Ford Super Duty (1999-2016) :: Power Windows Not Working - Door Locks And Interior Quit Working?
Jul 16, 2006
Troubleshooting a problem with friend's 2000 F250. His power windows aren't working and are causing problems with his door locks and interior lights. When he tries to use his drivers side power window, his power door locks quit working. If he puts the switch to raise, the interior lights flash. From what I've read, it sounds like the GEM to me, we've inspected the wiring and it all looks good. I pulled it out today and it looks good inside, no sign of water leaks on it. If it is the gem, how much do they cost and do they require programming?
View 5 Replies
Advertisement
I just bought a 2007 f350 lariat and my radio, pwr Windows and the 2 lights beside the dome light don't work either... it looks like there was a new relay put in recently.... Is this some kind of wiring problem or where to start looking..or what might be my problem... I am clueless when it comes to wiring .
View 3 Replies
1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
View 7 Replies
Vehicle: 2002 f250 xlt 7.3 powerstroke reg. Cab
Issue: door ajar light stays on, power locks on driver and passenger door don't work, radio stays on after truck is off an door is opened.
Events leading up to issue: went to temporarily hook up a wolo dixie horn to see if it worked. Wanted to do it fast so I took + cable, tied one end to the battery terminal and then connected other end to dixie horn relay. I then grounded both negative wires to the truck. One ground on the frame the other I temporarily wrapped around a one of factory ground mounts under the dash. Immediately after doing this the problems stated above started.
How can I fix this. I need to fix this by tomorrow. I have a guy from Craigslist coming to look at the truck. Now the 4x4 issue.
Truck has zf6 manual and the electric 4wd select ****. Just thought I'd list this if it was needed to be known for solutions.
4x4 high light stays on in while 2wd all the time. 4 low will stay on after switching back to 4 high and 2wd but it goes out if I ether stop the truck shut it off then restart it. or back up and slam on the brakes. Also when in 4 high the front driveshaft won't spin. However It will spin when in 4 low.
Another random issue I'd thought I'd just list while I'm writing this.... Cruise control does not work. And when I press the "on" button and the "coast" button at the same time the horn honks.
View 3 Replies
All 4 crew cab door locks are not working...I see and hear them moving a little but not enough to get the job done.....Ive read a good fix on this forum but have a few questions...... 1. Could the problem be in the switch or wires ... 2. If I try to fix---do I need to fix all doors or is one door somehow messing the other up.
View 6 Replies
Ihave a 2004 F350 4x4 Dually diesel. While in my hay field I hit a small rut and the truck bounced. About two seconds later all gauges and lights/windows quit working and the truck ran rough. I have a Banks system and it registered a code 33. Maybe 32 error. Book says it is an airbag deployment. They did not deploy. So I drove out of the field and turned it off to see if that would reset the gauges. No, not only that but the gauges all swept the faces from off to full to off and the truck would not start, just chatter.
I disconnected both batteries and waited. Reconnected and it started, but the gauges quit after 10 seconds..... Everything flatlined even the banks IQ. But the truck kept on running. Got back to the ranch and the batteries went flat overnight... Charged them up, starts fine gauges work but alternator puts out 11.5.
View 2 Replies
I have a 2004 F250 Super duty that had a battery die (I left the keys in the ignition switched on overnight) and after jumping the battery off the vehicle started up but now I have no power door lock or window functions. Any reason a dead battery issue might affect the power locks and windows?
View 10 Replies
My door locks stopped working new battery in fob, I can hear them trying to work. 2000 f250 crew cab .....
View 3 Replies
Two nights ago I got into the truck at night and realized the interior lights don't come on. I tried the rocker switch it will only dim the dash gauges now. It did work before guessing its a bad rocker switch. I can turn them on manually front and back....
View 5 Replies
Driver's side rear door quit working today - opens about an inch or so. What is the remedy?
View 7 Replies
I bought a 2002 f250 Crewcab bout 6 months ago. A couple of months back I noticed that after driving it and turning off ignition and opening door my radio would stay on and doors would not respond to key fob or switch on doors. Eventually it would reset and radio would turn off and key fob would work. It also makes the locking sound when press on brake. It doesn't happen all the time though and that's only issue. Truck is in awesome shape only 106,000 on it, belonged to an old man who only used it to tow camper twice a year. I've read a few posts that have similar problems and have heard could be gem or vsm.
