Ford Super Duty (1999-2016) :: V10 Running Rough / Engine Ran Fine Until Battery Died
May 15, 2017
2002 F-250 SD V10 Auto Trans 140K miles.....
Engine ran fine until battery died. Vehicle then sat from Nov to May with no battery in it. On start up now after install of new battery, engine initially surged at idle and seemed to miss (run rough) in gear/under load. No CEL or codes. After a single short drive idle and running under load seemed to have improved a bit, but not yet back to what I would call normal.
QUESTIONS:
Is this simply a matter of the computer having to relearn after battery disconnect?
Will driving restore things back to where they were/should be?
How much driving/How far?
View 7 Replies
Advertisement
Lately my 2001 F250 5.4 engine is running rough when I am accelerating or keeping it certain speed. It feels like it is jerking. Like if the truck lost power for a second. This will go on for few minutes. Where to start to trouble shoot.
View 8 Replies
I have a 1999 F250 SD V10 4x4. I recently had a transmission installed and the truck is running erratic. I have an engine miss (sometimes when idling, more so when in drive and foot on the brake). I say sometimes because there are times it will not miss and the engine runs smooth. The transmission shifts a little strange and sometimes hard.
I am getting a code reading that says my TPS is faulty, but I installed a new one a few months back.
The engine is running rough (jerky on acceleration) especially when driving. I was wondering if I should take it to a shop and have them flash the computer to reset it?
I also remove the AC compressor a while back (bad clutch). I installed an aftermarket pulley.
View 2 Replies
I have an 02 f250 5.4. I just did the intake manifold. I also changed the spark plugs and the valve cover gasket. Following this I drained the oil and filled it with fresh oil.
It started right up but it felt like the engine was really vibrating and running rough. The check engine light than came on. I don't have one of those tools to diagnose it.
What could be wrong?
View 11 Replies
My 1999 F350 SD V10 that would crank but not start. I ended up checking numerous things because before it decided to truly stop running, it would run rough for a time and then be fine. The check Engine Light came on and I got the codes P0171 & P0174. Well, I bought MAF Cleaner and took the air cleaner housing off, disassembled it and thoroughly cleaned the sensor and replaced the air cleaner. I continued to get those same error codes, but before I could go any further, the truck totally died. It sat for nearly 2 months with the bed in the air as I had decided to lift the bed to check the fuel pump vs. drop the tank.
Fast forward a bit and I have since replaced the fuel pump and put $40 of Premium Gas along with Royal Purple Fuel Treatment in the tank because I figured things got stirred up and could use a bit of cleaning. I do not drive much, and during the first few trips, it ran perfectly. Then today, it started again with the rough running and trying to die if I let it idle. If I pushed on the gas, it would completely smooth out. If this were a carbureted engine, I would think the low idle was set too low, but since it is not, I am guessing it is one or more of the sensor/s that is/are causing the issue.
I am disabled and can’t play parts swap until I hit on the right part, so I was hoping that I might get some guidance here to narrow things down to the most probably causes so that I won’t go broke changing things until I hit the “right one”. The truck has 153,000 miles on it and I had bought it from a retired couple who used it to pull their 5th wheel travel trailer, so it had mostly highway miles on it. It was immaculate when I bought it and ran perfectly, needing only normal maintenance (oil changes, etc.) over the past 12 years that I have owned it. In those 12 years, I have put about 60,000 miles on it.
View 3 Replies
TBC fault has been showing on my 2006 Ford F-250 for a couple of years dealer said it wasn't an issue--- check engine light has been on for months, then lost speedometer back in November. Intermittently radio and fuel gauge shut off while driving--- stared needing a boost in really cold weather for the last month.
Driving today my battery just died while driving and I had the truck towed to mechanic--- they put new battery in and ran electrical diagnostics. Saying that it might be timing chain/cam shaft OR electrical components for computer system... I'm lost and so are they and don't want to spend thousands while they diagnose the source.....
View 6 Replies
2005 F250 6.0L ... My truck is running really rough when the engine isn't all the way quite warmed up. once the truck is fully warmed up to normal running temp it runs good. I am getting four engine codes. P0672, P0673, P0674, P0676 These codes say 2,3,4, and 6 glow plugs have a open circuit. Can this be the cause of my problem?
View 7 Replies
Driving down the highway, battery gauge read fine power, but battery light came on. In a remote Alaska situation so I couldn't diagnose, plus truck is new to me. Kept driving towards civilization. All gauge dropped. Then lights dimmed, then truck died. This was over about 15 miles. At night with lights on. Truck has a plow with plow lights, aftermarket cranking stereo which I was using, heater on (Alaska). It sits 70 miles up the highway from where I'm at getting ready to go back and work on it. So...
Of course first thought it is the alternator, not providing enough power for all this. Looked inside, it is a newer looking reman. Belt is fine. My question is, if not this, what else could it be? I'm hoping to haul the alternator and whatever else out there and get it going without having to drive back and forth for more stuff I need. I can always return stuff I don't use. Probably I'll throw a new battery in it as well. But after that, anything else I should be thinking/ready for?
