My 6.0 has been leaking oil for a couple weeks now possibly longer judging by the staining underneath. Very slow leak. 1 drop hits the ground when I get off work and go to get in the next morning. It never really reads off the dipstick a drop in the level. But I want to get it fixed. Ive attached pictures of where its coming from and was hoping to get pointed in the right direction.
View 3 RepliesIf I use ATP AT-205 stop leak to stop a slow leak coming from the rear main seal, will it last a long time? And if it stopped working eventually, would adding more stop the leak again?
Also, I'm going to have the transmission out anyway, so how many hours would it probably take to just replace the seal at that point? And someone told me some seals were two halves that fit together as one, and others are just all one piece. Is that true? It would seem to me that a two piece seal like that would start leaking prematurely.
My vehicle had a shudder which felt like driving over a rumble strip. It would usually occur after hitting a small bump at around 35 mph and hearing a clunk underneath. The shudder lasted just a few seconds. Checked the whole steering, suspension, chassis, drivetrain, u-joints, rear e-brake shoes etc. Finally found that the RF axle shaft could be moved up and down excessively in the steering knuckle. Removed axle shaft, R&R u-joint, vacuum hub seal and the torrington bearing in the hub. (used to call it a spindle bearing) ...
There was a little bit of wear into the stub shaft where the spindle bearing rides. That removed the play from the axle when it was all re-assembled. I was very happy until about a month later when it started doing it again, but not as bad as it was originally. I think maybe the stub end of the axle shaft needs to be replaced due to the wear in it. I don't want to just throw a somewhat expensive part at it without some info about "superduty shudder".
Our 2009 F-250 in our signature with 53,000 miles on it recently had a transmission episode that has me concerned. We were towing our fifth-wheel camper which weighs around 9000 lbs. We were nearly home on a 275 mile trip. All interstate at speeds of no more than 67 MPH. As I was in the process of exiting the interstate on the last 12 miles of our journey I noticed some smoke coming from underneath the truck. I immediately stopped and got under the truck and noticed transmission fluid running down from the top of the transmission and dripping onto the crossover exhaust pipe.
I let the truck idle for several minutes and it seemed to stop dripping fluid, or at least it had slowed considerably. I took off again being very careful not to gas it up at all, if fact I was very light footed with it from there on home. The ScanGauge II showed the transmission temp. had never got above 186 all the way home and it was at about 185 at the time I saw the smoke. The ambient temperature was around 90 and the truck had not labored at all on the way home. It would do the usual down shifting at overpasses but since I installed the 4.30 gears it doesn't do all that much shifting with the cruise control set on around 65-66 MPH.
I couldn't see where the oil was coming from but it was toward the top of the transmission. The transmission acted perfectly normal in every way even at the time of the dripping.
As I said, I took it plenty easy all the remaining 12 miles home and the tranny temp. dropped down to around 181. I parked the truck and camper on our asphalt driveway and saw no sign of drippage after it was parked. I fired the truck up the morning after this incident and drove it pulling the camper until the transmission temp. got to 185 and came home and parked it on the asphalt again and saw no signs of any leakage.
I checked the transmission fluid level per the instructions in the owners manual and it appeared to be right up to full. I don't believe it was over full. It smelled like it was new without a hint of any burnt odor. I bought the truck with 31,000 miles on it and had the dealer at which I purchased it change the transmission fluid at that time so it should be in very good condition.
I am going into a very busy time with this truck and can't chance any down time if it can be avoided. According to the research I did at the time I purchased this truck the automatic transmissions Ford used in the 2009 F-250 are pretty much bullet proof if maintained properly and not overly abused. This one has been well maintained and I've NEVER abused it. I wanted a manual trans. at the time I bought this unit but could not find one anywhere. I'm not a big slush-a-matic fan and I sincerely hope this one doesn't make me realize my long standing fear of slush-a-matic transmissions.
I have a 2003 F250 4wd with a 5.4 and 6 spd and 175,000 miles. Yesterday I came out to start it and noticed it had a ticking noise coming from underneath. According to the stock gauge it had normal oil pressure and the oil looked nice and clean and was full. I checked it while running and was able to verify that it is coming from the bottom oil pan/bell housing area. Before anybody says exhaust leak, I just put on JBA headers a few months ago and verified it wasn't an exhaust leak. I was assuming it was a rod bearing so I figured I would let it get to operating temp and see what happens. Once it started getting warm it started getting quiet and finally it just stopped once it hit full operating temp. Took it for a drive and found that it does it when in gear no matter what but stops when I put it in neutral and let out on the clutch. it makes the noise in neutral with clutch pushed in, but stops as soon as you let it out.
