Ford Super Duty (1999-2016) :: Truck Would Squeal All The Time On And Off When In 4x4
Feb 13, 2014
My truck was in 4x4 and would squeal all the time on and off. Here is the situation today, this has happened prior but i just didn't post on here until it lasted for 30 miles on the highway.
4x4 system:
-MM hubs
-all stock minus the hubs
-Pass side vac hose melted against tire (doesn't matter with the MM hubs but too much info is not a bad thing)
-Replaced u-joints in November
-the screeching when not engaged predates the MM hubs that i installed, it occurred when i had my auto hubs locked last year because they would not disengage
Trip:
-average of 45mph
-30 miles from NH to MA (route 3)
-truck was operating up to temp
When it occurs:
-Under Acceleration
-15-45 mph
- when going from stop-30 it makes a hollow tapping noise instead of the screech
- when hubs are locked and t-case is NOT engaged it screeches for about 1 miles and then stops
Sound in the video occurs within the first 8 seconds, its faint in he video but very loud in person. Highway didn't look that bad in the video but i was in a plowed sctretch other than that the last 25 miles were through about an inch of snow and slush.
View 13 Replies
Advertisement
It seems like recently almost every time I start my truck it beeps 5 beeps 5 times. so it beeps 25 times. what could this be and how do i get rid of it. I wear my seatbelt so it is not that. There has to be a relay or something to stop the dam thing from doing it.
View 14 Replies
I'm assuming I might have a coil going but I'm not sure. Yesterday morning and this morning I started my truck and it was fine, I backed out the driveway again truck was fine. I put it into D and pull forward it was fine till I hit about 1300rpm, then it felt trike the truck was stumbling, I went a little faster to 1500/1600rpm and it stopped, as soon as I slowed up and then hit the go pedal it started again at around 1300rpm and stayed till 1600rpm and then it went away. So this is twice now two days in a row this has happened the exact way and only in the morning and goes away with no problems. I hooked up my SCT X3 and there are no codes and when it stumbles I have no lights come up. What I should do?
View 14 Replies
2002 5.4 super duty. My truck had started to ping, and knock worse over time. I did some research on this site, and I decided to remove my K&N air filter. Replace it with a traditional paper filter. Then I cleaned my mass air flow sensor. The results were great, no more knock and ping.I will check the MPG next to see if I get any improvements.
View 1 Replies
While engine braking I started hearing a squeal under the hood , when I started accelerating it became a little louder, I pulled over and when I rev it up it gets louder and has a little rattle sound, sounds like it coming from the turbo....
View 5 Replies
I have a 2013 f350 with the 6.2L gas and automatic transmission...when it sits idling in gear or park it starts to whine or squeal for about 30 seconds then stops and starts again. it makes a horrible sound if you shut the truck off while it's making the noise... Ford has had the truck for 5 weeks and checked the motor for vacuum leaks and changed the torque converter...but it's still doing it but less frequently now but according to them it's louder. I have a video but don't know how to upload it. if you go to YouTube and search ford raptor whine it shows a raptor making the same noise also.
View 7 Replies
At low speeds, I notice a squeel sound in all four wheels. Ford tells me that it is due to the type of metallic pads they use and is essentially brake dust noise that warrants no repair.
Any after market pads that are good quality for towing heavy loads, yet aren't metallic in composition? For instance, are porcelin pads a good choice.
View 2 Replies
I have a 2011 F-350 Diesel. It started making a strange whining sound when I start it in the morning. Very random and only does it when it's 0- -4 c. Took it to the dealership and they said its the cooler fan clutch. Got it replaced yesterday, and this morning I started it up and the whining sound was back. It also had a weird vibrating sound. What it could be?
View 10 Replies
So today pulling out of the gas station I turned my steering wheel to the left and I heard a high pitch squeal from the drivers side. It wouldn't do it again unless I was just creeping, nothing going down the road. I did a few searches on here but they all are if the truck is moving say 30 mph or better. I know I need to replace my ball joints. 99 F250, V10, 4X4, extended cab.
View 8 Replies
I have an 2001 Ford F250 V10 CCSB. I installed 3157 LED Brake//Turn light. Now when I turn in my left turn signal it blinks fast which I can live with that but it would be nice if it blinked at the regular phase. Here my big problem. When I turn on my right turn signal there's a loud squeal in the cab of my truck. !!!
