New, 2 month old 2015 CC, gas 4x4 with standard bed. At 50-55 I have a rolling vibration, or it can even be explained as a slight growl. Seems worse since I upgraded to 285/75/18 Toyo AT's and new wheels. If i speed up to about 60, goes away. If I pop it down to 5th gear, it seems to go away, however, I need to try this a few more times to make certain.
View 9 RepliesThe other day I pulled a fella out of a ditch. It was a dulley 350 with a lowboy trailer and a small dozer on it.
Well, after finishing and driving away. I inadvertently left the truck in 4x4 while driving on wet pavement at speeds ~30 mph. What I noticed was: when I let off the accelerator there was a low growl/vibration noise coming from the front/under the floorboards while the truck coasted to slower speeds.
I have never had my truck A) in 4x4 on clear roads or B) at speeds above 10mph in 4x4. Maybe they all make noise at low speeds in a quite cab in 4x4. I wouldn't know, I've never driven it under these conditions.
So, can you hear your truck in 4x4 when not giving it gas and coasting on the road?
I did not think I put the truck through too much while pulling that fella out, but now I'm wondering....oh, and I at one point I coasted forward and ran over the towing strap that was attached to my front pull hook and it made a HECK of a noise...could that have done something bad?
4x4 still works, and everything seems/sounds fine otherwise. I might just be hearing the front end putting friction on the transfer case and I can hear it in the tranny as she coasts to a stop (it goes away as soon as I press the accelerator at any speed) but like I said, I've never noticed this before.
Ok here is whats happening. 2003 F250. When the axle gets warm and I turn a slight left or right turn I get a bad vibration and Growl from the rear axle. I have changed the fluid and added two bottles of the Ford Limited slip fluid but the problem just keeps getting worse. The question is am I looking at limited slip clutches or do I have bigger issues. I had new Ford 4:30 gears installed about 3 years ago and don't know if they put new clutch pack in or not,
View 13 RepliesI bought this Ex a little over a month ago and finally got around to replacing some stuff.
I have a slight vibration between 50 and 60 MPH. The vibration is the same weather I am accelerating, in Neutral, Coasting down (well, a little bit worse when coasting down), in 2WD, in 4WD, turning, going straight, hot or cold.
I have replaced the following:
Rear Driveshaft U-Joints
Tires and Rims
Upper and Lower Ball Joints
Wheel Bearings
Steering Stabilizer
Cleaned and Greased the Hubs
Greased everything greasable up front
I still have the exact same vibration as when I started. I can feel the vibration in the steering wheel as well as in the body of the vehicle. I am thinking that it may be in the steering linkage. If there is a loose joint then the wheels would be allowed to jiggle a little bit. I am at a loss. What else should I check?
Also, When doing the ball joints, I noticed that the tie rod ends were quite stiff. How stiff should these be? I can't move them by hand, but they will move a little bit when moving the free end of the tie rod.
I am taking it in for an alignment on Friday, and if I can't figure this vibration out, I might have them take a quick look into it. Would a stuck slide pin in the front brakes do this? Both sides on my truck are seized at the current moment.
I have an 08 F250 supercab 5.4L that I bought this past July. The truck has 153000 miles on it now it had 150000 when I bought it. I don't drive it every day just usually on weekends and when I need the truck. The truck was really well maintained and had all the work done at a local ford garage. I live in western pa and lately it has been pretty cold and snowy so I have been using the 4x4 more than I normally would the past few days. My wife was driving the truck the day before yesterday and had it in 4x4.
The past 2 nights it has been really cold right around 0 degrees. I drove the truck yesterday and it just didn't seem right when I first drove it almost like there was a tire going flat or a flat spot with one of the tires. I got out and checked and everything seemed ok but it was still doing that. I saw that the passenger side hub was still locked while the drivers side was on auto and I was in 2 wheel drive. When I got home I sprayed the hubs down with PB Blaster and tapped on them with a rubber mallet. I put the truck back in 4x4 and drove it down my road to the end then put it back in 2 wheel drive and reversed down the road. When I got back into my driveway and checked the hubs were both in auto so all was good. T
he only thing now is when I am driving everything is normal but when I start to brake or decelerate I get a humming noise like you would get with off road tires on the highway. I wouldn't say that it is that loud but definitely noticeable and there is a vibration in the floor in the front along with the humming. When I am going really slow decelerating you can also hear a noise similar to if you would spin one of those wheels with the metal pegs at a carnival or something to win a prize.
