Ford Super Duty (1999-2016) :: Fluid Leak On Left Rear Side Of Transmission Near Extension Housing
May 2, 2016
I just recently had to replace the extension housing on my truck. Well after doing so I went to start it up and top off the tranny fluid and it started to leak out on the left rear side of the transmission near the extension housing. Ive looked and looked and found that the fluid is coming from the top right in front of the extension housing but when i clean it off there seams to be no holes or cracks. It isn't the housing seal, cause it pools in front of that. What could be the issue? My truck is a 01 F250 4X4 5.4L.
View 4 Replies
Advertisement
I was trying to replace the output sensor in my 5r110 when it broke off in the housing.
View 7 Replies
Noticed a small oil spot on my drive way where i park my truck the other day. Got up underneath and saw it was leaking from a rectangular rubber grommet on the front of the transmission bell housing.
What could be causing this? Have heard a few different things, turbo line leak, turbo pedistals, HPOP leak. Seeing what Super Duty Nation thought of the problem. Going to the dealer sometime this week.
View 1 Replies
Put new backing plates, parking brake shoes, springs, etc on my 2004 F350 DRW 4x4. Replaced the inner hub seals and axle o-ring. Filled with Ford Rear end lube and went for a test drive. All was well. Went out last night to take her out again and I've got diff lube running out of both sides on the inside of the rims. Did Ford sell me the wrong seals? Could I have installed the seals wrong? Ford seal part number is 4C3Z1S177A. Axle is a Dana 80, confirmed by reading the tag on the diff.
View 2 Replies
I noticed an oil leak out of the front housing of my 2016 350. I have 3 Ford dealers nearby and all 3 can't get me in until 8 August. It looks to be just a few drops daily. Is it safe to drive pulling a 5th wheel until they get me in? The leak is at the bottom of the housing.
View 3 Replies
I trying to see if this is something that is a easy fix or mayor work. Leak coming from that metal housing behind alternator. Does this housing came off? or do I need to take out the intake out? .
View 8 Replies
I have a 2005 F350 XL Heavy Duty 6.0L truck that has 68,XXX miles. I recently changed the rear brake pads and about a week later the rear passenger side is leaking brake fluid. The fluid is slowly dripping from the bottom caliper bolt but i am not sure if there are seals in this area. the driver side is fine and the fluid is only leaking from the bottom caliper bolt not the top.
View 2 Replies
Made a short run to get lumber yesterday and when I got home the truck smelled hot I checked it out and found a transmission oil leak at the rear of the transmission in front of the transfer case. can not really see what is leaking only has 22,000 miles. What may have happen. 2011 F250 4x4 6.7....
View 14 Replies
New to me truck has 80k on it, it's leaking at the bell housing. Pulled the inspection plate and it's definitely red stinky automatic transmission fluid. Back of the torque converter is clean.
Ford warranty has run out, however I do have an aftermarket warranty on the truck. Trans temp isn't above normal or running hot.
I'm a very mechanically inclined engineer, I do not work on cars for a living, but I have replaced an input shaft seal on a 4wd transmission before. That's my best guess as to what's leaking. Is this a common issue?
View 3 Replies
I have a 2000 F450, 7.3, 4x4, dually, VIN 1FDXF47F0YEA44380, with 30k miles, That needs a new rear axle - hub retainer threads on axle housing are stripped (nut welded on by previous owner). This axle is a case ID F81A-4001-BK, 4.88 ratio, 11.25 ring gear, with a 41.5" spring center. I have heard that the '99-'02 axles had issues until Ford switched over to the later square housed axles in 2002 or 2003 (Dana 110, I think). Is it possible to adapt these later (2002- 2004) axles onto a 2000 F450? And if so, what would be involved?
View 3 Replies
I have replaced the cruise control cut off switch and post-recall pig tail twice in two years for fluid leaks. Whats the deal do they all leak?
View 6 Replies
I have a 2000 SD F250, gasser, auto. Last week I pulled a heavy load and developed a tranny fluid leak. The fluid appears to be coming from what looks like a freeze plug on the bottom of the casing forward of the (torque converter?) pan . Is that plug easily replaced by a DYIer. Small leak. 150K on the motor. First time it has leaked. Heaviest load I've pulled.
