Ford Super Duty (1999-2016) :: No Start After Several Tries / Little White Smoke Came Out
Jan 15, 2017
I just replaced my up pipes, turbo pedestal O-ring, ICP, IPR, New O-rings in all my injectors and torqued to spec, new glow plugs, glow plug relay, oil loom wiring harness, new O-rings on oil cooler, oil filter, oil, and antifreeze. I have tried and tried on upwards of 50 or time to get it to turn over. A little white smoke came out and it sounded like it wanted to fire up, but only a few times. I have good batteries and a charger on it working along, 3-4 trys in 5-10 second burts or longer if it doesnt lose power every 30 -hr. oil is in HPOP too. 2001 F-350 7.3 auto 2wd 4dr longbed 329,611 ml..
View 8 Replies
Advertisement
Truck: 1999 Ford Truck F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F
Problem: Especially when it is cold outside . . . The truck takes forever to start and while doing so a ton of white/grey smoke comes out of the exhaust.
My starting schema: Turn the key on have the gas pedal pushed to the floor until the "wait to start" light goes out. Then, I turn the key off and back on while still pressing the gas pedal all the way down. When the "wait to start" light goes out again I remove my foot from the pedal and try to start it. I never leave it cranking for more than 5-7 seconds. If, after trying this process several times I will not push the pedal in at all. Also, sometimes I will leave the pedal pushed in while I am cranking it over.
The truck used to start after a couple of tries but lately it won't start at all, even after 20 tries. Sometimes it will spin up for a second as if the engine gets going but then just doesn't continue running. When it is warm out it will usually start after a few tries but doesn't seem normal to me. After I first bought the truck(used) it would start up within half a second after turning the key.This all started after I had to fix an o-ring that was damaged on the top/back of the motor that was dumping all my oil out of the top/back of the motor.
View 14 Replies
The last couple weeks my excursion had started to have a stumble and smoke white ate the first startup or after I let it sit for a long time. I did get progressively worse. I noticed the hpop line to the driver side head was leaking from the fitting so I rebuilt the boss fitting and now it's not leaking but when I started it up this morning it did the same thing.
If I give it throttle it clears up pretty quickly but if I let it just idle it will put white for probably 5 minutes. I have no codes showing when I looked with the scanner I don't see any other oil leaks and I don't smell a fuel leak.
View 6 Replies
Just bought a 02 f-250 7.3 with 115k miles. A couple days after I bought it I noticed a lot of white smoke on cold starts for about 20-30 sec at 50 degree temperature. So I tested the GPR which ended up being bad a replaced with the one that is double in size(name escapes me atm) and also did the 50 cent mod to keep the through-valve cover harness from losing connection since both sides were lose.
After that the temp warmed back up and it would only blow a "puff" of white smoke. The past two days it has gotten down to 30-32 and the truck has a rough time starting. Cranks fine but it's almost like it's getting choked or flooded then it will blow smoke for 3-4 minutes after it starts. The truck does have a FASS fuel system on it with stock injectors. Should I try to Ohm out the glow plugs again or where should I start trouble shooting?
View 3 Replies
2001 F250 5.4 with 160K miles. My wife "borrowed" my truck as she drove away, I saw white smoke coming out of the tailpipe. The kind you see in cold weather. Its was 75 degree in Texas this morning, so what could that be? There is antifreeze in the reservoir and I recently changed the oil and there was no water in it.
View 5 Replies
I have a 2008 Ford 250 diesel that is pouring out white smoke from the exhaust when it goes into "cleaning filter" mode. I really don't understand this because I have a dpf delete with a sct tuner. I thought with the tuner and delete the truck wouldn't go into filter cleaning mode. I contacted Ford and they said it was normal for white smoke to come from the exhaust during this process. What's going on maybe tuner is bad?
View 5 Replies
My truck is a 2005 6.0 with no after mods and has 73000 miles on it. It began to blow white smoke out exhaust. I changed out the egr valve and cooler. After putting back together it then blew white smoke ran it to clear out. This worked however once it warmed up it began to blow thick white smoke at 20 mph and clears up by the time it reached 30mph and white smoke shoots out at rapid acceleration. As well there is coolant leaking out under the truck from somewhere in the motor about in the center. I am looking to work on this myself as I have heard of owners taking it to shops and paying a lot of money for the prob to not get fixed.
View 7 Replies
I have a 2002 f250 powerstroke 7.3, while driving it smokes pure white smoke and feels like its loading up and will start shaking if I floor it, it will rev slowly popping like its loaded up then cleans out runs good for a 1/4 mile than same thing. My temp gauge stopped working and it just seemed to get worse. Stuck it on a scanner and it didn't have any codes but was saying the engine temp was -211f. I got a new sending unit didin't fix any of the problems.
View 14 Replies
I have a 2006 f350 6.0l. I was driving home from work and all of a sudden I had no gas pedal. It would stumble and die with a bunch of white smoke out the tail. It also is not using the turbo at all no boost. I have a edge monitor and the engine codes it's kicking out are in the picture below. I have a warranty but the dealership that we bought it from and the closet ford dealer is 30-40 mins away and they don't currently have a diesel mechanic to work on it so I would have to go almost 1hr 20 mins to get to the next dealer. Will it hurt it to drive it that far?
