I have a 1999 f350 7.3. Turn the key lights and fuel pump come on but the starter wont crank. I replaced the starter and checked all the fuses i could find. The only way I can get the truck to crank is by jumping the relay under the hood.
View 9 RepliesI have an 02 F250 6.8 with 51,000 miles on it. I recently replaced the battery about a week ago, and only actually drove it yesterday for the first time since replacing the battery. I drove it about 25 miles, parked, and when I went to restart, it wouldn't. The starter doesn't crank, so I mean its not a cranking issue as in cranking, and not starting. It only clicks at the relay when turning the key. It acts like when you try to use a wrong chip coded key.
All of the dash lights came on, and I can hear the relay clicking, but that's it. I swapped the relays around, and no luck. If I let it sit a while, about an hour, it will fire right up. The battery cables are tight and free of corrosion. I am curious, since I just put in a new battery, could this be the culprit? Why will it start fine cold, but not hot? I have NEVER had an issue with this truck until now.
I have a 1999 f350 7.3. Turn the key lights and fuel pump come on but the starter wont crank. I replaced the starter and checked all the fuses i could find. The only way i can get the truck to crank is by jumping the relay under the hood .
View 5 Replies2015 F350 6.2, 4 door 8' bed FX4...... 17,200 miles.
This morning when outside to start it (nice sunny morning) and turned the key and all the dash lights went on and also went crazy. Said it had all kind of problems on the dash, Trac system, Over heating and so on. The starter did not crank over at all. Tried this about 8 times in 45 minutes, no worky. Call Ford, they towed it to the dealer. I last drove it 2 days ago. All stock, no programmer.
Got 01 F350, 7.3
Started having issues with starter bogging down my batteries. Slow crank, it would catch anyway and runs great. I have spare used starter in the garage, threw that on and it cranks fast, but occasionally just free spins half way thru the cranking.
My question is, can I make one good starter from these two? Monday AM buyer is coming to get my truck, and I don't want to have to buy brand new starter if I can avoid it, but I want him to have reliable used starter.
What causes free spinning (not flex plate related), and what causes power drag and slow crank? I was thinking throw solenoid from fast starter onto slow one, since slow one doesn't spin out but it bogs down my voltage?
I have a 2005 f-250 King Ranch 5.4 triton engine...my problem occurs when i turn the key to start the pickup....i get a clicking sound and then nothing....when i use a portable jump starter, it fires right up...on the other hand, when i try to jump from a running vehicle i only get a clicking sound from the starter...
not sure what i should be testing...also, when i bought the vehicle it had been sitting for several months...for my test drive, they used a commercial charger/starter to fire the truck...i drove it about 10 miles, stopped, turned off the motor and 10 minutes later it wouldn't start...when i contacted the owner, he drove to me and "reset" the kill switch under the fuse box in the cab and then jump started the truck...
I drove it 40 miles home and for 4 days had no starting issues...on day 5 forward, i have had to use the portable jump starter every time...my battery shows 13 amps resting and drops to 5 amps when i try to start without portable jump starter...when i start it with the portable jump starter, it only drops to 10 amps...
2002 F450 7.3 Turbo
Ok first problem : Starter Motor fuse kept blowing and I spent weeks trying to figure it out. No luck. so wired up a push button just to get the truck started, its a work truck so it was needed asap.
2nd problem : he truck stopped starting completely. Wont start in Park or neutral and after a NEW STARTER (because I thought the solenoid on the starter was bad I replaced it) Everything work correctly for one start with the key. After the second time trying to start it blew the starter fuse again. So I tried the straight wiring to starter. still nothing. I was wondering if there are any shims or anything at the transmission housing to correctly position the starter. I am thinking that maybe the gear is stuck or gets stuck sometimes. when I straight wire the starter it does nothing but the wire gets hot so I know its pulling.
Starting about 4 months ago, when starting my truck, the starter would miss; I would turn the key to start, then the starter spins and spools up very high and loud but not crank the engine. I have to turn the key off to make it stop and then try again. Usually the second or third time it will grab and turn the engine and start. It happens about once a week or once every 10 or 12 times I start my truck with all the other times being normal. Doesn't matter if it's a cold start or already warmed up. It's a 2012, 6.7L F250 with 52,000 miles. What is causing it and how it can be fixed.
