My truck is acting up. Last night when I was parallel parking I noticed the RPM was jumping, I then noticed the OverDrive switch was blinking. I turned off and turned it back on and the issue went away. This morning on my way to work, it did exactly the same and it automatically corrected itself. The overDrive ON/OFF light keeps blinking.
My truck : 7.3 Diesel, Auto trans, 86 K Miles, Super Chip.
I just recently got handed a 2005 ford f250 6.0 PSD from my older brother, new to the whole diesel game, well all of a sudden as i was driving down the road about 65 mph, trucks RPMS shoot to about 4K and tow haul light starts blinking as i start pulling over (still in drive of course) i realize i can't move anymore the trucks rpm just rev. In all gears it does not move i moved 1-3 D and R and nothing truck just revs. i had my father get under the truck as i shift from gear to gear and the linkage is moving back and forth on the transmission as i put it in reverse the reverse lights still pop on, I'm new to the diesel game...
View 9 RepliesThe problems that I am having at the moment are that the abs light is on from the speedometer, odometer, also the blinking overdrive light that comes on at around 25 mph. After some research I had purchased a ford factory sensor for the rear dif. I then replaced the old sensor with the factory one. Started the truck and not a single thing had changed, both the meters were not working as well as the od light was still flashing.
View 4 RepliesTruck : 2000 F250 XLT A/T 6.8L v10 4x4
Issue : O/D off light is flashing on the shift lever. In a drive gear (R, OD, D2, D1) there is very low power when giving it gas, more so from a stop. In P and N, I can rev the motor with no obvious issues. In O/D, I can't even get forward momentum going from a stop when on a slight incline. When on flat ground and in O/D, flooring the gas only gets me going a few MPH and RPMs don't go above 1500ish. When selecting 1st or 2nd, the truck still struggles a bit from a stop but does get up and going.
What happened leading up to the issue : I was on the freeway driving about 80MPH without cruise control se,t and with O/D on as usual, when the blinking O/D off light caught my attention. Not knowing at the time that this was a transmission problem light, I started pushing and holding on the O/D on/off button to try and get it to stop. Probably about a minute later, I realized I was losing speed even when giving more throttle so pulled over to the shoulder. I shut the truck off and restarted it, noted the Service Engine Soon light was now on, then I put it in O/D and gave it gas but only got going a couple MPH which it sounds like the engine was choking/struggling. I then tried D1 and D2 and, while still struggling a bit from stop, was able to accelerate up to 35+ MPH.
OBDII Codes:
P0743
Torque Converter
Clutch Solenoid
Circuit Electrical
P0750
Shift Solenoid A
P0755
Shift Solenoid B
P1747
Pressure Control
Solenoid A Short Circuit
P0443
EvaPorative Emission
System Purge Control
Valve Circuit
P0135
O2 Heater Circuit
(Bank 1. Sensor 1)
P0155
O2 Heater Circuit
(Bank 2. Sensor 1)
Troubleshooting : Transmission fluid check looks good (full and red)
Checked fuse 23 of the Central Junction Box
Held a ground wire to bottom of Transmission pan and to the frame while I started the truck, O/D light still flashing
Wiring looks good coming to the plug on the driver side of the transmission
More info:
- No "Service Engine Soon" or blinking O/D off light prior to all this happening.
- I don't believe I'm getting 1st gear. I don't recall if I got my speed up to 30+ MPH while in D1, but while in D2 I never noticed a shift from stop to ~35MPH. At 35MPH, my RPMs were around 2500 I believe.
- While cruising at 35MPH in D2, shifting to O/D results in lost power. I had to stay in D2 all the way home.
