Ford Super Duty (1999-2016) :: F350 - AC Won't Start / No Air Until Hit Around 2800 RPM
Jul 20, 2013
So I am not getting anywhere solving this problem. my 99 f350 psd air condition wont start until you hit around 2800 rpm. Then the clutch engages and it blows ice cold air.The truck will sit and idle once the clutch has been engaged and stays engaged. Turn of the air and it wont start again till it sees 2800 rpm. Put power to the clutch with the engine off and it works fine. Cant see it being a pressure problem because without the clutch engaged nothing changes in the air conditioning system so why does it take 2800ish rpm to have it engage.
View 3 Replies
Advertisement
My two oldest sons and I have a 1999 SD F250 4x4 with the V10 automatic. My boys burnt the trans. We had a spare that was pulled from the same year truck with the same motor. The boys installed it without me. Everything seems to work as it should, EXCEPT! 1-2 will not shift until 2800 rpm. 2-3 is the same. When I checked the install I found that the new trans has a speed input sensor on top of the housing behind the bell housing. It is Not plugged in, my harness does not have that plug. Old trans does not have that sensor. Is this the cause of the high rpm shifting?
View 14 Replies
I have 99 f350 single rear wheels 4x4 . I went to start it this morning and it would crank but not start b/c it was cold. I plugged it in and still wouldn't start then it wouldn't even crank. I checked all fuses swapped relays and I have new batteries. The last thing I did was hit on the starter a few times and it started. So I went and bought a new not remand a new starter and put it on and now it won't crank!? I get 12v at the little wire on the selenoid on the fender. So now what?
View 4 Replies
2001 f350 w/v10, 6.8. the fender mounted starter solenoid went out so I replaced it, while doing so I also replaced the battery (previous owner had a marine/rv battery installed, I purchased the truck a couple months ago). after replacement the truck still will not start. when attempting to start it barely if at all cranks, long story short I was going to have the starter tested but in the course of removing it the terminal posts broke off so I ended up replacing it too. The truck still would not start or really crank so I dug down with the expectation of finding a bad ground someplace. cleaned up the ground points. Now I have the battery on a charger awaiting it to finish recharging. Something that is likely/remotely likely to be causing the engine not to crank over and start that I have missed?
View 11 Replies
Came out to start my truck today a hit the key and got nothing. After I settled down from being upset about my truck already giving me trouble (bought it in Nov and had 25k miles on it, 35k now) and that I should have stayed with a Chevrolet, I was able to start it by crawling under and jumping the started with a screwdriver. The truck started up no problem and got me home where I did some troubleshooting. Looks like I dont get solenoid power at the starter (just main power), the relays and fuses checked out, anhe d it looks like the key is still programmed.
I had been getting what seamed like a delayed start every now and again that was going on for a while, but thought it was just me. The next items I thought that may be the culprit are the neutral safety switch or the ignition switch. The gear selector seams to work fine and it wont start in either P or N, the backup camera turns on and nothing seams to be incorrectly working on that account. Also, the truck is a 2011 F350 Crew Cab 4wd Lariat with the 6.2 gas motor.
View 10 Replies
My 1999 Ford F350 V10 will crank forever but will not start. Seems like it isn't getting fuel.
Here are the facts.
Truck 8 months ago was used by my brother.
When he got back 2 weeks it sat then truck wouldn't turn over. Thinking it was a bad battery I charged it But then I let the truck sit 8 months.
I put the battery back in and when I started cranking it the gas peddle felt floppy.
SO, I realized I was out of gas. I went and got 5 gallons.
I turned the key on and off like 5 or 6 times and then tried to start the truck.
The Pedal is NOT Floppy anymore. It has pressure like the gas is back in the line again.
But the truck will crank and crank and crank without turning over. It won't even try to turn over.
The truck has a brand new Fuel Filter in it that was put in 3 months before my bro used it so it worked after that was changed.
I assume maybe it can be the Fuel Pump but WHY would that go bad from sitting and wouldn't the Floppy feeling in the Gas peddle STILL be in the pedal if the pump was bad??
View 14 Replies
I just bought me a 2006 Ford F350 Lariat. A sticker in front of the radiator says says that my truck is equipped with remote start. How would I go about using it? I only have one fob. If it is in fact something that I can utilize I have seen guys on youtube program their fob to do it by clicking three times.
View 2 Replies
Truck started to feel like it was missing here and there. A couple rough starts in the morning and a very potent exhaust smell at startup. Then finally after a couple days of this, it wouldn't start.
At first it would try to turn over and almost did several times, then it degraded to just churning and churning with no close attempts to turning over. No codes thrown when we hooked up the code reader. I've had the IPR go out on me twice, the churning and churning is how it acted when the IPR(s) had gone out.
Towed it home and pulled the IPR, everything looked in order with it. Changed the upper fuel filter and oil/filter in an attempt to rule out the easy stuff. Tried to start it up last night after doing this and it churned and churned for awhile (about 2 minutes), then it almost turned over several times. By this time the batteries were too low to continue. Hooked up the code reader again and still no codes.
I'm planning on charging the batteries and replacing the lower fuel filter today, but not feeling real optimistic that it will do the trick. Any other issues to check for?
View 14 Replies
I have a 2000 f350 xlt and it has been very good until now. I can be driving normal and stop and park, when I get in and try and start it , it acts like the neutral safety switch is not working. the key turns and all my dash lights work, radio works, everything but the starter. I have to put it into neutral to get it to start. then after I stop again, it works fine. I don't get the problem all the time and I can't find a neutral safety switch.