View 5 RepliesI have a 2004 f250 with a 5.4l and it won't start. I went to leave the store and went to start it and the truck started when I turned the ignition on not when I engaged the starter so I drove home anyway but there was what sounded like a spraying noise coming from underneath the truck all the way home the truck did die once on the way home but started right back up without me doing anything. Got home shut the truck off now it won't crank or anything all my lights and everything come on like normal just won't crank. What the problem is?
View 7 RepliesLast few months my 08 F250 has been slow going up hills. The fluid checks out ok and it shifts fine.
It just seems to take forever to get up hills. Has 124K....
Also has a huge hissing noise thats RPM dependent on the passenger side. Will make the sound in neutral just revving.
I have a 1999 F450 Diesel dump truck. Automatic. The problem that I have is that the truck will drive VERY SLOWLY while the rps go up.
You can hear the engine revving up, and a strong air sound when doing so (do not know if intake or exhaust, but its like a strong wind sound. And not like a hiss, so I do not think its a vacuum leak).
The transmission goes through gears fine, but it does the rev up thing through every gear. So I am wondering if something like the torque converter might be broken or slipping.
For example, if you go with the loaded truck up a hill, you have to really push it to keep any type of speed. Or when you get off a red light.
When I bought it used, I thought that it might have a really short final gear. But that would not explain the high RPM and no push.....
No codes at all.
I have an 08 f350 lariat with the 6.8 with 66000 miles. A month ago took it to the dealer with a plugged catilityc converter. All covered under warranty. Got the truck back, starts great when cold including 18 degrees the other morning. I drive 7 miles to work, shut it off and restart, it acts as if the starter is struggling to turn the engine over. Once it cools off, starts fine again. I took it back to dealer, they replaced the starter. No change. Took it back again, they replace battery. Cranks a little faster, but you can tell it's still struggling. It always starts, I'm just wondering how it will be when it's 80 out and in pulling my 9000lb camper....
View 14 RepliesIve had this 2009 F250 4x4 Super Crew, 6.4 for 2 years now. Bought it the way it sits with a 6" ProComp lift and 37" Yokohama Open Countrys. Recently, once I get up to 40-45 mph, the rear end starts vibrating violently until I speed up or slow down. There isn't any clanking noise and it's silent. I look in the mirrors to see if it's the tires but they appear to be rotating smoothly. It's never done this before. It's like a tire is out of balance but it shakes much harder than that should be at that speed. It rides smooth as can be at any other speed all the way up to 80 mph which is the faster than i drive. What this could be? I've done searches but can only find info on the front end death wobble which is not the case here.
View 4 Replies2006 F250 6.0L CC Lariat with Climate Control
- 1st Start in morning, AC Blows cold.
- Run it down the Interstate AC Blows cold.
- Get back into traffic, slow speed, low RPM, AC doesn't cool.
Is this likely the clutch going South or low Freon perhaps? At higher RPMs, 1000+ seems to work good. At idle, when hot, not so much. Just looking for possibilities.
I notice the gas nozzle clicks off all the time when I am filling my truck. Normally I just hold the nozzle up more and it seems to work.
F250. Slow fuel fill or fill nozzle keeps shutting off....
[URL] .....
Got 01 F350, 7.3
Started having issues with starter bogging down my batteries. Slow crank, it would catch anyway and runs great. I have spare used starter in the garage, threw that on and it cranks fast, but occasionally just free spins half way thru the cranking.
My question is, can I make one good starter from these two? Monday AM buyer is coming to get my truck, and I don't want to have to buy brand new starter if I can avoid it, but I want him to have reliable used starter.
What causes free spinning (not flex plate related), and what causes power drag and slow crank? I was thinking throw solenoid from fast starter onto slow one, since slow one doesn't spin out but it bogs down my voltage?
