After 225,000 miles, my turbo appears to have failed -- not spinning. This is a stock turbo that is unaltered. Yes, I change my oil and filter every 3000 miles.
My question is; what is a reliable after-market replacement part that will bolt up?
I have a 2002 f-250 7.3 diesel, i straight piped it but only by cutting muffler off and welding a piece of pipe in its place, it is pretty loud but id like to hear the turbo more like more of a whistle, it has a pretty good whistle once i get past 1500 rpm, is there a slightly bigger turbo i could put on without putting too much strain on the 180,000 mile engine?
View 6 RepliesI have a 2006 6.0, edge programmer, and egr delete. I had the hpop replaced back in July. I have a straight piped exhaust system as well. I have always noticed a loud whistle at idle from the turbo but yesterday when I started it there was not whistle at all. When I drove it it would still build boost but not like it used to. I have to really get on the throttle to build boost like it should. Is it my turbo going bad?
View 2 RepliesI have a 2003 6.0l did a rebuild on it. Got it all back together runs ok, but the turbo is making noise. I can unplug the actuator and the noise stops. How can I check the actuator. now the noise is of course when it is running.. but unplugged the noise stops.
View 2 RepliesA friend has a 2000 Super Duty 7.3L Diesel Power Stroke. 300,000 miles and having an oil leak around top of engine near turbo. It's losing oil at a rate of half a quart every two days. Driver says that engine lacks power. Is it time to replace turbo? What else should I look for concerning the oil leak. Also, what else should be replaced/inspected while replacing turbo?
View 2 RepliesGot a 2006 6.0 won't build turbo pressure had to previous codes a p0098 and a p0405 I replaced the egr valve and the mafs codes went away but still no boost
View 9 RepliesWhy am I getting oil seeping out around these boots? Is my turbo seals going bad?
View 3 RepliesJust bought a 1999 7.3 f250 w/71000 miles and took it to a diesel guy and under load he said that the whistling was normal..is this correct?
View 3 RepliesI have a 2005 6.0 with 279k running pretty strong. I met a mechanic that has the same year truck with 700K!! He showed me one of his mods and he used a longer line on his windshield wiper fluid and put a Tee Connector on the line and ran it into his intake for the turbo. He said he will use it when cruising along sparingly but it cleans his turbo and such. Is this a water injection hack?
View 6 RepliesI have a 2000 f250 7.3 powerstroke. I bought the truck with 218000 miles on it, I have only put 1000 on it. I have had some issues with. The cps went out of it, and it wouldn't start until u replaced it. I have a Ts chip on it and cold air intake. It will not start after a cold night, it starts fine if I plug it in. It also lopes, or misses no matter the temperature outside. Also, it will blow a steady flame when you get on it. Finally, it also gets hot, smoke will come from the turbo after driving it for a while, no matter how you drive it.
View 2 Replies6.7 Boost ... Under full acceleration does the turbo go to 40 PSI or stay in the middle at 20?
View 4 RepliesJust bought a watchdog monitor by Bullydog. What are the normal levels for Boost, MAF, Load for a SD Twin Turbo 6.0L?
View 7 RepliesI have been smelling raw exhaust in the cab, especially when the weather is colder and when standing still.
I took it to the dealer and in the process of fixing minor coolant and oil leaks on the turbo, they located a small exhaust leak with visible soot on the back side of the turbo.
They tell me that there is no way to repair it and that only Ford can rebuild or repair these turbos.
2011 SD 6.7
Bought a 08 F350 with the 6.4 Liter, with 80k mikes on it. Was traveling up an incline. Both Turbo's were engaged, when suddenly I lost boost, and PSI dropped all the way down. They barely create any pressure now. Checked intake, also checked boots too inter cooler. All seem fine. After driving it for about five minutes at low PSI, a check engine light came on. It was a sudden loss of power.
View 13 RepliesI recently pulled the stock tp38 off. The reason for rebuilding is the turbo started making an awful screeching on start up and shutdown when the compressor is at a low rpm and starts to wobble.
The shaft has 1/2 in and out play with 1/8 in every direction. the compressor has some wear marks but no chips, the turbine has some good chunks missing. from what i can see there are no marks on the housings.
What should i put in it as far as new compressor and turbine/shaft. nothing that requires machining. I am not looking to run more boost or anything, just looking to reduce spool up time if possible. Any specific rebuild kit? what turbine and compressor should I go with?
I have an exhaust leak between the manifold and turbo ( in the flex part of the pipe) on my 2008 6.4 f250 would this create rough idle when at operating temp?
View 2 Replies2006 F350 6.0l dually. Head gasket replaced, racing studs installed, other assoc components replaced few years ago. Y pipes replaced two years ago.
3 weeks ago had oil change and service. Last week engine started making roaring sound. Hubby raised hoid and discovered coolant fill tank cap off ( sitting on battery). Shop owner came to our home and filled with coolant, about 3 gal in. We drive from Houston to Lubbock then Dallas this week. Added about another gal coolant.
Hubby thought he heard an air sound yesterday, but was slight. Today after driving for about an hour at hwy speed, after we slowed for an exit, when throttle depressed again, air noise very loud and turbo weak. Limping home.
Have had some of the flexible hoses replaced in the last year or so as well.
Did I just blow up my turbo or what? I'm kinda new to diesels, I just purchaced a 2005 F-250. Today I was pulling my rv out of Devils Den State Park in Arkansas, beautiful place. There is a steep grade coming out, my truck was seeming to be having a kind of hard time, then a loud PFFTTTT sound. That is the best I can do for writing sounds. It sounded like a compressed gas cylinder blowing up! The pulling power went to nothing and the turbo gauge went to 0. It sounded fine at idle, other gauges were fine. I'm guessing my turbo is DEAD, what say you?
View 4 Replies2003 6.0 F350... Under full throttle from take off goes about 20 mph just revs at 2500 let off the throttle in feather it shifts and acts like it wants to go just not allot of power sometimes. In neutral won't rev past 2700 rpms I do hear a screech from the turbo on acceleration and declaration. Also if in tow haul the truck won't shift at all. I can get it up to speed but even the smallest incline drops to 50 mph then takes bout 2 miles to get it back up to 65 mph or if I go downhill.... turbo makes the noise the whole time sometimes goes into passing gear in have to let off in it kinda my the truck hop in this is at 60 +mph. Only thing I have really tired was fuel filters and checked at plugs and boots.
View 1 RepliesAfter finding that a battery was low and not getting charge, they found the alternator was bad. Replaced that. Next the battery that was low was able to be charged and did not effect the other battery. Both batteries have been load and charge tested and they both read 84% charged. I am told this is "good."
Next I swapped both fuel filters and did the oil change as well. I finally got a chance to get my friend to run his scanner on it. The results are injectors and FICM. The codes are PO261, 264, 267, 270, 273, 276, 279, 282, and finally 611. I guess this means that the FICM is toast.
I have tried salvage and no one has anything. I guess I still don't understand how this truck is capable of running daily with the computer throwing every code dealing with the injectors and the computer that runs them.
This is and 6.0L 04 135000 miles. I was pulling a load up a hill when the turbo back fired this was no fart hose blew off at bottom of rad, hose clamp was gone. I reattached hose but now I have lost some power and getting poor fuel mileage. I think turbo is making a howling noise at higher rpms I pressure tested the system does not seem to be any leaks, I'm assuming there something wrong with the turbo, but is it possible the hose clamp was sucked into the rad?
View 2 Replies