Ford Super Duty (1999-2016) :: Output Sensor Broke Off In Extension Housing?
Apr 27, 2016
I was trying to replace the output sensor in my 5r110 when it broke off in the housing.
View 7 Replies
Apr 27, 2016
Advertisement
Ford Super Duty (1999-2016) :: Fluid Leak On Left Rear Side Of Transmission Near Extension Housing
I just recently had to replace the extension housing on my truck. Well after doing so I went to start it up and top off the tranny fluid and it started to leak out on the left rear side of the transmission near the extension housing. Ive looked and looked and found that the fluid is coming from the top right in front of the extension housing but when i clean it off there seams to be no holes or cracks. It isn't the housing seal, cause it pools in front of that. What could be the issue? My truck is a 01 F250 4X4 5.4L.
View 4 RepliesFord Super Duty (1999-2016) :: Drive Output Ratio From The Transmission?
I just purchased a F250 Gasser with the 6.2. I made sure to get it with the 4.30 rear to babl to tow a little better when i upsize the tires a little. Where I can find the drive output ratio from the transmission?
View 2 RepliesFord Super Duty (1999-2016) :: Possible To Adjust Trailer Brake Output Sensitivity?
I have an 08 F450 equipped with Ford integrated trailer brake controller. I tow between 6,000# and 14,000# machinery on a daily basis. I know the gain can be adjusted up to ten. I have noticed while braking "normal" The controller only outputs 1 green bar of power. Manually, the brakes on all my trailers don't grab untill around 3 bars of output. I find myself always sliding the manual lever to relieve the truck. The truck is suffering. I have the gain set to 10 just to get minimal result from the 1 bar output. I know my trailer brakes rock, they can stop the truck and trailer if needed. Can it be adjusted? How many bars are you folks getting with easy braking?
View 6 RepliesFord Super Duty (1999-2016) :: 2011 F450 - Low Output From Heated Seats
Just bought a 2011 F450 king Ranch. really like the truck but the heated seats a REALLY slow to warm up and then just warm. I see that these work different than all the other heated seats I have used and use the blower motor to blow warm or cool air through the seats instead of an element under the seat covers. Is there anything I can do to get more heat? The blower filters look ok and will replace the when I can find a set. Tries without the filter and didn't see much of an improvement. Where is the heat element and is it east to get to?
View 2 RepliesFord Super Duty (1999-2016) :: 2014 F350 - No Output For Brake And Turn Signals?
only have clearance lights at plug no output for brake and turn signals
View 1 RepliesFord Super Duty (1999-2016) :: Front Driveshaft Broke?
I was having a problem with 4wd and regreased/ cleaned hubs and when I went to test operation both fronts would engage and worked good. After a while.of testing in and out of 4wd I heard a loud clunk and looked under, the front driveshaft blew apart at the weld.the u joints dont seem to be bad so im at a loss as why this snapped. It was not a clean break and the edges looked like it had to started to tear at some part in the past due to rust build upon the inside.of the shaft and torn edge. Im lookin at 2 feet of snow expected here Tuesday, so im trying to find some answers as well as a.new shaft.
View 14 RepliesFord Super Duty (1999-2016) :: 40/20/40 Center Armrest Broke - Fix?
Is there some sort of fix for this?
You know, you get in the truck and lean on the center "arm rest" to get better situated. After a while the constant abuse brakes something and now the armrest is now floppy
FYI, this in an 04 crewcab F350
Ford Super Duty (1999-2016) :: Outside Door Handles Broke?
My outside, driver side front door handle is busted. I was about to order a new one from Rock Auto, and came across this-
DORMAN Part # 80645 {#7C3Z3622405APPTM} Front Left; Paint To Match
DORMAN Part # 79306 {Click Info Link for Alternate/OEM Part Numbers} Front Left; Black; Textured Finish; From 3/15/99
What is the difference here? Is something different on the early 99's?
Ford Super Duty (1999-2016) :: Overfilled Transfer Case Or Leaking Transmission Output Seal
I just changed transfer case fluid on my father's F-350 for the first time in 13 years. (over 230k). Removed fill plug first and fluid gushed out of the fill hole unexpectedly. Did not have catch pan ready, so made a mess. I thought it was just over filled form the factory, but too much was coming out to be simple overfill. Almost 2 qt came out of the fill plug.
Did some google search and found many Ford trucks have failed transmission output shaft seal and transmission fluid leaks out to transfer case, causing transfer case to overfill. I am yet to check transmission fluid level, but considering how much came out of it that probably is the case.
