Ford Super Duty (1999-2016) :: Gauges Bottom Out / Overspeed Light Starts Flashing / Engine Goes To 3000 RPMs
Jun 7, 2015
2002 F-350SD V10 Automatic. Running down the road with no load or with load. First gauges bottom out, next overspeed light starts flashing, engine goes to 3000 RPM on it's own. Stays that way until I shut off then restart. Sometimes it does this several times in one mile.
Second trick, again driving along, all gauges stay up but engine just stops. Got to set dead for 5 minutes before it will start. The shop says on the first problem this happens: Voltage goes way low then goes way high then everything starts failing. We changed battery but no luck. Got to be down line from battery.
View 6 Replies
Advertisement
What this could be? It blinks all the time was on the truck when I got it. Has a button in the bottom of it. This is on a 2009 super duty 250 and the 6.4 L if that matters.
View 3 Replies
My father-in-law has a 2008 f-250 with the 5.4. as he was driving a while back all the gauges of the dash quit. The engine still kept running without any noticeable difference but when he shut the engine off and tried to restart, it wouldn't even crank but the security light was flashing. He tried starting it again a few hours later and it started just like normal and ran fine.
He has had this problem occur several times in the last few months, but the other day it repeated the problem again and would not restart for about 5 days. He has tried charging the batteries, changing relays, checking all fuses and finding none blown, scanned it with his code reader, and checked the steering column for bare or rubbed wires.
View 10 Replies
I just recently got handed a 2005 ford f250 6.0 PSD from my older brother, new to the whole diesel game, well all of a sudden as i was driving down the road about 65 mph, trucks RPMS shoot to about 4K and tow haul light starts blinking as i start pulling over (still in drive of course) i realize i can't move anymore the trucks rpm just rev. In all gears it does not move i moved 1-3 D and R and nothing truck just revs. i had my father get under the truck as i shift from gear to gear and the linkage is moving back and forth on the transmission as i put it in reverse the reverse lights still pop on, I'm new to the diesel game...
View 9 Replies
I go out of town for work for a week and come back and my 1999 F250 V10 GAS, is acting up. It started when i tried to drive it and it didn't want to shift, it would rev up to 3000+ RPMs and finally shift really hard into gear along with the speed odo not keeping up and bouncing around not wanting to work. I also had my entire gauge cluster lit up with no key and door closed. all the lights were on and it was "dinging" like the door was open and it wasn't. you would hear it when you put your ear up to the door.
So my first thought was to change the VSS (which I did) no luck. So I started wiggling wire loops under the fuse box in the cab and the "dinging" quit.. i took it for a drive and it works like nothing ever happened. Obviously I am guessing there's a short so i brought it to my mechanic and hes saying he couldn't find anything by the fuse box but he thinks its closer or even attached to the gauge cluster itself. could this be true? Why would the gauge cluster loop throw off the shift points?
View 5 Replies
2000 F250 V10 Auto/Rebuilt Tranny... This weekend, I noticed my truck wasn't shifting at lower RPMs like it has been. I'm not hitting much higher RPMs per shift then normal. Very soon after, I get a "Service Engine Soon" light and my "OD OFF" light on my shifter handle started flashing.
View 8 Replies
We have a 2008 f250 super duty with the 5.4 triton well ever since I replaced the power steering pump its been running raggedly, it idles rough and when i get up to 50, 55, 60 the check engine light comes on i put a diagnostic reader on it and said something along the lines of ECU bank 1 an Bank 2. What that is and I've been a mechanic for almost 3 years.
View 2 Replies
I have a 2008 F250 SD 5.4L with 335,000KM's(200,000+miles).
The engine light came on a few weeks ago and I cannot seem to get rid of it. I have also noticed when I'm accelerating hard at higher speeds/RPM's the engine light flashes?? After when I get to the cruising speed and let off the gas pedal the engine light stops flashing and stays solid. Also when accelerating hard there seems to be a hesitation, almost like the engine is choking itself. Once it gets passed the hesitation point during hard accelerating it seems fine? I have ran about 6 bottles of Seafood through the engine and gas tank. It definitely worked out but still has the hesitation, flashing engine light syndrome...I have changed the following with still no luck...
-Spark Plugs
-Coil on Plug
-Fuel Injectors
-Cam Phase sensors
View 5 Replies
2013 F250 4WD gas V8, auto, stripped basic truck, 72500 miles.
I'm driving back to the shop today, chimes start going off, Service Advancetrac comes up where the odometer is & starts flashing. More chimes, airbag, battery, seatbelt & a couple of other lights start flashing, & coming off & on at random. Check Brakes starts flashing where the odometer is. This gets worse & worse, more & more noise, but the truck runs fine, starts & stops fine.
Ford saw fit to not put a volt meter in, so I don't know what the battery was doing. This went on for at least 5 minutes. I finally was able to push the button to turn off the Traction Control in the split second when all the lights went out. With Traction shut off, all the noise & flashing went away.