I am yet another sufferer of the 40mph vibration syndrome I commonly read about on this site. I have had my 2006 f350 club cab sd to the dealership about 7 times for this, and now am being told it is a normal characteristic of this truck. They have replaced wheels, tires, vibration machine analyzed, put on a vibration damper, etc., but nothing fixes the problem. It has done it since the day I drove it home.
How many of you out there are upset about their super duty that jumps up and down at certain speeds? Lately, my dealership has had my truck more than me. From the amount of posts I see about this problem, I am certainly not alone. Ford is now trying to brush me under the carpet, yet I have a truck with a built in gyrator that is totally unacceptable. The truck now has about 20,000 miles of bouncy misery on it, and it isn't getting better.
2002 Ford F250 4x4 Superduty Lariat (4 door). Just changed the locking hubs to a new set of Warn manuals. I began to periodically hear what sounds like a rumbling/bearingish/howling kinda sound. Happens when you hit a bump at any speed...then howls till you hit another bump..goes away..then process repeats. Come to a complete stop, and the sound usually goes away till you hit another bump. The hubs are "free" at this time.
Heres the weird thing...when the noise starts...I switch it into 4 wheel drive on the dash...the sound instantly goes away. Click it back outta 4 wheel drive (hubs are still unlocked this whole time) and the sound is gone. drive some more down the road, maybe hit a slight bump, and the sound returns. Switch it back into 4x4...sound instantly goes away. Its not really in 4 wheel drive, cause the hubs aren't locked in...but that cures it till I take it back out. What could be causing this howling ? Its getting worse, and you can feel a slight vibration in the floor now when its doing it.
My 2003 Ford F250 V10 seems to have a vibration, sometimes at all speeds and sometimes at freeway speeds. I replaced front hub assemblies and ball joints and rear calipers last year. When braking i have a vibration in rear as well, which I think is from uneven rotor but can it be causing my vibration? Also sometimes I can smell hot brakes from the rear.
View 2 RepliesThe truck is in my Sig 01 F250 5.4
Just got back from a long trip with it. Parked it for 3 days, all was running fine. Went to dinner Sat night and all was great, left the restaurant and as soon as I started the engine I noticed a slight vibration. As soon as I hit 42 miles per hour, it started shaking pretty good. I pulled over and checked under the truck to make sure I did not have anything I was not supposed to hanging down.
Driveshaft looked good, nothing leaking from rear end or tranny. When it does vibrate, the Tach shows the unhappiness as well. This a.m. driving to work it was vibrating at all speeds and shifting was very rough, had a hard time deciding if it wanted to be in second or third gear. I don't think this is drive train issue... When it shutters and sputters at 40ish MPH, its almost like it loses power and I have to let off the gas. and then under power it shakes badly.
I had the super chip settings for performance tow when this started and then I changed it back to stock settings, thinking it might work, which it only got worse. Changing the settings with the Superchip you have to disable the fuel system and I do this by pulling the fuel pump fuse under the hood in the power distro box.
I think the ujoints are still good, the oil and tranny fluid are spot on. Hubs are locked but in 2WD. Had all the front end replaced 15K miles ago. Brand new tires and wheels in Sept, front end alignment done at same time, front brakes were 90% and rear brakes at 20%.
Today I noticed that our 5R110 was delaying slightly when shifting from drive to reverse. It was probably about a 1-2 second delay but it replicated itself twice in a row. There was no delay going from reverse to drive. It is just an engagement delay. We are running a Superchips Heavy Tow tune on the truck, it is a 2006 6.0 Powerstroke.
View 4 RepliesIve read here that our trucks can lose all of their AC fan speeds except High - mine has done that as well. However, even High on my truck doesn't blow much air. I looked behind the glove box for an interior air filter, thinking it might be clogged but couldn't find one. What could be stopping my blower from putting out?
View 2 RepliesJust noticed today, while taking slight right turns 20-40MPH, I get a really loud and angry chirping sounds? Its only right turns...It sounds like a forest of angry crickets.
View 4 RepliesI recently bought an 03 F-250 6.0 Lariat crew cab FX4. It has an EGR delete, ARP studs, and the updated oil cooler. It has 138,xxx on the clock.