View 2 Replies
My air conditioning on my 02 is having a issue, when you first start it and run the ac all is well and it cools perfect but then after a while it will quit working all together no more cold air, shut it off for a bit then it starts working again and repeats the process, charge is fine, been doing this all summer, it verys on how long it will work somethings for 5 minutes other times 40 minutes give or take, any thoughts?
View 2 Replies
We just replaced an injector in my truck. Everything was fine, ran great, etc.
On the freeway home, the dash, windows, locks, radio all quit working. at first they'd stop and come back, stop and come back, etc. then finally they stopped. As I was getting off the nearest exit, the truck started dying on me. Once I got pulled over out of the way, it acted like the battery was completely dead.
After a few minutes of scratching my head and staring under the hood, I happened to look at the passenger side batter, and the crossover cable from the drivers side was broken off right at the terminal!! We must have broke it off while doing the injector. as I look closer at it, it had been broken before. Some idiot before me had actually taken a broken crimp style terminal, shoved it and crimped it into a new one and called it good.
I was able to redneck it back together so i could finish the last couple miles home. I fixed it properly with a new crimp terminal, heat shrink, etc. Why did the engine die with the crossover connection broken? was it because the series was not complete, and all the electronics were running off the battery(s) and not the alternator? I'm really confused. I've heard of people only running one battery before.
View 9 Replies
Have a F350 V10 super duty the power windows intermittently stop working along with the radio. I have replaced the acc relay key switch under a recommendation. I looked over the fuse panel under the dash for corrosion. Still can't find problem. It was worse this past summer than this winter. When it goes bad after driving 30 miles it will start working.
View 14 Replies
All at once my power locks and windows on all doors and the power mirrors quit working. The Driver Info center also says "Unknown Driver" when I start the car. After that happened the check engine ligth came on and when I went to get that checked there was no power to the ODB port (not sure if it is related or separate). Also, the brake, ABS, and traction control lights are on...they have been so I'm sure that is a separate issue.
View 1 Replies
I was driving my truck and my power windows quite working I figured it was a fuse so I wasn't to excited about it I stopped and unloaded some scrap metal and then when I started my truck back up I couldn't shift it out of park unless I unplugged the brake pedal sensor or turned the key just out of the off position then shifted to neutral then started then I could put it in gear and go so I got home and started looking checked all my fuses all good then I realize the windshield wipers are not working either and the door beeper, if you have your keys in the ignition also isn't working the horn, isn't working the lights on the window and lock switches isn't working either so I'm kinda lost now gonna barrow a relay tester in the am but I'm kinda thinking maybe the computer ?? For all this to happen at one to,e doesn't make any sense to me that's a lot to all go in one shot it makes more sense to me
No horn
No power windows
No accessory lights on the window and lock switches
No wipers
No buzzer/beeper (like when you open the door and leave the keys in the ignition
Won't shift out of park without doing it with the engine off or the brake pedal position sensor unplugged
I've gone thru with a test light and got power to the fuses for everything but still nothing
View 14 Replies
The interior lights, radio, and power window gauges and the ignition buzzer on my 2002 F350 quit working. What could cause this? Everything else still works.
View 7 Replies
I'm having trouble with my '99 F-350 7.3L 4X4. One day, my power windows, cruise, dome light, horn, wipers, and 4 wheel drive stopped working. After checking all of the fuses, I have found no bad ones.
View 3 Replies
2006 F150 5.4 2WD extended cab tow package 24k miles
My power windows have stopped working from all locations. I checked and the fuses are good. I can no longer use the exterior keypad to unlock the truck, yet my remote keyring switch will electronically open both driver and passenger doors. Neither driver's nor passenger's interior door switches work.
View 7 Replies
I have a 2000 Taurus and recently the power windows and power locks stopped working. They won't work from any door switch but when I use the key fob to unlock or lock the car the locks will work. However, the windows won't work from any door switch. I didn't see a fuse marked for the windows or locks.
View 3 Replies
I have a 2003 jetta GLI (vr6 6 speed) that i received from a friend because of some body damage to the doors mainly. so i replaced the doors with some from a 2001 jetta glx, but the power windows don't work with the switches inside the car. However, when I put the key in the door and turn it, all of the windows will go up and down...(So the motors are good and they are getting power) the door locks, gas cap lid, trunk, sunroof all work and the interior lights work as well.
So i researched it and everyone said fuse #14 or ccm... so i replaced the fuse.... multiple times now just to make sure... After that didn't work, i bought a new ccm with the same part #. that didn't work at all... still same problems... I was wondering if maybe the new doors are or aren't CAN-BUS? if that even matters?
View 4 Replies
