Ford Super Duty (1999-2016) :: F350 - Rust Behind Windshield
Aug 7, 2014
I didn't get the windshield replaced rusted the whole way across the top of the window. Now to fix it right need a new roof panel. This truck barely see snow if it does it gets washed underneath. gets waxed 5 times a year washed every 2 weeks if not sooner now a spot of rust anywhere else on the body. well the bottom of the tail gate but that was covered by a bedrug. But the windshield has me upset to say the least. Really would like to know if there is a problem there like ford not prepping the metal right since it was a new body style for that year.
View 10 Replies
Advertisement
My windshield wipers aren't working. I can hear the relay click and I've checked the fuse. I found this ground wire, what it goes to?
View 1 Replies
Filled up the windshield washer tank this morning and could not get the sprayer to work. Looked under the truck and it looks like all I put in is on the drive. Any one else had issues with 2011 F350 washer tanks?
View 3 Replies
On my 02 f350 xlt my turn signals work but not my wiper speed switch, when i put the small fuze in, the wiper go full speed and wont stop unless i pull the fuze out... What could be wrong?
View 3 Replies
Windshield wipers, and washer were suddenly not working the other day, so I discovered a blown fuse. Put a new one in, and it immediately blew again. So there is definitely something grounding out, and I am suspecting the wiper motor itself because so far I have not been able to find any wires shorting out, but before I go to the trouble of pulling the motor out and testing it, or replacing it.
Truck is a 2002 F350CC 7.3 TD. Wipers were working fine the other day before I pressure washed it, which is why I really suspect the wiper motor itself.
View 3 Replies
So yesterday we were towing our camper home from a weekend trip. We were pulling on the interstate at about 70mph, up a slight grade into a strong headwind. The outside temp was about 85 degrees, so not too hot out. After about 5 miles I got antifreeze sprayed on my windshield, coming from under the left front corner of the hood. The water temp held at about 220 degrees where it usually runs when towing hard but the oil temperature steadily worked up to about 240 degrees. I limped to the nearest place to stop and pulled over to let it cool down.
After it cooled down I added water to bring it back up to the minimum mark. We were 200 miles from home on a Sunday so I stopped in the local Wal Mart and picked up a can of stop leak and poured that in then we hit the road again. About 10 miles down the road the water again sprayed onto the windshield and the oil temp came up, this time hitting about 260. The water temp stayed between 218 and 220, once working up to 225, so I slowed down and the temps came down. I was able to creep along and made it 50 miles to a relatives house where I let it cool again and added more water.
When we hit the road again we made it about 10 miles and the oil temp had worked back up to 240, water temp stayed around 218 so I stopped at my parents house and dropped the camper. We drove the 100 miles home from there without the camper. The water temp stayed around 195 and the oil temp held at 212. If I got over 60mph the oil temp came up, but keeping it under 60 the temp held. So, what is wrong with my truck? Is the oil temp up because I was a gallon and a half low on water? The most I had to put in was a gallon and a half. Did I plug the oil cooler up with the stop leak?
The oil temp when towing has always ran 12 to 18 degrees higher than the water temp. I forgot to add, 2005 F350 with the 6.0 diesel. 240,000 miles on the truck. I have owned it just under a year and don't know a lot about it. I don't know if it has had any work done to it prior to my owning it, the antifreeze looks orange or yellow colored.
View 1 Replies
My truck, 2001 F250 SuperCab 4x4 should be delivered any day from the Pacific Northwest. It has Zero rust on it and I want to keep it that way. Unfortunately here in Kansas City, Missouri most of the trucks of this vintage I see have rust around the back wheels on the bed. What steps, if any, can I take to prevent rust on my new truck? I'm pretty OCD about cleaning my vehicles (or anything for that matter, lol) so washing the wheel wells is a no-brainer.
View 14 Replies
once a year i remove all my seats (yes i unbolt front and rear seats and vacuum real good) and when i lifted the rear bench seat back from the rear wall i noticed THIS to some it might not seem like a big deal but to me this is a HUGE problem, i know my trucks a 2004 but whats gonna happen another ten years from now and longer down the road if i don't stop this now? Im gonna have to be buying or making a repair panel for the rear cab thats what! I plan on keeping my truck forever and buy a new truck down the road so i want this one to last, only thing i can think of is the rear sliding window rubber seal is leaking and letting the water get between the two body panels? From outside where the cab corner meets the center body panel piece none of the factory body sealer is missing or cracked so it has to be the rear slider seal?
