Ford Super Duty (1999-2016) :: Fairly Loud Noise Coming From Just Right Of Center Fold Down Cup Holders
Oct 6, 2013
The Truck: 2008 F350 Super Duty, Lariat Crew Cab 6.4 Diesel, Off Road package with just under 90K.
The Noise: It sounds like a cross between Morse code ticking (No Morse code message. I thought of that) and the sound a styrofoam cup makes when it rubs against another cup. The noise is fairly loud. Noticeable at standard conversation speaking levels. Doesn't just go away once it starts.
The Apparent Location Of The Noise: Sounds like it's coming from just right of my center fold down cup holders between the driver and passenger sides of the dash.
Process Of Elimination: No set rule for when it starts to happen but it doesn't happen all the time. SEEMS like it happens after a longer trip.
Air conditioning on or off doesn't make it stop. Fan on or off doesn't change anything. Restarting truck at a stop light doesn't change anything.
Varying truck speed doesn't make a difference. Banging on the dash near the sound doesn't make a difference.
View 4 Replies
Advertisement
I have a 2010 f-250 lariat with a drivers side power fold mirror that does not fold. The part number is 1448007. Do they interchange? My mirror is a Power Fold, heated, extending type.
View 1 Replies
I thought there was a v10 specific superduty section like how the psd does, but my thread went in the "performance, engine, troubleshooting" section.
I wanted more exposure than that particular small viewed area.
I don't have a video of the noise, but my 99 f450 v10 5spd has some iffy noise coming from the front. I've read so many threads on this and they either end with "my motor had 1-2-3 bad pistons" or "my flexplate was cracked" and all that dealt with chain tensioners were never finished.
I know what piston slap sounds like (worked on many cobras and lightnings with forged pistons that had it) and have experience with bad wrist pins and broken piston skirts, and this noise doesn't sound like any of it.
Noise is a loud clicking/clunking/Detroit diesel idle noise. When you rev the engine up it doesn't lighten or get better, only worse as rpm goes up. Oil is terrible looking, I'll be getting that changed this week.
Story on truck. I've had this thing for 4 years with blown motor. I got a buddy that acquired a parts truck and he said it ran good. I dropped my truck off and he swapped the engine. I got my truck back running, but with this engine noise. He said it needs to get run some more and change oil.
I think it's timing tensioners, my buddy says it will come out of it, a mechanic friend says it's going to blow up "because they all do" and I don't really want to replace the engine again.
If it's tensioners, how big of a job is it. I have the cam clamps and crank stop and the ford tools to make sure crank and cams don't rotate while apart.
I'm just 650 miles from my truck and may need someone else to do the work. Which sucks.
View 4 Replies
I just picked up a 2001 F350 with the 5.4L with 200k miles. When I test drove the thing the engine sounded fine. I got it home and noticed that it occasionally has a loud knocking noise that is coming from the Left Valve cover area. It sounds like an old Chevy 6.5L Diesel ...
It comes and goes, Hot or Cold. It seems like it usually goes away when driving with RPMs above 1500 or so, however I took off with it yesterday and the noise would not go away, it seems like it might be low on power when the noise comes on, but then again it always feels low on power, so who knows.
I have changed the plugs, oil, and verified there are no exhaust leaks at the manifolds.
Here is a video of the noise: YouTube....
I dont think it is the timing chain, as it seems like its coming more from the center of the cover, when placing my hand on the cover near the timing set there is no vibration or anything that would lead me to believe its the chain.
All of my searching so far turns up 3V stuff, and little info on the 2V engines. The valve cover looks like a nightmare to get off, who have to work on these things (including me).
View 14 Replies
I found water under carpet next to door. Appears to be coming from area above center of vehicle. Only occurs during rain etc. Not from A/C or heater housing.
View 14 Replies
I cant get my rear seat back to fold down anymore. I was on some very rough roads over the weekend and when I went to fold the seat back down the handle doesnt move. Is there a way to fold it without? Its almost like something is jammed which may be from the pounding the truck took over those roads.
View 3 Replies
A fellow ford driver (f150) pulled around a car on a residential street and clipped my mirror. His whole mirror as removed from his white beater truck. My mirror has the bottom plastic housing broken. Power fold and in/out and all glass movements work. How do i fix. Do the housing on the manual fold mirror with signal is the same as the power fold.
View 10 Replies
Alright so, I've done a lot of research to come across a mirror motor and I found one, problem is I don't have the slightest clue on how to take the morror apart. It attempts to fold then stops. So, I kind of jumped the gun and tried to pop off the main mirror and I cracked it. How to disassemble the mirror.
View 2 Replies
I was wondering how do you remove the cup holder part of the console dose it just pop off or are there metal clips or screws hidden some how?
