Ford Super Duty (1999-2016) :: TPMS Sensor Fault Warning - Orange Light Stays On
Aug 9, 2016
The warning in the title has been appearing for months. Push reset and the display message goes away but the orange light stays on. No rhyme or reason. Sometimes it's gone after a restart for a day or two. Sometimes it stays on no matter how many times the truck is shut down and restarted in a day.
So I finally took it into Ford for service today because the truck is still under warranty. They ask if the tires have been replaced. Obviously they have because I've got BFG KO2s that are a size or two bigger than stock. But I explained that the tires have been on for several months and that the issued did not present itself when the truck came out of the tire shop. It didn't happen until a couple of months later.
So they tell me that their tool can't even detect that any sensors are present and that they'll break down a tire to check and see that a sensor is there. Two & a half hours later they tell me that they've ordered a body control module and cut me loose with the truck. They'll call when the part is here.
View 14 Replies
Advertisement
driving my '06 f250 last night, i noticed a couple random dots and dashes of orange on the warning light cluster. upon shining a flashlight on it, realized it's the ABS light (or what's left of it). there's literally 2 tiny sections of it visibly lit up. Upon shutting the truck off, and just turning the key on, I noticed the whole middle row in the warning light cluster isn't illuminating with the key on. top row (turn signals, high beams, "wrench") and bottom row all seem to illuminate fine during start up and key on. I'm mainly nervous that the check engine light could turn on and i wouldn't know. is it possible that one row of the warning lights could go out? and only partially? seems strange....
[URL]....
View 2 Replies
I have a 2013 F250 and to day the TPMS light came on with a low tire warning message. A little back history, I put new tires on the truck when I bought it and they currently have 9200 miles on them. I didn't like having the tires at the 80psi the tire shop set them at so I lowered them to 62psi right away and haven't had any issues with the low pressure warning going off. Today I was backing into a parking spot and the warning light came on with a low tire message. I checked all the tires and they were right where they should be, but when I got home I added another 5psi to see what would happen and the light never went off after taking it on a 10 mile drive.
My question is, do I have a wheel sensor issue or is something messed up in the computer? I know the door sticker says 75psi front/80rear, but I've been running the tires at 62psi for 9200 miles without trouble so I can't think that the pressure is the culprit. Also, does the spare tire have a sensor in it? In the manual in one paragraph it seemed like it does, but in the next it said that the spare doesn't have one so the light will stay on to remind you to change the spare out.
View 10 Replies
Got a 'Tire Pressure Sensor Fault' message a few times on the way back from Florida. Tire pressures were all fine. Hate that it doesn't say which monitor has the problem. Anyway... it comes on, but after a few minutes goes back off. Saw it a total of three times over the course of 1,000 miles in two days. Is this the sensor failing and requiring replacement? Or is the system itself starting to fail? Would ESP cover this?
View 6 Replies
I recently picked up a 2005 f250 SD 5.4 4x4... I was having issues with sporadic shifting and wandering shifts while cruising around 100kph, scanned it and came up with p0721 OSS sensor circuit performance fault.
I checked the harness and all looks fine, now I attempted to remove the OSS at the rear of the tranny, got the 8mm bolt out however could not, for the life of me get the sensor out. I tried not to use pliers to twist the sensor or anything for fear of breaking the sensor off and having bits go into the transmission.
View 2 Replies
Just got a new-to-me 2006 F350 Super Duty XL with the 5.4L V8 and 5-speed auto. I haven't had a full-size truck in a few years and forgot what I was missing!
When I bought the truck, all gauges were inoperative except for the fuel and oil pressure gauges. The previous owner told me they would work intermittently and at some point just stopped. The usual warning lights - ABS, CEL, and "the wrench" - were all lit, and from Googling and searching this forum, it looked like an easy fix - probably a pinched or frayed shifter wire, or possibly a cluster repair.
I took it home and did a self test on the gauges. The "sweep gauges" made everything swing fine, so I was thinking it might not be a problem in the cluster. I pulled the steering column apart, removed the Tow/Haul overdrive wire from the plastic retainer, re-ran it with some slack, taped the end where it comes out of the shifter (even though I saw no breaks/frays) cleaned the connections, gave it a dollop of dielectric grease in the connector, and put it all back together. VOILA - GAUGES and no warning lights! You can imagine the touchdown dance in the driveway.
Fast forward a few weeks and....back to no gauges and warning lights lit. Figuring the overdrive wire had finally given up, I ordered and installed a replacement shifter figuring it was an easy and cheap fix. No joy - same problem. Tried cleaning and reseating the connection. Nothing. I've searched FTE like mad and it seems like 95% of the problems are with the wire exiting the shifter fraying and/or blowing a fuse, but this is a new shifter. I've also checked fuses #2, #24, #33, #36, #41, and #45 (some referenced #19 but I don't have a fuse there). All were unbroken - just put them back in and reseated firmly. I did a code pull via OBD2 and have a "rear catalytic efficiency degraded" code...not sure if that's related, but figured I just had an exhaust issue.
I may take the dash cover off and try to clean and reset the connections on the gauge cluster, as well as do the same for the PCM. Is it possible that the tow/haul overdrive wire to the PCM (where the shifter connects to) is bad? How to test and/or replace if it comes up bad?
View 14 Replies
Is there some sort of reset to turn off the Check Engine light? I had replaced the TPS sensor, and after a day the engine seems to have stopped the high idle and returned to normal, and now it still has the check engine with the same error code, but the problem seems to be resolved. My previous post: [URL] .....
View 14 Replies
The brake light stays on all the time. It started 5+ years ago going out intermittently, then began going out more frequently for longer as the years went by, until now, where it stays on continuously (except for one small miracle where it cam back on during a short drive around town). I don't normally care if it stays on, but for the first time in 7 years I'm going on a long road trip and can not engage cruise control with the light on.