View 2 Replies
Recently have had a sct live wire extreme on my truck and ever since put it back to stock put the dpf back on its been blowing white smoke got a p2452 and p1335 code but when you turn the tuner back on and turn the dpf off no more white smoke and no codes ? What could be causing this? beyond confused ?? (the reason I took the tuner off is cuz I am sell the truck and the dealership wants it stock),
View 3 Replies
I have an 04 F250, stock. Two times within the last week I have noticed whiteish smoke coming out of the tailpipe and a diesel smell. Could this be the glow plugs going out and not burning the fuel, I have not changed them since owning the truck or something else.
View 14 Replies
During the winter, the truck would always start very hard. When it was trying to start it would pump out some white smoke. Now during the summer the truck will still start hard. At one point during the winter we were getting glow plug codes, now these have gone away that its warm. We did replace the glow plug control module, but that did not solve the hard start during the winter. We figured that there was a bad glow plug which is sorting out the rest. So we then figured the hard start issue would go away with the warmer weather but it has not.
View 3 Replies
I just recently purchased my 06 Ford F-250 it's got the 6.0 in it once I made a 6hr trip I've noticed once you warm it up and ride a little bit kill it let set for 30min or better and crank it up it blows white smoke for a min or two than on the way to work this morning my heater.
View 2 Replies
I have a 2003 F250 that has recently started blowing white smoke. I replaced the EGR Valve but no luck.
View 3 Replies
I have a 03 250 5.4 with 160k. I just recently replaced #4&3 coil packs. Truck was running great again. Then a few days later the truck was running extremely rough and white smoke from the exhaust. I noticed the pcv valve was not all the way in(pretty much out) put it back in and ran fine for two days now running rough every now and then and the pcv valve is making a vibrating noise but stops if I pinch it slightly. I did replace the plugs a year ago.
View 14 Replies
I bought a 2004 6.0L F-250 used a few weeks ago. There have been a few problems here and there that I have been competent enough to fix. I am now facing a problem of A: the truck not starting (I believe it was just a battery problem, charged and started fine). But also B: I have had a slightly frayed serpentine belt that I noticed a few days ago. After I got the truck running from my the no-start and driving it around the block I parked it and went inside. Came back out a few minutes later and I tried to start it. It hesitated a little bit but started with a loud whining noise and white smoke coming from the belt. Turned the engine off and saw on one of the bottom wheels (pulleys?) some residue that looked and smelled like burnt rubber. Is this just simply a need for a new belt?
View 5 Replies
I'm looking to buy a 08 f250. It has 70k miles on it. The guy is running a mini max tuner on it. I did notice on a cold start as soon as he hit the acceleration it had alot of black smoke. Is this normal? And is there anything I should b aware of when looking this truck over.
View 2 Replies
I have a 05 f250 6.0 that currently will not start and no smoke. Replaced batteries and tested ficm. At initial injector buzz voltage drops to 18.8 then jumps back to 48.8 and drops again to 18.8 while cranking. My question is if the voltage is this low does the pcb still just need a resolder or are there components that will need to be replaced?
View 1 Replies
I had a post a couple of months ago about this E350 van I purchased with the 7.3. It would leave me stranded every few weeks and I replaced the injector oil pressure sensor and the camshaft position sensor. This truck has a intermittent running problem that cannot be pinned down to hot or cold.
It runs and idles well but sometimes during acceleration it will start to flatten out and smoke out the exhaust. Giving more accelerator pedal powers through the flat spot and the truck runs smooth. It does not do it every time. It does it hot or cold, wet or dry, city or highway, If this was a gas engine I would be replacing the fuel pump or checking a fuel starvation issue but the white smoke tells me that it has unburned fuel.
A cylinder contribution test passes fine. I monitored engine data with a Snap On Verus pro and compared oil pressures with another 03 7.3 I have and they are too close to the same. It starts fine, no issues there. It may take off great one time and buck and smoke the next. I swapped out the throttle position sensor with the other 7.3 and no change. I swapped out the injector control module and no change.
I've thought about injector Orings but I would think the problem would be consistent. I've changed engine oil, checked fuel pressure, changed fuel filter, and drained the fuel system to be sure no water is in the separator. This engine was rebuilt about 30k miles ago. If you floor the accelerator in park it will rev up, flatten out, smoke and buck for about 2-3 seconds, and then take off like normal. I pulled a trailer with it a couple of days ago and wasn't impressed at all. I have a 6.5 GM that seems to have more power than this.
I thought maybe a sticking injector and I added a half gallon of two cycle oil to the fuel to see if that might work. It hasn't. It just seems like it is flooding at a certain rpm and clears itself after a couple of seconds. There are no codes being thrown in the pcm. I am at a loss.
View 2 Replies
06 6.0
Goes from max to min line on degaus bottle every couple months. No puking or white residue. Going to pull egr tonight and see if damp. Anything else to check besides obvious leaks at hoses/radiator/etc?
View 13 Replies
Nut are they bad for the motor? If so than why do semi's always puff large amounts of smoke? Why do people wire in switches to cut off their turbo, isnt that bad?!
View 6 Replies
