My 06 f250 with the 5.4 has a hard time being filled at the pump. So I followed the tsb and replaced the carbon canister, filter box and solenoid with the kit from my local ford dealer. Before it was impossible to get fuel in. Now it is way better but I have to fill it up with the gas nozzle upside down in order to fill at full speed. I have blown out the vent with compressed air.
View 6 RepliesI can't find canister pressure valve hose. It looks cut from the pressure valve in some way. Tried following it from gas tank but I've lost it through the chassis.
View 4 Repliesso long story short a few weeks ago my truck would start clicking the pump. Every 3 seconds it will click and stop. Tried different pumps, upside down, nothing works. Now it won't even go in like something is stuck in the fuel neck and its spitting gas back out. I stuck a wire and it went down pretty far. I see people saying the evap lines but I have no clue where they are.
View 9 RepliesI had a new Fuel Pump put in the cheaper plastic one into my 2001 F250 5.4 with a 112,000 miles.
Problem I am having since getting it back is when filling the gas tank up it will shut the pump off at 3/4 tank. I then have to sit there playing the squeezing game to get more gas in. The vent line looks fine no kinks in it and the tank looks level so what could be the issue causing me this headache?
Just got back from a 2500 mile trip and the 800 mile DEF warning came on. Went to a DEF pump but it just filled the neck. Went to another DEF pump, same . Went home and used a Ford DEF jug with the Ford spout. It still will not go in. If I squeeze the jug, I can hear a little bit dropping into the tank.
The vent and fill pipes are not kinked. The vent hole in the fill tube looks clear. I washed off the top of the tank since there is a vent there.
Still no fill. I do not have a bore scope to look in the fill tube. I ran a 1/2 inch flexible hose down the fill tube until it stopped. Still no fill.
I have stripped my HPOP fill plug. Any experience on getting one out? And a part # for a new one?
View 10 RepliesI notice the gas nozzle clicks off all the time when I am filling my truck. Normally I just hold the nozzle up more and it seems to work.
F250. Slow fuel fill or fill nozzle keeps shutting off....
[URL] .....
Is there an easier way to fill the rear end on my '01 f250? I have a gadget with a valve on it with a length of tubing that you put on the bottle, but you still have to snake the bottle up through the chassis.
View 14 RepliesYesterday went to fill up ($4.05 a gallon geezz!) and noticed that after getting back into the cab, the fuel gauge still showed almost empty. So after yelling a few expletives, I looked again and noticed the gauge starting to make it's way up the dial. It took almost 30 min. before it showed almost full. I'm not sure what the problem is, as the gauge seems to still function. I don't drive the truck much as I use it as a tow vehicle. However, I do try and take it for a spin about 3-4 times a month just to exercise it. I was wondering if the fuel has started to gel and that is the reason for the slow fuel gauge response. Should I add a fuel conditioner/cleaner now that I have a full tank?
View 9 RepliesMy 2000 F-350 during fill-ups will spill out about a quart or more of gas from under the truck somewhere right when the filler clicks off. Also can smell fuel sometimes when between half and full tank. 2000 f350 SWR crew-cab 4x4, 5.4 gas.
View 3 RepliesAny downside to using a nut that covers the entire stud on my '99 450?
View 2 RepliesAfter 225,000 miles, my turbo appears to have failed -- not spinning. This is a stock turbo that is unaltered. Yes, I change my oil and filter every 3000 miles.
My question is; what is a reliable after-market replacement part that will bolt up?
Suspect I have a bad fuel pump. I checked for power thru the Inertia Switch. When I first energize the ignition I receive 12v after a couple seconds it drops to 7v. Is this normal? I checked at the connector to pump module and see the same reading. I swapped fuel pump relay and same readings. Just want to makew sure I dont have some other issue before doing pump.
View 2 RepliesI am working on a 2003 7.3 truck that I am having trouble starting, but once it is started runs well. I have installed manual gauges to both the low and high pressure pumps. The low is running 40 at an idle and 50 at 2000 rpms. The high is running 500 at an idle and 1200 at 2000 rpms. The low doesn't show pressure while cranking. Would you say the low or high pressure pump is bad?
View 6 RepliesThe gas pump/hose keeps shutting off when I fill my tank. The problem is progressively getting worse. No Codes. Truck runs fine. I looked at the filler neck and filler hoses. They appear to be original but no obvious signs of an issue...
View 9 RepliesMy "new" truck has a sluggish seatbelt on the driver's side. It won't retract all the way.
How do I get to the mechanism to have a look at it or put in a replacement?
The belt on this one comes out of the top of the seat, not from against the door.
07 Superduty, Oxford white. I have been looking all around NC pick a parts for a decent replacement tailgate. I know more recent years will fit, with hinge mods. Question is, what is the most recent year that will fit with hinge swaps only?? Looking for a source in SC/NC/VA for a replacement?
View 7 RepliesUsing LED replacement bulbs? I have a 2008 super duty. Want to upgrade lighting.
View 14 RepliesI seem to be having a run of bad luck with my dash vents. 3 of the 4 vents in the dash have broken and I would like to replace them.
Are these vents made aftermarket? If so who? The dealer wants fifty some odd dollars each.
I have a lot of play in my front suspension and steering components. At first I thought it was my old tires, so I had them replaced and that worked, but there is still quite a lot of play. I would describe it at loose steering.
I went to get an alignment and they said they couldn't do it because of too much play in the tie rod end.
So that is going to get replaced. What else is down there, bushing wise, that I should replace to eliminate play and rejuvenate my steering?
How often in miles (mostly highway and city) would you change the following:
1.Baldwin spin on fuel filter added with hutch mod
2. Napa diy 6637 air filter mod with no sleeve over it, just the paper element
3. Stock fuel bowl filter after having added a pre-filter (previously mentioned in #1)