I put in the X codes and it doesn't show. The icon is on the screen but no reading for temp shows up. The truck is a 2008 with the 3V V10. Maybe verify the codes for me?
View 6 RepliesI have noticed that in the past 1-2 months my trans probably has just get to 150*. Even on warm/hot days. Lately its just been 120-140 all day every day.
Can this cause any problems? It used to go up to 150-170 when warm, now it takes a hot day to get there.
I assume its fine, but just checking because I have, admittedly, neglected my trans fluid.
I have a 16 with a 6.2. Truck has less than 1k on it but the tranny seems to run hot. What do these run at?
View 10 RepliesI recently purchased a ScanGuage II and installed it in our '09 F-250 SD 5.4 slush-a-matic with 4.30's and 31 1/2" tires. This unit is primarily used for towing and I wanted to keep an eye on the trans fluid temp. By the way, I really like the ScanGuage II. It gives me real time fuel mileage, coolant temp and accurate trans fluid temp, among many other things.
My question for you guys that pull your trucks hard on a regular basis is this, what is the maximum trans fluid temp that I should allow the slush-a-matic to rise to? I towed our 9000# 5ver 200 miles one way to Indy for the 500 over Memorial Day weekend and the highest TFT was around 180 to 185 max. It was under 180 most of the time.
What are the upper parameters of TFT that his tranny will endure and still live a long trouble free life?
I was wondering what is the normal range of trans temp in this truck? I was driving home last night and after a couple burst of wot , getting on the freeway, I checked the info display and it showed 200 degrees for Trans fluid. Truck was unloaded with 80 degree Temps.Also I guess how accurate is the dash Guage? does this seem like higher than normal Temps? 15 f350 cc sb 11 k miles ,gas motor. i aslo drove another couple miles coasting around and the temp never dropped past 196 .
View 4 RepliesI have noticed my trans temp gauge needle is dead center of the gauge even on a cold start. I thought my sensor was under the pan so I pulled it and did not see any sensor at all. Is there a external sensor?
View 5 RepliesThe trans temp guage on my '08 F-350. V-10 started acting erratically, and the wrench icon popped up on the display. i crawled under the truck to look for the sending unit and it's lead. i assume that i found the lead. it is encased in a corrugated sleeve, and appears to be a vaccuum type tube and boot connector? the boot still had a small round gray cap plugged into it. it appears that the cap was never glued (go figure) upon assembly. i have tried to reach up on top of the trans to find the sending unit to figure out the best angle of attack. i can barely touch it with the tip of my finger. going with mechanical guages is out of the question at the moment, so i'm wondering can it be driven any distance this way, AND any schmooze tricks developed to get at the sucker without dropping the cross member or exhaust????
View 3 RepliesI have an isspro sensor that I need to install on my 4r100. I have it all installed except for the actual sending unit. My question is where is the best place to put it?
I've watched multiple YouTube videos and it seems a lot of people use the test port on the driver side above the linkage. I found out the hard way that it is a very poor choice of location. A lot of people say that the best way is to drop the pan drill a hole and weld in the bung? I was wondering would it be possible to put it on the "out" line on the transmission oil headed to the cooler? 01 f-350 7.3
I replaced the sensor on top of the water pump and the gauge still doesn't work. I tested the gauge by unplugging and grounding out the wire and the gauge goes all the way up. What I can try next. I didn't get a Motorcraft sensor so I'm going to go get one of those tomorrow hoping the duralast wasn't correct even though it looked 98 percent identical to the original. 7.3 lite diesel.
View 1 RepliesI have an '06 F350 dually with a 6.0 diesel. I bought this used about 5 years ago and for the most part have loved it. i would always smile on the inside when i heard people bash the 6.0...i thought i got lucky....until today.
140k miles. recent oil change. all is swell...until this morning. Stick in key and turn it. glow plug indicator comes on...all lights come on for a few second....wrench, abs, dtc etc....wrench shuts off...glow plug light comes on...4 or 5 seconds later wrench light comes back on....turn key and NO CRANK.
All fuses are fine...starter cranks if i jump the solenoid...but it won't start. Miles to empty and everything else is just dashes hit the OBD and it says "engine sensor data error"/ "trans temp error" ...
My CC display shows all icons on the right regardless of settings (see pic). The temperature setting and outside temp will not come on.
The second issue is that my front blower starts to lose velocity and sounds strange on long road trips.
