Ford Super Duty (1999-2016) :: Shift On Fly / 4X4 Not Working
Dec 10, 2013
2004 Excursion 6.0... What might be cause of my "shift on fly" 4x4 not working? No lights on dash, no mechanical noise, fuse appears Ok.
View 3 Replies2004 Excursion 6.0... What might be cause of my "shift on fly" 4x4 not working? No lights on dash, no mechanical noise, fuse appears Ok.
View 3 Replies2007 f250 4x4 shift on fly will not work. switch to 4x4 high light will not illuminate and it will not go into 4x4. i have tried in park, in neutral, rolling are stopped. both lights work when you turn ignition key to on.
View 12 RepliesI have a hard shift between 2-3 that is somewhat violent. It doesn't matter the rpms or how hard I'm accelerating, it will always do it. At wot, it sometimes throws a code that stays on for a few minutes, then goes away. When I hook up a code reader, it shows no record of it and it never throws a blinking OD light ever.
It has an ATS transmission, but I don't know how the controller works, if it is wired correctly, or if it could even cause this issue. Currently the truck has 210k and unknown on ATS.
So it appears as though my shift lever (automatic) will not shift into the 1st gear position? However when I drive the vehicle, the transmission seems to shift through 4 gears, then into Overdrive? What could be the issue?
View 3 RepliesI have a 2003 F350 Super Duty 6.0 L with the dash mounted 2H-4H-4L switch. I was using 4wd and the light went out by itself and now I cannot shift it out of 4wd. Fuse 31 has no power to it, and the drivers book says it is the fuse for 4x4. Where the power for that fuse comes from? There is no power to the switch as well, of course.
View 5 RepliesMy air conditioning on my 02 is having a issue, when you first start it and run the ac all is well and it cools perfect but then after a while it will quit working all together no more cold air, shut it off for a bit then it starts working again and repeats the process, charge is fine, been doing this all summer, it verys on how long it will work somethings for 5 minutes other times 40 minutes give or take, any thoughts?
View 2 RepliesMy 05 superduty is in the shop because it won't shift in or out of 4Hi. Ford garage says I need a new transfer case shift motor, and 4wheel drive module. They said the shift motor was full of oil. I am not really up to speed on how the shift motor works, other than it bolts externally to the transfer case, that's why it confuses me about the shift motor being saturated with oil. My truck has never leaked even a drop of any type oil, ever.
View 6 RepliesMy two oldest sons and I have a 1999 SD F250 4x4 with the V10 automatic. My boys burnt the trans. We had a spare that was pulled from the same year truck with the same motor. The boys installed it without me. Everything seems to work as it should, EXCEPT! 1-2 will not shift until 2800 rpm. 2-3 is the same. When I checked the install I found that the new trans has a speed input sensor on top of the housing behind the bell housing. It is Not plugged in, my harness does not have that plug. Old trans does not have that sensor. Is this the cause of the high rpm shifting?
View 14 RepliesWhen I shift into 4Lo I get no 4 wheel drive. 4Hi works. Did have a/c redirect to defrost a couple of times. I remember something about the air redirecting having something to do with not having 4x4 but don't know just what it was.
View 8 Replies99 v10 auto 4x4. Won't go into park completely. Have to start in neutral. was fine yesterday, now it doesn't work. if it wasn't snowing like crazy id just crawl around and find out. do our trucks have a linkage? or shift cable? I imagine I am just out of adjustment somewhere. any advice what to look for or where to start when the snow finally stops??
View 3 RepliesI was taking my boat out of the lake last night. Shifted T-box into 4Low and removed the boat. I then tied everything up and when to shift back into 2Hi and it wont. I have a 2001 F350 diesel w/ automatic and the auto locking hubs.Hubs are not engaged atm. I have never had this issue before and was wondering if a shift solinoid is stuck or something might be wrong with my Transfer case??
View 14 RepliesFriend parked his well working truck and when starting it up after sitting a few days it won't shift into any gear. Lever moves as normal but the truck won't move. A soft clicking sound is the only difference to be noticed when shifting the lever. where to start? Temps are below freezing here if that matters.
View 11 RepliesTroubleshooting a problem with friend's 2000 F250. His power windows aren't working and are causing problems with his door locks and interior lights. When he tries to use his drivers side power window, his power door locks quit working. If he puts the switch to raise, the interior lights flash. From what I've read, it sounds like the GEM to me, we've inspected the wiring and it all looks good. I pulled it out today and it looks good inside, no sign of water leaks on it. If it is the gem, how much do they cost and do they require programming?
View 5 Replies2004 Ford F250 CC 4x4 6.0L
Took the family down to the beach today. Had some tough sand to get across in a few areas to move away from the crowds. Got a little dicey and the truck got stuck in 2WD. Switched to 4WD but back tires kept spinning. Couldn't figure out why and the truck started to dig deeper in the sand. Got a little nervous and I didn't want to start the day off with having to get pulled out.
Got out of the truck, locked the hubs in manually and I was out, no problem. Left the hubs locked until we left the beach and back on pavement.
What might be the problem and why the "shift on the fly" switch on the dash didn't seem to engage the 4WD? I even tried to switch into 4L and back to 4H (truck in neutral, break pedal compressed) and still no workie. Only manually locking the hubs would engage the 4WD.
2006 350 here. I was wondering if it would be possible to replace my Automatic tranny shift lever with one from a newer truck (08+). If possible, what exactly would need to be replaced?
View 1 RepliesI have a 2000 F350, Turbo diesel with 223 000 miles. 6 speed manual transmission will not shift into reverse or low.
View 14 RepliesSo when I try to kick into 'passing gear' in this '01 f250 5.4l, i get no tranny shift. Whether I'm in tow/haul mode or not.
View 10 RepliesI have a 2003 super duty crew cab 4x4 with V-10 auto w/167k. Awsome truck. I recently have noticed alot of slop in the shift lever on the column. Everything is tight on the tranny end. It appears to be under the dash. Is there a part that may be replacible? And if so... is it fairly simple to repair?
View 14 RepliesThe other day I was driving i was driving down the road when suddenly my truck wouldn't shift out of first gear, then the truck died and the motor wont turn over either. Acts like it is locked up. Its an 01 with v10 and 4r100.
View 6 RepliesI finally got around to installing a transmission temp sensor in our '06 F250, and I have noticed today that it seems to be at 180 degrees regularly driving around town unloaded. It has been around 80-85 degrees outside today. We just got this truck about a month ago, so I'm still getting used to its little quirks. On our old 7.3 with a 4R100, it wasn't at all unusual to see 180 on a day like today around town. Is this normal on a TorqShift?
View 13 RepliesI have a 02 F350 V10 4x4. Tonight I went out to go to a friends house and the truck started fine but when I push in the brake it will not release the lock on the shifter. You can hear a click noise when you push in the brake pedal.
View 14 Replies