Ford Super Duty (1999-2016) :: Loud Spinning Sound When Driving Down The Road
May 8, 2014
I have a 2004 Ford f250 6.0. When driving it down the road i will hear a loud spinning sound, sorta like putting a playing card in your bicycle spokes. The sound can be heard until I make a complete stop where at that time the sound stops and a clunk can be felt. After that the truck sounds normal. This also only happens once between starting the truck and turning it off. I took it into the shop and they could not hear the sound, all they said is i need new ball joints.
View 6 Replies
Advertisement
01 F350...4R100/V-10/4wd. Sometimes get a vibration driving down the road. First thought of tire out of balance but then the vibration goes away and may not come back for a few days or more. It starts sometimes around 30-40 mph and stays all the way up to around 65 mph. Even slowing down it vibrates or shakes. I can stop and take off again with nothing happening. Would think tires out of balance would do it all the time. And a few times....pulling my 5th wheel...making a right turn out of a parking lot.....it feels like a rumble from the rear.
View 2 Replies
While driving down the road the truck will just cut off. We wait a few mins and start it again can drive a few miles and it cuts off again. we have replaced the ignition coils and it is still doing this. No codes are coming up to get any idea what it can be?
View 14 Replies
A few weeks ago, my employees were driving home one of my work trucks, a 2001 F350 7.3 4x4 Crew w. 130K miles. They were on a straight road in a small town when the steering went completely out. The truck veered into a telephone pole. No one was injured. The truck has major damage to the front passenger's side.
I finally got the truck back to my shop today. It is quite evident what caused the problem. The gear/splined shaft that protrudes from the steering box and is connected to the pitman arm sheared completely off.
View 14 Replies
2004 F-250. 6.0 I was driving down the road when the engine dies. It was like I had turned off the key. When I tried to restart it, it was no click, no starter sound, nothing. The glow plug light remained on, even while turning the key over. What could cause this?
View 10 Replies
I have a 99' f250 I purchased a few months ago. Here's what happened. Today I was driving down the road and it started to surge. I pulled over and shut the truck off. When I went to start it, the motor turned over slow for a sec and then clicked. When I put a jump pack to it, it fired up. I took it home with the jumper still hooked to it and checked voltage. The alternator was throwing 33.4 volts!! I went to the auto parts store and bought a new battery and alternator. Now the battery shows 11.7 volts steady. The alternator still reads 33.4. Also, if I unplug the positive lead while it's running, the truck shuts off. And one more thing. If the key is off and I reconnect the positive lead, I can hear the fuel rail pressurize. What is going on? I hate electrical gremlins.
View 6 Replies
1999 5.4 ... I was just driving down road and truck suddenly wouldnt shift into overdrive/higher gear. pulled to side of road and the motor was revving very high at 2500 rpm. shut truck off and on a few times...kept doing it until finally after a while it went back to normal....
View 1 Replies
I have a 2004 6.0 133000 miles will be driving down the road will start to hesitate and looses powers and shuts off. wont start back up but if you wait 10 to 15 minutes will start up and run just fine. wont do it again. Just had new head studs put in new head gasket and egr delete 2 new injectors put in
View 3 Replies
Have a 06 f350 just rebuilt the engine. Started up ran it down the road a couple miles and lost low side oil pressure. Got back to the house and will not start again so put a gauge on and it only has 3 lbs after cranking for 10-15 sec. Pulled the balancer and lpop cover and front cover had some deeper scoring then before. No noticeable stuff in the pan or filter. Changed out the front cover and lpop. Still has only about 5 psi.
View 3 Replies
I've been tracking down all sorts of issues in my Excursion 4x4 lately and I have a few questions. I have an issue where everything is spinning as I drive even in 2wd. I gutted my hubs and removed the driveshaft. I had new u joints put in the front shaft today and re installed it. I still have the same issue of everything spinning while driving in 2. I had my marks move with the shaft in or out. I assume its getting toward front axle joint time. The shop owner said there should not be any movement in 2 but every SD I've seen has the axles spinning driving around town. I'm just confused because I have the entire driver side axle move when I spin the shaft by hand.
View 11 Replies
Picked up a new to me 2011 F250 Lariat. She had a few odds and ends to take care of, but I was ok with that. So far I fixed the reverse sensors (2 were out) creaking in the back (leaf spring bushings needed a little Lithium Grease) Squeak in the back (tailgate step needed a little greasing). Now on to my next problem!
This is my first 6.2l (first f250 in general). Truck starts up great and idles quite. Taking off driving, it sounds loud as hell under the hood. To me it sounds like the Fan is making a loud sound as the motor is accelerating. It is more noticeable when you really floor it. Prior to this I owned a 2010 F150 and I know stomping on it the motor really revs up, but this other sound to me isn't right/normal. Googling around, the closest I found to it was:
Loud "Air" Sound Upon Accelerating 2002 FORD EXPEDITION - fan clutch! - YouTube
Granted it's for an expedition, but the sound is damn near identical. Looking on youtube at 1 or 2 videos of a f250 doing a 0-60 all I heard was the sound of the motor revving, so that has me convinced the sound I'm hearing is not normal. I'm 99% convinced it has to be the fan clutch.