My tranny only goes to 3rd gear in 4x4 lo is that normal? 2014 6.2 xl f250 ....
View 14 Repliesfirst heard it a few weeks ago after the wind storm hit us here in nj, my girlfriends grandmother has her fifty foot pine tree rip out of the ground in her front yard. since it was only thirty feet from the street. I said hell ill drag this sucker to the road and cut it up there instead of dragging everything by hand. I figured 4wd high was good (don't know how heavy a pine tree this sized weighs) and I hooked the tow strap to the tree trunk and started to pull. first 4wd high was struggling but the real problem was this high pitch howling i was hearing, went about ten feet and the noise started to bother me, so I stopped and put the truck in 4low the noise stopped and the truck drug the tree with zero effort.
So I didn't think much more of it till today, got a little dirty trying to take the dog swimming and needed 4wd, as soon as i started to hit the skinny pedal and the motor made the tires turn that dam howl came back! rocked the truck a few times and ever time the motor lugged from trying to spin all three tire the same howl came back. switched to 4low to get out and the noise went away?????? Went back to 4high and sure enough the howl was back? regardless i got out but now i have this howl when using 4high and I am really working the truck hard in 4high. I am thinking torque converter is slipping making the sound and4low multiplies the power enough to make it go away from the ease it now has to spin the tires? I am gonna go tomorrow and climb a few hills and see if i can get the howl to start again in 4high...
Is there some sort of reset to turn off the Check Engine light? I had replaced the TPS sensor, and after a day the engine seems to have stopped the high idle and returned to normal, and now it still has the check engine with the same error code, but the problem seems to be resolved. My previous post: [URL] .....
View 14 RepliesSo when I try to kick into 'passing gear' in this '01 f250 5.4l, i get no tranny shift. Whether I'm in tow/haul mode or not.
View 10 RepliesI have Russell fittings and hose coming to hook up my new 6.0 cooler into my 5.4 powered truck. Have a question on the fittings on the bottom of the radiator for the cooler lines, first what is the 3/8" line called? Is it a double flare or what? And second question the female end that's into the plastic tank with the hex head does that unscrew or is it made into the tank? Trying to figure this out so I can overnight two adapters so I can get rid of the fugly hard line completely and use Russell braided line throughout my install
View 14 RepliesI have a 2001 Ford F250 V10 crew cab, I am getting trans fluid in radiator. i have had radiator replaced. it was good for about 3 months.
View 6 RepliesBackground 2006 F350 5.4L 3V, 4WD, K&N CAI, Superchips tuner, 3.73 gears, Jett MAF, 215,000mi.
My issue is I have a shift problem from 3-5. This doesn't happen when I'm granny driving, only under a hard acceleration. The problem is the tranny doesn't seem like it wants to upshift. RPM goes up but the truck doesn't accelerate unless I let off the gas. I have changed the fluid and filters every 20k since I got the truck (150k). This problem came up after I changed my fluid and filter a couple days ago.
This time I changed to Mercon LV because I couldn't find Mercon SP (which is okay according to ford TSB). I used Valvoline max life ATF which said it was Mercon LV compliant. So is this the fluid type (multi ATF, Mercon LV compliant) or a bad solenoid from my understanding it would be the direct drive solenoid? Or am I SOL?
I have a 1999 f350 v10 stock truck. It has plenty of power when it's cold out or raining or I'm on backrooms or highways but if I drive through town on a hot day the transmission kicks bad I have changed the fluid and filter, it also seems to shift at a high rpm from 2nd to 3rd. Unless I you let off quick and go back on kinda like engaging a 2 speed rear end. Does it need a bigger trans cooler or is the trans shot
View 4 Replies2008 f250 auto
is the trans filter change possible?
i didnt see this in the tech folder and no videos for a 2008
2002 F350 Super Duty 7.3 Diesel.Transmission trouble. Came off interstate - took foot off throttle at yield and hit gas as turn was clear. Did it fast and felt like hit wall. Immediately lost transmission engagement. Trans did not reengage until below 20 MPH. Tried to speed up and disengaged at 20 to 25MPH - just free wheel - engine wine. Went to 1st gear and would come up normally. Shift to 2nd and could get up to 30MPH and probably higher - didn't push. Shift to drive and trans disengage. No trans fluid leakage and level looks good and clean. What to look for? 126K miles.
View 1 Replies