Ford Super Duty (1999-2016) :: F550 - Uneven Load On Rear Suspension
Jan 21, 2014
I have a new to me 1999 f550 w/ 7.3 and I have installed an aluminum service body with a crane on the passenger side bins. The crane itself weights about 650lbs plus the steel frame it is mounted on (superstructure in the aluminum service body). I'm concerned about the uneven load on the rear suspension. It does sag slightly to the passenger side - guessing 1" - I will measure tomorrow.
1) Should I be concerned?
2) What can I do to correct it? (without just adding weight to counter balance it).
View 7 Replies
Advertisement
Have a 2001 F350 7.3 4X4 with single wheels in rear. Started hearing brakes noise and decided to change both front and rear pads. Front had almost half the pads left. Rear on drivers side had about half the pads left. The passenger side metal to metal on the inboard pad and about half the pad on the outboard side. The slides on the caliper were a little sluggish but moved freely. Don't think there is enough to have them turned so will have to replace the rotors. Why this would happen. Could the caliper get stuck? It was easy enough to compress with a C clamp.
View 3 Replies
1999 F350 7.3TD auto 4x4 crew 8'. I've noticed that I get a soft, low, short grumble from the rear end when leaving a stop with a load.
My son just used the truck and says he thinks the rear is binding while in reverse while backing into a parking space, wheels turned.
What are the potential problems here? I've heard a fluid change with "anti-slip additive" could be the answer. Which anti slip additive should I use?
View 7 Replies
I have a quick question, but thinking of changing out my stock OEM rear axle blocks for the 2012 F350 SD 4x4 SRW type.
Does it matter what the wheelbase is?? Model being a CC, SC, etc?
Or...are all 2012 F350 SRW rear axle blocks the same?
View 14 Replies
Ok, so I am trying to get are 99 F550 all fixed up and have a few things to ask.
So we have had the ABS light on now for some time. I had it scanned at O Riley's and the scanner said the abs sensor on the passenger side was faulty. So I replaced that and the light was still on. We had taken the truck to ford to get it checked out for a rear end problem we have been having as some of you may know from a previous post I made.
Well ford said it was the rear sensor on the axle that was causing the abs light to come on. So I replaced that. Still have the abs light on. I disconnected the batteries to try and see if that would reset it and it did not. I hooked up the Scan Gauge II and ran to see if it picked up anything. It said it did not pick up any thing. I still did a code clear but it didn't work. If there a tricky way that you have to get the code cleared off?
2nd I was checking the fluid. I noticed that the tranny fluid is over filled quite a bit. Will this hurt it? Should I drain the fluid to where its at the fill line?
View 3 Replies
I have a 2005 king ranch and have a clunk coming from the back over bumps/heaves in the road. It doesn't happen all the time but often enough. I just replaced the shocks, that worked a little but didn't solve the problem. Now thinking rear sway bar end links? Anything I can check/inspect?
View 1 Replies
I know this has been discussed but I still don't understand. Hence my "dumb blonde" user name.
I just purchased a 2013 super duty f350 extended crew cab DRW.
I also purchased a 42 foot (box is 36) Goose neck Bison LQ horse trailer. Trailer weight is 12048 and tongue weight is 4468. Fully loaded I am about 18,500.
Truck pulls and stops great but it is obvious the rear suspension is sagging.
Now what? Do I need air bags? Timbren? Spring Coils? I have called several installers and they all say something different.
View 14 Replies
OK, so I have the brake pedal downshifting, but there is no real exhaust brake. Can I have one installed, like the latter model 2015 or even the 2016, with the button?
View 9 Replies
I have a 2008 f-550 diesel. Had water in fuel. Flushed the entire system. Replaced the fuel filters and injectors but still will not start.
View 2 Replies
I'm working on a 2000 7.3 that was running but had no power so we changed out all the injectors and glow plugs and rebuilt the turbo now there is no start ...
View 2 Replies
It has a 7.3 bone stock in it. When it is cranking you can hear a relay clicking. it's behind the dash just below the radio. There are 3 relays together 1 big one which is for trailer lights and 2 small ones which i don't know where they go. but i replaced all 3 and i still hear the clicking ONLY when the engine is cranking.
