it as of late is that whenever I perform a full turn I hear some clunking coming from the front end. The clunking is similar to that heard from cars that use CV joints FWD but of course it sound more "manly"
Anyways, my truck has the full axle on front so I suppose it could be either the u-joint at the hub or the hub itself. I would like some pointers so I can acquire the required parts.
View 14 Replies
An odd noise just started recently where as I'm turning left, a popping noise happens seemingly right under my feet. I don't have a video, but I can probably try to take one later. It sounds like something is loose and when the weight shifts off of the left side of the truck, something is shifting and groaning.
I lifted the truck up yesterday and there is no play in the ball joints, wheel bearings, sway bar/end links, or tie rod ends. There is no play in the shock or in the spring, nor is there any movement in the radius arm or where the axle mounts to the body.
I should probably add some info on the truck. '00 V10 CCSB 2wd. I can't see anything out of the ordinary, and can't reproduce the sound unless the truck is in motion.
View 9 Replies
My dually has started to make a rubbing or grinding noise just about every time I make a turn, left or right. What this could be, truck has 8500 miles on it.
SD Dually
View 9 Replies
Had an issue with the negative cable n had to replace the bolt n nut. Since then its been making weird noises under the dash n under the hood even when the key is off. Sounds like something moving around under there almost but i know there is nothing. Also making buzzing noise every 30 minutes or so for a few then stops. Separate noises n 2 separate issues tho
View 4 Replies
I have a 2011 F250 4x4 with 8000 miles. I put a 3.5" ReadyLift on it at 3500miles and Rancho dual stabilizers at 5000miles. This past week I've started to noticed my truck's steering making slight popping noises when turning the steering wheel. I crawled under the truck today and I can't pin point the orgin of the noise. It seems it is coming from higher up in the steering system possibly. It doesn't seem to be from the wheels or tie rod.
View 14 Replies
'08 F350 6.4l 4wd, I had the truck come in with a exploded transfer case. (See pics). Ive read all about this happening to many others. The truck still drove, hubs not locked, plenty of fluid in the TC, pretty sure it was the double Cardan that did it. Anyways I replaced thwith TC, replaced the front driveshaft, filled the TC with recommended fluid. Test drove and drives great, shifts fine. Only until I turned left.
At slow speeds turning hard or 15-20 taking a turn, it sounds like a ratchet clicking from somewhere on the left side, right around the drivers door, from what I can hear from the cab. Does it in 2wd, 4wd hi/low, hubs locked or not. I changed the vacuum pump, no leaks, changed the IWE solenoid, pulled out both locking mechanisms, tightened crossmember, checked everything from the hours of research I did on the internet. I cannot find the problem. I don't know what else to check. Front axles free spin and lock when they are supposed to. I'm at the end...
View 6 Replies
First off my trucks a 2000 v10 f250 with four-wheel drive and 2 wheel abs with about 230000 miles on it.
I Recently replaced my unit bearing on my drivers side because I thought it was the cause of a grinding that only happens on hard left turns but I wasnt the cause it was going bad causing play in the half shaft. I didnt seem to notice and wear on the shaft from bad needle bearings but I have to take it all apart again to be sure. Was just wondering what else could be the cause of this noise. I plan to pull the axel shaft and change all the seals.
View 3 Replies
I have a 2003 f250 superduty v-10 -- 4x4 -- when turning with 4wheel drive disengaged I have consistent thumping sound coming from front end -- more so when turning to left but still prevalent on right turns -- I put new hubs in due to the grinding noise when driving slow to mid speeds -- like axles not totally disengaging and grinding on teeth. but this is a secondary noise -- replaced left front axle with dorman unit -- tried to replace u joints on oe axle but rusted so badly couldn't get c clips to separate from ujoints --
this one is kicking my butt and making me look like a novice -- don't think it is ball joints or anything suspension related but I could be wrong -- sounds like thump thump thump as turning in slightly tight circle or going around corner in the parking lot.
View 1 Replies
Just noticed something funny yesterday while flushing my radiator. I have an 04 F350 with the 6.0. When I have the heat set to come out both high and low vents, the A/C compressor also kicks on. The pipes by the passenger side firewall get cold. If I set the heat to just come out high or low, it turns off. This is not with the defroster on. Why does this happen? Is it supposed to happen?
View 5 Replies
Ok i have a 99 f250 with a 6.8 v10 that is not turning over at all. I have checked the battery and its good. I have replaced the starter and the starter relay and have tested the starter and its good too. I have also used a volt meter on the batter, starter, and relay and looked at the relevant info and they are all in the correct volt range. I have also taken the starter off and looked at the flywheel and it has good teeth so thats not an issue. I am completely stumped now as to what it could be?
View 5 Replies
I'd like to be able to have the key in the ignition and still have the door open without the incessant dinging of the key alert. Is there any way of shutting it off without having to cut wires, etc.?
View 1 Replies
Have my truck in signature making a very high pitched, annoying squeak from the front end. I believe it is coming from the right side because i just took the wheel off and it has a coating of brake dust on it (the 3 other wheels are clean). Only makes the noise when turning right at speed, and goes away when i straight it out or hit the brakes. I am not very good with brakes or the front end parts.. what could be causing this noise? Could the slide pins be frozen? i know that is a problem with these trucks... but not sure if these are the symptoms.
View 14 Replies
All of the sudden ignition stays on aux when the key is removed. Starts and runs fine with key , also shuts off with key. However when key is removed all aux functions still work ie touchscreen reciever will not turn off, and door chime continues to ding. 2000 excursion 4x4
View 1 Replies
So I've been having this problem that sometimes when I am turning the truck dies. It doesn't stutter or anything it just shuts off and will start right back up. It doesn't do it all the time either. Was also having an issue where the windshield wipers would shut the truck off too. But I don't think that's the same problem.
View 3 Replies
My trouble is upon turning key to start everything goes dead (no power to anything). Does not always happen, sometimes she starts just fine.
After the power cut out if I turn key off, wait a minute, then back to on position she will sometimes come back as normal or sometimes the on "ding" will chatter and dash lights will be dim.
I have checked batt connections, starter/solenoid connections, block ground connection. All seems fine. Get same problem when I jump starter with screwdriver. Been suggested to me ignition switch to blame.
View 5 Replies
