Ford Super Duty (1999-2016) :: Plugs Covering Holes In Plastic Piece Missing - Truck Wrecked Previously?
Feb 1, 2014
Bought a dealer demo last may. Truck has been wonderful. Had less the 1500 miles on it. Noticed when I was installing the lock on my tailgate that some of the plugs that cover up the holes in the plastic piece inside the tailgate were missing. Maybe some of the screws, not sure. Dunno if it's supposed to be that way or what. Just started to get a horrible feeling about it, Taft maybe something major happened. Any way to find out or round they have told me? Mebbe I'm over thinking this.
View 6 Replies
Advertisement
I was washing my 2004 F-250 today and I looked down by the front passenger wheel well and I noticed a small chuck missing from the bottom of the frame. The other side in the same spot doesn't have it and at the spot in question, I noticed some sort of crack had been welded before. I never had any of that done to the truck. What about getting it fixed? get it fixed right away or keep an eye out for cracks. so far its just that hole and what looks like a welded crack above. everything else seems fine. I know a repair would be inexpensive and easy just to weld a steel or titanium plate on the spot.
View 11 Replies
One day after my mechanic replaced the heater core my truck started to misfire after the motor warms up and is under load. No codes and nothing pops up when hooked up to o a scanner. It's been cold in the morning and when I start it up it runs like a top. But after it warms up it start to miss a little, then it gradually gets worse especially when under a load at higher speeds. I thought it was a vacuum hose or something got left unplugged.
View 7 Replies
I have a 2001 ford f250 6.8 v10 with just about 183,000 miles on it my wife has been driving it and she told me it was running kinda rough so I took it for a drive and she was right so I pulled #1 COP and found it was full of oil and the same with#2 and #3 had a little bit of oil not as bad. What is causing my plug holes to fill with oil?
View 14 Replies
I purchased a 2000 F250 SD with 5.4L Automatic for a project with my daughter. After removing the fuel rail and the coil pack on the driver side I noticed two spark plug holes had oil in it almost to the top of the plug. I'm guessing it is a bad rocker cover gasket that is allowing oil to leak into the plugwells? Nothing I could find on the internet relating to this.
After removing the rocker cover the silicone gasket was intact but wet with oil. I purchased a replacement Felpro gasket but now understand they might need grommets for the crazy bolts Ford uses to hold the cover on the head.
View 13 Replies
My 2011 f250 has 92k miles, I want to change all 16 spark plugs.
Do the 6.2l plugs have problems breaking like the 3v engines did?
I think I'm going to pull the passenger fender liner to get to the lower plugs in the head.
How does the coil pigtail unclip? I looked at them briefly earlier and it looks like you pull the red tab back, then press down and pull on the pigtail but that did not work and I did not want to break anything.
View 14 Replies
I need to identify these random plugs under my dash. I think they might be for some sort of alarm or remote start unit and they seem to be tapped into the ignition wires. Suspiciously like remote start plug wires but I can't figure out what unit they would be for?
View 8 Replies
Went to hook up my trailer today and both the trailer plugs do not work. I checked the fuses and all is well. They worked fine the other day but now they don't work at all. I confirmed this by hooking up to another trailer and nothing. Also got another truck and went to trailers and it worked.
My truck has 19000 miles so it's practically new. I have never seen this. I called dealer but they can't see it til next week and I need the trailer brakes and lights. Where could I look or what could the problem be?
View 14 Replies
Got a 2015 6.2. No where near time to change plugs, with alot accessories i have installed it would suck if the cab has to come off. Can the plugs be changed with the cab on?
View 12 Replies
I have a 2002 f250 super duty 4 dr w/ full lenth bed. has v10. had oil cooler problem, motor oil in coolant. fixed that, then rad started leeking, replaced that. now blowing freeze plugs on block. replaced i on drivers side rear, now popped one on pass side. whats going on? i know oil pressure is more than water, did the oil cooler leak losen the freeze plugs? What size freeze plugs they are? no parts house around here knows.
View 14 Replies
Have a 5.4l that has multiple issues.