View 8 Replies
Truck details:
2008 f350 6.4 290,000 klm
DPF and full EGR delete
K&N intake
IDP custom street tune
Loud squealing noise that happens when cold or at temp.
2000 to 2500 rpm's to 3000 rpm then it goes away
Happens only when accelerating over 50% anything under and the noise doesn't happen.
15 to 20 pounds of boost
Turbo sounds good
No codes
All plumbing looks sealed and tight
Fuel coolant res is full and clean
I'm thinking it could be the lift pump dying or having trouble supplying the fuel demand. Started after I did the cold air intake....
View 8 Replies
The Truck: 2011, 250, 4x4, Super Cab, 6' box, 6.2 with 6R140, currently 40K miles. It did have an 8' plow on it. An 80 year old gent plowed his personal 200' driveway with it for 2 winters before I bought it. You can tell the truck was taken care of, or I wouldn't have purchased it. I have all the service records. He had his local dealer do all of it. Plow and all the controls were removed prior to my purchase.
Scenario: Trucks cold (summer ambient). Driveway has a grade down to road. Doesn't matter if I am nosed or backed in. Start up, back/pull out of driveway on to flat road, and very slowly take off. The 1-2 shift produces a lose thunk sound and sensation, very faint not loud. Almost Like a lose motor mount. Only will do it once, only on the first start and 1-2 upshift. Ive tried to reproduce it after the first occurrence, no luck. If you gas it under the same circumstances it wont do it.
It doesn't necessarily feel like an internal trans problem. More of a "somethings just lose enough to shift or move" problem. Sounds like somethings hitting the frame, core support, cab floor on this slow 1-2 up-shift. Its upfront passenger side. I've spent several hours under it looking for lose items witness rub marks etc...to no avail
Again it only does it after it sits or upon the first start in the AM or when leaving work PM. Not when its warm.
View 14 Replies
I have a 2003 Ford F450 super duty xl. At first there was a loud clicking sound coming from under my dash. I charged the battery up and the sound went away but the truck will fire up but not turn over and start. I thought maybe it could be the relays but the clicking sound quit.
View 2 Replies
After the hard downshifting full throttle highway run low speed stomp on it freeway cruising tires spinning on gravel crawling through town day yesterday -
my tranny just doesn't know what to do!! One thing that it does like to do is make that 6.2 spin and sing! Eventually we'll be on the same page so we can work and play seamlessly.
View 14 Replies
With the tranny in neutral and clutch out is when it is the loudest. With the clutch in their is 0 noise. The sound is a spinning clacketing sound best I can describe. The clutch is 2yrs old and was installed by a local shop using all OEM parts, the fluid level is perfect and looks brand new. The sound has come on gradually over the past 6 months but now can be felt thru the floor at the top of the gears as a rumble. The funny thing is that their are no performance issues like grinding,popping out of gear,hard shifting,etc.
This is not rolling gear mesh it is very loud clacking clunking sound coming directly from the tranny, not the transfer case, nor rears or u joints. This is standing still. Sometimes it will be a little less loud if I roll to a stop in neutral with the clutch out as opposed to gearing down to a stop push clutch in goto neutral and letting clutch out.
View 6 Replies
What will make a loud blower sound cycle on and off constantly when towing if i turn the ac off it stops....
View 7 Replies
We have a lot of snow and a lot of ice up here at the moment and my 2003 ford F-250 SC Fx4 isn't performing so well. The truck is stock other than a pair of 285/16R BFG A/T's
I have been noticing that my rear tires will spin while trying to go up hill on some ice or snow covered areas and my front tires just sit still while in 4x4 or 4x4 low. In the case I just described I remain stuck in place until the rear tires can get a grip then I continue up hill. I don't understand why my front tires are not spinning as well, to me this seems just like 2 wheel drive not 4x4. I have been using ESOF most of the time. I have mentioned in other threads that I do plan on upgrading to warn premium hubs, but I am wondering if its that my truck isnt actually shifting into 4x4 or if there is a reason why even in 4x4 my rear tires would spin while my front tires do not?
I am confused because when I shift on the fly while driving I can feel the 4x4 kick in because it just feels different than driving with 2 wheel drive, but then something like I described will happen and I start second guessing myself. What might be happening? It's not that I am opposed to switching to the warn premium hubs, but is that actually going to fix this issue or is my truck acting normally??
View 13 Replies
I have a 2008 F250 XLT. When i am driving and turn the wheel a squeak is noticeable while the tire is spinning. as i speed up the squeak gets faster and slower when i slow down. I have it narrowed down to the right front tire but cant figure out what is causing it.
View 5 Replies
Yesterday I was parked on an incline with my front wheels on gravel and the rear wheels on wet grass/mud. When I tried to go, the rear wheels started spinning. I then switched on the low 4x4, and tried to go. The rear wheels continued to spin, but the front did not turn. I had new wheels installed, that has a cap that covers the manual locking hub, so I couldn't turn it to lock the hub. What should I look for to fix the problem?
2007 F250 4X4 Larriat SRW
View 2 Replies
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 Replies