View 1 Replies
I have a new 2013 F-550 Lariat 200" WB on order. I can and will increase the combination weight on the truck, to make full use of the 19, 500 gvwr. My question is how much will a current F-550 pull on a 5th wheel/gooseneck style trailer before it becomes dangerous? I plan to set the truck up with an 11ft aluminum Eby flat body, with a Holland FW6000 5th wheel placed under the body. I am considering a 35 or 40 ft flat gooseneck.
The combination weight would be changed based upon the axles I choose to put under the trailer. Two 12k axles will give me 44,000 gcwr, two 15k axles will give me 50,000 gcwr, and two 16k axles would give me a 51,000 gcwr. The truck will be able to carry about 10,000-11,000, the trailer needs to take the rest. I am confident that 44,000 gcwr will not be a problem, but the idea of 50,000, or 51,000 really makes me question safety. So, how much have you hauled with a F-550, and a gooseneck trailer?
View 11 Replies
New to me 2012 F550 parking lights will not go off. Battery disconnected now. Touch battery cable parking lights come on.
View 14 Replies
I have a 2001 F550 flatbed tow truck with a 7.3 and the ZF 6 trans. i put a Luk clutch flywheel pressure plate new throw out bearing new clutch fork New clutch slave cylinder and master set up. When i push the clutch in it is VERY EASY compared to the way it was before. Ane when you push the clutch in and put it in gear you can hear the clutch disc rubbing on the flywheel and if you lift your foot the thickness of a hair the truck takes off. Also i can't engage my PTO because the clutch is not disengaging all the way. there is No adjustments on this set up. What Now.
View 2 Replies
I have a 1999 Ford F550 with a 6.8L V10 and a 4R100 Auto.
I want to run an underhood hydraulic pump, like what a wrecker uses only I want to use it to run a generator under the truck.
How can I get a 6.8 to idle up to 1200 or so? I searched the Body builders guide and it looks as if the idle up is for the 7.3 only.
My truck also is not a 2005 and up like the other posters, who can take advantage of a drive by wire.
Also I doubt my transmission has a PTO cover so I think a generator option using that route is a dead end. What are my options to idle the truck up to 1200?
View 2 Replies
My 2008 rear suspension creaks and squeaks and groans when I move my horse trailer. Truck has 32k miles, has done since purchase last year, squirted wd 40 and that works. At ford place now, they say it is because I added the ride rite air bags. Told them it made same sound before I installed. What to tell them (tech service bulletins ?) or give up and keep spraying and looking for dry joint?
View 1 Replies
I am trying to figure out where the relay would be when i look online for the map of the relay box under the hood it says nothing of a horn relay. I don't have a key fob for the doors to unlock so I wouldn't think its tied to the computer. Should mention nothing happens when you hit the horn also fuse is fine. No power at the actual horn when i hit the steering wheel(horn)....
View 8 Replies
Really love my 2013 F550 but the door chime is driving me crazy. On my 2003 f150 you could just drop the column cover and unhook one wire running to the tumbler. So I had a look and found it to be totally different. How to unhook it on this truck?
View 2 Replies
Recently removed a plow and wiring harness from my 00 F550 and now my headlights no longer work. The headlight plugs have an adapter that the plow harness plugged in to and it now appears I need some type of end plug on each one to complete the circuit. The problem is the dealer doesn't understand what I need and doesn't think there is such a part out there. Perhaps my thinking is all wrong.
View 3 Replies
I bought a new Motorcraft door latch for my F550 because the door latch won't stay latched. You close the door firm and it seats well then pops loose the first bump in the road. I found all kinds of OEM replacment latches all over the internet but nowhere can I find any instructions or videos or any talk of the best way to go about replacing the door latch. I know they wear out from constant use on the drivers side.
View 2 Replies
I am looking for the location of the fuel pump relay for my 1999 Ford F550 V10 4WD Gas truck.
I have replaced the fuel filter and fuel pump. When the key is turned the pump gets juice and 2 seconds later is not getting juice. No lines are coming into it, so it's not getting up to pressure and shutting off.
View 3 Replies