1st, fouled spark plugs on passenger side. All of them have a carbon glaze. That side of the engine seems dead. I checked the pcv valve and its fine. I took the head off to have fixed a broken exhaust manifold screw. After reinstall when The engine started and there was a lot of white smoke from the exhaust. Then it quit smoking. I was hoping it was from the new exhaust manifold i put on, guess not. I took the intake manifold off and noticed that there is an extra hole past the back of the manifold that the manifold gasket goes over but not the manifold itself. The pictures Ive seen make me think the setup is correct, but what is the extra hole for?
2nd, high idling. Around 2000rpm's. I am guessing its because of the right side not working for smoother idling?
View 7 Replies
I have an 01 F250 with a v10. Driving through heavy snow in 2013 a plug blew out. Should I expect this to happen again if I do some heavy hauling and should I do something preemptive?
View 14 Replies
Looking to sell my '12 F-250 turbo diesel Lariat. She's in great condition, and only 8000 miles. Her only sore point is some scratches and scuffs on the plastic cap on the top edge of the tailgate (see picture below). I think it's part # BC3Z-9940602-B.
How to remove this cap, preferably without breaking/scratching anything else. It looks like there are no external fasteners, so I'm guessing it's just held on with clips on its underside, or some such. It might be more obvious once I get and examine the replacement part, but just figured I'd ask.
View 6 Replies
OK changing plugs and boots on 2003 f 350 5.4 (I have a bad miss and mis-fire code) First time messing with these things. When taking out the coil over plugs it looks like somebody put die-elect grease up underneath the boot at the top where the spring and the metal prong touches together. I thought I just needed only to grease the plug on the sides to keep the boot from sort of melting onto the plug. And some boots had maybe a drop of water in them is this common or any concern? Might be condensation and water does conduct elec, so not that concerned, but these C-O-P's are new to me and thought I'd ask. I've searched here and read posts about changing of the plugs and C-O-P's but don't remember any water boot coming up.
View 6 Replies
My '99 was running rough - coughing/spitting/sputtering when under a load - especially at lower idle/rpms and going up inclines.
Brought to mechanic and he put it on "the scope" which told him the #1 pack was bad. Replaced. Got it back and it ran better, but, then went back to the coughing/sputtering.
Replaced the spark plugs - OEM Motorcrafts. Seemed perfect for a wee bit, now I notice an occasional cough/spit but all in all not bad.
Curious: was it foolish to not replace ALL coil packs at time of plugs or is it ...acceptable to do just the plugs and then come back and do packs if needed.
View 5 Replies
Just purchased my first ever Ford truck a few weeks ago, it's a 2012, and where the drivers right arm rested on the center console, near the cupholder, it's perpetually sticky. At first i thought it was just filthy, but after thoroughly cleaning it, it just stays sticky.
View 12 Replies
Was the plastic exterior trim on my 01 F250 originally black or grey? I was thinking of repainting the running boards, side mirrors, door handles, front bumper trim and bed trim with that Dupicolor bumper black. Want to make sure and keep it factory in appearance.
View 9 Replies
2011 250 CC FX4 LARIAT 6.7l Just had the oil changed on Friday and I noticed a couple oily spots in the driveway. Crawled under to investigate and there is a slow drip coming off the plastic oil plug. Called the service center and they said the seals on those plugs fail pretty regular. What was done to eliminate this issue?
View 9 Replies
Have a 2000 F-250 V-10 4x4 with 335,000 miles on the clock. Has started hesitating at 40-45. You can't really notice it at idle. Drove it around at lower speeds and just a miss here and there. Take it up to 40-45 and it's quite bad. Hasn't thrown any codes. Hooked it up to the scanner to get no additional info. My gut says coil packs but am kinda confused that I haven't gotten a misfire code yet. What to check?
View 6 Replies
The other day I was under my truck and noticed electrical plugs behind the front splash guards. What these might be for? I have a 00 F250 superduty XL model with the 5.4.
View 8 Replies
my 2000 f550 master cylinder reservoir plastic is cracked from vibration and it would be good to know if it can be replaced separately than having to purchase a new complete unit.
View 2 Replies
