My "new" truck has a sluggish seatbelt on the driver's side. It won't retract all the way.
How do I get to the mechanism to have a look at it or put in a replacement?
The belt on this one comes out of the top of the seat, not from against the door.
The top mounting point on my seatbelt is squeaking like crazy. The guide for the seat belt is rubbing on the piece it bolts to because the plastic tabs on the plastic cover have worn out. Where to get a new one of these? Its just the plastic triangle shaped cover that goes over the seatbelt mount.
View 1 RepliesHow to disable the belt minder chime on a 2015 SD? I tried unplugging the harness under the seat, but it turns on the airbag light. No instructions in the owner's manual like there was for my 2005.
View 8 RepliesDoor chime /seat belt or key chime comes on random and frequently while driving. With seat belt attached. Bushings in shift handle are worn out. Could this be the culprit? I'd kind of prefer to fix the problem before I disconnect the chime...
View 1 RepliesI have a 2005 F250 King Ranch 4X4 Diesel and now experiencing an issue with the front seat belts
The problem is while being worn sometimes they will not let you lean forward- they act like you have a foot on the brake pedal and are locked-you have to lean back and forth several times to get them to let out if reaching for something on the dash etc..
I have searched the forum and found many issues where the seat belts stopped retracting- but my issue seems to be unique in that the seat belt will at times 'Not Let Out" when you lean forward.
2001 F250. My drivers side seat belt buckle randomly releases and it's getting worse. Any sources on a new one or used even. Also, what other vehicles may have the same part number if I go used.
View 10 RepliesWhat is the part # for this bottom for an 05' F250 supercab?
I swapped these seats into my OBS truck, but the driver's seat bottom has the typical wear/tear on it and its getting worse.
I have been searching for three days for a replacement bottom cover. I have found them for F150s and the pattern is close but not right. I cannot find them for F250s or F350s as I cannot find the proper part # for the gray DS cover.
This is the tan one: 4c3z-2562900-eaa
How can I pull this up?
I need an expert. 2007 Ford F-350 King Ranch and tonight, the wife and I were coming home from friends house and I tried to buckle my seat belt. The receiver would not click and hold the seat belt. Cannot find the replacement. What should I do?
View 13 RepliesMy Dad has a 2006 F550 Lariat with the grey leather seats, and the drivers seat is starting to fall apart. So my Dad is wanting to replace it. My Dad thinks its from a lot of sliding in and out, and having all kinds of dirt and other stuff on it. It has a big spot torn in the lower left of it and then the armrest is starting to rip as well.
So I was wondering where a good place to get some replacement seats for it was. Definitely leather and grey to match the rear seats since its a crew cab. I don't think it necessarily has to be stock, but something that looks good and still at least somewhat matches the rear and rest of the interior.
Here's some pictures of the seat. Nice hole in the floor mat too. I think some nice plastic ones would work and look much better.
2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
I have a 2016 F250 6.2 XLT CC 4X4 that is mostly stock, except I did put on 18x9 wheels and LT275/70/18 Cooper ST MAXX tires. I have noticed recently on hwy driving and even in town driving, that the passenger seat rattles/vibrates quite loudly. Obviously if there is someone setting in the seat, it is just fine.
Is this a common issue? Is there a quick fix (tightening a couple bolts or replacing a couple clips?) Or should I take this back to the dealer for warranty?
My heated seat that quit. Pass side heated seat on my 07 went out. The light on the button stays on, where do I start diagnosing to figure out if it is the back or bottom that went out?
View 4 RepliesAny downside to using a nut that covers the entire stud on my '99 450?
View 2 RepliesAfter 225,000 miles, my turbo appears to have failed -- not spinning. This is a stock turbo that is unaltered. Yes, I change my oil and filter every 3000 miles.
My question is; what is a reliable after-market replacement part that will bolt up?
Just bought my first 04 F250 super duty Xl...4x4 Ext Cab...need to get this bench seat out and buckets and console in!!! I hear this is easy swap but never done before, or believe anything is easy.
View 1 RepliesI know it uses the ignition key, but after that? 2016 F-250 Crew Cab.
View 1 RepliesSee my sig for truck.
I have 3 kids in the crewcab. 2 are in booster seats, and 1 still riding in a Britax. The 2 in booster seats can buckle their own seat belts in the wife's Odyssey. But they cannot buckle their own in the truck because as they try to push the 2 pieces together, the short 'female' end slides down between the seat and seatback. So I have to buckle them. Every time.
Anything to prevent the female end from sliding down? I'm thinking maybe putting a ~4" long 1-2" diameter piece of tubing around the belts. Something like that.
I was told that I have to disconnect both batteries if I want to remove my seats by a car-stereo place. Is this true? They said it was because of the air bag sensors.
Gotta remove the center seat to get an amp out from under there and to do that, you have to remove or at least loosen both front seats.
Is there a way to do this without disconnecting both batteries?
I cant get my rear seat back to fold down anymore. I was on some very rough roads over the weekend and when I went to fold the seat back down the handle doesnt move. Is there a way to fold it without? Its almost like something is jammed which may be from the pounding the truck took over those roads.
View 3 RepliesI am upgrading an F150 w/ pass-through console to an F250 w/ jump seats. Have not gone to see the truck in person and am wondering where the rear air vents are located?
Reason being I have two very large dogs that own the back seat. It's basically a large dog bed. The console vents are fantastic, keeps them cool back there. I can't figure out where the vents are in a jump-seat configuration.
Truck is 08 f350 lariat with minor issues. Both seat heaters don't get hot. Click is heard under driver seat. Both dash lights come on. No heat. Steering wheel fan control won't turn fan up. Turns it down fine.
PO put aftermarket HID with ballasts and bulbs and factory light housings. Factory housings scatter light and they are waaayyy bright. Can't drive anywhere with out blinding someone. What aftermarket projectors will work with HID set up I already have?