Ford Super Duty (1999-2016) :: Starter Does Not Crank - Only Relay Click When Turn The Key
Aug 17, 2014
I have an 02 F250 6.8 with 51,000 miles on it. I recently replaced the battery about a week ago, and only actually drove it yesterday for the first time since replacing the battery. I drove it about 25 miles, parked, and when I went to restart, it wouldn't. The starter doesn't crank, so I mean its not a cranking issue as in cranking, and not starting. It only clicks at the relay when turning the key. It acts like when you try to use a wrong chip coded key.
All of the dash lights came on, and I can hear the relay clicking, but that's it. I swapped the relays around, and no luck. If I let it sit a while, about an hour, it will fire right up. The battery cables are tight and free of corrosion. I am curious, since I just put in a new battery, could this be the culprit? Why will it start fine cold, but not hot? I have NEVER had an issue with this truck until now.
View 14 Replies
Advertisement
I have a 2001 for f250 with the electronic shift on the fly and when I turn the switch to put it in 4hi or low nothing happens I don't hear a click and the lights don't come on but the 4wd light works it comes on when I first start the truck and I put different relays in that we're good and still nothing I tested the the relay box itself for power and there wasn't any.
I used the truck last year for plowing and it worked sometimes it wouldn't go In or come out but after a few tries it would end up working but I've tried everything I could think of I'm starting to think it's something electrical because the relay box isn't getting power to it but idk if a vacuum leak would do that or a bad transfer case motor or iwe solenoid or if it's something more like a broken wire some where.
View 1 Replies
I have a 1999 f350 7.3. Turn the key lights and fuel pump come on but the starter wont crank. I replaced the starter and checked all the fuses i could find. The only way I can get the truck to crank is by jumping the relay under the hood.
View 9 Replies
Alright so I have a 99 7.3l. One day I went to start my truck and when I turn the key to the on position all is normal and then when I turn it all the way to crank it nothing happens. I hear a relay click ann thed that's it. Me and a buddy of mine spent quite some time on going through the entire truck. The starter was replaced, the neutral safety switch was replaced and the ignition switch was replaced yet the problem is still there. We then discovered that fuse #20 under the dash keeps blowing with every turn of the key. The manual states that this fuse is a starter motor relay coil PCM ( gasoline only). So if it's gas only why is it even in there. Let me just say that I can jump the fender mounted relay and the truck starts.
View 7 Replies
I have a 01 Ford excursion 7.3 auto and it will not start unless you jump the starter relay, I have replaced the starter, starter relay and swapped out batteries from my 2000 F250 auto, not sure what to do and this is my daily driver. Not sure if this matters but just had the transmission rebuilt. I have tried searching other threads but still not finding what I need. Once it starts it runs and drives. When you turn the key you hear a click like a relay is engaging and all of the lights and gauges work it just won't start with the key.
View 2 Replies
I just bought an 03 f250 5.4l . I'm just using it to plow my driveway this winter. The starter just clicks , after multiple attempts it will start. The previous owner said it's been like that for a long time but always starts.
I'd like to fix this now while it's warm out , before I buy a starter I'm wondering if I should look into other causes and how to trouble shoot the issue.
View 6 Replies
Its and 09, I can hear a relay click under the dash. It has gotten really hot since i bought it in sept to the point where I had to turn it off because I thought it was going to burn my bottom. I am guessing its not an easy fix.
View 4 Replies
I work for the transportation department at a school and we have a bunch of 6.0 f350/450 busses and this bus I am working on has a no crank condition. Bus in question is a 2006 F450 6.0.
Currently if you turn the key to start the engine the solenoid just clicks but the engine wont crank. The person working on it before me assumed that the batteries and or starter were bad so they were replaced(0 miles on them right now) but the problem still persists.
First thing I did when I started working on this bus was jumping the starter relay and the starter engages and starts the engine perfectly. That being said I know the starter wiring is fine.
Secondly I looked through the wiring diagrams and saw that the PCM grounds the 85 terminal on the starter relay so I tried grounding the 85 and I was able to crank the engine with the key so that was telling me that the actual starter relay is fine. Next I went and swapped the PCM with another 2006 f450 thinking maybe the grounding switch in the PCM was bad and I have the same no crank condition. The PCM from the bus in question was swapped to the doner bus and it cranked perfectly(PCM in question is fine).
Next thing I did was look up all of the ground locations for the PCM or anything to do with the starter and they were all cleaned and still have the same no crank.
Looking around on the internet I see that the viscous fan can cause a problem if it shorts out so I unplugged that and no change in the no crank. I also saw that the trans range sensor could cause a no crank condition but I am getting back up lights/beeper and the bus "wants" to crank so I am thinking that the TRS is not the problem.
Lastly I tried hooking my Modis scanner up to this bus and was NOT able to communicate with either of the PCM's I tried. Not sure if this is related to my no crank condition. I checked all of the wiring that I could but could not find any chafing or breaks in any of the OBDII wiring. My planned next step is to replace the TRS...
View 10 Replies
I have a 1999 f350 7.3. Turn the key lights and fuel pump come on but the starter wont crank. I replaced the starter and checked all the fuses i could find. The only way i can get the truck to crank is by jumping the relay under the hood .
View 5 Replies
2015 F350 6.2, 4 door 8' bed FX4...... 17,200 miles.
This morning when outside to start it (nice sunny morning) and turned the key and all the dash lights went on and also went crazy. Said it had all kind of problems on the dash, Trac system, Over heating and so on. The starter did not crank over at all. Tried this about 8 times in 45 minutes, no worky. Call Ford, they towed it to the dealer. I last drove it 2 days ago. All stock, no programmer.