View 1 RepliesSuspect I have a bad fuel pump. I checked for power thru the Inertia Switch. When I first energize the ignition I receive 12v after a couple seconds it drops to 7v. Is this normal? I checked at the connector to pump module and see the same reading. I swapped fuel pump relay and same readings. Just want to makew sure I dont have some other issue before doing pump.
View 2 RepliesI own a 2004 F-250 Super Duty V10 truck. It's always ran and started great. I don't use it often so I make it a point to start and drive it around town twice a week. The other morning I went to start it and nothing. Engine will not turn over. Tried cranking with head lights on and they stay bright. It's an automatic and I tried going between park and neutral and still nothing. I can hear the little square relays in the fuse box clicking. Could the starter just have died? How are they to replace on these?
View 14 RepliesSo I have a 2003 6.0L Powerstroke 1 ton. I just replaced the starter thinking the solenoid was the problem. But my luck it wasn't. I turn the key and the ding stops and it's quiet. Dash lights go off. I have the engine light and water in fuel light on. ABS is on I think aswell. I've run out of options.
View 1 Replies2004 super duty crew long bed 2wd, v10 auto SLT.
Manual says not in fuse block.
Looked behind radio, nothing, not even a space or the blue one there.
There are some on the firewall, driver side not marked. No pink wire.
Where else??
Will it be easier for me to drop the tank or to take off the bed of the truck does a 1990 F350 7.5 liter dual tank gas
View 1 RepliesI have searched through the site but have not found anything like the problem I'm having. I have a 2003 F250 5.4. Three weeks ago I attempted to start my truck and it just cranks. The fuel pump was not coming on. I left the truck over night and the next morning the truck starts with no issues. It ran normally for the next three weeks then the same thing happened again. Towed to the mechanic but the truck started up and ran. It shows no codes after both no starts and both times ran fine the next day. When running fuel pressure is where it should be.
View 3 RepliesSo here's the deal, crank no start its getting fuel. Has base oil pressure and i put a ficm on that test good with a voltage meter key on engine off and cranking. I haven't hand any trouble finding info on this issue so. We can keep picking away. Just cant find anything about this.
A buddy of mine who has been trying to figure it out for me, Got it to start using a starting fluid. And it would run if someone was pushing the gas peddle but wouldn't idle. Or start without the starting fluid.
Yesterday I was on a pretty long trip and stopped off the interstate to grab some food. My truck is really loud so I always shut my engine off at the drive-thru. When I went to crack it back up everything lit up but when I turned the key nothing happened. I had the truck towed home and I put a new starter on it. Still nothing.....
Well after further investigating where the positive wire that comes from the starter to the battery was broken at the battery post. Don't know how the heck that happened but I fixed it back to factory condition but still nothing. I'm at a complete loss. I checked all fuses and everything looks good.
When I turn the key everything lights up, then turn to crank it and nothing but a slight sound coming from those square silver things in the fuse panel under the steering wheel.
2007 f250 PSD with to many extras to list
I have 08 f250 6.4 was driving down the road truck just died. Will turn over but not crank. I've checked oil level, water level, fuses, fuel cut off switch. Still no start.
View 3 RepliesI have a 2007 f-350 with the 5.4. The fuel pump is not running, have voltage at the inertia switch but none at the pump. Where the pump driver module is located at?
View 2 Repliesi have a 04 f250 with the 5.4 gas motor, yesterday i changed the fuel pump in it, after we were done we started it up ran fine turned it off went to go start it again nothing, and yes i already checked the inertia switch under the passenger kick panel.
View 8 Replies1999 f-250 super duty... okay, here is what i have going on. basically no power to the fuel pump. For the last 2 weeks the fuel pump relay and 1 of the relays behind the radio (next to the blue relay) would chatter and the truck would die. Wait about 5 minutes and turn the key on and if the chatter was gone then it would fire up and run... So NOW no chatter on either relay and not cranking up. - motor turns over just fine- just no power to fuel pump. So I changed out the relay- both behind the radio and the one under the hood. still chatters and no start. i have checked the Inertia switch and 12 volts there... Here is my question, when i turn the ignition on, i have no power to the base of the Fuel Pump Relay.... Where does the power come from to power the relay???
View 13 RepliesI have a 1999 f350 with the 5.4l engine. I have no power to the fuel pump or fuel pump relay. I have battery voltage to the pcm relay. I don't know what else to test because I don't have a proper wiring diagram.
View 2 Replies