Ford Super Duty (1999-2016) :: Power Steering Wheel Won't Turn At All At A Complete Stop
Feb 10, 2016
I just bought the truck 2 days ago and the power steering is acting up. When I test drove it I noticed the power assist seemed weak but it has gotten way worse over 2 days.
Truck is a 2001 F250 4x4 V10 auto. 60k miles and totally stock except for Harley Edition wheels and stock size tires.
Now at a complete stop the wheel won't turn at all. If I roll it works. Doesn't matter if I rev the engine. It doesn't matter if I'm on or off the brakes. Tires have plenty of air. The pump is quiet and does not make any abnormal noises.
This is terrible because how can you maneuver a trailer if you can't turn the wheels when stopped.
I noticed the fluid was low and not reading on the dipstick. I added a few ounces and that's all it took with no change. I then used a suction pump to empty the reservoir with the truck off. The fluid was very dirty, probably the original fluid given the mileage. I removed about a quart and refilled it with fresh Mercon ATF. I also changed the serpentine belt because I noticed the belt was probably the original and was cracked.
It went away briefly tonight as I was playing with it. I thought I fixed it but I was fooled. What I did was remove the reservoir cap and turn the wheel from lock to lock while rolling forward slowly. Suddenly it was fixed . But 5 minutes later the problem was back.
View 11 Replies
Advertisement
I have a 2001 F250 SD V10 and when at a dead stop and with the brakes applied, steering becomes very stiff and almost impossible to turn the wheels. If I let off of the brakes and move a little the steering is just fine. I hate like hell to spend the money on a new power steering pump if it isn't going to fix the problem. Simply put, deap stop, brakes on, wheels don't want to steer. How do I fix it?
View 10 Replies
Have an 06 F250. When I slow down to make a turn then accelerate it's like the drive shaft spins half a turn before it catches. Been doing it for awhile now. Now I'm get a clunk when I come to a complete stop. When you stop then truck settles there is a little clunk. Does this sound like the slip yoke problem?
View 1 Replies
My steering wheel makes a popping noise at the same location every time I turn it, ie the 7:00 position. The popping is within the steering column inside the truck and sounds like its right behind the airbag. Its simply a popping noise and slight movement in the steering every time I turn the steering wheel from 12 to 7. I have no clue what it is and cant figure it out. My truck is a 2008 F250 2WD 5.4
This is a video of another person who appears to have the same exact problem, hopefully this will add some clarity to what I was trying to describe above. If you notice, when he turns it to the right, his steering wheel pops in the exact same location every time as well which is what mine is doing when I turn it to the left.
2010 f150 steering wheel pop - YouTube ....
View 2 Replies
2016 F250 6.7L 4x4
I getting some tranny noise when towing on incline from a complete stop. When I slowly press the gas pedal I hear grinding noise. If i press the gas more my truck starts to move and the noise goes away. It doesnt happen all the time. This started right after my 1000 miles recommended break in before towing per ford manual.
My truck now has 2800 miles and the grinding noise occurs intermediately regular driving. Mostly on steep incline or decline. I haven't taken it to the dealer yet because I cant recreate the issue all the time.
View 6 Replies
I have a 2000 f250 superduty gas v10 6.8L . I bought this truck about 4 months ago. Now when I take off from a complete stop the truck shakes up until second gear, shifts fine all the way up until the last gear it looses power "loosing power" i mean i can put my foot into the pedal and it takes forever to climb speed meanwhile the RPM'S never skyrocket like it the transmission was slipping if anything a couple times the RPM's dropped are stayed the same then as i take my foot off of the pedal once i have my desired speed sometimes not always the truck will give me a little jerk Also Just the other day I was driving on the highway and decide to put her on cruise control at about 70mph, I set the cruise control and the RPM gauge was just over 2,000 and the tach was fluctuating up and down about 1/16 of an inch. I been reading alot of forums and what I got out of them is it maybe pointing me to a misfire maybe the coil packs? Plugs?It's not something major like a transmission rebuilt.
View 6 Replies
I have a ford f350 super duty that has a little problem turning to the left but is really hard to turn to the right. How do I fix this?
View 4 Replies
Every time I try turning at idle or with foot on brake it wont turn at all. Is this just a super duty thing or vacuum leak or power steering pump going?
View 9 Replies
I have a 2004 f250 superduty. I lost all electric to truck. No lights, radio, etc. Turn key and no click or dash lights. I put a charger directly to battery and nothing. Is there a main fuse in power line prior to the fuse box under the dash??
Also, right before this happened, I went to start my truck and my batteries were low, the truck turned over a few times, started dying, so I turned the key off, and the truck kept turning over on its own, as if the circuit remained closed for ignition due to low battery, and it turned over by itself until the battery was completely dead. But putting my battery charger on it now gives me no electric at all.
View 5 Replies
Starting about a year ago, "sometimes" when I step on the brakes and am turning the steering wheel, I loose the power steering. I took it to Ford and they said that this is a a known issue but they didn't say what it would take to fix it. Because this problem is intermittent it is very hard to get this fixed unless the mechanic can experience and verify the problem for himself...
