Ford Super Duty (1999-2016) :: Lost Cruise Control And Horn After Replacing Steering Box
Feb 8, 2014
So i was replacing my power steering box after the shaft broke on it and apparently i didn't have my steering wheel back to exact center. after putting everything back together and started to drive down the road a very thin flat wiring harness broke and got tangled around my steering column under the plastics of the column. I then lost my horn and my cruise control and i believe my airbag. I pulled the wiring harness out and it was very long with two white plugs on either end. I'm not sure what this part is called or where i would be able to buy another one. And if there's some kind of instructions on how or where this harness plugs into sense it was ripped out.
2000 ford f-350 lariat 7.3l diesel....
View 6 Replies
Advertisement
I have a 2001 F-250 SD XLT with the ABS light on, cruise control doesnt work and the horn only works with the key out. The codes for the ABS is no signal input from the left and right front wheel sensors. No problem there. Also my speedo stops or jumps when I press the horn button while driving down the road. When I quit pressing the horn button the speedo works fine. So after looking over the posts on cruise control, etc. Does the rear speed sensor have anything to do with the cruise, horn not working? All fuses are good so I am thinking the cruise control switch on the master cylinder or a short in the steering wheel column or my ignition switch. What do you all think?
View 7 Replies
I have a 2002 f350 my horn went off in the middle of the night got up and unplugged the horn what is my problem. also, the cruise control won't work when it all happened
View 3 Replies
Been searching but can't find a clue. I replaced my steering gear box. Went fine, but after starting back up. My alarm goes off, my cruise or horn doesn't work and my air bag is giving a code 32.
Is there a ground wire or something I could of missed when installing the gear box?
View 3 Replies
I'm having trouble with my '99 F-350 7.3L 4X4. One day, my power windows, cruise, dome light, horn, wipers, and 4 wheel drive stopped working. After checking all of the fuses, I have found no bad ones.
View 3 Replies
02 E450 Super Duty V10, C class a motorhome, 29000 miles. Cruise stopped working a month or so back. I searched this forum and managed to fix it with the info provided. It turned out to be the pressure switch on the master cylinder, the recall had been done. I replaced the pressure switch and the harness with an aftermarket one from the local auto parts store. It worked well for about 200 miles, it knocked off again on our road trip last week. It was working on the road and we stopped for breakfast and it didn't come on again, no light in the dash or anything.
When I ran the internal diagnostics on the first repair all the lights would flash when the buttons were pressed and the servo would cycle through at the end of the test as it should, based on the diagnostic instructions. This time when I run the diagnostic test the light will flash when I first turn the switch on (holding the off button down) and when I push the on the button but will not flash when I press the other 3 buttons.
I have not been able to find a wiring diagram for this particular truck, I've found 6 or so but none of them match my fuse boxes under the hood and dash.
I have no trouble lights on in the dash CEL or ABS. I'm at a loss what direction to take from here.
View 1 Replies
I have a newer 2012 f250 that i souls like to disable cruise control on, can this be done with auto ingenuity, our will the dealer have to do it with ids?
View 3 Replies
New problem with my 99 f-250 superduty supercab 4x4. Cruise control does not work. Checked all fuses and all are good. No cruise light or speed cont light . Where do I start? What do I need to look for? Where do I look?
View 4 Replies
I've got a '08 F250 XLT that the cruise control has become intermittent. It works most of the time but at times it will "go out to lunch" and not do anything. I've taken the controls from the wheel and didn't see any gummed up coke spills or anything there. It may not be anything but twice when it failed while on a trip I pulled over and shut the truck down. Started it up and the cruise would go back to working. Once I did this and it went back to working only to shut off in about 2 seconds but I was able to engage it again and it kept working. When it stops working there is no green indicator on the dash either.
View 9 Replies
My 1999 SD was originally a Work Truck without cruise. I'd like to add cruise of some sort (factory or after market), but also trying to keep the cost and difficulty factors low.
Have any of you SD drivers ever done this and if so, what you went through?
View 9 Replies
Suddenly my cruise control dropped out. With some investigation I'm pretty sure it's that sensor or switch stuck to on position. Brake light is on. Checked the brake system and everything works well. Fluid is full all 4 pads replaced 2 days ago. Plenty brake power.
The question is: how can I bypass that switch to get my cruise control back? I see 4 wires coming out of the switch: red, blue, green, red/orange, green/purple. How do I do it?
