Ford Super Duty (1999-2016) :: F350 Diesel - CEL Came On - Fuel Level Sensor Code
Aug 5, 2010
We just bought and '05 F350 Turbo Diesel, about two days after getting it the check engine light came on. We had the dealer check it since the mechanic wasn't in and it came up as "Fuel Level Sensor" . My husband can't remember the exact code. We have been told it's no big deal but we want it fixed and the engine light to go off. The dealer is giving us the runaround, or at least I think so.
View 14 Replies
Advertisement
I keep getting a lean bank code. I have cleaned tb and replaced one of the rubber lines. It only comes on when I take a good ride with the truck. Not sure what else it could be. I'm thinking O2 sensor maybe.
2008 F-350 5.4 3V. 65k miles
View 9 Replies
I have a 2006 f-350 6.0 and i went to fill up my truck with diesel. After that the truck did not start. Currently has the code p2285 - injector control pressure sensor circuit low. I tried disconnecting sensor, still no start.
I have the torque pro app and another 6.0 that I use for comparison. Check power at ficm 48 volt, flp 11.5v, FVP 11.5v. Hpop while cranking shows 1400 psi. removed oil filter and see low pressure oil ok, fills up reservoir. ipr at crank about 65%. fuel filter full of fuel.
Replaced the dummy plug on passenger side because originally hpop was very low psi 12. after replacement it went up to 1400 on cranking. What should I be looking at next, should I be removing ipr? should i be looking at crank sensor or cam sensor? Just installed 2 new batteries also because my dad kept cranking the truck until it died.
Checked to make sure fuel cut off relay not triggered, Ok. The truck has been having long cranks before it died. Also right now the injector cycling is 10 seconds long while on my other 6.0 it is about 4.
View 14 Replies
So I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....
View 5 Replies
2005 V-10... I've found some info on the "fuel level data error" but thought there must be more on this. In the last month or so I get the error on the message center and the fuel gauge goes to E. Happened a couple times here and there and then the CEL has come on. Have nto been able to get the CEL to go out because it happens too often now.
Have tried a couple bottles of Techron because that is suppose to fix it but no luck after about 150 miles. Can't find any loose wires/connectors. Am ready to give up and drop the tank. Is the sensor separate or part of the pump assy? Also don't see alot on dropping the tank on SDs. Any tips?
View 14 Replies
My '03 V10 F250 gas with 135k miles on it went from showing weird fuel levels last week, showing low when I just put $40 in it to now being absolutely below empty, pegged as far south as it can get. I have a CEL light on too but my OBD test shows, "N/A 01-01". So all I can think is that there may be an open/short circuit that the OBD cannot diag.
I replaced my fuel pump about 2 years ago with a replacement AutoZone unit and all had been fine since then. I just do not remember if the fuel level sensor was part of the pump itself or a separate item. If it's a integral part of the pump I should be able to go back to AutoZone and get a warranted replacement.
Is there anything I can test a forehand before either pulling the tank or doing a dump-truck again?
View 4 Replies
What exactly does the sensor on the rear axle do? 08' f350. I know it's a speed sensor of some sort, but what does it do or control exactly.
View 3 Replies
I have been trying to find a new sensor after my truck popped a P2285 code. I can't find ICP sensor at any auto parts store. I found this but it was labeled as a fuel pressure sensor on RockAuto: More Information for Standard Motor Products ICP103... Is this the same thing?
View 2 Replies
I have an isspro sensor that I need to install on my 4r100. I have it all installed except for the actual sending unit. My question is where is the best place to put it?
I've watched multiple YouTube videos and it seems a lot of people use the test port on the driver side above the linkage. I found out the hard way that it is a very poor choice of location. A lot of people say that the best way is to drop the pan drill a hole and weld in the bung? I was wondering would it be possible to put it on the "out" line on the transmission oil headed to the cooler? 01 f-350 7.3
View 4 Replies
2004 f350 sensor switch will now and then let me turn it "on", but turns itself off immediately. Has never worked since I owned truck.