View 14 Replies
My 02 F-250 (week end truck) has begun to start showing a lot more surface rust on frame and axles. It's about half rust and half black frame. Are there any products that I can spray or brush on that will convert and stop this. ?
View 6 Replies
I own an '03 F250 and have had it since new. I love the truck, keep it in good condition, and plan on keeping it for at least a few more years. For some time now I've had the classic small spots on one rear fender well. The spots are getting a little bigger and look like they're going to come through soon. I'm not a big fan of fender flares, but from what I understand, that's the easiest way to fix the problem, cut the rust out/seal it, install fender flares. Is there any other way to fix the rust without repainting the whole bed? I don't like fender flares because I think they look a little weird with stock tires and also because it's only one fender that is rusting, but I'd have to install them on all four. If fender flares are the only way to go, any that are small and low profile?
View 14 Replies
What is the thread size/length of the 20 transmission pan bolts on the 4R100? I am replacing the pan since the rust has finally started weeping ATF, and the bolts need to be replaced as well, they have turned into little rusty nubs. So i want to use stainless ones. I could pull one and go to the hardware store, but what is the size i can stop on the way home.
View 14 Replies
It appears it is mostly surface rust and am looking for something relatively simple to fix it. I would prefer to use something in aerosol cans since it is small amount of total area, maybe Rustoleum products?
I will attempt to remove as much of the rust as possible with circular wire brush on drill but feel there will still be little crevices that I won't be able to fully clean.
I'm also interested in knowing what I should use to harden the surface to prevent the excessive chipping of paint in this area.
View 3 Replies
Problem is two fold. First......my grill "Ford" emblem is chipping and fading. Second....there is rust along the inside edge of the tailgate near the weep holes. I have been told the rust must perforate the area in order for it to be covered by warranty. Truck is pretty close to pristine condition and two service reps said rust is coming from the inside of the tailgate. Doesn't make sense to me to wait for the rust to get really nasty before it being covered by warranty. I bet a new tailgate cost more than that!!!! Hey whats the deal with the eroding "Ford" emblem??? Looks like the coating is flaking off and letting the blue paint fade away. I don't think this is normal but that too doesn't seem to be covered by warranty !! Maybe I should think twice about my next vehicle !!!!! Comments ??????
View 14 Replies
IMG 4396 - YouTube
What this sound is? Been to the dealer 3x already and they are throwing parts at it and each time telling me its fixed.
View 7 Replies
1999 f350 gas 4x4 . Truck runs fine. even passed inspection. However just recently my windshield wipers seem to work only sometimes. Right now won't come on at all. I checked the fuse.
View 3 Replies
I have no windshield wipers. Since i bought the truck ive fixed other issues but cannot figure out the issue with the wipers. Tested for power not sure if it's accurate but seems like there is power to the harness to the motor but not 100% positive.... Can it be the switch? Blinkers and rest on same switch still work but no ww. I also dont hear clicking from a solenoid like ive read on some research.. Fuses are all good pulled everyone out since they arent labeled with numbers next to them...im at such a stand still and cant drive the truck was screwed the other day when we got sun showers for nor reason and i was on a major highway.
View 6 Replies
I have a 1999 f250 super duty and an old problem has reoccurred , I start the truck and as I put on the windscreen wipers the truck cuts out?
View 6 Replies
2011 F250 with hood mounted windshield washer nozzle. How do I remove the nozzle? In a campground with basic tools.
View 6 Replies
Windshield wipers not quiet? This morning mine sounded like they were hitting the rubber windshield gasket above the windshield at the end of their sweep. I wanted to stop and get out and watch then it quit raining. I looked at the windshield gasket just now in good daylight and I don't see any scratches or hickeys anywhere....
View 2 Replies
My 01 f250 has a leak coming down my line of sight on the windshield. Not sure if it's the seal, or the clearance light above it. Ever run into this before?
View 3 Replies
I have a 2005 F-250 6.0 Powerstroke.
My washer fluid pump is not working, it was a few weeks ago but now it is broken. The Owner's Manual only has the listing fuse 33 for "cluster, 4x4, wipers". It looks like some of the older models have an actual fuse for the "washer fluid pump". I checked fuse 33 under the dash and it is ok. What fuse controls the washer fluid pump?
The pump does not make noise when activated, so I'm starting at the fuse but I don't know what the hell is going on.
View 5 Replies