Randomly, only when it is at normal operating temperature it will have a slight shake to it at idle. when i try to take off from this shaky idle it feels like it is "missing" i guess you could say. it clears up about 1/8 a mile down the road every time. And i will go ahead and say this does not happen everytime it idles. Only maybe once or twice in a 30 minute trip.
What might be going on? I have not added a coolant filter yet, and it does not have synthetic oil in yet either (just bought it) I plan to use full synthetic Rotella 5w40 very soon. I think this might be a stiction problem? but i read it is uncommon to have stiction when warmed up. I do not have anything yet to pull codes or read the FICM yet. both batteries are good.
I have a 2001 Ford F-250 5.4L V8. 117,000 miles. The problem I have been relentlessly trying to diagnose is a slight bucking that occurs under load when the truck is in overdrive. When the truck bumps up to higher RPM's it is fine but when it is around 1500-1700 RPMs on the highway it does a small buck like I'm hitting a bump in the road. I know there are many threads on this but none of them have gotten me any closer to a resolution. It also seems to have a bit of power loss when accelerating. Things I have done so far.
-Spark plugs and COP replaced about 1000 miles ago
-New fuel filter
-Cleaned MAF sensor
-Cleaned throttle body
-New PCV
-Seafoam treatment in gas and through brake booster.
I noticed a slight whistle last year coming from my front left hub. I pulled the hub and greased the gears as best I could and it sort of went away. Now this year it is a little louder. It only happens when the hub is locked. Is starts around 20mph and goes away at 40. Is the bearing in the hub shot or is this normal. 4x4 works fine and there is no visible excess wear on the gears. The truck has 93k.
View 6 RepliesI purchased the truck from a used car lot about 3 months ago and after driving for a few thousand miles I am feeling a slight wobble after hitting a bump in the road. Here is my truck set up:
- 2011 Ford Lariat F250 4X4 FX4 6.7 ltr
- 67400 miles
- Tires stock and great tread
- Rancho steering stabilizer kit
- Rancho Shocks
- Rear air bags
It does appear one of the rancho stabilizer dampers is leaking slightly. Why would the previous owner install a rancho stabilizer kit? Is it because of the rear air bags?
Bought a 2014 SD 4x4 in December of 2013 and this is the second time the big girl has been to the shop with A/C problems. First time it was the evaporator about three or four months ago. During the last few weeks of the summer I began to smell something strange (like band-aids) when the A/C was on and it lingered until the next re-entry. ALso, began to hear a slight hissing noise when the compressor was kicking in and out. They replaced the evaporator, smell remained as they said it was the refrigerant I was smelling. About two or three weeks ago the smell got slightly "larger", and last weekend she would not cool. This is the fourth time shes been to the shop with other problems such as the My Touch system..............
View 7 RepliesI have a 1999 f350 v10 stock truck. It has plenty of power when it's cold out or raining or I'm on backrooms or highways but if I drive through town on a hot day the transmission kicks bad I have changed the fluid and filter, it also seems to shift at a high rpm from 2nd to 3rd. Unless I you let off quick and go back on kinda like engaging a 2 speed rear end. Does it need a bigger trans cooler or is the trans shot
View 4 RepliesThe other day I pulled into the parking lot put it in park and let it idle for a couple minutes, it stumbled and when I started driving off it was missing. I pulled the valve covers off and check the connection.. I drove it home and it had a bad misfire at 1500 RPMs. The truck shook violently at that RPM but when I got it up over 2000 smooths out..
View 1 RepliesOnly 2 speeds of the 4 speeds are working on my blower. I was thinking it may be the switch, but someone at the shop told me to replace the blower resistor first. I did that and still only have 2 speeds. Im guessing I need to replace the switch now?
Also, I am having problems with my heat adjustment. I have it set to warm (half way between cold and hot) and out of the blue it will start blowing hot. I turn it down all the way to cold until it blows cold air and turn it back to warm, and it will be fine for a few minutes and start blowing hot again. Vacuum problem? blend door problem? How would I go about trouble shooting this problem?
My daughter has this truck and I was driving it the other day I noticed it misfiring when the trans shifts down under a slight pull and/or going up hills. It looses power and speed when this happens but if you back off, it smooths out when it shifts into overdrive. I haven't had it to a mechanic to check any codes yet.
View 3 Replies