Ford Super Duty (1999-2016) :: Transmission Slipping In / Out Gear - Code P0705
May 20, 2014
I recently had a thread going regarding my 1999 F350 2wd auto transmission slipping in/out gear. Tried to follow up on old thread but got confused so I'm trying to start a new one. Basic problem is that truck was slipping in/out of gear. Cleaned the solenoid pack electrical plug (as instructed on previous thread) and the truck didn't act up for 2 weeks. Today it started slipping in/out again and this time it registered a code of P0705.
View 7 Replies
Advertisement
Truck is slipping in/out of gear in 3rd gear. Shut it off and the problem may not come back for several days, but in general it is getting more frequent. No codes are registering for the transmission. Curious the wisdom of performing a simple fluid/filter change vs taking it to the transmission shop. Fluid basically looks/smells good, and is full.
View 14 Replies
I have been having trouble with my 2008 Ford F250 4x4, 6.4 liter diesel transmission. SCT tuner, 10" lift, egg delete and dp delete has been done. I have been losing power mainly in reverse but have noticed that the transmission hasn't always been going into the last gear on the interstate. Code PO741 would come up. The other day the shifter was stuck. So I played with it and found that the cable on the transmission had fallen off. After replacing it. The transmission wouldn't go into reverse but has been doing semi good in forward. Well I have been limping it around until today when I was going down the road and it completely stopped pulling. Now no matter what gear I place it in, it will on go in reverse. What could be causing these issues or where to even begin to start looking?
View 3 Replies
I been having a issue with my truck lately. It's a 2008 with only 88,000 miles. When doing 55mph it feels like the transmission is slipping. Sometimes it will do it over and over. If I speed up to about 60mph it goes away.its has gotten worse in the last month or so. Hoping it's nothing major.
View 6 Replies
Got the truck 2 months ago and it only happened 3 times; always on a cold engine.
2 times were on my street at low speed just out of my driveway. It's like the engine shuts down for a while and maybe downshifts too. Feels like someone is stepping on the brakes for a second and then all is back to normal.
Last time I was getting out of a restaurant and accelerating hard to get up to speed on a 70km/h road. The downshift happened while I was going almost 70 but still in low speed so the braking effect was severe enough to throw me forward. Once again everything was fine the next second.
I'm not sure if it's the transmission downshifting or the engine cutting; maybe even the ABS kicking in for some reason. It happens too fast and too rarely to be sure. My feeling from what I remember is that the truck is downshifting and I'm feeling the braking effects from compression. 6.2 engine.
View 8 Replies
1999 F250 SD... Tranny fluid is low, tranny slipped one time on me. I checked the fluid and it's low. No drips on the garage floor, so I'll have to inspect closer. But my question is can I add new fluid without screwing it up even more? It's got 170,000 miles and I doubt the fluid has ever been changed. I just bought the truck last week, so I can't say for sure, but it hasn't had a regular flush or change. It doesn't smell burnt but it's just a little darker than new fluid. I was told by the guy I bought it from that the torque converter was changed in it not too long ago.
View 11 Replies
2011 f250 gas 4x4... I bought last year with 65k miles, now has 105k. sometimes when accelerating it slips for a second like a manual would if you jabbed the clutch while pulling. I had the 100k trans flush done. I noticed it a couple times before but more frequent recently. How concerned should i be?
View 6 Replies
I bought my F-250 Super Duty 6.0 last October, and I am extremely happy with it comparing to my former '03 Dodge 2500 TD. The Ford drives so much better!
There is only one problem I have with it. Without pulling it shifts nice and has lots of power. A Month ago I bought a fifth wheel trailer and I hardly notice it behind the truck, also it doesn't use more diesel pulling. However going uphill the transmission seems to slip, and I can hear (sounds like) a fan running loud? I loose speed.
All the temperature gauges stay normal, no difference. It starts to pull worse. I replaced de tranny filters, inside and the outside one. Also I did put the correct transmission fluid in there, no difference. Almost no grindings in the oilpan/magnet.
I looked on many sites, but cannot find anything on this. Personally I think it's the torque converter? My final step would be to have the transmission rebuild, with the best parts available, (close to WA, ID, MO)...
View 8 Replies
I have a 1997 F250 heavy duty 4x4 7.5 efi. I just bought a 2003 weekend worrior weighing 5800lbs dry. When I go up slight hills in 4th gear it seems to work real hard especially on freeways, could my clutch be slipping or am I just at max tow
View 11 Replies
New truck 11000kms ago thats done medium amount of work but nothing heavy or sustained for long periods of time. I get the feeling of clutches slipping especially when truck is cold but also when normal temps. Doesnt make any weird noises or anything. I can really notice the difference in torque if in manual mode being much better, but still not perfect if i stomp on the gas pedal and go through the gears in manual mode will still slip. Also is really harsh shift if i come to a halt in 3rd manual mode with the brake pedal depressed push minus button the truck makes very loud clunk noise into gear 2 then 1. Took it to ford they couldnt find anything ? Thinking of trying another dealer.
View 2 Replies
1999 f250 SD 5.4 reg cab 320000 km. (200000 m for all those south o the border)
Short story is after plowing truck doesn't like shifting out of second. usually works again next morning. Took it in to have tranny flushed/serviced. No change. obd says p0705, transmission range sensor circuit malfunction. today just as I got home I gingerly (seriously not boring the snot out of the truck) started using the plow to shave the bank out of a corner of my driveway. started taking its time to shift into D. reverse is fine.
Finished what I was doing and went to turn around, backed up 3 point style and it wouldn't move forward in any position tried D, 2 and 1 and nothing. put it into 4wd low range and it did move a bit, tried it again in 4wd high and nothing, tried it with 4wd off and nothing. eventually it felt like clutches engaging like the abs would, very grabby but not moving much.
