How often in miles (mostly highway and city) would you change the following:
1.Baldwin spin on fuel filter added with hutch mod
2. Napa diy 6637 air filter mod with no sleeve over it, just the paper element
3. Stock fuel bowl filter after having added a pre-filter (previously mentioned in #1)
After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 RepliesI had my fuel filters changed at the dealership today on my '15, and then I bought fuel and headed home (70 miles). About half way home I got a "Low Fuel Pressure" message and a little while after that "Reduced Engine Power" along with the check engine light.
I pulled over to see if they did something like leave the drain open, thinking it might be sucking air. Of course it was dark and I could not see anything. However I did hear a buzzing sound and could feel a vibration when I touched the fuel line going into the top of engine filter.
While it is possible I got bad fuel, I suspect they did something wrong installing the filters. Even after cycling the fuel pump multiple times they had a hard time getting it started afterwards; I think they finally disconnected the top fuel line to bleed the air out.
I continued home and made it, but not sure what to do now; its 70 miles back to the dealer.
What is the most likely problem? Improper fuel filter installation or bad fuel?
Should I pull the filters in the morning see if there is something obvious like an out-of-place gasket? If so, top or bottom filter?
Is this a tow truck affair or should I drive 70 miles back to the dealer?
What the heck is the buzzing sound?
Here within the next couple weeks, i am wanting to do some routine maintenance. right now on my list is just an oil change along with the fuel filter.
View 6 RepliesWe have been having near zero temps for several days and it occurred to me that there may be some amount of water in the water separator in the rail mounted fuel filter (not enough to send a message, but maybe some amount). I only have 3,000 miles on the truck. So, just wondering if a small amount of water is going to hurt anything in the filter or filter housing if it freezes? Should I drain the filter in freezing weather even though enough water hasn't collected enough to activate a message?
View 6 RepliesAny luck changing the external transmission fluid filter, without breaking it or its piping?
View 2 RepliesI have a 2003 Ford f 250 turbo diesel 7.3lt V/8,is there a tool to undo the cap on the fuel filter as i have problems every time i service the truck.
View 5 Replies2 nights ago changed the fuel filters for the 3rd time on truck since bought it a year ago. It has 67,000 miles. F350 6.4 L 2008. The truck ran for about 2 minutes and then wouldn't start. For the last two nights have done everything including cycling the key over and over to purge air, replacing the fuel filters thinking the first ones may have been defective, pumped the gas pedal while trying to start it, tried to start it with fuel cut off switch held in, changed o rings etc. The first night I didn't get fuel at the head but after changing the filters a second time, I now have fuel at the head. That is the only progress I have made. The truck has gas and it is fine as we are using it in other trucks. The battery has never been allowed to totally deplete.
View 9 RepliesI have a 2000 f250 V10 CC 4x4 long bed. The rubber fuel line that has a quick disconnect to attach to the fuel filter along frame is leaking. This is on the filter side going to engine. Ford tells me fuel line not available. Dorman products tech assist can't tell me which connector of there's will fit my truck.
View 2 RepliesI'm gonna change plugs , hoses, belts and fuel filter on my 08V10. Hoping it works with the mpg.
Anything else I should look for or do? Is there anything I need to know about changing the fuel filter?
I have an 2005 F250 4.2tdi XLT. There is a buzzing sound coming from somewhere near the fuel filter area in the engine bay. This started after changing the fuel filter during a service. Its also difficult to start now. It has to swing for 10 secs before the engine fires. What it could be?
View 4 RepliesMy stock OEM fuel tank has a crack in it. I've got to replace it. I was thinking of getting a TransferFlow replacement tank. It would nearly double my capacity. My wife wants me just to go stock to save the money, but I'm thinking the extra capacity would be nice. One thing that did concern me, however, is how much my fuel efficiency might diminish because of the extra weight of the tank (150 lbs) plus fuel. Since it is a gas truck, not many options.
View 8 RepliesSo there I was doing a simple oil change and when I took the filter out I noticed the little spring on top, in the center of the big spring (oil filter adapter) cocked to the side with the little plastic piece broken.
does anybody know if I can replace just the oil filter adapter (spring thingy that goes in the middle of the filter when installed) or do I have to replace the whole filter bowl assembly? And if so where would be a good place to get this part?
Changing tranny fluid/filter today, all has been going great until I went to take the filter o-ring out that didn't come with the filter. It will not come out! made a hook tool out of an old tooth brush like someone on here did, o-ring wont budge. Tried a hook pick, it wont dudge (actually bent the tip on the pick and started to tear the o-ring). Everything is ready to go back together and get filled, but this stupid o-ring will not come out!
View 3 RepliesOn my previous 1992 F-350, when I serviced the E40D 2WD trans I replaced the filter during a trans service. I read about some filters falling down inside pan causing shifting issues. There is an aftermarket clip sold that holds the filter in the up position and prevents it from falling into pan.
Is the clip also used on the 2WD 4R100? is it the same issue of potentially falling down in pan as was the case with the E40D? Preparing to service my 2003 F-350 2WD 4R100 and install a new filter and want to be sure I have all parts/supplies ready to go.
My 6.0 powerstroke will not start at all. I changed the rail fuel filter and the oil and oil filter. All oem for caps and filters. But the fuel filter in the engine bay is stuck. I didn't change the filter and I don't think I put diesel on the o ring to lube it. Could this be why it's not starting. I tried using starting fluid aswell no good
View 2 RepliesDo my 2012 F250 6.7 liter Powerstroke diesel has a cabin air filter? I have looked everywhere I could think of and am unable to find one. Does this mean it doesn't have one?
View 9 RepliesJust had my 2005 F250 a few weeks and the 'check air filter' warning came on
Checked the filter, it looks fine, hasn't come off...it's the cylindrical one.
Is this the same thing as the regen? Got it for the first time yesterday at 775 miles. Just curious. On a related note, I've tried to run around town some with 5th and 6th locked out (speeds of around 55-60 on a regular basis, running about 2300-2500 rpms) to try to run this process...am I doing it wrong?
View 10 RepliesFirst 11,000 miles on this 2015 F-350 6.7 diesel was a love affair last 2,000 miles I hate the damn thing it has been in the shop three times in the last month. Exhaust filter over loaded drive to clean. Will not clean while towing a load gets to limp mode. What do I do leave trailer on side of road in order to regen and then go back to pick it up?
View 14 Replies2008 f250 auto
is the trans filter change possible?
i didnt see this in the tech folder and no videos for a 2008