Ford Super Duty (1999-2016) :: F350 - Steering Wheel Locked While Driving
Mar 22, 2016
Yesterday while traveling about 30mph and starting into a slight left turn the steering wheel locked, when the brake pedal was applied it was rock hard and would not engage braking resulting in a single vehicle crash, no injuries. 8300 miles...
How would I make Ford aware of this incident and get them involved? Is it likely that such events may have been logged somehow in the computer? The truck is at our collision repair shop waiting for an insurance adjuster to inspect.
View 14 Replies
Advertisement
The steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 Replies
I have a 2013 f350 4x4 diesel. I bought used with 80,000km on it. Started getting a bad vibration in the steering wheel around 80km/h. went too ford and replaced the track bar ball joint and steering stabilizer. After that the truck drove perfect. The next day I went and put on my new rims and tires (used tires) 20" rims with 35x12.5 r20 amp m/t tires. They used beads too balance tires. I left the tire shop and the wobble was back, I went right back too the tire shop and they took the tires and rims off too inspect more and found that one tire had kind of a flat spot and uneven wear.
So they put it on the back as too take away a little bit of the vibration, idea is too wear down that bad tire till the flat spot is gone, when I'm driving it at highway speeds it wobbles a little bit and those goes away and then comes back every 20 seconds or so, will this go away or do I need too replace that tire, buddy of mine told me too do a little burnout and maybe even out the tire a little bit but amazingly that didn't work...or could something else be wrong? Factory tires were 275/65/r20 That I had on before. Also the worst vibration is at 80km an hour but like i said it comes and goes. Will it get better?
View 7 Replies
I have a tow haul problem with my 2008 F350 6.4L. It will not go into tow haul unless I tilt steering wheel up all the way and than slam it down and than it will engage. Than when I want to take it out, I have to shut off truck. Any wiring diagram and info on how to get at the wiring. Do I have to disarm Air Bag and pull Steering wheel?
View 13 Replies
I have an 04 lariat f350 and after cleaning the steering wheel it is a bit sticky.... What the material is?? Or how to resolve the sticky issue??
View 8 Replies
I have a 2005 f350 lariat 6.0. My horn, cruise volume, heat and fan controls on the wheel are not working. The airbag light isn't on. I am thinking that it's the clock spring. The stereo controls were intermittent for a while so I think it's the clock spring. I just want to be sure. Anything I could check?
View 2 Replies
So I have a 1999 F350 diesel and the fuse panel under the steering wheel is acting up. I was driving my truck home the other night and I lost power and my truck shut off. I have had a problem in the past with the #30- 30 amp fuse ( controls the PCM and glow plugs from my understanding) that is under the steering wheel, I replaced the fuse and everything started working normally again.
Until the other night when my truck shut off, so I replaced the fuse the truck drove again for 20 feet died again, I was able to hold the #30 fuse and allow my truck to start up again but would eventually killed the PCM and shut off again and would not start up due to what I believe the fuse location shorting it out and killing the power to the PCM preventing me from starting it up again. I had my truck towed home and charged the battery and it started up fine the next morning. If I push on the #30 fuse my truck the shorts out and kills the power, I do not know if this is normal?
The fuse is sitting loose in the fuse holder is there anyway making it fit tighter to prevent it from being so loose? I have read every other post online about the problems and tried everything they have recommended but still can not figure out what was wrong with my truck. I disconnected the fuel filter heater, and also the wastegate solenoid to see if that would prevent the truck from shorting out if I pushed the fuse it did not work.
What the problem could be causing the #30 - 30 amp fuse to be shorting out preventing everything from working? Or how to test the fuse panel and all the relays?
View 2 Replies
I have a 2005 F250 6.0.. I'm the third owner, only 146,000 miles on it. Had most of the front end replaced. Ball joints, tie rod ends, track bar bushing, front end alignment done...
Still likes to walk as I call it side to side while driving down the road. Factory size tires, factory rims. A little excessive movement in steering wheel while driving, side to side and not transferring to pitmen arm. So I think the gear box shot. Got to looking closer and the power steering box has a re-manufactured sticker on it, so thought about rebuilding it. I do not know where previous owner got gear box at.
View 2 Replies
I've noticed when I'm towing, on long down hill grades if I touch the brakes I get what feels like a rotor causing the steering wheel to shake. At first it was only mild, but today on a long 6% grade it got really bad. Never does it on a level road, I've tried to duplicate it, only on a long down hill grade, and I'm not getting a pulse in the brake pedal at all, only the shake in the steering wheel. It's probably time to replace the pads anyhow, and I'll check the rotors. What things to look at?? 2006 F350, 6.0 dually 4x4.....
View 2 Replies
I just picked up a 2005 SC LB 4x4 5.4 v8 6mt F-350 yesterday and drove it about 250 miles home. It is my first Super Duty, and I love it so far but... the steering has some issues. There seems to be decent amount of play in the steering wheel when I'm driving straight. Also, the truck drives straight when the steering wheel is turned about 30 degrees to the left, and I would like to fix that and bring it to center. When I was cruising on the highway (65-70 mph), there was also two 20 minute periods of time spaced an hour apart where the steering would get light and the truck would dart to the left (i do not think road conditions were a factor as it did not happen on the worst stretches of highway. The truck has 133,000 miles on it, and has had pretty routines maintenance done on it, as it was owned by a drilling business as a work truck to haul tools. The guy I bought it from said that it needed the steering shock/damper replaced, so I will do that, but what else to you think I need to do to the truck?
View 2 Replies
Well long story short, I had the the factory hubs in my 04 f-350 and I was driving down the road and it started making this horrible popping noise. So I pulled over and couldn't find anything and just curiosity locked in the hubs and all was fine. Made me think my hubs were bad, so I went and bought the warren premium hubs, installed them. Went for a drive and still the same noise is there when they are in free spin. But once they are locked in its fine. What this could be? Wheel bearings?