View 14 Replies
Im having an issue with my 2000 f250 7.3 diesel. 4x4. The od light is flashing and the tranny is kind of jerky when it shifts. Also my truck won't go into 4 low. (I have shift on the fly) and every time I put it in park my truck revs up to 2000 rpm for a few seconds. I do have a ts 6 pos. Chip with can tunes on it. And I have already replaced the IPR. It does it even in stock setting.
View 1 Replies
I have a 2003 F250 with the 5.4 and I believe I am having a fuel delivery issue. I took out yesterday and stopped to get a drink at the gas station, came back out and the truck wouldn't start long enough to idle. It would start, barely bounce off zero rpms and die out. I checked the fuel interia switch and it was down. I tried turning the key back and forth thinking it might reset the fuel pump or something and that didnt work. I get the truck towed home and couldn't get it to start last night. I go out this morning and it starts, come home from work and now it won't. This happened about 2 years ago and I never did anything about it, but it took 2 years for it to happen again.
View 2 Replies
I'll try not to post an entire book.. But I bought a 2000 F250 not even 8 months ago, it did have issues before but I changed out the spark plugs and coils and it fixed it's original missing issues.. I also just recently changed the fuel filter but it didn't fix it's new problem.. It drives ok around town but if I get over 35 mph it doesn't run well... If I try to keep a steady foot on the gas but don't get the RPMs over 2000, the RPMs will stay where they're at for just a second then they will drop down and the whole truck starts shaking.. I push more on the gas and it shakes even more and the RPMs don't move at all until I really step on it.. It lacks in power going up hills as well... The dealership i bought it from said the Catalytic Converter was bad but my uncle who is a mechanic says it isn't.. It's the first vehicle I've bought so kinda wanna make it last..
View 11 Replies
My 08, when I connect my 7-pin trailer up, bouncing down the road that message and tone CONSTANTLY going off....drives me nuts! I have went thru the wire harness 2x now, cleaned all the contacts, etc. Any other thing short of a 12 gauge? When it does pop on, the controller starts flashing...I've reached down a few times and manually hit the brakes and it still hits em so whatever it is, I feel its very minor or whatever....just don't know where to go now! All contacts have been cleaned good as well.
View 8 Replies
This morning, the tow/haul light came on, tranny temp gauge wouldn't read (stayed below zero), "check gauges" warning came up on the panel, and "check engine" light came on. Truck ran fine/shifted fine, always has.
2007 F-250, V-10, 5-r 110 tranny.
View 5 Replies
My prob started with key in ignition warning alarm working with no key, then radio on off at will and interior light not working or delay not turning them off when door closed. Now all gauges and warning lights/alarms go out also. If I open door and key alarm is on all systems work at that moment and without touching truck alarm can stop at will, at that point ignition alarm, interior light, radio and gauges do not work. When I giggle key with truck running the door ajar alarm activates when system working!
View 4 Replies
03 f 250 super duty, my battery light came on and when I accelerate my dash gauges shut down and radio turns off, if I idle or stay under twenty MPH, everything works fine. Battery and alternator test good, lights never dim, any thoughts
View 4 Replies
this morning my 02 decided to turn the ABS light on, and start bouncing the speedometer. plus, the OD light is flashing when stopped with foot on the brakes, but the trans is shifting fine.
nothing changed on the truck except almost 3 inches of rain fell last night.
will AE tell me if the VSS is going bad?
View 6 Replies
I recentlyHad to replace the right front wheel bearing and after the install the speedometer and turn signals don't work, the ABS light is on and the overdrive light on the shifter is flashing. I've replaced the VSS on the rear diff, pulled and cleaned Speed sensors on front hub?
View 2 Replies
Just changed the oil in my 6.0 and I'm sitting here looking at my tuner and is telling me my idle rpms are about 770.
Before I changed my oil it idled around 750.
It's running fine, I was just wondering why it changed? More pressure to the injectors with the newer oil?
View 1 Replies
I have a 2002 F-450 crew cab 2wd automatic 7.3 diesel with 298k on the body and about 120k on a Jasper engine. About a month ago I started it in the morning to let it warm up. Went to make coffee. Came back and it had died. It was low on fuel and I didn't pay attention. Played hell getting it primed back up. Now if I don't let it warm up for twenty minutes it won't run worth a flip and has been dying out. Changed fuel filter. Unplugged ICP. No change. When I crank it it will turn over for about thirty seconds then oil pressure gauge moves, then engine starts to run very roughly. It will die. I repeat a few times. It will eventually start and start and stay running. Blows whitish grey smoke until it warms up. No loss in power till CEL comes on. Still not too much loss. Sometimes it takes a long time to get it running. Sometimes it will die after I get out of the driveway if I don't let it warm up. Truck was serviced maybe 3000 miles ago. No water in fuel. New fuel filter. New air filter. It is a company truck. I work for a small company building cell towers.
View 7 Replies
I know this has been done to death, but on my '08 F250 XL I can't seem to get the truck to enter into the programming mode to program some fobs to it. I've done the cycling business and the best I get is a flashing light on the dash of the truck with a little lock on it, but nothing else. Can you not program the XL? Is there a major step I am missing?
View 14 Replies
