My outside, driver side front door handle is busted. I was about to order a new one from Rock Auto, and came across this-
DORMAN Part # 80645 {#7C3Z3622405APPTM} Front Left; Paint To Match
DORMAN Part # 79306 {Click Info Link for Alternate/OEM Part Numbers} Front Left; Black; Textured Finish; From 3/15/99
What is the difference here? Is something different on the early 99's?
I was having a problem with 4wd and regreased/ cleaned hubs and when I went to test operation both fronts would engage and worked good. After a while.of testing in and out of 4wd I heard a loud clunk and looked under, the front driveshaft blew apart at the weld.the u joints dont seem to be bad so im at a loss as why this snapped. It was not a clean break and the edges looked like it had to started to tear at some part in the past due to rust build upon the inside.of the shaft and torn edge. Im lookin at 2 feet of snow expected here Tuesday, so im trying to find some answers as well as a.new shaft.
View 14 RepliesIs there some sort of fix for this?
You know, you get in the truck and lean on the center "arm rest" to get better situated. After a while the constant abuse brakes something and now the armrest is now floppy
FYI, this in an 04 crewcab F350
damn motor or something broke and of course its fully open. any tricks to disengage from powered sliding system? just need to get by for a bit til i can get to the dealer.
View 3 RepliesI was trying to replace the output sensor in my 5r110 when it broke off in the housing.
View 7 RepliesThe terminal (+) on the passenger side battery broke, and I see is a 1 piece cable and terminal all together.
Where to get that cable on how create a new one?
Truck would have a miss that went away when warmed up past 180. Ficm voltage was low so I got a new one from diesel tech ron. After I installed it The truck would crank for maybe 5-6 turns then lock up and kick the starter out. The starter broke away from the motor from the kickback. I got a new starter in and set up my scangauge 2. In the few turns of the motor i can do before it kicks out, ficm is at 48.5 koeo and cranking, ipr at 14.4, and the icp shoots up to 1100. The ficm sync wont come on and I m stumped what to do next. Dont want to start throwing new sensors at it. 2004 f250 6.0 ...
View 1 RepliesI have a 2011 f250 sd that I removed the front grill and noticed 3 of the clips that hold the lower part of the grill in (bolts on the top) are broke. I went to the local Ford dealer for the clips and was told I have to buy the whole complete grille for it. The parts breakdown doesn't show the clips sold individually from the grille.
View 2 Repliesthe driver/rear suicide door combo is rubbing at the top and thus rattling on bumps. Looks to me like it is actually from the rear door as the gap in the very back is very wide at the top. the driver door gaps look normal along the front. Before I dig into this I wanted to check and find out the best way to approach. Is there an adjustment inside the hinge? the bolts on the jam look solid and have never been adjusted. Perhaps there is a hinge pin in there?
View 9 RepliesVehicle: 2002 f250 xlt 7.3 powerstroke reg. Cab
Issue: door ajar light stays on, power locks on driver and passenger door don't work, radio stays on after truck is off an door is opened.
Events leading up to issue: went to temporarily hook up a wolo dixie horn to see if it worked. Wanted to do it fast so I took + cable, tied one end to the battery terminal and then connected other end to dixie horn relay. I then grounded both negative wires to the truck. One ground on the frame the other I temporarily wrapped around a one of factory ground mounts under the dash. Immediately after doing this the problems stated above started.
How can I fix this. I need to fix this by tomorrow. I have a guy from Craigslist coming to look at the truck. Now the 4x4 issue.
Truck has zf6 manual and the electric 4wd select ****. Just thought I'd list this if it was needed to be known for solutions.
4x4 high light stays on in while 2wd all the time. 4 low will stay on after switching back to 4 high and 2wd but it goes out if I ether stop the truck shut it off then restart it. or back up and slam on the brakes. Also when in 4 high the front driveshaft won't spin. However It will spin when in 4 low.
Another random issue I'd thought I'd just list while I'm writing this.... Cruise control does not work. And when I press the "on" button and the "coast" button at the same time the horn honks.
So the other day i opened the door and heard a super loud clunk noise come from the door and when I turned the car on and pulled hte window down it wouldn't go down all the way, only about 75% of the way so I assumed like BMW cars the window motor died but oddly it continued to go up and down just now 100% down.
Then 3 days later when I came to drive the car again the window went down to the 75% mark and now its jammed there with no movement even if I tried to lift the window up myself. Usually a broken motor allows this to happen but since it isn't budging I am wondering if its an electrical issue with the power window button more than the motor?
I say this because when i try to lower the passenger window from the driver side it works than out of no where on the 3rd time it wont move at all than 5 minutes later it will move or if it doesn't move I just go and pull the window down from the passenger side then I come to the driver side and try it and it works again than it'll stop again. So maybe its the power window control buttons on the drivers side that's failing?
It's been happening the last week or so, on and off. I'll open the door and close it and the cab light won't go off and the red DOOR AJAR light on the dash won't go off. The last two times it went off after about a minute. Now I don't care about it in the daytime, but at night it's a real pain. How do these sensors work? I see the little plastic lever on the rear door (ext. cab), but it can happen when I open just one of the doors. Is there a centralized receiver for both the door sensors?
View 3 RepliesThe door on my trailer plug is broken. I can't seem to find just the door. Need to get one without having to buy the whole plug assembly?
View 6 RepliesWhere is the door chime? I just want to remove it. My truck is a 2014 e350.
View 1 RepliesI figured out how to go from the passenger door to in the cab, but how do you do it on the driver's side? The area is pretty "busy" around the emergency brake area.
View 6 RepliesI noticed yesterday after using my drivers side rear door that i really have to force the door shut to have it latch properly. It has always needed a little more force than usual to shut but not I never had to grip the side of the door and force it like I'm gonna punch the side of the truck. After its latched the top is solid and doesn't budge but the bottom seems to be able to move a little if i grab it and try and wiggle it.
I am not sure if it is misaligned or what but its driving me crazy, is there something I should look for in particular? The passenger side shuts like an average door and doesn't really require a lot of force to shut but the drivers side has been like that since the day my dad picked it up new except now its really bad. I tried the search function but I could only find threads about door stuck shut not doors that wont shut.
How do you get the door chime to go away when the key is still in the ignition?
Also, how do stop the driver seat from moving every time the key is removed?
The red door panel light that comes on when the door is open did not work on my 04 F250 Lariat. I removed the door panel to fine there is no whires for a light. My 01 xlt has them, were they a option?
View 7 RepliesAll 4 crew cab door locks are not working...I see and hear them moving a little but not enough to get the job done.....Ive read a good fix on this forum but have a few questions...... 1. Could the problem be in the switch or wires ... 2. If I try to fix---do I need to fix all doors or is one door somehow messing the other up.
View 6 RepliesHow to disconnect the door chime? I like to keep my drivers door open while I listen to the radio and it would be nice to not have the annoying chime ring.
View 11 RepliesWhere are the door sensors located?
The ones that turn the light and off when you open and close the doors.
It use to be switches on the old trucks and cars.
But on my 2006 F-250 I can find anything that seems to do that function, nor is anything mentioned in the repair manuel.