Ford Super Duty (1999-2016) :: No Speedometer / Overdrive Flashes / Fuel Gauge Erratic
May 15, 2016
I'm having an issue on my 2002 F350 7.3. Today I hop in it and drive off I notice my speedometer stopped working. My overdrive light on the shifter started flashing. The trans seems like its not shifting correctly. It will eventually shift into overdrive but not always. Also now when I start off my fuel gauge raises and when I come to a stop it drops all the way to E and causes the ding and fuel light to light up. I figured this was all due to the VSS being bad. So I drove over to Autozone bought another VSS and a cheap tool set and changed it in the parking lot. No dice. I do have a scanner to pull the trans code but its late and I just got home.
View 1 Replies
Advertisement
My dads 05 f250 6.0 PSD. He says he'll take off in the morning and the fuel gauge will randomly drop to empty and trigger the low fuel light, but then also the Check Engine Light will come on. My brother did a code scan and no codes come up. Where we should be looking to remedy this one?
View 14 Replies
I have a 2001 F250, 5.4, 4X4. My ignition key stuck in the start position and when I pulled it back to the run position, everything seemed ok. As I started down the road, my speedometer stopped working and my overdrive light was flashing. Also my turn signals had stopped working and my A/C clutch didn't engage. Figured I burnt a fuse. I looked in both the under dash and power distribution box and all seemed well. I checked the fuse for the turn signals/flasher and it was fine. The flashers worked. Thought I might have fried something so I replaced the ignition lock and switch. Also my service engine light came on throwing a code for the vehicle speed sensor.
Looking for solutions on this forum and the internet, I learned that the turn signal switch could have gone bad and the VSS sensor is on the top of the rear dif and an easy fix. Well replaced the sensor but nothing changed. So I went back to the fuse box. Examined every fuse, big and small and I found a 10a with a small space. This was #24 under the dash. From the manual, "#24, 10A, A/C clutch, Blend Door Actuator, Trailer Tow Battery Charge Relay Coil, Four Wheel Anti-Lock Brake System (4WABS), Turn Signal." Replaced it and everything went back to normal. Turn signals work, A/C clutch works, no flashing overdrive light and speedometer works. All from a 10A fuse. If you have any of these symptoms examine all the fuses carefully. There's a 20A fuse for turn/hazard lamps and this other one buried that's only 10A.
View 1 Replies
When I purchased my truck 1999 F350 about 5 years ago, I was told it was on its third transmission since the awesome 7.3 diesel engine has 200,000 miles on it. At first I noticed that going up a hill with the truck empty would cause the tranny temp gauge to climb to 250 degrees F. Nowadays when I tow my boat or carry my camper, the temp gauge pegs over 250 and the overdrive light flashes steadily when I do any hill climbs. I have had the fluid flushed several times, and I have a large fan powered oil cooler too. I also recently noticed that the tranny heated up when the truck is just idling in place.
I just got back from burning man and during the 800 mile round trip the overdrive light started flashing at least 6 times and the temp gauge read over 210 the whole time, with it pegging over 250 during hill climbs. No fluid boiled out but I am very concerned that damage is being done.
Is it possible there is a clog in a line somehwere restricting the flow of oil? Or should I replace the tranny?
View 14 Replies
Everything was working fine, getting down to about 1/4 tank. I do the usual, fill up, startup, reset the trip, and look at my level and it hasn't changed, neither has the 'km until E'. What would cause this? Failed Sender? No check engine light (yet). I guess I'll be watching the trip meter for a while.
View 8 Replies
2000 v10 f350 single tank...fuel gauge is stuck on full. I'm on the road so I don't have my drawings so I tried some quick troubleshooting. If I remember right 160k or so is full and 20k ohms is empty...so I unplugged the sender from the harness which should be open and the gauge should read empty. With key on its reading full. I then followed the harness and unplugged it near the brake booster...key on it reads full. Just wanted to make sure I'm not doing anything wrong before I rip the dash apart.
View 6 Replies
1999 F250 V10 gas. I changed out the fuel pump, and now the gauge doesn't work. Checked all fuses - they're good. Is there any possibility that I could have accidentally pinned the float under the pickup sock, or got it hung somewhere? Is this a common occurrence? Don't really want to drop the tank again - but looks like I will have to in order to check/fix.....
View 3 Replies
I have a 2000 ford F 250 with V-10 engine with fuel gauge stuck. The problem started in the winter a couple years back on a cold night when I fueled the truck with it running. The fuel gauge never went down. I assume this would indicate a stuck float? I dropped the tank and noticed a loose yellow wire. I can't see that the wire was attached anywhere though? A V-10 is not the engine to be guessing with on fuel...
View 1 Replies
On my 05 Super Duty, the gauge light for the fuel and oil pressure are out. The needles are still illuminated red but the backlight for the gauges are dark. Are these replaceable bulbs or are they a circuit board diode or something that can't be easily replaced?