View 1 Replies
Code was showing for the knock and climbed under the truck and checked to see if it was plugged in grabbed the wire and to my surprise the wire kept coming and so did a piece of the knock sensor, is this going to affect my truck badly?? worst case?? 97 f250 4.6 standard
View 4 Replies
Here within the next couple weeks, i am wanting to do some routine maintenance. right now on my list is just an oil change along with the fuel filter.
View 6 Replies
I have a 2003 F 350 Diesel. When the heater is on, I can smell diesel fuel through the vent. This happens mainly when I am at a stop sign and the fan is on high. I did some research on this forum and found some others with a similar problem. The question I have is it seems like some said it was the cracked injector cups or a leak at the reservoir on top of the motor where the filter is. What I wasn't sure of was the symptoms. If it is a crack injector cup, would the smell be all the time and not just when I am stopped at a stop sign? Or would it be intermittent as well? It is definitely not exhaust smell. It smells like fuel. If it is the gaskets in the reservoir, I think I will do the blue spring replacement cause that seemed to improve a couple things based on the treads of the forum. I do see drips on the pavement every once in a while at the front of the truck towards the passenger side of the truck. Not all the way to the side near the tire, but off center on the passenger side. Is there anything that could be leaking fuel on that side of the motor?
View 4 Replies
I have a 2007 f-350 with the 5.4. The fuel pump is not running, have voltage at the inertia switch but none at the pump. Where the pump driver module is located at?
View 2 Replies
OK, I have a 2002 F350 with 160k miles that cranks fine, but has a hard time starting when it is cold. By cold I mean that it is not hot from being driven in the last 5 hrs or so. No problem starting after being at rifle practice for 3 hrs or after a trip to the store. Always have trouble starting in the morning, like this morning when the temperature outside was 49 deg. I have to crank for quite a while to get it to turn over, but once it catches, it runs like a champ. Afraid I'm going to wear my starter or batteries out because It seems like I have to crank for about 2 minutes.
I have a fairly new CPS replaced less than 15k miles ago, new glow plugs, and recently replaced the leaky bleeder valve on the bowl. This difficult starting condition came about some time before the bleeder valve seal repair, and is still doing it after the repair. This problem seems to have cropped up on it's own unrelated to any work I have done. I am using Mobile 1 5W-40 diesel oil. When the no start occurs, there is no smoke present out of the tail pipe like what you would get if you had bad glow plugs. There is just no fuel getting into the injectors.
View 2 Replies
I bought my 2005 F-350 Diesel 6.0 Brand New. Whenever my low fuel light comes on, I only have a few miles to go before I run out of diesel. Is there a way to adjust this light so it will come on with maybe 20-30 miles to go before running out? Its seems to only have maybe a gallon in the tank when this light comes on...
View 7 Replies
I have a 99 F350 with a 29 gallon tank. I filled it up yesterday and the total gallons was a little over 24. The low fuel light was on and the gauge only goes up to almost 3/4. I recently bought this truck. I've searched for a thread on here possibly addressing this but have been unable to find one. I've been going through possible issues in my head.... What the problem is?
View 14 Replies
My 2000 F-350 during fill-ups will spill out about a quart or more of gas from under the truck somewhere right when the filler clicks off. Also can smell fuel sometimes when between half and full tank. 2000 f350 SWR crew-cab 4x4, 5.4 gas.
View 3 Replies
I have a 1999 f350 with the 5.4l engine. I have no power to the fuel pump or fuel pump relay. I have battery voltage to the pcm relay. I don't know what else to test because I don't have a proper wiring diagram.
View 2 Replies
I have a 2014 350 crew diesel short box. I am told, I have a 28 gallon tank but can't get over 22 gallons in it even though my gauge show e and my read out says I have 10 miles left until empty? Dealer says the left over 6 gallons is a reserve...
View 14 Replies
So here's the deal, crank no start its getting fuel. Has base oil pressure and i put a ficm on that test good with a voltage meter key on engine off and cranking. I haven't hand any trouble finding info on this issue so. We can keep picking away. Just cant find anything about this.
A buddy of mine who has been trying to figure it out for me, Got it to start using a starting fluid. And it would run if someone was pushing the gas peddle but wouldn't idle. Or start without the starting fluid.
View 2 Replies