View 8 Replies
I have a 2003 f350 v-10 drove it yesterday to get fuel, went to start it after fueling. No start, no lights dash was gauges were acting odd, and clicking under dash from behind fuse box. did get it to start after a while, put my foot on brake to go into drive, never made it ... truck died I do have remote start system thought it was that with the brake pedal issue. disconnected complete system. no change
Had it towed, home now no nothing, connect battery and just clicking from under dash no start ? not battery, wont even jump
View 8 Replies
I have a 2012 Ford F350 I've been looking to install a compressor on. I've poked a hole in the gasket that runs wires through the firewall and cut the tips off of a couple of the accessory wires. Went to go get some more parts and now the truck won't start! The lights and radio turn on when the car is turned on but the starter doesn't even click when I try to start it. What should I look at?
View 7 Replies
Truck wont start with key. It has a brand new battery, brand new starter & brand new solenoid. When I turn the key to the on position the lights come on but it wont start. The truck will start when I jump the solenoid. Im wondering if its the ignition key cylinder or the ignition switch, or maybe something else like a relay or faulty wire. Where I should start or what the problem could possible be?
View 6 Replies
I have a 01 f350 7.3 turbo dsl. will not start cold. engine turns over fine. plug into block heater over nite , will start! outside temp does not make difference. I have replaced glow plugs, glow plug relay, wiring harness under valve covers. Where to go from here?
View 14 Replies
i have a 01 Ford F-350 7.3L quite and won't start I have replaced the ipr valve and sensor and the crank sensor and the truck still won't start...
View 1 Replies
2007 6.0l cranks but no start. Read all the forums and I think I performed all the checks. Getting a ficm/ cam sensor/crank sensor no sync. I'm also getting 84.70% at the ipr while cranking. Do I have multiple problems? Watched videos on either the ficm or ipr percentage but not one that had both problems. Getting injector clatter and fuel pump runs. Didn't see anything obvious with the harness.
View 5 Replies
I had just installed an amplifier and speakers into my f350. Everything looked fine in the wiring, but when I turned the key on, I heard a sizzle. Now the truck won't start, although the battery is charged and all the lights come on. It does click, so the ignition relay should be working. Where to start looking for the problem? I am going to disconnect all wiring related to the amp and stereo for starters as well as try the reset mentioned in another thread tonight. If that doesn't work, what's next?
View 2 Replies
I own a 1999 F350 with a 7.3 diesel engine, every time I drive it, it will start once then it won't start again for hours. At first I thought the starter was getting hot because of the exhaust is too close to it but I tested the wires going to the starter and i am not getting power to the starter when this happens. When it started doing this, it would only act up if it was above 80 degrees outside. Now it makes no difference. I have replaced the Valve cover gaskets, glow plug solenoid, and starter solenoid.
View 3 Replies
2002 F350 7.3 intermittently wont start after I've shut it off, it runs fine but sometimes won't start when it's (warm)? Wait hour or more and it starts right up.
View 2 Replies
I have a 2001 ford f350 v10 dually. about 2 months ago it blew a plug out and i had it fixed and shortly after it developed a starting issue. It starts fine for a day or so then after it sits for a day it wont start without out cycling the key 5 to 10 times....It cranks fine just wont try to start or even sputter....took to a shop that replaced my jem Module and he had it for a week and only one time did it not start. I drive it home and it sits overnight and wont start the next day. took it back and he couldn't find out what is going on.
Its has started and ran just fine no issues once its running but shut it off for a couple hours you got a chance it wont start. I've eventually got it to start every time so far. The shop said my fuel pressure was 40 psi but would go down after it sat to about 10 to 20. The one time it did not start for the shop they said it had no fuel pressure but then he just cycled the ignition a few time and it started. What to check that would be normal like the fuel pump or relays and fuses. I should say early this year around jan feb it had the starting issue once and thought it was due to a autostart that was installed before I bought it and so got it going and just removed autostart when started having trouble with starting.
View 6 Replies
Over the last two weeks I have had an intermittent no start on my 2005 F350 6.0. on four different occasions. With enough cranking and charging batteries it would start again. I am running a scangauge, during these no-starts ICP was at 200. I pulled the IPR and the screen was damaged so I ordered a new one thinking the IPR would fail intermittently. Replaced the IPR last night with a new one, and truck ran great. Started it three different times with no problems and let it run about twenty minutes.
This morning, another no-start, but IPR is at 1162 psi now during cranking. I am thinking fuel delivery now, but have not yet checked fuel pressure, I need to find an adapter for the M12-1.5 port on the secondary fuel filter.
Details: 2005 F350 6.0 SRW 150,000 miles 4x4
Studded a year ago
New oil cooler a year ago
Upgraded STC fitting a year ago
Coolant system flushed and coolant replaced with ELC months prior to cooler change
Coolant filter installed months prior to cooler change
EGR Delete
Scangauge II
Plenty of Oil
New Motorcraft Fuel Filters
Fuel Filter Bowl fills fast during KOEO
LPO registering on dash gauge during long crank
1162 PSI ICP during crank
37% IPR during crank
FICM voltage 48 - 47.5v during crank and run
Batteries tested good last week
SYC = 1 (last night while running)
Codes: Threw a code this morning during long crank "P2614 - Camshaft position output circuit" - One forum stated that this code will appear during long cranks - don't think this is my problem. This is the only code that it has kicked out during this issue.
Fuel Pressure = UNKNOWN
View 2 Replies
My 2000 ford f350 will start and then dies on me when i try to put in gear. I changed air n fuel filter. Adding oil i noticed the stick was still reading dry. Noticed a big oil spot under the hood. What should i try to do? Do not want to put in shop cause every time she goes in I come out broke.
View 1 Replies