I have a 2006 F350 6.0L Diesel with about 72,000 miles on it. It has been the best truck ever, but just about two weeks ago it started doing something real strange. While driving, and it seems to only be at slow speeds, (idle or just accelerating), the truck will shut off the engine. And it is always in this order, it will first "pop" all the speakers real loud, then the radio will reset, (go to the AM radio and shuffle through my 6 disc changer) and then the engine will shut off.
Once I bring the truck to a stop and put it into park, it will then start back up with no problems at all. There is nothing I can seem to piece together as to when it will do it other then it seems to only be at slow speeds... Besides that, it is completely random. One day it did it four times, and then it didn't do it for the next few days at all... The only thing that has changed over last 2 weeks is that, the last few times that it has done it, it didn't kill the engine, it still popped the speakers like normal and then reset the radio, but didn't shut off the engine.
Since it has gotten cool outside my truck is back to not having any power or acceleration when cold. About 10 miles and it is fine. Also I got a code 2286 injection pressure high. Are these related? I cleared the code and it has not returned. The truck is completely stock.
View 7 Replies2011 250 CC FX4 LARIAT 6.7l Just had the oil changed on Friday and I noticed a couple oily spots in the driveway. Crawled under to investigate and there is a slow drip coming off the plastic oil plug. Called the service center and they said the seals on those plugs fail pretty regular. What was done to eliminate this issue?
View 9 RepliesYesterday went to fill up ($4.05 a gallon geezz!) and noticed that after getting back into the cab, the fuel gauge still showed almost empty. So after yelling a few expletives, I looked again and noticed the gauge starting to make it's way up the dial. It took almost 30 min. before it showed almost full. I'm not sure what the problem is, as the gauge seems to still function. I don't drive the truck much as I use it as a tow vehicle. However, I do try and take it for a spin about 3-4 times a month just to exercise it. I was wondering if the fuel has started to gel and that is the reason for the slow fuel gauge response. Should I add a fuel conditioner/cleaner now that I have a full tank?
View 9 Replies1999 F-350 7.3 Dually 2wd Front End issues. I think I may have several things going on so here goes. Truck has about 130,000 miles on it . Bought it with 60,000 miles in 2009.
It's always worn the front tires weird but it's gotten a lot worse and it's happening in about 10-15 thousand miles now. It's wearing the tires on both sidewalls like under-inflation but I run 70 lbs in them. I've noticed for several years now that it makes a knocking sound and I feel it in the floorboard, shakes in the steering wheel when I turn to the left only in a corner at speed. (65-70) ...
Now it's started intermittently going into the death wobble at slow speeds like the caster is to negative on it. I'm sure it could use some shocks but I just rotated the tires and I felt no play anywhere. I know when we used to get that bumping in the floor board on older Fords it was a bad radius arm bushing but that couldn't be all of what's going on here. I've done searches on this and it has happened to others but I haven't found a resolution from any yet.
I've got a 2008 5.4L I just bought. The previous owner just ran around the city and never pulled anything with it. After the truck has been pulling and the engine is hot, when I slow down to an idle the engine starts to diesel. This lasts for a few seconds then goes back to normal. Is this just because the engine isn't used to working and the computer hasn't adjusted yet? is this something that could be serious and I should have checked out by a garage?
View 4 Replies2006 F250, 6.0, AT, 59K. Week and a half ago, started cranking slow. I charged the batteries and checked with a professional load tester. Both batteries good, but voltage was fluctuating and tester said charging system needs service (no battery light). I swapped in a remand alternator as a new was not available that day. It lasted 6 days and this time the battery light was intermittent.
I checked voltage and again it was fluctuating. I swapped in another remand unit and 3 days later, same thing, intermittent battery light and fluctuating voltage. I'm installing a new, not remand unit tomorrow. However, could a bad FICM cause this problem? I noticed that the engine seems louder (not the exhaust note) at idle. This truck is clean and I have no corrosion issues. What is the right direction to test the FICM?
My dad has a 04 f250 5.4 auto. The motor turns over but very slow and will not start. He's put two new starters on. I went and looked at it and figured it was loose cables or corrosion, but it was fairly clean, and tight. We decided to pull the battery out of his van that he drives everyday, and I cleaned everything very good. Same thing. Pulled the belt to make sure nothing was lockup, same thing. Truck was running and starting great, then just did this one morning on him.
View 9 Replies