Ford Super Duty (1999-2016) :: Low Power On Take Off / Shudders / Poor Shift Point?
Jun 19, 2017
hey there, new to your forum , been reading alot here , i have a 1999 f 250 super duty, frame was rotted, so i found a 2003 frame with motor , trans , transfer case & both axles , put my cab on it with the 1999 pcm , having trouble with low power on take off , shudders , poor shift points , at highway speeds , turn signal on , the speedometer will pulse same as blinkers, new head gaskets , timing chains , replaced trans with the old 1999.
View 7 Replies
Advertisement
I blew 2 fuses the other night, one in my power point and one in my lighter. I was using my ipod in the lighter and my beacon light outta the powerpoint. i changed them both (20 amp) and the lighter is fine but the power point keeps popping. What the problem might be? I would take it right to ford but unfortunately my warranty expired 9 days ago...
View 12 Replies
I have a 6.0L diesel that is not a daily driver so it sits for days and even weeks at a time. When I go to start it the batteries will be run down to the point that sometimes the truck will not start and I will need to charge the batteries. I was thinking about installing a battery tender and leaving it plugged in so the batteries will stay charged. I'm looking at the tender in the link.
View 14 Replies
When pulling my trailer away from a stop transmission shudders in first gear, feels like t c. Once it changes to 2nd, it clears up. Getting ready to take in for service. Any thoughts? Still under bumper to bumper warrenty. 2008 6.4 auto f 350. 26k miles
View 4 Replies
My 04 F350 has a bad shudder when slowing down between 30 and 10 MPH. Not so noticeable at other speeds and almost nothing while speeding up. How to fix?
View 1 Replies
My friend has a F250. He was getting terrible mileage and the mechanic he took it to replaced the intake gaskets. After that the mileage went to 12 and he was happy. Now its down to 6-8, just highway. It seems to me the throttle response is terrible compared to my dad's 01 V10. And it sounds terrible. Exhaust manifolds aren't leaking that I see.
I've got AE and have hooked it up, but I'm really not very familiar with these trucks. I don't get any codes that would relate to anything. Had one trans sensor code but that was about it. Key on engine running test didn't say anything.
View 5 Replies
I have an 02 F250 V10. Ive always wondered about the transmission gauge. It seems to always point to the middle of the gauge range. This weekend I was pulling my car hauler up and over the Ozark mountains, and when I stopped for fuel I noticed the transmission was vomiting fluid underneath the truck (and on my exhaust creating a nice smoke bomb for everyone around me). The gauge indicated normal temps. It kind of gave me a sick feeling. I have ordered the 6.0 Trans cooler from Rock Auto and a new temperature sending unit. Do the trans temp gauge is supposed to move or is it pretty much useless?
View 14 Replies
I have an '04 EX with 6.0. When braking at highway speeds the rear end shudders until I get the truck slowed down some. Around town speeds of 45 or less the problem is almost non-existent. It almost seems to be hydraulic instead of pads/rotor issue. Wouldn't a warped rotor show up at slower speeds as well? I have some good mechanics around, but have never found a great brake shop that I can trust. Go in needing pads and they try and upsell saying this or that is going out.
View 9 Replies
I have the factory keyless entry on my '03 F-250 SuperCab. I have always had to be within about 5'-8' of my cab to get the doors to lock/unlock. I thought it was normal for the longest time, but recently learned it's not. I am out of warranty now so I need to try and fix this myself. What is the location of the receiver module, and what it looks like? Also, is there an external antenna w/ the factory keyless entry, and where is it at? Transmitters are fine, as is battery power. Only think it could be is receiver/antenna.
View 14 Replies
It's a 1999 f250sd 5.4l auto. Has code p1747. Truck shudders and almost dies when you drop it in gear, put it back in park idles fine. I have read all the post on here about this and checked wires from trans up to pcm look and test well. Tested plug c1048 wires with the digital meter to body ground with battery unhooked and got 6.66k ohms on pin 11 circuit 925, 421 ohms pins 1 and 12. Plugged c1048 back to trans checked 925 w/y wire at plug c103 got 9.1 ohms back to trans. Is the EPC solenoid bad or is it pcm? I think its epc but want to verify before i take trans apart.
