Ford Super Duty (1999-2016) :: O/D Light Flashing - Engine Idle Up - Tranny Jerky While Shifting?
May 5, 2015
Im having an issue with my 2000 f250 7.3 diesel. 4x4. The od light is flashing and the tranny is kind of jerky when it shifts. Also my truck won't go into 4 low. (I have shift on the fly) and every time I put it in park my truck revs up to 2000 rpm for a few seconds. I do have a ts 6 pos. Chip with can tunes on it. And I have already replaced the IPR. It does it even in stock setting.
View 1 Replies
Advertisement
2006 E-350 Dually Ambulance Chassis with the 6.0... Approx 125000 miles.
Recently, the truck started an issue. its an every once in awhile thing but has been doing it more recently. The OD light will start flashing and the vehicle will start to have clunking in the tranny and start shifting rough. ABS kicks in making it hard to stop. Once you turn the truck off and back on, Its fine until it does it again. Im connecting to a scanner tomorrow to see if i get any codes.
View 14 Replies
We have a 2008 f250 super duty with the 5.4 triton well ever since I replaced the power steering pump its been running raggedly, it idles rough and when i get up to 50, 55, 60 the check engine light comes on i put a diagnostic reader on it and said something along the lines of ECU bank 1 an Bank 2. What that is and I've been a mechanic for almost 3 years.
View 2 Replies
Just got the transmission rebuilt in my truck and other then shifting hard sometimes it has been doing great, Hooked it up to the goose neck this evening and everything was fine then went to back it up and pull it forward and after a short distance the od light was flashing and when i ran a check on it it was p0720? The transmission has less then 1000 miles on it?!?!? 1999 Ford F-250 7.3 Automatic....
View 5 Replies
I have a 97 F350 5.8 with E40D trans. I bought the truck with it shifting hard thinking maybe a simple filter/fluid change would fix it. It may have worked a little but did not fix the issue. There were 3 or 4 codes that I have already cleared up with new parts. I am still getting a 327 (something with EGR?) and 629 (Converter clutch control circuit failure). These show up in KOEO and KOER self test. The O/D does not flash ( bulb does work).
Parts that have been replaced: VSS, MLPS, new connector going into solenoid pack (tabs were broken), TPS. Removed the trans wiring harness and there is no damage or loose connections. When I replaced the solenoid connector I noticed there was some trans fluid in the connection. I cleaned it the best I could and reinstalled with dielectric grease.
The truck runs fine and shifts in and out of every gear fine its just shifting hard. If I unhooked the battery it will shift perfect for 5-10 minutes but then the hard shifting returns.
The only other thing I can find with my research is maybe the solenoid pack needs replaced. I figured if I take it somewhere they are going to want to rebuild/replace transmission. It seems like it can't be something very major since it will shift fine when reset...
View 4 Replies
I have a 2006 f250 5.4 4wd with 5r110w trans. Check engine light was blinking and then one day the tranny just stopped working in all gears. Engine code p0751 came up, shift solenoid "A". Changed it, code went away and still no gears. Checked pump pressure, good in all gears, all I can think of now is TCM....
View 3 Replies
So I was driving earlier this morning and I noticed my overdrive light blinking, I didn't think much of it since I know the multi-function switch is bad and I haven't had time to change it yet, but a while later I was accelerating and just before it would shift from 2nd to 3rd it went to neutral. I played with the shifter a bit and found that if I shifted the column to 2nd I could drive in second, not a problem being only 3-4 miles from home.
I did a bit of digging and found I had blown the OBD2 fuse and saw a few people mention fuses as a possible shifting problem, Replaced that and still having issues. I have found that if i start out in drive I can shift into 2nd on the column then at the proper rpm put it back up into drive for 3rd and 4th. I just had the transmission re-built 400 miles ago and it is under warranty but I want to make sure it's not a computer or some other sensor before I call and bitch to them. I saw a couple posts referring to the shift solenoid but the problem was different.
View 3 Replies
2000 F250 V10 Auto/Rebuilt Tranny... This weekend, I noticed my truck wasn't shifting at lower RPMs like it has been. I'm not hitting much higher RPMs per shift then normal. Very soon after, I get a "Service Engine Soon" light and my "OD OFF" light on my shifter handle started flashing.
View 8 Replies
I have a 2008 F250 SD 5.4L with 335,000KM's(200,000+miles).
The engine light came on a few weeks ago and I cannot seem to get rid of it. I have also noticed when I'm accelerating hard at higher speeds/RPM's the engine light flashes?? After when I get to the cruising speed and let off the gas pedal the engine light stops flashing and stays solid. Also when accelerating hard there seems to be a hesitation, almost like the engine is choking itself. Once it gets passed the hesitation point during hard accelerating it seems fine? I have ran about 6 bottles of Seafood through the engine and gas tank. It definitely worked out but still has the hesitation, flashing engine light syndrome...I have changed the following with still no luck...