Now, how bad of the problem this really is? Will overfilled transfer case cause some serious problem? 4x4 is rarely used (once or twice a year in winter) on this truck and from what I understand transfer case doesn't really do anything in 2WD other than just passing output from transmission through.
There are no fluid leaking outside and repairing the seal would be a too much of work for me.
Also changed rear differential fluid for the first time and I was surprised how clean the fluid was. There were thin layer of black sticky residue (sludge?) covering everything, but the fluid itself looked clean and no visible metal shavings. I guess that is why Ford said it does not require change under normal condition.
Ford Super Duty (1999-2016) :: F350 DRW - Oil Leak Out Of Front Housing
I noticed an oil leak out of the front housing of my 2016 350. I have 3 Ford dealers nearby and all 3 can't get me in until 8 August. It looks to be just a few drops daily. Is it safe to drive pulling a 5th wheel until they get me in? The leak is at the bottom of the housing.
View 3 RepliesFord Super Duty (1999-2016) :: How To Close A Broke Rear Slider
damn motor or something broke and of course its fully open. any tricks to disengage from powered sliding system? just need to get by for a bit til i can get to the dealer.
View 3 RepliesFord Super Duty (1999-2016) :: License Plate Lights / Housing Broken
I was just washing my 2016 superduty that just turned 3000mi and noticed the light housings and plastic are broken on the license plate lights. The one just fell apart in my hand. 55k and this happens at 3000mi.
View 9 RepliesFord Super Duty (1999-2016) :: Power Fold Mirror Housing Smashed
A fellow ford driver (f150) pulled around a car on a residential street and clipped my mirror. His whole mirror as removed from his white beater truck. My mirror has the bottom plastic housing broken. Power fold and in/out and all glass movements work. How do i fix. Do the housing on the manual fold mirror with signal is the same as the power fold.
View 10 RepliesFord Super Duty (1999-2016) :: Coolant Leak Coming From Metal Housing Behind Alternator
I trying to see if this is something that is a easy fix or mayor work. Leak coming from that metal housing behind alternator. Does this housing came off? or do I need to take out the intake out? .
View 8 RepliesFord Super Duty (1999-2016) :: Battery Cable Terminals On Passenger Side Broke?
The terminal (+) on the passenger side battery broke, and I see is a 1 piece cable and terminal all together.
Where to get that cable on how create a new one?
Ford Super Duty (1999-2016) :: 2004 F250 - FICM Voltage Low - Starter Broke Away
Truck would have a miss that went away when warmed up past 180. Ficm voltage was low so I got a new one from diesel tech ron. After I installed it The truck would crank for maybe 5-6 turns then lock up and kick the starter out. The starter broke away from the motor from the kickback. I got a new starter in and set up my scangauge 2. In the few turns of the motor i can do before it kicks out, ficm is at 48.5 koeo and cranking, ipr at 14.4, and the icp shoots up to 1100. The ficm sync wont come on and I m stumped what to do next. Dont want to start throwing new sensors at it. 2004 f250 6.0 ...
View 1 RepliesFord Super Duty (1999-2016) :: 2014 F250 6R140 Transmission Leaking At Bell Housing
New to me truck has 80k on it, it's leaking at the bell housing. Pulled the inspection plate and it's definitely red stinky automatic transmission fluid. Back of the torque converter is clean.
Ford warranty has run out, however I do have an aftermarket warranty on the truck. Trans temp isn't above normal or running hot.
I'm a very mechanically inclined engineer, I do not work on cars for a living, but I have replaced an input shaft seal on a 4wd transmission before. That's my best guess as to what's leaking. Is this a common issue?
Ford Super Duty (1999-2016) :: Code P2195 (Bank 1 Sensor 1 O2 Sensor Stuck Lean)
So I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....
View 5 RepliesFord Super Duty (1999-2016) :: 2008 F250 V10 - Bank 2 Sensor 2 Oxygen Sensor Is Faulty
My Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 RepliesFord Super Duty (1999-2016) :: 2011 F250 - Front Grille Replacement Clips Broke?
I have a 2011 f250 sd that I removed the front grill and noticed 3 of the clips that hold the lower part of the grill in (bolts on the top) are broke. I went to the local Ford dealer for the clips and was told I have to buy the whole complete grille for it. The parts breakdown doesn't show the clips sold individually from the grille.
View 2 Replies