View 4 Replies
08 F-350 Lariat. Folded mirrors in twice today. Second time they would not come back out. After four hours the fold function has not returned. As I read Owner's Manual, if it's a fuse it should take out power to driver's seat . . . correct? All other mirror functions including telescope seem to work normally. So if I've identified the fuse correctly what else could it be? Fold relay? Switch? Where is the fold relay located and how can one test it? What pins on the switch are the fold pins? I just looked at power distribution box schematic. Power fold mirror relay fuse is there. Apparently the only function it has. Better go check it out.
View 5 Replies
So the other day i opened the door and heard a super loud clunk noise come from the door and when I turned the car on and pulled hte window down it wouldn't go down all the way, only about 75% of the way so I assumed like BMW cars the window motor died but oddly it continued to go up and down just now 100% down.
Then 3 days later when I came to drive the car again the window went down to the 75% mark and now its jammed there with no movement even if I tried to lift the window up myself. Usually a broken motor allows this to happen but since it isn't budging I am wondering if its an electrical issue with the power window button more than the motor?
I say this because when i try to lower the passenger window from the driver side it works than out of no where on the 3rd time it wont move at all than 5 minutes later it will move or if it doesn't move I just go and pull the window down from the passenger side then I come to the driver side and try it and it works again than it'll stop again. So maybe its the power window control buttons on the drivers side that's failing?
View 2 Replies
I have a 2003 Ford F450 super duty xl. At first there was a loud clicking sound coming from under my dash. I charged the battery up and the sound went away but the truck will fire up but not turn over and start. I thought maybe it could be the relays but the clicking sound quit.
View 2 Replies
I just installed a set of power folding mirrors on my 2008 F350. I noticed that the driver side mirror has a longer travel time than the passenger side. How to fix, or why this is like that? Is it normal? watch the video to see what I mean.
[URL] ....
View 3 Replies
With the tranny in neutral and clutch out is when it is the loudest. With the clutch in their is 0 noise. The sound is a spinning clacketing sound best I can describe. The clutch is 2yrs old and was installed by a local shop using all OEM parts, the fluid level is perfect and looks brand new. The sound has come on gradually over the past 6 months but now can be felt thru the floor at the top of the gears as a rumble. The funny thing is that their are no performance issues like grinding,popping out of gear,hard shifting,etc.
This is not rolling gear mesh it is very loud clacking clunking sound coming directly from the tranny, not the transfer case, nor rears or u joints. This is standing still. Sometimes it will be a little less loud if I roll to a stop in neutral with the clutch out as opposed to gearing down to a stop push clutch in goto neutral and letting clutch out.
View 6 Replies
I have a 99 f250 4x4 super duty. Just started getting a loud squealing noise off and on in the front end. Changed the ujoints and axle seals on both sides. They where all in bad shape. It still makes the noise off and on while in 2wd. If I lock the hubs in it doesn't. What it could be ?
View 14 Replies
I was driving and i was doing about 60 65 and i hit a bump and i heard a loud rattle and it shock the hell out of me then it just stop...
View 2 Replies
So my '01 E350 has been fine but tonight when I went to start it I didn't get a WTS light and the SES light was on and there was a weird number on my PHP Hydra that looked like r5 ? This happened a few times back to back so I tried starting it and it just cranked and cranked. Wtf? So I started pushing the button on the chip and all of the sudden I got the WTS light and the hydra flashed, now the chip was on tune 10 instead of 5 where it was when I parked it. I should also note that during these episodes there was a fairly loud clicking/clunking sound coming from the drivers front under the hood when I toggle the key on.. Sounds like maybe a relay? Louder than I recall ever hearing.
View 5 Replies
I have an '08 F250 w/ a 6.4. A couple days ago I started getting a loud squeaking when I turn to the right. It only does it under speed, almost like it needs the weight transfer to make the sound. In addition it's only when I turn at a like 45 deg angle, I can turn less or more to make it stop. But it has gotten louder and louder.
View 1 Replies
I have a 2004 PSD with 85k miles. The engine fan is all of a sudden loud. You can clearly hear the fan pushing air and it's noise is relative to the engine RPM. I've had this truck since it was brand new and have never heard the fan blades unless I had my head in the engine compartment. Is the fan supposed to turn relative to the engine RPM or is there something wrong? Either way it's now all of a sudden super loud.
View 1 Replies
uper Duty 6.2L ... Alright, the loud cam phaser or fuel injector noise/tap..Is this just a cold weather issue or is this going to be like this all the time under start up? Mine was quiet until now (1200 miles) now under cold start loud knock/tap sound. Seemed to go away when truck warmed up and was idling. Was or Is there any fix to this noise.
View 14 Replies
I have a 2004 Ford F250 Turbo Diesel, egr delete, headstuds, intake, dual stacks, etc and when i turn my wheel a loud whining noise comes from under the hood, I noticed it put tension in my brakes. When I accelerate it gets louder and when i let off the gas it goes away... i checked my fluid in my steering pump and it was low so i put some more in and the next day it was all sitting under neath the truck.... any quick fix or do i need to replace the whole pump?
View 2 Replies