View 9 Replies
2005 F250 4x4, manual locking hubs, ABS light stays on. Plugged it up, front sensors had a bad signal. Replaced both front sensors, still had light. Pulled out the sensors, cleaned the sensor rings the best we could with a little screwdriver. Installed the sensors, cleared the codes. Drove the truck a few miles, light came back on. Plugged it up, same codes. Removed the sensors and there was grease back on the sensor rings. Cleaned it up again, ran through the motions, drove it, light comes back on. Is there supposed to be grease on the sensor ring? It keeps coming back in every time it is driven. My next guess would be the hub bearings are going bad?
View 4 Replies
Im an outside sales rep and I drove 85k miles last year in a F-150. The time came where I needed a new company truck and now I'm in a 2015 F-250 2wd 6.2l lariat. I love the truck but my back is killing me. I've only had it a little over 3 weeks but it has over 6k miles on it. The majority of the time my bed is unloaded but there has been a few times my 1/2 ton was overloaded so i stepped up to a 3/4 ton. Ive tried lowering my tire pressure but the TPMS light comes on. I also bought sand bags to leave in the back of my truck to add weight to it when not loaded. Im about to pull the trigger on bilstein 5100s but was wondering of there is anything else I could do make the truck ride a little smoother.
View 14 Replies
I have a f250 super duty. I blew a brake line the main going to the rear. So the genius that I am I replaced the line an simple enough I decide hell why not replace the master cylinder too, so I did an I bleed the brakes an everything works jst fine but now the the brake light won't turn off I have tried everything not sure what could possibly cause the light to stay on. I will eliminate some suggestions, I bleed the brakes, the brake fluid is full, the level sensor is completely attached, the parking brake is not on, I pulled the parking brake completely out, even completely disconnected the sensor thinking it would turn off bu it didn't.
View 1 Replies
This is the third time my TMPS light and "Low Tire Pressure" message have popped on... I have checked all (4) tires and they are still exactly where I had them inflated several weeks back when I went through this the last time. What the threshold pressure is to set the TMPS warning off? I do run about 10psi lower than the door sticker because the door sticker pressure was too much and wearing the center of my rear tires... I just find it odd and frustrating that there are no problems for a period of time, and then all of a sudden I have to go through and over-inflate the tires for a few miles for the TPMS sensors to reset and clear the light, and then drop back down to where I need them for proper tire wear and it seems OK for weeks, and now here we go again
View 2 Replies
I recently installed takeoff 2017 factory 18" wheel/tire combo on my 2008 F250 to replace the 17" steelies. Didn't even know it had a TPMS system. Light never came on in 10 years of driving. After installing and airing up to 70psi, the TPMS warning light came on. Checked pressures, all good. I'm guessing that the new 18's have different sensors than the 2008 17's. 08 has the rim mounted green rectangular style. Don't know what the 2017's are as the tires were never taken off the rims. What do I have to do to get the new sensors to work?
View 8 Replies
So on my way to work this morning taking off from a light on a smooth blacktop my message center lit up with "tire pressure sensor fault". is there any way to tell which sensor it is without a scan tool?
View 11 Replies
All you need to do is pull out the head lite switch find the solid brown wire that is the running lights wire now find the yellow wire this is fog lights wire (these wires are on the gray plug ) you need a 3" piece of wire and 2 blue wire connectors it slips over the wires no cutting any wires then slide wire in the other end of the blue connector after you jump them your fog lights will come on with running lights and will not go off with high beams...
View 4 Replies
Had this issue for a while, but it doesn't seem to cause a problem. It's more of a curiosity than anything... Most of the time, the dome light operates as usual- close the door and the light stays on for a bit before shutting off. But about a quarter of the time, the light goes off immediately after the door is shut. It's done this the entire time I've owned the truck (about 2-1/2 years). Why?
View 1 Replies
Am I the only one who thinks the tire pressure monitoring system is a silly feature? Is there any way to delete this and stop the light from coming up on the dash? I want to do new wheels and tires on my 2008 f250 and I don't want to deal with the tpms. Can it be tuned out from the computer?
View 14 Replies
I bought a crew from a dealer, all the dome lights and cargo lights had the bulbs removed, so i put them back in and of coarse they all stayed on after you close the door, plus the door ajar light stays on when you are driving. I do notice the radio shuts off when you open the door after you turn off the ignition. Does that work on the same door switch, eliminating those?
Also are there switches on the rear doors also? Noticed that the radio isn't effected when you open a rear door. I tried to get the dealer to look at it a day after i took it home, a ford dealer at that, and they told me they tried to figure it out , and couldn't before they sold me the truck. Doesn't say much for their service department.
View 13 Replies
I have a 2003 Ford F-450 with the 7.3 Powerstroke. The problem I am having is the dome light stays on, the map lights will not turn on, I have no door ding with the key in the ignition, and the radio wont turn on. If I press the clock button on the radio the clock comes on but the radio will not come on when I press the power button. What it may be? I already hosed the door latches with lubricant and that changed nothing. I checked all the fuses they are good.
View 2 Replies
TPMS sensor has recently came in and stays on. However i checked all 4 tires and the pressures in them are at the appropriate values. I am assuming this could be related to maybe the system just not "seeing" one of the sensors or something. I heard if you use an OBD2 adapter you can see the values reported and it will show exactly what tire is reporting the problem.
View 13 Replies
I was running tire chains on my front end and broke the wires going to the wheel (I know ,not smart) . Immediately Service AdvanceTrac, Hill Descent fault, ABS light came on. I took it in to a shop and they repaired the wires but lights are still on and won't clear. Buttons on the dash wont work either. Messed up the sensors maybe?
View 1 Replies