View 4 Replies
Let me start with I have a 2003 f250 5.4. The motor blew on my truck and I had a 100k motor dropped in it. I've put new spark plugs, ohmd out the coils. I tried both sets of injectors. cat delete and new fuel pump. It has rough idle and stalls but runs fine at higher rpms. Also has basically no brakes. I am thinking vacuum but I've check all the lines. No codes either!! also cleaned throttle body.
View 4 Replies
It has 100k on the clock. I bought it about 2 years ago and only put about 500 miles on it. It is only used as a farm truck. Historically it would periodically die at idle in park. Would always start up immediately and run fine. Plenty of power.
Today the truck started up and idled a few seconds and started idling rough. It died and would restart but has zero power. Put it in gear and it would die. Did this a few times now can't even get it started.
I checked all fuses. I checked the dist cap and rotor. Don't look the best but don't think this is the problem. I get the same result on both front and rear tanks. From what I have read sounds like a fuel pump or regulator. Where is the regulator located?
1997 F450 superduty 7.5 gas ...
View 1 Replies
Had an issue with the negative cable n had to replace the bolt n nut. Since then its been making weird noises under the dash n under the hood even when the key is off. Sounds like something moving around under there almost but i know there is nothing. Also making buzzing noise every 30 minutes or so for a few then stops. Separate noises n 2 separate issues tho
View 4 Replies
My wife was using my truck and she felt it lost power and ran rough, so she pulled over can contacted me. We both are deaf, but I can hear some and it sounds really bad. So, I had it towed home and I recorded it.
2001 F250 5.4 V8....
View 14 Replies
The battery light is on when running. The light is dim at idle. Light is bright when driving with rpm's. The battery voltage is 12.8 per my older volt gauge. Alternator out put is 14 volts at idle and with rpm (2,000) +. I had the Alternator checked at AutoZone in there parking lot. Meter hooked up. The alternator passed all test.
View 4 Replies
The truck I'm working on is a 2003 f550 with a 6.0, and 382000 kilometers. My service truck died on me couple days ago, while running. As I rolled to a stop, I noticed that my temp gauge on the dash dropped to cold. (Truck was hot). Tried starting, and I have a crank, no start situation.
After towing it to my shop at work, I hooked it up to my scanner, and found that the pcm will not communicate with the scanner (otc genisis). I have no injector buzz with key on, wait to start light comes on for an abnormally long time. I have 48.3 volts on the ficm,(4 screw), and haven't been able to find any chafed wires as of yet.
View 1 Replies
I have an 2003 F250 7.3 Diesel 4wd. Yesterday I knew I was low on fuel but I don't think I ran out of diesel. My gauge was above the "E". 50 miles left on my overhead readout, but you never know. All of a sudden the truck misfires and is running very rough before it dies on me. I get it towed home.
Thinking that it possible I ran out of fuel and screwed up my fuel pump, I bought a new fuel pump and fuel filter, installed them and I have the same symptoms. I am guessing I lost my prime, who knows. I have 180,000 miles on it and haven't ever had engine problems.
View 11 Replies
V-10 running rough at idle, chugging. a problem has developed with my 2004 E-350 V- 10 after having a new fuel filter installed and the induction service done . Picked it up from a local shop and it was running rough after bringing it in when running great! I figured maybe it fouled a plug or something so I drove it home but it didn't improve so I brought it back and had new plugs installed. It is still running rough and wanting to almost stall when accelerating from a stop and the shop cant figure it out , not showing any codes.
I'm thinking maybe they caused some type of vacuum leak that is so far undetected. The killer is it came to the shop running great !!
No other problems with the vehicle, I drive it every day and have owned since new. 278,000 on it now and it has been the best vehicle I have ever owned.
View 8 Replies
I bought it and changed the fuel filter and it was dirty. Then ran a tank of gas with seafoam and then with lucas fuel injector cleaner. Still nothing. It idles like its missing and as long as you are light on the pedal it revs up fine but if you're heavy on the throttle its. Its has no codes that's why I haven't replaced the coil packs and plugs but they have been ordered. I just thought there would be an engine code if any of the coils or plugs were bad. Looked for a vacuum leak but couldn't find any. The donut gasket on the pass side is bad would that cause it to run shifty with no code.
View 2 Replies
I have a 2000 Ford F-250 6.8 v10 that is running rough and cutting out when I give it gas but I can turn the key off and turn it back on and it will run right, what it could be?
View 1 Replies
2001 V10- F250.. Runs rough- had the computer put on it and was coming up with P0174 codes (I think that is right)- In any case I replaced the Mass air flow sensor- checked for any vacuum leaks visually- I did not see anything obvious.... still runs like crap.... smells like gas when idling.... anything else I can check??? The check engine light went off finally (probably due to the MAF)- but it's driving me nuts- Any hoses I have not located I need to check?
View 10 Replies
So about a month or so ago i had my alternator replaced because my truck wouldnt start and had it checked and replaced well tonite it started rough dont know what to think what/where should i check first?
View 6 Replies
1999 F350 & lately if I don't plug it in even if it's like 40 out for like the first 30 sec sounds like its only running on 4 cylinders than it'll just even out & alls good. thinking glow plugs here. I did replace them last fall unfortunately with the cheep ones that I been now reading bad things about.
View 2 Replies