View 5 Replies
I have just replaced the EGR cooler, Oil Cooler, professional turbo reconditioning, both dummy plug's and stand-pipe's, blue spring, fuel filters, oil changed, cleaned the EGR valve and intake manifold. I am in the process of doing a coolant flush when my issue occurred. I was on the road for about 10 minutes when I lost power and started blowing black smoke. I have normal power till about 45 mph then nothing. I can baby the truck up to 55-60 and then nothing and the whole time blowing black smoke.
I stomp on the pedal with no power. I hear the whine of the turbo. The truck idles and sounds fine. My SCT showed my oil and coolant temps within 15 degrees. I opened the hood and saw soot all over the top of the engine from the compressor to the EGR valve and all in the valley from valve cover to valve cover; but more so on the driver side to FICM. I obviously didn't connect something properly. I am just about to remove the intake manifold and reinstall, but before I do just wanted some input.
View 3 Replies
My father's truck is still having power steering issues. After replacing the power steering pump I went from no power steering to power steering when I turn right but not when I turn left. So now I'm going to replace the Steering Gear Box. Where I can get step by step instructions on the best way to get to the gear box and how to get it out?
View 1 Replies
Just noticed today that my cruise control on/off button is sticking. Push to off it stays pushed off, push it up to on and it stays up so i must physically center it myself. Is there a way to remove the button and take it apart to clean and regrease the contacts so it doesnt stick? Kinda dumb actually since i might have used it eight or ten times since buying the truck new....
View 2 Replies
2010 f250 cc 5.4 145000 miles. I bought it last fall have not drove it a lot. When using the cruise control and a load is added grade or hill in the roadway. It jerks hesitates or miss then cleans up and runs fine. When using the accelerator it does not do this. No codes.... Thinking about changing the plugs.
View 5 Replies
Just bought the 03 listed in my signature line, and I just found out that the cruise control isn't working, so started trying to troubleshoot anything obvious.
When I switch it on, I get no cluster light that the manual shows to be to the right of the brake light. When I turn the key to run, it never lights up, so am guessing the bulb is bad.
Can't see how a bad bulb would keep the system from activating, so am thinking I have bigger issues. I pulled the fuse panel, but the manual does not have a listing for speed control. Which fuse it is combined into?
Also need the skinny on how to change the bulb. Can I reach my hand behind there? does the cluster have to come out?
Last question. What is the most likely culprit for non functioning cruise? A module? Perhaps the switch in the steering wheel?
View 14 Replies
Our cruise isn't working, I've read through the posts here and tried a few things
2000 F-250 V-10
-First symptom was the cruise light would light with the ON button and go off with the OFF button but I could not set the speed with the SET button. Now the cruise light hardly comes on at all any more.
- I've run the cruise self-test diagnostics and all the switch presses passed with no additional light blinks. After the static test the speed control servo makes a sound but does not move the throttle at all.
-The horn works
-Fuses are good
-Truck was taken to the dealer several years back for the cruise update. The pigtail with the green label is installed at the master cylinder. I've disconnected both connections and sprayed with contact cleaner.
That's about it. What it could be or what to test next?
View 10 Replies
I was driving home from school last week and noticed my cruise control would stay set for 5 minutes or so, then slowly (over several minutes) lose speed. I've noticed it happen before, but very infrequently and usually if I stopped to use the restroom, when I started the truck back up it was fine. This time it continued to happen.
As I was getting nearer to home, I noticed that while I had the cruise set, I would hear a high squeaking noise in the dash almost dead center under the radio. Then , when I would tap the brakes, there would be a rattle. This would only happen with the cruise set.
Noise in dash - YouTube
Not sure how well the squeak can be heard, but the rattle is definitely audible. What the cause might be? Electrical, mechanical, are the cruise and the noise even related? Other than that, the truck seems to be running alright.
View 4 Replies
Just picked up a 99 F-350 V-10 today. Decently clean, works well. It'll be an occasional tow vehicle for hauling my car to car shows.
Anyhow, on the way home, I couldn't get the cruise control to work. I've read about the brake pressure switch problem before joining today. I can hit the on button and set it, and the cruise indicator lights up in the dash and will stay on, but will not hold the speed.
From what I've read, I can't seem to determine if the brake pressure switch will allow the light to come on or not. Should I be looking elsewhere for the problem?
Next fix - overhead console. That one seems simple.
View 4 Replies
I have a 2005 f350 lariat 6.0. My horn, cruise volume, heat and fan controls on the wheel are not working. The airbag light isn't on. I am thinking that it's the clock spring. The stereo controls were intermittent for a while so I think it's the clock spring. I just want to be sure. Anything I could check?
View 2 Replies
1999 F250.. What would cause my cruise control to work sometimes and not others. it may work today and not tomorrow.
View 2 Replies
