Ford Super Duty (1999-2016) :: V10 Downshifts To First For No Apparent Reason And Not Shift Back Up
Mar 16, 2017
I have a 99 F350 V10 that has started with shift issues. While driving in drive it will down shift to first for no apparent reason and not shift back up. If I drop the shifter to second it will go back into second from first. I can then shift back to drive and it goes back to drive. It will last a few minutes and then down shift again. It's a dually dumper if it matters..
View 2 Replies
Advertisement
My truck was sitting in front of the house, unlocked and the alarm disarmed. For no apparent reason, the alarm on the truck went off. I tried pressing both arm and disarm button on the FOB and the alarm would not shut off. I opened the door, started the engine and the alarm immediately turned itself off. I need to look in the manual and see if there is any condition that would cause that particular event. Strange to say the least.
View 3 Replies
I was taking my boat out of the lake last night. Shifted T-box into 4Low and removed the boat. I then tied everything up and when to shift back into 2Hi and it wont. I have a 2001 F350 diesel w/ automatic and the auto locking hubs.Hubs are not engaged atm. I have never had this issue before and was wondering if a shift solinoid is stuck or something might be wrong with my Transfer case??
View 14 Replies
I need to solve tranny problem, it started out a while back, would not shift back into drive after stopping at stop sign (after driving fine for about 20 miles) thought maybe dirty filter so did fluid and filter change seemed to work for a while then started again noticed it was mostly after using cruise control, but u joints were very bad, so replaced 2 of the 3 and worked fine for about a thousand highway miles, then got really bad. Now when I check the tranny fluid cold and /or hot it is way up on the dipstick. Took to ford dealer in ladoga, lied and said no speed sensor codes, but list on the paper he gave me had all kinds of abs and a p500 code.
View 9 Replies
New 2016 - 6.7 automatic with exhaust brake:
In tow haul mode is the exhaust brake automatically activated or do you still have to turn on by button? Getting mixed answers, and seems to me that it does not activate unless you push the button which is seems to be what the literature is saying.
On steep downhill pulling heavy trailer, in tow haul mode every time you hit the brake it downshifts, and isn't long before it will over rev, unless you kick it out of tow haul mode. is there a way to hold it in a gear in tow haul mode? Or should I shift into manual mode at the top of the hill then use the +/- buttons.
View 5 Replies
2014 Elantra GLS ... Upon closing, and just as it reaches the wind defector, the Sunroof will " kick back" no apparent reason. This may happen once, twice in a row or not at all. I have checked the sunroof path and the wind defector, but no obstructions are visible.
View 2 Replies
I have an 04 f250 the 4wd won't lock in for some reason. The truck has manual locking hubs (turn them to the right to lock in 4wd or turn them to the left to unlock them) and I get the light on the dash just fine but the truck doesn't actually lock in.
When i I put it in 4 low it feels like it's in but it's not. I also noticed that when I put it in park while it's in 4 low it makes a crazy sound like it would when you put a car in park while you're still moving and the park pin makes that clicking noise.
Anywhere in particular I should start to look? Nothing up in the front end looks abnormal or out of place.
I've had the truck 10 years. Never had any 4wd related issues. I did however replace the transmission in December (and I did successfully use the 4wd after the transmission was installed).
View 3 Replies
1999 F250 .. Blower works some times then for no reason stops. When it works, I have all speeds, it makes no odd noises. I shut the engine off and then it does not work. I have power to the blower motor even when it is not working. I doubt it is the speed resistor module because that is not used in high speed. I've taken the blower motor out of its housing and pulled the resistor module as well. I find nothing wrong, power it up and the blower works. I put it all back together and it does not work.
View 4 Replies
I have a hard shift between 2-3 that is somewhat violent. It doesn't matter the rpms or how hard I'm accelerating, it will always do it. At wot, it sometimes throws a code that stays on for a few minutes, then goes away. When I hook up a code reader, it shows no record of it and it never throws a blinking OD light ever.
It has an ATS transmission, but I don't know how the controller works, if it is wired correctly, or if it could even cause this issue. Currently the truck has 210k and unknown on ATS.