As I said I already flushed the tranny and had a service done on it. From what I read my next step is to change the transmission range sensor (same as a neutral safety switch yes??) What could my problem be?
View 5 Replies
I was pulling the I-40 ascent to Asheville today while empty, got to the top and started down the other side got to semi flat road and the tach suddenly went up about 600 rpm's. Transmission temp about 180*F. I let off, then resumed and everything was fine. About a mile later it happened again. This time the tranny lost 3rd and OD, still had 1st, 2nd, and Reverse. So, we limped into a service station. Temps hovered in the 170-180 range. At this point there are no codes, no lights, O/D is not flashing.
I shut the truck down to check fluid level and current condition. Everything was fine last night. Fluid level is still good and fluid is still red and clean. I changed fluid about 2k ago and the fluid coming out looked almost as good as the fluid going in.
Got back in the truck started it up, checked for codes and got a P0705, put the truck in gear to get to a diesel shop down the road and everything was fine, shifted completely normally through all the gears. This lasted until about 1 mile from home and then the same thing happened all over again. Fluid still looks clean, not burned, still no CEL, no flashing O/D, but only have 1st, 2nd, and Reverse.
View 14 Replies
I have a 2012 F-250 ccsb lariat and the shift from 3 to 4 seems to be a bit prolonged as if the converter is slipping and wont go ahead and push it into 4 gear. Also it will want to downshift from 3 to 1 and feels like the car behind nailed you. I have read that the early 2011 had some of this problem and the dealer reflashed the tcm and it did not do much good but as mine being a 2012 mine should have been flashed with the lastest tcm flash from the get go?? Egr fell off and am running Kory Willis tunes through ez lynk so the stealership is probably out of the question. I have also read that changing a couple solenoids( dont remember which ones) will fix the problem.
View 11 Replies
The tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 Replies
I have a delay when I put my truck into gear. It only happens when I have turned the truck back on. It happens in forward as well as reverse. What is causing this? Syncros?
View 8 Replies
2015 F 250, less then 5k miles. When towing travel trailer, weight 7500lbs, on occasion transmission will not shift out of gear. Happens in first, second, or third. Very intermittent. Take off from a stop engine goes to 6k rpm. Let foot of the throttle goes all the way back to idle, still no shift. Accelerate back up to speed still will not shift. After doing this a couple of times finally shifts. Have had this happen in second and third. Not a lot of fun with cars behind you or trying to merge on highway. No codes
First trip to Ford dealer they re calibrated computer. Still happened towing. Second trip to dealer they put a flight recorder on it and I towed again. Did not hang up in first or second ,but would not shift out of third on highway doing 70mph, even when I lifted from the throttle and coasted. I finally shifted to manual and shifted to fourth and was able to upshift After reading flight recorder mechanic said it appeared normal. I explained that having to shift the transmission manually is not really normal and they agreed.
View 14 Replies
Drove the wife to work this morning. The turn off into town there was a lady stuck so I pulled over in the drifts. After putting in back in gear I had to get on it to get out of the drifts. Snow was blowing over the windshield, and I imagine throughout the engine bay.
After that it felt like it stayed in 2/3rd gear. I'd hit the pedal and it would redline and sort of accelerate jumping in and out of gears. So i slowed down to a stop. Accelerated slow and it was ok but when I got more on the pedal it would feel like it was slipping. Once I got in the driveway, she idled for about 15 mins while I shoveled out my spot. Once putting in gear again I had to rev it up for it to move.
Also reverse, had to rev it up to move it.
View 2 Replies
I recently overhauled a 5r110w torqshift in an 03 F350. The trans is acctually an 06 trans. The original problem was that the truck was "tieing up" on take off. When i tore the trans down i found the Low/Reverse clutches were burned bad and welded together. Everything else looked decent. I replaced all the clutches and checked all the clearances, except the OD clutch because i could not find any specs, or a way to adjust it. The trans has been doing good for around 200 miles. Now it has an intermittent problem.
When you first start the truck its like the converter has to fill up. It has a delayed engagement, but only AFTER you shut the truck off. Also, after driving about 10 miles, sometimes it will feel sluggish. I put my Solus Pro on it and while watching the trans data noticed that the transmission is not downshifting all the way int first gear at times. It will down shift, and then try to take off in 3rd and sometimes 5th gear. I was looking thru my ATSG manual and i can see which clutches turn in for 3rd. It seems like a solenoid is sticking on and allowing fluid to "leak" and keep the wrong clutch turned at the wrong time.
View 12 Replies
When pulling my trailer away from a stop transmission shudders in first gear, feels like t c. Once it changes to 2nd, it clears up. Getting ready to take in for service. Any thoughts? Still under bumper to bumper warrenty. 2008 6.4 auto f 350. 26k miles
View 4 Replies
I know this is a common code and a common problem. I have had a buzz test and glow plug test done, no codes. Scanner code came up with P0275. I have read about injector change out, to O ring failure, to new EGR style. I have a 05, 6.0 SD SRW auto.
View 1 Replies
2015 F-250 Super Duty, 6.2 L Gas with 6r140 Transmission. I have 13 K miles on my truck. While pulling my travel trailer up a hill the transmission kicks down thru the gears, which is fine, but as I crest the hill and in 2nd gear, the engine begins to rev up and the speed increases, the transmission will not automatically go into3rd gear. I have tried to let up on the gas pedal, but it remains stuck in 2nd gear. I have to shift to "Manual" and then put it in 3rd gear. Then it shifts up as it should. I have tried with the transmission in "TOW' and not in "TOW". I have even tried it in "Cruise Control".
View 3 Replies