View 2 Replies
250 2006 Superduty v10. Codes p2106 and p2135 ... Only occasionally when coming to a stop it shudders like it would stall. It happens for just a few seconds then ok again but wrench light comes on. After the next shut off and start the light goes out. I had the throttle control position sensor checked and they said it was ok. Got a software update at Ford. I hate to just start replacing expensive parts. I have about 60000 miles and it is a great truck otherwise.
View 1 Replies
So I have a 2004 F250 5.4 regular cab 4wd long bed that was bought used with a very heavy Western Pro plow. The truck only has 70K miles and it is equipped with the snow plow package and heavy GVWR package. Since I had no use for the plow, I removed it and all mounting hardware as soon as I got it home. The truck wanders and bounces down the road terribly.
It is tiring to drive and requires total attention. Reading posts on here about "wandering" left me thinking my steering box was probably worn out. I replaced this without any change. I figured that I must have other components needing fixed, but had not had time or money to dig deeper yet.
Now, this morning when leaving work, the truck had accumulated nearly an inch of very heavy, wet snow with a small layer of ice on the hood. Driving home was as if I were in another vehicle. Everything was tight and much less "hopping" when hitting small bumps. So, this leads me to my question. Do you think that simply adding some weight back to the front end, i.e.,: bumper, or brush guard, could be my answer? Or, is this simply covering up a more extensive problem?
View 10 Replies
Its a 1999 f250sd 5.4l auto. Has code p1747. Truck shudders and almost dies when you drop it in gear, put it back in park idles fine. I have read all the post on here about this and checked wires from trans up to pcm look and test good. Tested plug c1048 wires with digital meter to body ground with battery unhooked and got 6.66k ohms on pin 11 circuit 925, 421 ohms pins 1 and 12. Plugged c1048 back to trans checked 925 w/y wire at plug c103 got 9.1 ohms back to trans. Is the epc solenoid bad or is it pcm. I think its epc but want to verify before i take trans apart.
View 3 Replies
My 2010 F350 shudders when turning right. From what I read it could be the auto locking hubs not dis-engaging or sticking in the locked position. Tutorials show it's pretty easy to pull the auto locking Hub out taking out the three screws holding it in place. My questions is what type of grease do I need to apply to the auto locking hub once I have them out and determine that is what the issue is?
View 13 Replies
I have a 03 f 350 6.0. My 4x4 wont engage. I checked my fuses all are good except 31 no power. Is this the culprit?. I get power at the 6pin pig tail on shift motor, but the 2pin pig tail doesn't get any power at all. I pulled shift motor off manually put power on it and it works. I also replaced both 30amp relays under hood...
View 1 Replies
My 2000 SD 7.3 has developed a quirk. For some reason the trans has decided to shift late in all gears. This only happens once, then resumes shifting normally. However the OD indicator on the shifter blinks from that point forward. Once the engine is shut down and restarted. The sequence starts again. Late shift, through the gears, once, then shifts normally with light blinking. Fluids are up and clean.
View 4 Replies
I have a hard shift between 2-3 that is somewhat violent. It doesn't matter the rpms or how hard I'm accelerating, it will always do it. At wot, it sometimes throws a code that stays on for a few minutes, then goes away. When I hook up a code reader, it shows no record of it and it never throws a blinking OD light ever.
It has an ATS transmission, but I don't know how the controller works, if it is wired correctly, or if it could even cause this issue. Currently the truck has 210k and unknown on ATS.
View 2 Replies
So it appears as though my shift lever (automatic) will not shift into the 1st gear position? However when I drive the vehicle, the transmission seems to shift through 4 gears, then into Overdrive? What could be the issue?
View 3 Replies
I have a 2003 F350 Super Duty 6.0 L with the dash mounted 2H-4H-4L switch. I was using 4wd and the light went out by itself and now I cannot shift it out of 4wd. Fuse 31 has no power to it, and the drivers book says it is the fuse for 4x4. Where the power for that fuse comes from? There is no power to the switch as well, of course.
View 5 Replies
2004 Excursion 6.0... What might be cause of my "shift on fly" 4x4 not working? No lights on dash, no mechanical noise, fuse appears Ok.
View 3 Replies
My 05 superduty is in the shop because it won't shift in or out of 4Hi. Ford garage says I need a new transfer case shift motor, and 4wheel drive module. They said the shift motor was full of oil. I am not really up to speed on how the shift motor works, other than it bolts externally to the transfer case, that's why it confuses me about the shift motor being saturated with oil. My truck has never leaked even a drop of any type oil, ever.
View 6 Replies