To do (I believe):
1. Check shift solenoids (looking for DIY info)
2. Check shift solenoid pack (looking for DIY info)
3. Check TCC solenoid (looking for for DIY info)
It sounds like there are a couple shift solenoids to check as well as a solenoid pack (how best to check these out, I'm still looking for)?
had a problem with their OD light blinking and shift problems. This past week my od light started blinking and when I shifted into drive, it was stuck in overdrive. When I shift into 1st it would go to 2nd and stay there. So basically I had 2nd and overdrive. I started replacing sensors like the VSS, and checking the wiring warness. Took it to a transmission garage and they told me it was toast. Then I decided to bite the bullet and buy a new tranny. After replacing the tranny it did the same thing with the same codes showing. Then I got smart and checked the fuses. Of course it was as simple as a blown fuse causing all the trouble. In my truck it was fuse 23 under the dash. A 20 amp fuse that was listed as engine control. Im not saying that in every case if the OD light starts blinking it's as simple as a fuse but in my case it was, so lesson learned. Always check the fuses first.
View 13 Repliesive got a 2000 v-10 excursion with 111k. Never had a problem like this before but last week I was driving home an noticed the theft light blinking while I was driving. Got home shut it off. next morning went to start it and nothing! when the doors open it makes a clicking noise under the dash. if I jump it the truck will start right up. If the batt is disconnected them re-connected it will start once until turned off and then nothing until its disconnected again. I ve got an elk hunt in 2 weeks and need to figure it out!
View 6 RepliesMy Ford 250 Super Duty, it is a 2008 model. I can't get it to start and the anti-theft light keeps blinking. At least i think it is an anti-theft light, a blinking red lock on the instrument panel. I bought this truck from an auction so I don't have a manual, neither do I have a key set with the push button stuff on it. Just 2 electronic keys. Someone suggested unhooking the battery overnight, and someone else suggested pressing the valet button. I found a button under the dash, I have no idea if it is the right one.
View 4 Replies1. About march 1, my check engine light came on- took it to oreileys for a scan and said Speed Sensor A (cannot remember code), I was not overly concerned to fix it very very busy.
*Drove about 800 miles no further issues except the annoying CE light*
2. ABS comes on a few days ago
3. Today the truck, 4 miles from home decides it wont let RPM's get above 2500, and 40mph. It slightly hard shifted once.
Truck has 97000 miles and is a 1999 V10 has NEVER had any tranny shifting issues or engine issues....
4. Check tranny fluid when we get home it does not smell burnt and is red- its not even that warm...
I have read a couple places that a VSS can cause this? But I never noticed my speedometer acting up EXCEPT for the day the CE light came on- which there was a lot of ice and tires were spinning and speedometer said 0.
I currently am driving a 2001 F-350 V10 SuperDuty, and recently the battery light was blinking. I replaced the alternator in it, but it didn't work. I thought it was bad so I went and got another and it still didn't work. Turned out that the alternator wasn't big enough. I then went BACK and got a larger alternator, and it still won't work. Now the battery light is solid, and I'm getting absolutely no charge out of the alternator. I checked all the fuses and nothing is wrong. It seems like all the things you think could be wrong are running perfectly fine! What could be wrong. The truck will start, and idle, but will run off the battery only.
View 14 RepliesThe battery light blinks in my truck. It's not a controlled blink, but it flickers like a loose bulb. It started a week or so ago. It would blip every once in a while. Gradually it would start to flicker more often. At first I thought it was belt-related but it isn't related to the transmission shifting at all. So if you're thinking that it's belt-related, you're going to have to explain why it doesn't blink either right before or right after a transmission shift (i.e. a rapid change in engine speed).
Earlier in the week, the light was flickering so hard that it was virtually on. I drove home last night and didn't see it once, although that's the first time I haven't seen it happen at all in a week. The battery gauge itself doesn't move a bit while this is happening. I have a cigarette lighter voltmeter and it shows a pretty steady 14.1 volts regardless of whether the light is flickering or not.
I had the batteries tested in my truck by a real battery shop about 4 months ago and they are fine. The battery connections all seem tight and clean, and the belt, tensioner and all that seems fine. So..What can cause a battery light to come on that isn't voltage related?
My buddy has a 2002 F350 CC Longbed with a 7.3. Last night the overdrive light started blinking. He said he drove it today and it takes about a mile or so for the light to come on but then it is a steady blinking. Truck has about 254K miles on it. He said other than the blinking light everything seems normal. How to figure out what this issue may be?