View 12 Replies
Only got a click when turning key, in Park or Neutral. Made sure I had >12.4V from battery. Jumped starter solenoid with a remote start switch across main power line to starter and the 's' post, crank pulley almost moved, but didn't rotate. Removed belt, all pulleys rotate, but could not budge the crank pulley with a short breaker bar/socket, rotating clockwise from front. Removed starter, that upper bolt is a super pain! Not even sure I'll get it back in. Jumped starter solenoid again on the bench using a battery and jumpers, not the best connections, starter hesitated little bit, but opened up fully a few times, so I'm thinking it's ok (even though the power line from the solenoid to starter motor needs re-taping). Tried rotating flywheel from starter hole, no good leverage point, but no movement. Before I re-install the starter, how much torque should I be putting on the front crank pulley? Some say it should move easy enough cause the starter isn't that powerful. Others say remove the spark plugs to reduce compression? This truck is new to me, so I unfortunately have no history.
View 1 Replies
Got 01 F350, 7.3
Started having issues with starter bogging down my batteries. Slow crank, it would catch anyway and runs great. I have spare used starter in the garage, threw that on and it cranks fast, but occasionally just free spins half way thru the cranking.
My question is, can I make one good starter from these two? Monday AM buyer is coming to get my truck, and I don't want to have to buy brand new starter if I can avoid it, but I want him to have reliable used starter.
What causes free spinning (not flex plate related), and what causes power drag and slow crank? I was thinking throw solenoid from fast starter onto slow one, since slow one doesn't spin out but it bogs down my voltage?
View 1 Replies
I have a 2005 f-250 King Ranch 5.4 triton engine...my problem occurs when i turn the key to start the pickup....i get a clicking sound and then nothing....when i use a portable jump starter, it fires right up...on the other hand, when i try to jump from a running vehicle i only get a clicking sound from the starter...
not sure what i should be testing...also, when i bought the vehicle it had been sitting for several months...for my test drive, they used a commercial charger/starter to fire the truck...i drove it about 10 miles, stopped, turned off the motor and 10 minutes later it wouldn't start...when i contacted the owner, he drove to me and "reset" the kill switch under the fuse box in the cab and then jump started the truck...
I drove it 40 miles home and for 4 days had no starting issues...on day 5 forward, i have had to use the portable jump starter every time...my battery shows 13 amps resting and drops to 5 amps when i try to start without portable jump starter...when i start it with the portable jump starter, it only drops to 10 amps...
View 7 Replies
2002 F450 7.3 Turbo
Ok first problem : Starter Motor fuse kept blowing and I spent weeks trying to figure it out. No luck. so wired up a push button just to get the truck started, its a work truck so it was needed asap.
2nd problem : he truck stopped starting completely. Wont start in Park or neutral and after a NEW STARTER (because I thought the solenoid on the starter was bad I replaced it) Everything work correctly for one start with the key. After the second time trying to start it blew the starter fuse again. So I tried the straight wiring to starter. still nothing. I was wondering if there are any shims or anything at the transmission housing to correctly position the starter. I am thinking that maybe the gear is stuck or gets stuck sometimes. when I straight wire the starter it does nothing but the wire gets hot so I know its pulling.
View 3 Replies
My neighbors 02 250 6.8l the turn signal/hazard relay is clicking with key off, sounds exactly like a turn signal when truck is off and switches are not engaged. Here's the weird thing, if you hit the brakes the relay stops clicking, if you engage the turn signal or the hazards the lights on the dash are in time with the relay as it should be, but when the turn signal switch or hazards are turned off the relay keeps clicking except when you hit the brakes. Also the turn signal will work with ignition off, if you pull the relay out the turn signals and hazards are inoperable but the brake lights still work. I swapped in a new relay and same thing...
View 8 Replies
Starting about 4 months ago, when starting my truck, the starter would miss; I would turn the key to start, then the starter spins and spools up very high and loud but not crank the engine. I have to turn the key off to make it stop and then try again. Usually the second or third time it will grab and turn the engine and start. It happens about once a week or once every 10 or 12 times I start my truck with all the other times being normal. Doesn't matter if it's a cold start or already warmed up. It's a 2012, 6.7L F250 with 52,000 miles. What is causing it and how it can be fixed.
View 1 Replies
My 2000 F-250 V10 won't start has a new alternator and new starter all it does is Click when I turn the key?
View 14 Replies
Ok so my fire station has a 2003 f550 rescue truck with a rescue body with the round tail lights, we recently upgraded them to the LED ones that are much brighter but of course it flashes at the speed of sound. The question I have is:
1. the relay {flasher} is located on the driver side inner fender? I think....
2. does the same EP-27 relay/flasher fix the problem?
View 1 Replies
Recently got a 2003 f 250 6.0 that has had a little work done on it. Absolutely love it with 1 exception. When I turn on the ac or heat It blows a 10 amp fuse that goes to the blower relay. It was occasionally now it's all the time.Blower ok, fan speed resistor ok. What or where to look.
View 8 Replies
I own a 2004 F-250 Super Duty V10 truck. It's always ran and started great. I don't use it often so I make it a point to start and drive it around town twice a week. The other morning I went to start it and nothing. Engine will not turn over. Tried cranking with head lights on and they stay bright. It's an automatic and I tried going between park and neutral and still nothing. I can hear the little square relays in the fuse box clicking. Could the starter just have died? How are they to replace on these?
View 14 Replies
So I have a 2003 6.0L Powerstroke 1 ton. I just replaced the starter thinking the solenoid was the problem. But my luck it wasn't. I turn the key and the ding stops and it's quiet. Dash lights go off. I have the engine light and water in fuel light on. ABS is on I think aswell. I've run out of options.
View 1 Replies
