Ford Super Duty (1999-2016) :: Unpredictable Steering When Turn Sharp Right Or Left Suddenly
May 3, 2015
My steering pulls hard left or hard right, and also seems to have a mind of its own when it turns sharp right or left suddenly, as though someone else is driving. It's very disconcerting when you think you're making a left and the truck veers right.
Today I was making a left onto a bridge and truck kept going straight. I almost hit the bridge. I have an 06 Ford F250 Turbo Diesel. What this could be?
View 4 Replies
Advertisement
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
View 14 Replies
My 07 has developed a steering gear issue.....it suddenly developed about a quarter to a half turn of slop......mechanic checked the front end and found everything to be tight and right so......I ordered a Redhead rebuilt box and will replace it upon it's arrival. My question is How often do these boxes go bad and if and when they do is it at all safe to drive the vehicle with that much play? I have to drive it about 15 miles to get to my mechanic ( far too cold for me to do it at home) and I also plow a couple of yards commercially and will need to use it there in the event of a snow storm.
View 8 Replies
2012 350, crew, 4x4, 6.7, LB. Ignition does not always engage when you turn the key (we've changed the tumbler and the batteries) after sometime the truck will start. the dome lights do not work in auto anymore and every so often the steering will "grab" to the left, when I compensate it will switch to the right. I can drive from 20 - 300 miles sometimes before it does this and then it may or may not come out of it right within 5 - 20 minutes.
View 1 Replies
I have 2014 F350, was previous flood damaged, the steering keep sticking when I turn it to the left, not always in the same spot, but sometimes it just locks and will not turn right, needs lots of jiggling and then it release, as I say in different places but always when turning to the left, never when turning to the right. Does this indicate steering gear fault or something else?
View 9 Replies
I have a 2013 F350 DRW, 3.73 gears LS. 25K on the thing.
Today I notice that when I turn a corner I get a groan. At first I thought that maybe the springs are doing it. I sprayed them down really good with fluid film. No change.
So I had my daughter drive the truck with me standing on the rear bumper. It is definitely in the rear end. It is quiet when in a straight line.
View 7 Replies
Driving on a paved road(some potholes but nothing bad) came to stop sign. After waiting for trafffic to clear, made right turn onto state highway truck began to pull to left, at first I thought i had a flat tire but every thing looked okay. Drove two miles to home, if let the steering wheel go, the truck would change lanes in about 25 feet...
2002 ford crew cab 4x4 7.3 power stroke 20k on Michelin.
View 9 Replies
I own a 1999 F350 CC SRW w/ 7.3L PSD engine. My turn signals stopped working suddenly. I've checked the fuse panel under the dash but it doesn't show any fuse for the turn signals.
My hazards do work although I noticed something very strange. When I tilt the steering column down the hazards stop working and when I tilt the column all the way up they work again. Still no turn signals though.
View 1 Replies
Seems that after a sharp right turn, for instance turning right at a stop sign I'll get a loud pop that I can feel in the floor pan under my feet.
After the pop the steering wheel and whole front of the truck will shift left and right like someone is grabbing the wheel, sometimes violently. If I drive slowly it will cure itself and sometimes not do it again for several days. I've check ball joints and hubs and they are in great shape. I pulled the hubs and greased the needle bearings about 6 months ago. I checked all steering components and the linkage that attached to the steering arm had some play so I replaced it. Then I found that some idiot took the steel sleeve out of the bushing in one end of the steering stabilizer. I bought a new stabilizer and cured a pop I'd had since I got the truck, but the other issues were not solved.
Alignment has been checked too.
View 14 Replies
2012 F250 left turn signal on all the time no right turn signal.
View 2 Replies
I have a 1999 f250 sd with the 7.3. I'm not sure what is going on with my pickup. When I turn to the right i can turn with one finger, but when I turn left i have to put some muscle into it. Power steering fluid is full. I raised the front end and it turns both ways easy. My ball joints feel fine, there is no tire shake when i have it off the ground. My tie rods feel fine also, nice and tight. I was thinking about replacing the steering sector to see if thats the issue but wanted to get a second opinion first.
View 2 Replies
I bought a 2004 F250 Crew Cab LB 4x4 with the 5.4 Motor and when I turn left it has some Tight Spots and I can't figure out why, I checked the Drive axles to make sure the locking hubs were unlocked and they spun freely, I Also have a lot of play in the steering wheel, Could this all be Related to the Steering Box? What else should I check for ?