View 1 Replies
Ever since January My fuel gauge has been acting up big time. I can have any amount of gas in my tank at any given time and the fuel gauge will fall to empty resulting in the fuel and check engine light coming on. The gauge will then return to its position (it still doesn't read correctly) and the check engine light will stay on. I took it to the ford dealer and they said to replace the entire fuel sending unit assembly. I bought the oem motorcraft fuel sending unit assembly and did it myself. The only problem is, I still have the issue. I'm currently checking fuses and relays, By the way, my truck is a 2004 f250 fx4 5.4
View 2 Replies
Yesterday went to fill up ($4.05 a gallon geezz!) and noticed that after getting back into the cab, the fuel gauge still showed almost empty. So after yelling a few expletives, I looked again and noticed the gauge starting to make it's way up the dial. It took almost 30 min. before it showed almost full. I'm not sure what the problem is, as the gauge seems to still function. I don't drive the truck much as I use it as a tow vehicle. However, I do try and take it for a spin about 3-4 times a month just to exercise it. I was wondering if the fuel has started to gel and that is the reason for the slow fuel gauge response. Should I add a fuel conditioner/cleaner now that I have a full tank?
View 9 Replies
I have an 03 f350 4x4 cc long bed and I seem to be having a problem with my fuel gauge. It doesn't show the true amount of what's in the tank and because of that I have run out of fuel a few times.
sometimes when I'm driving the light will come on and the gauge will drop all the way to empty then a little later it will go to almost full even with only putting 10 gals in the tank.
Any fix for this or do I need to replace the sending unit?
View 3 Replies
I have a 2001 f250 with the 5.4. from what I have read i should have the 38 gallon tank. i have been really questioning the accuracy of my fuel gauge on empty with the light on 25 gallons and the fuel pump will click off and after i drive i can park and my fuel gauge will read lower than what it was when i pulled into the driveway with. me and the wife went driving yesterday and we pulled back into the driveway on half a tank this morning I went to go run some errands and when i started the truck the gauge was almost on a quarter of a tank my driveway is flat and after driving for about 35 minutes the gauge was still in the same spot and did not move up nor down.
I have a locking gas cap cover so i know someone is not taking gas out. I have changed the fuel filter and tried numerous different fuel system cleaners to try and see if maybe the contacts on the float in the tank are dirty nothing has changed or gotten any better. I have checked the wire harness from the top of the tank and followed it up under the hood and found no drop in voltage or cracked or damaged wires. I checked with my multi-meter I used my fluke meter not some cheap one. Don't know if the gauge is reading less or more from getting gas i am thinking it is showing less than what is in the tank. What could be my problem?
View 3 Replies
I have 03 F-250 with a 5.4 in it. Recently noticed the gas gauge is not moving much and seems like it will not go below half a tank. The gauge will go up however when i put gas in it. I just put techtron in it last night to see if this might work. Wasn't to sure if i did a battery reset on the truck if that may work as well.
View 2 Replies
I just replaced my fuel pump to avoid another tow truck ride and now my fuel gauge is off. I filled up the truck today and the fuel gauge is only showing half a tank. I turned the truck on and off several times to try to reset it, but that didn't work.
Truck is a 2003 with the 5.4.
View 1 Replies
As I was driving to work yesterday I noticed my fuel gauge going from half tank all the way to full going down the highway. I started looking at the rest and they seem to be in there normal spots. I looked up and watched the outside temp go from 40 degrees to 5. This morning the fuel gauge goes straight to full and the outside temp bounces between 2 degrees and 10. What may be going on to cause this?
The truck is a 2000 F350 crew cab with a 7.3 Power Stroke
View 3 Replies
Recently had extensive work done on my 2005 F250 PSD. 4 injectors replaced, fuel regulator, and STC fitting on HPOP.
Got the truck back, and the fuel gauge, and "distance to E" display are working intermittently.
When the truck went in for repair, it was about 1/8 tank. After repairs, shop put about 30 miles on the truck.
I picked it up, and the gauge read E, and display said 0 kms to E. I filled the truck up, and the gauge still read E, and said 0 kms to E.
I then drove for a while, then powered down, and back up again, and gauge read below E (like when truck not running), and display had 4 dashes...no numbers, for distance to E. I powered down, and then back up, then it read 696 kms to E, and gauge working normally.
This morning, on a cold start, the 4 dashes, and empty reading returned. I shut off truck, and restarted it, and it started working again.
Could the shop have damaged the sending unit, while driving 30 miles, with so little diesel in the tank?
View 5 Replies
I have a 2003 F250, 4x4, 5.4L and today my fuel gauge stopped working. I don't know if it had anything to do with a stall, I was on an exit ramp and the truck cut off, I quickly restarted and no issues after that. Other than the fuel gauge not working at this point.
I looked at the fuse panel diagram and there is no fuse for just the fuel gauge. The only thing I see is #35, instrument cluster. The rest of my instruments are working, so what else would cause the fuel gauge to stop working? It had a little over a half of a tank before the stall, after the stall it went down to less than half. I filled up shortly later and it's just stuck at less than half.
View 1 Replies
Got to work this morning, sitting at idle for a few minutes in parking lot, all of a sudden fuel gauge needle drops to below 'E' and the fuel light comes on and beeps. I know I have at least 1/2 tank of fuel. What would cause this?
View 3 Replies
2003 F 350 gauge indicates water in fuel. Second hand truck, the hex socket in the plug has be rounded out. Removing plug
View 1 Replies
177,000 miles, fuel pump was replaced just before I purchased it a few weeks ago. Truck has been running like new until today when it started doing this completely out of the blue. If you watch the video, the sound is not off, the tach is moving independently of the sound of the actual revs. Occasionally when doing this, the fuel gauge drops to zero. Thinking this is an electrical issue somewhere.
YouTube.....
View 14 Replies