View 4 Replies
We have a 2009 F350 that the engine is now locked up. Anyhow my question is can a 2001 Triton V10 interchange with what was a 2009 Triton V10 both 6.8L...
View 2 Replies
My brother is having a issue with his 99 F350 diesel 7.3 automatic tranny pu. When in manual 1rst gear the engine stumbles and runs like crap. In drive or 2nd gear it runs fine. He's getting a code for a bad cam sensor. A new OEM and aftermarket sensor has been tried with no solution to the engine problem. What might be going on? Maybe a bad ECM.
View 2 Replies
Ok so some one locked my hubs and put the truck in 4x4 4low i assume my aunt was driving it, truck wouldn't shift from 2 to 3rd is this normal since its in 4low. The shifter also seems pretty stiff and 4wheel isn't used much if there a way to know if 3rd gear toon a crap? Trans fluid seems fine not dirty or burnt...
View 1 Replies
So I have a 99 F-350 XL, 6.8 2WD, got 268K on it and it's been a great truck, hasn't ever given problem until last June it killed out a PCM, hydrolocked the engine and sent a connecting rod out the oil pan, so I swapped the engine and replaced the PCM and everything has been great, everything that it's equipped with works great, it's a base model truck, used to be a uHaul box truck, and we got it with 239K on the clock.
Well fast forward from last June to this month and it killed out another PCM, so I got one out the JY with the same numbers and all on it, and it ran twice and killed that one too, and it's got me at wits end, since there's literally nothing that blows fuses or DOESN'T work, everything is perfect but it won't stop it's PCM habit. It's only killing them when it's switched on, to narrow things down.
View 5 Replies
2008 F350 hubs wont stay locked in when in auto position. everything stays locked while in manual and 4x4 works fine, but in auto the hubs wont stay locked while spinning. I was trying to find the problem when i noticed that one hub stays locked all the time and the other locks and unlocks as it should but it wont stay locked while spinning. My question is do I have two bad hubs or is their a leak that wont let the hub stay locked? Also on the hub that wont unlock is this a leak problem as well or a internal problem?
View 5 Replies
Ok so I got a good deal on a used F350. When I got it home I found the heater was stuck on defrost. I posted on here a few weeks ago with questions on what could be wrong. From that post I learned that my front passenger side hub is stuck locked in. I pulled the vacuum lines at every connection from the pump on and had good vacuum all of the way to the passenger side hub. I turned the axle shafts and found the drivers side is free the passenger side is locked.
I flipped the dash switch and heard the drivers side hub lock. Then I turned the axles again and found they were in fact both locked in. I flipped the switch back to 2H and the drivers side freed and the passenger side was still stuck locked in. So I pulled the passenger side hub off of the truck and found it was seized up. I put it back together and locked both hubs in manually until payday when I can pick up a new hub.
Yesterday we had a lot of ice! Where I park the pickup the front wheels drop into a low spot. I could not get backed out of my driveway with the front wheels in the hole and the rear wheels on ice, so I flipped the switch to 4x4 and tried again. It still could not pull out, the front wheels didn't seem to engage. Now I am thinking I have more troubles than just the one hub stuck locked in.
So, my questions now are, 1 if the passenger side hub is bad but both are locked in it should still go into 4x4 correct? 2, the 4x4 light on the dash lights up when I flip the switch. If I had a bad switch or fuse would I still get the same result (light on and drivers side hub clicking in)? Does this pickup have to move a few feet before it engages the 4x4 or should it click right in? And finally what is a short explination of how the 4x4 system works. The dash switch engages the solenoid on the firewall to switch vacuum down to the hubs but what else does it do? I assume it has some kind of switch or motor in the transfer case that engages the 4 wheel drive?
View 14 Replies
2004 F350 150,000km ... I have a rattling/clicking sound from the front right wheel when the hub is not locked (Free) and I hit small holes or run over rough roads. the sound is gone when I lock the hub front hubs.
View 3 Replies
2005 f350srw 6.0 ps. If I stomp it for less than about 5 seconds no issues. Passing a car on a 2 lane or pulling a grade with the 5'r (longer sustained high boost over about 5 seconds) it will pull fine until normal driving recurs. Once normal driving recurs, converter locked 5th gear zero boost on accell. If I mash it to down shift it will stumble stumble stumble black smoke then finally boost fine. Let off same no boost issue. It seems to "reset" after about 4 miles/ 4 minutes. Sct canned tunes/ custom tunes don't make a diff. My dd is idp unlimited tow and 40 ficm tune. I cleaned ebp tube and sensor no change. Haven't tested sensor. I'm wondering if it's low fuel pressure related. Fixing to sell truck and want to fix this. Been going on for a year or so. Hasn't always been this way.
View 5 Replies
Got a problem with my F350 diesel truck's braking system. I pull a 5th wheel and last trip almost burned my breaks up coming down long hill due to having no breaks on the 5th wheel. Had a problem early on with the lack of trailer brakes and module was replaced under warranty. Bought a new module this time and it did not fix the problem. Have braking power when I use the module brakes (Hand) but not when I hit the foot brakes. Have checked the system with a meter and have good voltage with hand break but not with foot brakes. Have a good meter (voltage) read with hand breaks and faint read with foot brakes applied. Also have a faint pulsing read on test light with no brakes at all just key on.
View 2 Replies
When in 4x4 and I go to do a 90 deg turn. The steering wheel pushes back to straight and seems like I have to fight it to turn the wheels. What could be causing this? I was in 4x4 Low on a dirt road at first then stopped, put it in Neutral, and turned it back to 4x4 High and then when turning in a parking lot it started doing this.
View 8 Replies