View 2 Replies
So it appears as though my shift lever (automatic) will not shift into the 1st gear position? However when I drive the vehicle, the transmission seems to shift through 4 gears, then into Overdrive? What could be the issue?
View 3 Replies
I have a 2003 F350 Super Duty 6.0 L with the dash mounted 2H-4H-4L switch. I was using 4wd and the light went out by itself and now I cannot shift it out of 4wd. Fuse 31 has no power to it, and the drivers book says it is the fuse for 4x4. Where the power for that fuse comes from? There is no power to the switch as well, of course.
View 5 Replies
2004 Excursion 6.0... What might be cause of my "shift on fly" 4x4 not working? No lights on dash, no mechanical noise, fuse appears Ok.
View 3 Replies
My 05 superduty is in the shop because it won't shift in or out of 4Hi. Ford garage says I need a new transfer case shift motor, and 4wheel drive module. They said the shift motor was full of oil. I am not really up to speed on how the shift motor works, other than it bolts externally to the transfer case, that's why it confuses me about the shift motor being saturated with oil. My truck has never leaked even a drop of any type oil, ever.
View 6 Replies
My two oldest sons and I have a 1999 SD F250 4x4 with the V10 automatic. My boys burnt the trans. We had a spare that was pulled from the same year truck with the same motor. The boys installed it without me. Everything seems to work as it should, EXCEPT! 1-2 will not shift until 2800 rpm. 2-3 is the same. When I checked the install I found that the new trans has a speed input sensor on top of the housing behind the bell housing. It is Not plugged in, my harness does not have that plug. Old trans does not have that sensor. Is this the cause of the high rpm shifting?
View 14 Replies
When I shift into 4Lo I get no 4 wheel drive. 4Hi works. Did have a/c redirect to defrost a couple of times. I remember something about the air redirecting having something to do with not having 4x4 but don't know just what it was.
View 8 Replies
99 v10 auto 4x4. Won't go into park completely. Have to start in neutral. was fine yesterday, now it doesn't work. if it wasn't snowing like crazy id just crawl around and find out. do our trucks have a linkage? or shift cable? I imagine I am just out of adjustment somewhere. any advice what to look for or where to start when the snow finally stops??
View 3 Replies
Friend parked his well working truck and when starting it up after sitting a few days it won't shift into any gear. Lever moves as normal but the truck won't move. A soft clicking sound is the only difference to be noticed when shifting the lever. where to start? Temps are below freezing here if that matters.
View 11 Replies
I just noticed the clips in the pictures. Brand new F-250 crew cab.
There are two of them along the bottom edge of the back glass.
I can't find any reference to them in the owners manual and couldn't find anything by Googling it.
What these are and what they are for?
View 14 Replies
A while ago both back doors on my 01 crew cab stopped working. The outside handles jiggle loose but the inside ones feel like normal. They both went at about the same time. If it's those little black boxes that mount by the handle on the door, how do I even get to it to change it if it's stuck shut? I can't reach my hand in there either to even try to see what's wrong with it. How to get it open?
View 9 Replies
I have a early 2003 SD with the 5.4 triton. It has a oil leak on the passenger side, the oil blows back and gets on the exhaust.
I have been under the truck with the engine running looking at where the head meets the block and at where the valve cover meets the head and can not see a leak.
Sitting there running at idle it does not drip a drop off the engine but the entire underside of the truck is coated in oil.
I did notice that the depression around one of the upper valve cover bolts was filled with oil, I cleaned out the oil, let the truck run and it stays dry.
View 8 Replies
2004 Ford F250 CC 4x4 6.0L
Took the family down to the beach today. Had some tough sand to get across in a few areas to move away from the crowds. Got a little dicey and the truck got stuck in 2WD. Switched to 4WD but back tires kept spinning. Couldn't figure out why and the truck started to dig deeper in the sand. Got a little nervous and I didn't want to start the day off with having to get pulled out.
Got out of the truck, locked the hubs in manually and I was out, no problem. Left the hubs locked until we left the beach and back on pavement.
What might be the problem and why the "shift on the fly" switch on the dash didn't seem to engage the 4WD? I even tried to switch into 4L and back to 4H (truck in neutral, break pedal compressed) and still no workie. Only manually locking the hubs would engage the 4WD.
View 14 Replies