View 3 Replies
I had some steering issues with my truck so took it for an evaluation at pep boys. They recommended a new steering gear box and tie rod that hooks to the pitman arm so I had them replace them. Steering was improved but now the wheel is canted to the left or right depending on when I make a turn. When I make a left turn, the wheel is canted about 10 o'clock. When I make a right turn, it's canted about 1 o'clock.
I looked under and had my brother turn the wheel and didn't really notice any thing loose. I lifted the front and noticed the left wheel bearings need to be replaced. I also noticed the shocks were shot and replaced them but it didn't make a difference in the crooked wheel.
Do you think it's the wheel bearing that can cause this? How about the ball joints? The truck has 407k miles and I bought it a month ago. Previous owner said he never replaced any steering components. Should I just replace all steering components with the Moog kit? I'd like to hold off on the $600+ kit for now as I just bought a a boat and the boat needs some stuff. I hope to find that one thing (hopefully not more) that's loose.
View 7 Replies
At center, my truck is able to turn 2 1/2 revolutions to the right and only 1 1/4 turns to the left. Making sharp left turns is not possible currently. What needs to be adjusted in order to get the steering centered and even?
View 4 Replies
I have a ford f350 super duty that has a little problem turning to the left but is really hard to turn to the right. How do I fix this?
View 4 Replies
I just picked up a 2005 SC LB 4x4 5.4 v8 6mt F-350 yesterday and drove it about 250 miles home. It is my first Super Duty, and I love it so far but... the steering has some issues. There seems to be decent amount of play in the steering wheel when I'm driving straight. Also, the truck drives straight when the steering wheel is turned about 30 degrees to the left, and I would like to fix that and bring it to center. When I was cruising on the highway (65-70 mph), there was also two 20 minute periods of time spaced an hour apart where the steering would get light and the truck would dart to the left (i do not think road conditions were a factor as it did not happen on the worst stretches of highway. The truck has 133,000 miles on it, and has had pretty routines maintenance done on it, as it was owned by a drilling business as a work truck to haul tools. The guy I bought it from said that it needed the steering shock/damper replaced, so I will do that, but what else to you think I need to do to the truck?
View 2 Replies
Have a problem When i make a slight turn to the left sounds like the tire is rubbing the inner fender. Don't do it all the time. The tire is not rubbing.
View 4 Replies
Every time I try turning at idle or with foot on brake it wont turn at all. Is this just a super duty thing or vacuum leak or power steering pump going?
View 9 Replies
I have a 2009 f250 4x4 . When i make a turn and sometimes while driving the steering locks up. Sometimes i have to jerk it back. Sometimes it feels like i have no power steering . And some times its seems the gear box is stripped. I had it to a mechanic look at it and all the steering and suspension parts are good. The u joints are also good. There has to be a HUGE problem with this issue, due to know one having a steering box, even the dealer. I have a truck that I can't drive...
View 6 Replies
99 F250 super duty 7.3
Had new ball joints installed and alignment. Steering does not return to center. Returns a little on a tight turn like in town but difficult when just changing lanes in town or not. Took it to another shop and they said the ball joints were too tight. right side pretty tight and left side really tight. Moog ball joints. First mechanic says they will get better with a few miles on them. Second mechanic says not so.
Also, have new shocks but get a bouncing in the front when at 45 mph and goes away at almost 50 mph.
View 9 Replies
I just bought the truck 2 days ago and the power steering is acting up. When I test drove it I noticed the power assist seemed weak but it has gotten way worse over 2 days.
Truck is a 2001 F250 4x4 V10 auto. 60k miles and totally stock except for Harley Edition wheels and stock size tires.
Now at a complete stop the wheel won't turn at all. If I roll it works. Doesn't matter if I rev the engine. It doesn't matter if I'm on or off the brakes. Tires have plenty of air. The pump is quiet and does not make any abnormal noises.
This is terrible because how can you maneuver a trailer if you can't turn the wheels when stopped.
I noticed the fluid was low and not reading on the dipstick. I added a few ounces and that's all it took with no change. I then used a suction pump to empty the reservoir with the truck off. The fluid was very dirty, probably the original fluid given the mileage. I removed about a quart and refilled it with fresh Mercon ATF. I also changed the serpentine belt because I noticed the belt was probably the original and was cracked.
It went away briefly tonight as I was playing with it. I thought I fixed it but I was fooled. What I did was remove the reservoir cap and turn the wheel from lock to lock while rolling forward slowly. Suddenly it was fixed . But 5 minutes later the problem was back.
View 11 Replies