View 8 Replies
I have a 2004 F350 Crew Cab DRW 4WD 6.0L.
The front drive shaft is making a high pitched metallic squeal while the truck is in motion. I thought it might be the universal joints but after lubricating the joints, I can still hear the squeal and it sounds like it is coming from inside the drive shaft. I also hear this squeal when I spin the drive shaft by hand.
I have quite a few questions about these drive shafts:
- What would cause a squeal from within the drive shaft?
- Are there any replaceable parts or do I have to get a new drive shaft?
- How do I identify the correct drive shaft part for my truck? Seems like there are a LOT of different models on the web.
- Are any of the aftermarket drive shafts any good? Any to avoid?
- Is this a DIY job or will I need to take it in to the shop?
View 3 Replies
2011 F-350 XL, I can hear a squeal coming from the front brakes when rolling forward slowly, believe the pads are dragging on the rotors. If I touch the brake pedal the squeal stops as it does when I turn the wheel. Took the calipers off and greased the slide pins and put it all back together, still got the squeal. What don't I know???
View 9 Replies
I have a 2009 F350 and use it almost exclusively for towing. Every time I stop to fill up or eat or whatever I have to push the tow haul button again when I start the truck- no big deal really just annoying at times because I don't always remember to turn it back on. Is there a way to have it turn on with the button and not turn off until I push it again (even after the trucks been turned off)? I suppose while we're on the subject same with the heated seats?
View 12 Replies
Just did my first oil change on my 2015 Super Duty 6.2 engine. I got the Fram filter the book called for, a PH-2. There's goobs of room for the longer filter. Would that be the PH8A? The book is about to trying to figure the comparable long vs short filter. Why do they insist on those short filters when a full size will fit? My Dodge Ram Hemi was the same way.
View 14 Replies
Actually a couple of questions. I've had one oil change in my F250 6.7. Getting close to the second one. So, my question is, what is the computer using to decide when to tell you that you should change the oil? And, if you changed to a synthetic oil, could you go longer between changes? And, if so, would the truck's sensors be able to tell the difference in the type of oil being used?
View 4 Replies
Noticed the other day that the engine fan on my 2013 6.2powered F250 runs all the time. It's like it has two speeds- really fast where you can hear it running with the hood closed and a slightly slower speed where it still turns fast enough that you can't make out the individual blades. Is this normal with outside temps in the single digits.
ETA. it does this with the heater off also.I've noticed since it's cooled down this winter that when I slow down to drive through town or hit a stop sign my coolant temp needle drops a bit. Thought maybe the fan running is overcooling the engine or maybe it's always done that and I've just never noticed it before.
View 2 Replies
My truck threw a check engine yesterday, P1151 and P1152. What could be the problem? 04 f350 with 5.4 with 142,xxx on her
View 14 Replies
A good while back I seen a thread to do this , but can't locate it now. I have a 2012 F250 and looking to make my night time driving better ....... I want to run both low and high beams at the same time and getting the fog lamps to stay on when going from low to high beam.
View 14 Replies
I have a 2008 Ford F250 with 6.4. Having alot of problems with the 4X4. Went to put the truck in 4 wheel drive one day and noticed the light on the dash never came on to engage 4X4. Of course we had a big snow storm coming and I didn't have 4 wheel drive. I drove the truck across town and decided to just try 4x4 again and it worked that time. I got the light on the dash and could hear the transfer case shift motor engage. Came out a little later and tried it and it wasn't working again. Took truck to shop where they replaced transfer case shift motor with a remaned motor from oriellys.
4x4 worked for a few weeks then just started doing the same thing again. We thought maybe that motor had problems also so had it replaced too. Truck is still doing the same stuff. Sometimes it works sometimes it doesn't. Figured out that if its not working and I leave it in 4x4 and unhook power to shift motor then plug it back in it will engage 4x4. I've seen some post on here but sounds like everyone i've seen their motor just stops and doesn't work at all.
View 8 Replies
2012 F250 left turn signal on all the time no right turn signal.
View 2 Replies
Last night I was watching tv when my truck tried to start I thought I hit the remote start on my keys but it didn't start which I found weird. I went down stairs too see if it did anything else and it did it again it would turn over and turn over but never fire all while the keys are in my hand. At the same time the done light was stuck on and the radio went on and off. I'm pretty sure that my GEM got wet through the windshield, also Is the GEM dead or can it dry out and be ok
View 12 Replies
