Ford Super Duty (1999-2016) :: Rear Fender Flares Removal?
Aug 25, 2014
I want to get the rear fender flares on my dually painted, they had a few scuffs when I bought it & I will soon have some spare time to get it sorted. We can't get the truck in the paint booth so taking them off seems like the ideal solution. I have had a quick look & I think it's just a case of removing the plastic liner (screws & clips) then it looks like there are some nuts up inside the steel fender, disconnect the wiring & they should come off!
View 2 Replies
Advertisement
Where I can locate rear fender flares that will match 2011 and up f450 flares? Which flares would cover the f450 front fender flares holes?
View 3 Replies
I own an '03 F250 and have had it since new. I love the truck, keep it in good condition, and plan on keeping it for at least a few more years. For some time now I've had the classic small spots on one rear fender well. The spots are getting a little bigger and look like they're going to come through soon. I'm not a big fan of fender flares, but from what I understand, that's the easiest way to fix the problem, cut the rust out/seal it, install fender flares. Is there any other way to fix the rust without repainting the whole bed? I don't like fender flares because I think they look a little weird with stock tires and also because it's only one fender that is rusting, but I'd have to install them on all four. If fender flares are the only way to go, any that are small and low profile?
View 14 Replies
I have a 2000 F-350 Dually. One of the rear fender lights is not working. Is there a way to check the bulb without pulling the inner liner to access it?
View 5 Replies
I have a 2016 F350 super cab and I can't figure out how to remove the rear head rest. Short of taking out my sawsall and cutting them off. How to get them off...
View 12 Replies
I have a 2011 F350 with camper package (didn't want it). When I drive on a bumpy road (without 5th wheel), the truck suspension does not absorb the shock. The ruts just throws the truck side to side. Really hard, so I can't go on a dirt, rough road. On one bump it poped off my rear tire cap.
My problem may be with the camper package trying to keep the truck from going back and forth.
There is a 7/16 inch steal rod going from the truck bed, around the differential, and back up to the other side of the truck. Is that the rear stablizer rod?? Can I disconnect it? What would be
View 13 Replies
I want to know if there are any issues when removing the rear block, also do I have to put a new block in or can I just leave it out ....
View 12 Replies
I went to get my front window tinted and the place didn't have the "tool" to remove the rear view mirror and they did not want to get very aggressive with the mallet in fear of breaking the windshield. Has anyone bene able to get any of the "home methods" to work? I contacted a couple of local auto window repair places and they said they wouldn't do it because the windshield "ALWAYS" breaks.
View 7 Replies
I would like information how to remove the rear seat back on a 2012 F250. I want to remove the head rests and from what I can find out they are bolted solid to the rear panel. I asked the same question earlier and got a reply for 2011, would that be the same? Is there any place I could get a schematic, a picture is worth a thousand words.
View 5 Replies
I've got a 2014 f250 xl super cab and can't for the life of me figure out how to remove the back seat back.
View 2 Replies
I had a bad starter solenoid on the fender in my truck I swapped it out and then my starter went so I swapped it now it is not disengaging the starter If I turn the key to the run position it starts cranking and fires right up before I an let the glow plugs cycle or anything and it won't disengage the starter I turn off the truck and the starter is spinning loud for a couple seconds till it stops no matter if it just start the truck or start it and run it for a couple minutes then shut it off. 99 7.3L ....
View 6 Replies
I have a 2004 F250 Lariat Crew Cab FX4 6-3/4' bed.
What is the procedure to remove the Driver's side Rear Sway Bar Link upper bolt? - the link attaches to the frame. The nut is on the inside of the frame with about 1/3" to 2/3" clearance between the frame and the fuel tank. Of course, the frame's "C" shape faces towards the inside.
View 1 Replies
I recently had need of replacing my left exhaust manifold on a 2000 F250 4 x 4. I removed plastic inner fender well. Now I have a two pin harness with both white wires. One is white with red stripe, the other is white with black stripe. The harness is round with a locking square on one side. The harness is located about 10" from bottom of inner left plastic fender panel. It has 2 mounting pegs. Where the heck does this connect?
View 13 Replies
Have a problem When i make a slight turn to the left sounds like the tire is rubbing the inner fender. Don't do it all the time. The tire is not rubbing.
View 4 Replies
Not sure if this has been asked/done before but would the 2014 R Like fender flares fit onto my 2012 SE? I have the opportunity to buy the flares off of the 2014 but I wanted to make sure they fit without modification.
View 4 Replies
I picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 Replies
I want to remove the 4x4 stickers on my 2014 SD box. I think it looks cleaner without them. Are they difficult to remove or does the hair dryer trick and then some Goo-Gone do the trick without a big time effort? The last thing I want to do is make a mess of the paint finish.
View 13 Replies
Looking to get rid of the step handle, I did this mod on mine and it was a direct fit...take off old liner and unbolt handle, then get a liner from a non-step tailgate and it is a direct fit:
View 7 Replies
OK, so I ordered in the new lines and have them. BUT my problem is snaking the factory transmission line out from under the truck. I have pictures to show my struggles.
How do I pull this:
Out of here???
Towards the front of the motor
Front passenger side cab corner
Replacing these lines? I don't care about breaking the old one, but I still need to find a way to install the new one.
View 11 Replies
I am wanting to take off the center console lid to recover it. The only way I see to remove just the lid from the truck is to hit the rod out that is in the hinge. I was hitting pretty hard with a punch and it wasn't moving. I don't really want to break it so I'm asking if there is a different way or if I just need to use more force?!
View 4 Replies
Is it necessary to remove say about one and one half cups of oil from the HPOP reservoir when changing oil? I say not needed.
View 3 Replies