2008 F-450 Crewcab .... The seatbelts in the back seat keep tightening up when driving. They cant be working right which makes them dangerous. Had the grandson turning red they were holding him in so tight and every bump they tighten a little more? Any way to set them up or anything?
View 4 RepliesI know it uses the ignition key, but after that? 2016 F-250 Crew Cab.
View 1 RepliesI've got a 2014 f250 xl super cab and can't for the life of me figure out how to remove the back seat back.
View 2 RepliesI picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 RepliesI have a 2016 F250 6.2 XLT CC 4X4 that is mostly stock, except I did put on 18x9 wheels and LT275/70/18 Cooper ST MAXX tires. I have noticed recently on hwy driving and even in town driving, that the passenger seat rattles/vibrates quite loudly. Obviously if there is someone setting in the seat, it is just fine.
Is this a common issue? Is there a quick fix (tightening a couple bolts or replacing a couple clips?) Or should I take this back to the dealer for warranty?
My heated seat that quit. Pass side heated seat on my 07 went out. The light on the button stays on, where do I start diagnosing to figure out if it is the back or bottom that went out?
View 4 RepliesMy "new" truck has a sluggish seatbelt on the driver's side. It won't retract all the way.
How do I get to the mechanism to have a look at it or put in a replacement?
The belt on this one comes out of the top of the seat, not from against the door.
The top mounting point on my seatbelt is squeaking like crazy. The guide for the seat belt is rubbing on the piece it bolts to because the plastic tabs on the plastic cover have worn out. Where to get a new one of these? Its just the plastic triangle shaped cover that goes over the seatbelt mount.
View 1 RepliesJust bought my first 04 F250 super duty Xl...4x4 Ext Cab...need to get this bench seat out and buckets and console in!!! I hear this is easy swap but never done before, or believe anything is easy.
View 1 RepliesSee my sig for truck.
I have 3 kids in the crewcab. 2 are in booster seats, and 1 still riding in a Britax. The 2 in booster seats can buckle their own seat belts in the wife's Odyssey. But they cannot buckle their own in the truck because as they try to push the 2 pieces together, the short 'female' end slides down between the seat and seatback. So I have to buckle them. Every time.
Anything to prevent the female end from sliding down? I'm thinking maybe putting a ~4" long 1-2" diameter piece of tubing around the belts. Something like that.
I was told that I have to disconnect both batteries if I want to remove my seats by a car-stereo place. Is this true? They said it was because of the air bag sensors.
Gotta remove the center seat to get an amp out from under there and to do that, you have to remove or at least loosen both front seats.
Is there a way to do this without disconnecting both batteries?
I cant get my rear seat back to fold down anymore. I was on some very rough roads over the weekend and when I went to fold the seat back down the handle doesnt move. Is there a way to fold it without? Its almost like something is jammed which may be from the pounding the truck took over those roads.
View 3 RepliesI am upgrading an F150 w/ pass-through console to an F250 w/ jump seats. Have not gone to see the truck in person and am wondering where the rear air vents are located?
Reason being I have two very large dogs that own the back seat. It's basically a large dog bed. The console vents are fantastic, keeps them cool back there. I can't figure out where the vents are in a jump-seat configuration.
Truck is 08 f350 lariat with minor issues. Both seat heaters don't get hot. Click is heard under driver seat. Both dash lights come on. No heat. Steering wheel fan control won't turn fan up. Turns it down fine.
PO put aftermarket HID with ballasts and bulbs and factory light housings. Factory housings scatter light and they are waaayyy bright. Can't drive anywhere with out blinding someone. What aftermarket projectors will work with HID set up I already have?
We have a 2013 F150 Lariat. When you raise the rear seat bottoms the entire floor board opens into a really large nice flat space. By removing the storage tub from my 2015 SD Lariat will that provide the same results as the F150 ?
View 5 RepliesSo, I bought a set of seat covers yesterday and I'm trying to install them this morning. Surprise, surprise!! The head rests won't come out. I tried pushing the little button and pulling up hard, No good. I look for a little clip or some other retaining device. Nothing. How do I get the front head rests out?
View 5 RepliesI would like to remove the tray located under the rear sit. I don't want anything installed back in place of it.I want the open space when the rear seats are folded up. I have two large dogs and they hate the tray. Will the rear sit ride okay if i remove the tray or will it loose some support?
View 8 RepliesWhat is the part # for this bottom for an 05' F250 supercab?
I swapped these seats into my OBS truck, but the driver's seat bottom has the typical wear/tear on it and its getting worse.
I have been searching for three days for a replacement bottom cover. I have found them for F150s and the pattern is close but not right. I cannot find them for F250s or F350s as I cannot find the proper part # for the gray DS cover.
This is the tan one: 4c3z-2562900-eaa
How can I pull this up?
How to disable the belt minder chime on a 2015 SD? I tried unplugging the harness under the seat, but it turns on the airbag light. No instructions in the owner's manual like there was for my 2005.
View 8 RepliesOn a 2003 Ford Superduty, 4x4, 5.4, supercab; where is the fuse for the power seat?
View 11 RepliesI have a 2005 f250 that has a wander and a clunk what feels like under the drivers seat. The driver side bushing in the radius arm has no dirt and looks like wear on it compared to the passenger side which is completely covered in dirt. My question is, bushing wear out will cause wander and a clunk. Is it hard to replace?
View 3 Replies