-Spark Plugs
-Coil on Plug
-Fuel Injectors
-Cam Phase sensors
View 5 Replies
I have a 1999 F250 SD V10 4x4. I recently had a transmission installed and the truck is running erratic. I have an engine miss (sometimes when idling, more so when in drive and foot on the brake). I say sometimes because there are times it will not miss and the engine runs smooth. The transmission shifts a little strange and sometimes hard.
I am getting a code reading that says my TPS is faulty, but I installed a new one a few months back.
The engine is running rough (jerky on acceleration) especially when driving. I was wondering if I should take it to a shop and have them flash the computer to reset it?
I also remove the AC compressor a while back (bad clutch). I installed an aftermarket pulley.
View 2 Replies
2002 F-350SD V10 Automatic. Running down the road with no load or with load. First gauges bottom out, next overspeed light starts flashing, engine goes to 3000 RPM on it's own. Stays that way until I shut off then restart. Sometimes it does this several times in one mile.
Second trick, again driving along, all gauges stay up but engine just stops. Got to set dead for 5 minutes before it will start. The shop says on the first problem this happens: Voltage goes way low then goes way high then everything starts failing. We changed battery but no luck. Got to be down line from battery.
View 6 Replies
I have a 2002 f350 5.4l that has stalling issues, first some back round. Last week I pulled up the a stop light and the truck stalled I figured it was a iced fuel line as it was very cold so I put a bottle of drygas in the tank. Evidently there was a lot of moister in there because as soon as I started the truck check engine light came on and truck would not idle at all. I got through that tank and am now on my second tank. It is better but the truck will still stall when stopped at light (has never stalled in park or on the road only while stopped in drive) the check engine also light went off halfway through the first tank. What next?
View 9 Replies
I have an '03 w/ the 7.3L. Today the tranny stopped shifting up out of 2nd. And the O/D light flashes. There are no other MIL lights on. I have do some searching here and some say the VSS (Variable Speed Sensor) is bad, some say there is a connector on the passenger side that needs cleaning, and some say there is a solenoid just inside of the tranny bottom that needs replacing. So, what shall I do?
View 4 Replies
this morning my 02 decided to turn the ABS light on, and start bouncing the speedometer. plus, the OD light is flashing when stopped with foot on the brakes, but the trans is shifting fine.
nothing changed on the truck except almost 3 inches of rain fell last night.
will AE tell me if the VSS is going bad?
View 6 Replies
I recentlyHad to replace the right front wheel bearing and after the install the speedometer and turn signals don't work, the ABS light is on and the overdrive light on the shifter is flashing. I've replaced the VSS on the rear diff, pulled and cleaned Speed sensors on front hub?
View 2 Replies
I know this has been done to death, but on my '08 F250 XL I can't seem to get the truck to enter into the programming mode to program some fobs to it. I've done the cycling business and the best I get is a flashing light on the dash of the truck with a little lock on it, but nothing else. Can you not program the XL? Is there a major step I am missing?
View 14 Replies
1998 F-250 LD 4x4 463,000 km.
My truck begins to flash the OD light after driving about 10 km. So I borrowed a friend's scan tool and got a P0503, and P1500. So having been pointed to the vehicle speed sensor, I connected TORQUE and watched closely vehicle speed. Driving at a steady 80 kph it will jump rapidly up and down, from about 72-92, while the gauge in the instrument cluster reads a calm and steady 80.
Which sensor and wiring do I need to inspect? Rear diff or on the back of transfer case? Oh, and the ABS light is NOT on.
Sent from Nexus 4. IB AutoGroup
View 14 Replies
1999 f-250 7.3 diesel. Speedometer doesn't work and neither does the odometer, the ABS light stays on and once you start driving the OD light starts flashing and the truck starts shifting weird. I've changed the rear ABS/VSS sensor on the diff and the OSS on top of the transmission at the tail end. Still no luck.....
View 5 Replies
I have the dreaded flashing O/D light on my early 99 F350 7.3 4x4 auto. The only one's that seem to be consistently recommended are Snap-On or AutoEnginuity.
View 1 Replies
Tonight i noticed overdrive flashing. No changes in shifting, truck shifted fine. I shut it off when i got home, started back up, light was not blinking, not sure if its like the check engine light and stays on or not. Where light blinks but shifts fine?
View 10 Replies
OK, quick question. I have an '03 250 with the 5.4 and the OD light began flashing tonight. I looked in the forums here and everyone say's new tranny or sensor but over on the diesel forums the are saying that the alternator is a big cause of this (dirty power).
At the beginning of this year I noticed what I assumed to be a misfire when putting the motor under a load. Once up to speed it would smooth out and all was good. I was told that a plug job on these trucks is hellish and expensive since a lot of guys break the plugs off in the block. I put it off and the issue went away when the weather warmed up.
Now it's getting cold again and the misfire is back. Driving home tonight the truck died at a light. I restarted it and as I accelerated I noticed a difference in the shift from first to second and then saw the OD light blinking.
Again, the diesel guys are all talking alternator so my question is this: could the alternator cause both the OD light to flash AND the misfire? If the "dirty power" can cause the tranny to fall in to safe mode, can it also cause the ignition to be problematic?
View 4 Replies