I got AE hooked up on his rig.
When I pull (ALL) codes this is what I get:
When I pull (Current) codes I get this:
I tried to clear the code and the light stopped blinking, but he said it started blinking again on the way home.
Driving to work the other day my transmission shifted down and the transmission light started blinking. It felt like it geared down like it was in 4x4 I was doing about 55 at about 2600 RPMs. This has happened twice now and lasted around 2 minutes then stopped and ran great.
View 2 RepliesI have a '99 F250 SuperDuty Diesel with an Automatic Transmission. There is a button on the end of the gear shift which allows you to turn off overdrive -- in other words the transmission won't shift into overdrive once you press the button.
Here's my problem. I start off driving normally. I've not done nothing to the overdrive button and the truck shifts normally into overdrive. 10-15 minutes down the road, the overdrive light (which indicates the state of the overdrive button) is FLASHING. Pressing the button doesn't stop the flashing. Once this flashing starts, the only thing I notice is a much more abrupt shift from 1 -> 2 gear.
I have a 2006 f250 5.4 4wd with 5r110w trans. Check engine light was blinking and then one day the tranny just stopped working in all gears. Engine code p0751 came up, shift solenoid "A". Changed it, code went away and still no gears. Checked pump pressure, good in all gears, all I can think of now is TCM....
View 3 RepliesI have been having some inconsistency with my transmission in my 2005 F350. I bought it used 2 months ago and have had the low/tow overdrive light blinking. a month ago I removed the pan and changed the filter in the transmission. I had a friend run the diagnostic test and found transmission solenoid code as well as both cat. converters as well as my Number 8 cylinder misfiring... I pulled the transmission pan and filter to find what appears to be 7 solenoids? Where to start?
View 1 RepliesJust purchased a 2001 Ford F150 super crew lariat v8 4.6/5.4 2v OAD at 156k miles, iv had no problems with it until I drove over the pass and after 2hours of driving my truck started to jerk when I accelerate between about 40-60mph. I don't experience any other problems over 60 it runs smoothly and in town under 40 it also runs smoothly, no check engine light. The next day is still continues to make a jerking motion, which feels like from the rear....
View 2 RepliesI've been having issues with the charging system on my 2005. The battery was 7 years old, so I replaced it. Now, the battery light comes on dimly (and flickers) when at low RPM. I am thinking alternator. I replaced one on my 2002 F150, but haven't done a 250. How hard are they to get to and replace? This is on a 5.4 gasser.....
View 3 Replies2002 F-350SD V10 Automatic. Running down the road with no load or with load. First gauges bottom out, next overspeed light starts flashing, engine goes to 3000 RPM on it's own. Stays that way until I shut off then restart. Sometimes it does this several times in one mile.
Second trick, again driving along, all gauges stay up but engine just stops. Got to set dead for 5 minutes before it will start. The shop says on the first problem this happens: Voltage goes way low then goes way high then everything starts failing. We changed battery but no luck. Got to be down line from battery.
So I'll be driving down the road and the gauges will randomly start jumping around then the truck will just shut off, this just started a couple days ago, it seems to be gaining in frequency, when i try and restart the engine all my warning lights flash on and nothing happens, try again and it starts back up, now the last time it happened all of the above happened but it was followed by a fast clicking noise from under the steering column, it has to be a electrical issue as i have full tanks and motor is in tip top shape. Also no codes pop up with my code reader.
View 1 RepliesI have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 RepliesMy dad gave his 2005 Ford F-350 truck with the gas 5.4L (?) I drove it home. If i floor it it misfires badly, or if the RPM's get over 3000 it misfires then about 3800 it stops and keeps going. but i can't give it to much gas....
The spark plugs where replaced 2 years ago along with the cat converters. I can hear some very fait manifold gasket leak ...
A few days ago it was raining and it had a bad misfire with blinking CEL. but it never threw a solid CLE. can i still put the codes on it to see what cylinder it is? Are these issue related? Where should i start?