View 2 Replies
I was just under my 2000 F250 7.3l crew cab truck and noticed a small diameter rubber hose dangling from my front drivers side brake housing area. It is attached near two other cables which are similar to cables on the passenger side. I don't see a similar hose on the passenger side. The hose is completely deteriorated and broke off up higher towards the engine. I cannot see where it goes. What it may be?
View 4 Replies
I have 460 7.5L gasoline engine on a RV. After driving 300 miles straight and the front start smoking and I pulled over and saw the transmission fluid just shooting out from right in front of the trans oil pan, hot and steaming. Also saw the trail of oil a mile from where I stopped. All oil are gone. Next day go back and put in 2.5 gallons of oil until I see the oil dripping down the bottom. Drove to Aamco transmission, 12 miles down in 20 min. Nothing happen, not a drop coming out.
I left it there in the parking lot on Sunday. Today the shop called and said they found nothing wrong. They said I just overfill it and they drain down 1.5 quart, it is all fine now. Then I told them the story. I said the oil were shooting out and all empty out. I put in 2.5 gallons , not quarts. They said it didn't make any sense. I don't know what to tell them. The RV is still in his shop and he said he will look at it more and see what he find.
View 9 Replies
1999 F250 SD... Tranny fluid is low, tranny slipped one time on me. I checked the fluid and it's low. No drips on the garage floor, so I'll have to inspect closer. But my question is can I add new fluid without screwing it up even more? It's got 170,000 miles and I doubt the fluid has ever been changed. I just bought the truck last week, so I can't say for sure, but it hasn't had a regular flush or change. It doesn't smell burnt but it's just a little darker than new fluid. I was told by the guy I bought it from that the torque converter was changed in it not too long ago.
View 11 Replies
I have a 2008 f-250 6.4 Diesel. Yesterday the Brake Fluid light came on. I thought maybe a sensor, but once I parked and checked I realized my brake fluid was down to the Min line. I started looking for a leak and it was apparent that it was the front drivers wheel area.
I am attaching a picture of the brake. The leak is either coming from the area where the fluid line runs into the gold thing (caliper?) or the bolt at the bottom of the gold thing.
View 1 Replies
2014 Super Duty F350 CC SWB 4x4 20" rims FX4 Gas. Did some measurements today and it turns out the right rear is 1 inch higher than the left rear. The right front is 1/2 inch higher than the left front. Is this normal?
View 14 Replies
I just bought this Super Duty with a 5.4L engine. I want to do a fluid change on the transmission. From what I read, this transmission needs to be hot flushed in order to change out all the fluid. I have not called my dealer yet to see if they do hot flushes. If my local dealer does not have this machine, can I just drop the old fluid from the pan and be ok? I have not gotten under the truck yet to see if it has an external filter.
View 6 Replies
time to change the tranny fluid and filters on my 2010 F250. nothing in my owners manual about this.
All the parts look up places say I need 2 filters, the internal (FT-180) and an external (FT-145).
Problem is that I cannot seem to find the location of the external filter.
Doing some research, it looks like mid-08 the external was eliminated. So, do I have just the internal or do I have the 2?
Regarding the fluid. If I use the Maxlife dex/merc that says meets the LV spec, will that be ok to mix with whatever is in there now? (assuming LV, but I bought used with 145k on it, no idea if its been serviced before and if so, with what).
Going to check with dealer about the hot flush machine, but I really doubt they have one, and I'm kinda concerned about doing a flush at 150K not knowing the history of it.
View 8 Replies
Was going to change my transmission fluid and filter today but when I got under the truck to see what tools I needed, I was not sure I could drop the pan enough to get it off.
I have a 2009 V10 4X4 and the exhaust pipe catalytic are running down each side right under where the transmission pan is. It looks like I can get to all the bolts, but because of the catalytic are right under the flange of the pan on each side, the pan will not be able to drop straight down. It looks like it may drop about 3 inches before it hits the catalytic.
Will that be enough to slide the pan forward or maybe tilt it to get it out? Has anyone dropped the pan on their 4X4 with the 5RW100? Just looking to have someone say I can get it out before I try it.
View 14 Replies
So I'm off work today, and want to service the transmission. I've got both filters, and a 18 quarts of SP, but am not familiar with this transmission, and understand there's no drain plug for the converter. Want to get all of the fluid out, best I can. I'm at 153,000 on this truck with no issues. I do not desire to flush, just want a fluid change.
Searching the forums brings up a lengthy list of transmission threads, but nothing yet that gives me the step-by-step.
View 14 Replies