View 14 Replies
So I have a 1999 F350 diesel and the fuse panel under the steering wheel is acting up. I was driving my truck home the other night and I lost power and my truck shut off. I have had a problem in the past with the #30- 30 amp fuse ( controls the PCM and glow plugs from my understanding) that is under the steering wheel, I replaced the fuse and everything started working normally again.
Until the other night when my truck shut off, so I replaced the fuse the truck drove again for 20 feet died again, I was able to hold the #30 fuse and allow my truck to start up again but would eventually killed the PCM and shut off again and would not start up due to what I believe the fuse location shorting it out and killing the power to the PCM preventing me from starting it up again. I had my truck towed home and charged the battery and it started up fine the next morning. If I push on the #30 fuse my truck the shorts out and kills the power, I do not know if this is normal?
The fuse is sitting loose in the fuse holder is there anyway making it fit tighter to prevent it from being so loose? I have read every other post online about the problems and tried everything they have recommended but still can not figure out what was wrong with my truck. I disconnected the fuel filter heater, and also the wastegate solenoid to see if that would prevent the truck from shorting out if I pushed the fuse it did not work.
What the problem could be causing the #30 - 30 amp fuse to be shorting out preventing everything from working? Or how to test the fuse panel and all the relays?
View 2 Replies
the mechanism that locks the steering wheel is stuck. not the ignition key cylinder (already removed that). how do I release that mechanism to free the steering wheel.
View 3 Replies
Seems that after a sharp right turn, for instance turning right at a stop sign I'll get a loud pop that I can feel in the floor pan under my feet.
After the pop the steering wheel and whole front of the truck will shift left and right like someone is grabbing the wheel, sometimes violently. If I drive slowly it will cure itself and sometimes not do it again for several days. I've check ball joints and hubs and they are in great shape. I pulled the hubs and greased the needle bearings about 6 months ago. I checked all steering components and the linkage that attached to the steering arm had some play so I replaced it. Then I found that some idiot took the steel sleeve out of the bushing in one end of the steering stabilizer. I bought a new stabilizer and cured a pop I'd had since I got the truck, but the other issues were not solved.
Alignment has been checked too.
View 14 Replies
My truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 Replies
just bought this f250 seems to walk on the road alot, had it looked at has new balljoints, he says everything seems tight except there is lots of play at the gearbox, is it recommended to have it rebuilt or buy a reman, was told that even the reman seems to be the same way
View 14 Replies
The steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 Replies
So, don't know if this is normal or not, but after lifting the rig, I'm experiencing a whole lot of these types of sounds from the leafs or the springs or whatever, whenever I start, stop, or turn. Is there an easy way to silence the noise? I've tried all sorts of lubricants on the leafs and springs, but I only get (at best) a week of muted noises. While it's only an inconvenience, it sure would be nice to have the rig be quiet again.
View 6 Replies
Just got an inexpensive LED Stop/Turn/Taillight Bar my problem is it has (3) wires Red, Black and White while the available connection from the old bar has only (2) wires Black and White with Red Dots.
The wiring instructions for the new LED bar says (1) Attach black wire to tail lamp circuit(+), (2) Attach the Red wire to the stop/turn circuit(+) and (3) Attach white wire to a good ground(-) location.
How I should hook this up? My thought is Black to Black , Red to White with Red Dots and White to Frame metal.
View 1 Replies
2004 F350 6.0 Diesel 2WD, Question is my trailor lights running lights work fine also the electric brake, but i have no stop or right or left turn signals the truck signals are all working perfect. The truck came with factory wiring i have checked it at the plug on the bumper with meter to make sure it was not the trailor. Looked for blown fuses and cant find anything what am i missing it should have seperate fuses for trailor lights ??
View 14 Replies
06 F250 6.0 CCSB 4x4 163K Truck was in a pass side wreck about three weeks ago. Aside from bumper, head light, etc I had to replace the track bar and then I had the alignment done. Mech said the steering was loose and was either the steering box or column.
PROBLEM: Truck drove and parked fine last night, I went to leave the driveway this morning and I had to turn the wheel full right while backing up. The wheel locked up and wouldn't turn back to the left to straighten out. Hood wouldn't pop either to check anything
I crawled under the truck, the belt was in place and I didn't see any power steering fluid leaking. Thinking it was a PS problem and the hood not opening, I basically floored it and yanked on the wheel and it broke loose. Also, for what ever reason the hood opened after that
Now the steering is heavy and the wheel doesn't center on it's own. It will stay turned when I let go of the wheel. Scared that it would happen I didn't try turning it full lock on the way to work. but it happened again exiting the parking lot, again full right lock and the wheel stuck.
I managed to yank the wheel to the left again and I heard a distinct pop from what I'm sure was the pass side wheel area.
The PS fluid is dark and I'll figure out how to change it. I've read issues from the U-joints, ball joints, Steering box, steering stabilizer, and failing PS pump could all lead to this. Being the truck had a pass side fender bender, and I'm pretty sure the pop sound came from the pass side how do I check all of these items.
View 13 Replies
So I just got my 2014, upgraded from a 2007, and one change that is bugging me is the steering wheel controls for the radio. In the old truck clicking the scan up/down buttons scanned to the next radio station, in the new truck it scans through the preset radio stations. I really don't like that. Can it be changed or am I stuck with it?
View 2 Replies
