Ford Super Duty (1999-2016) :: F250 - Blower Works Sometimes Then For No Reason Stops
Jul 3, 2014
1999 F250 .. Blower works some times then for no reason stops. When it works, I have all speeds, it makes no odd noises. I shut the engine off and then it does not work. I have power to the blower motor even when it is not working. I doubt it is the speed resistor module because that is not used in high speed. I've taken the blower motor out of its housing and pulled the resistor module as well. I find nothing wrong, power it up and the blower works. I put it all back together and it does not work.
View 4 Replies
Advertisement
My 2001 f350 a/c blower works better on a/c compared to max a/c . When I turn the selector to max a/c it makes more of a blowing noise but less air blows out of the vents though. When I select plain a/c it makes less noise but blows more air out of the vents. What is wrong and how to go about fixing it is 93 here today and won't get much cooler over the summer months .
View 5 Replies
2001 f350 blower motor for (A/C - Heater) works sometimes and sometimes does not.
View 5 Replies
I have an 04 f250 the 4wd won't lock in for some reason. The truck has manual locking hubs (turn them to the right to lock in 4wd or turn them to the left to unlock them) and I get the light on the dash just fine but the truck doesn't actually lock in.
When i I put it in 4 low it feels like it's in but it's not. I also noticed that when I put it in park while it's in 4 low it makes a crazy sound like it would when you put a car in park while you're still moving and the park pin makes that clicking noise.
Anywhere in particular I should start to look? Nothing up in the front end looks abnormal or out of place.
I've had the truck 10 years. Never had any 4wd related issues. I did however replace the transmission in December (and I did successfully use the 4wd after the transmission was installed).
View 3 Replies
My truck was sitting in front of the house, unlocked and the alarm disarmed. For no apparent reason, the alarm on the truck went off. I tried pressing both arm and disarm button on the FOB and the alarm would not shut off. I opened the door, started the engine and the alarm immediately turned itself off. I need to look in the manual and see if there is any condition that would cause that particular event. Strange to say the least.
View 3 Replies
Only 2 speeds of the 4 speeds are working on my blower. I was thinking it may be the switch, but someone at the shop told me to replace the blower resistor first. I did that and still only have 2 speeds. Im guessing I need to replace the switch now?
Also, I am having problems with my heat adjustment. I have it set to warm (half way between cold and hot) and out of the blue it will start blowing hot. I turn it down all the way to cold until it blows cold air and turn it back to warm, and it will be fine for a few minutes and start blowing hot again. Vacuum problem? blend door problem? How would I go about trouble shooting this problem?
View 1 Replies
The power mirrors on my F-250 works halfway. I can get them to move inward but not outward. They also will upward but not down. These are both mirrors. Could it be the switch?
View 3 Replies
My Blower motor is intermittently going on and off. After messing with it for a while it seems to stay on. Motor may be going out. Not real easy to change the blower motor on this 2008. Haynes manual says to take the 2008 and up trucks to the dealer.
2008 F250 4DR 5.4L
View 8 Replies
My dad has a 2000 f250 4x4 with the 5.4. he said his blower would only blow on high. I told him it was his blower motor resistor. i thought it was under glove box. he took it apart and said no but there was a little box thing with wires he took off anyway and put back on. I then told him it was under hood below a/c lines. he replaced old one with a new one from auto zone and replaced the pigtail( plug too) fan works on high and a little bit on low very very little when u switch it to medium it stays the same. High works great. So we replaced the fan switch. (Radio was a bitch to remove) and it still does the same thing. I checked all fuses . when I check the plug at the resistor there is power to the center pin it stays on when u switch to low and medium but when u turn high on power goes out( on test meter) is there something I am missing? the blower blows on high even when u remove the plug from the resistor. Is that normal?.
View 4 Replies
Bought this truck a few months back. Nothing but problems. I always thought it has felt a little underpowered and hesitant. I chalked it up to being a 5.4l in a f250. Well now im thinking it has been a symptom all along.
Lately, the truck has been stalling at stops. Randomly, but not often. The truck idles at 750rpm when I start it, but after driving and then coming to a stop while in overdrive it idles at 400rpm. This seems too low to me.
It hesitates occasionally when giving it throttle. Just today it got really bad and was almost unresponsive. I would hit the throttle and it would just idle while randomly kind of shooting up in RPS and shuddering. It finally produced some error codes, it looks like, but I am afraid to drive it all the way to the autozone.
I am thinking TPS. Is the TPS attached to the pedal or is the TPS attached to throttle body under the hood? I've read some conflicting stuff about this. The good news is that if it is the TPS then it should act like a whole new truck after I replace it.
View 11 Replies
I have a 2000 F-250 Diesel that has started acting strangely. It starts and runs well, but every once in a while the peddle just stops working. Might be a second or so and then the RPM will go up. Or you may be running down the road and all of the sudden it just stops acting like it is getting enough fuel. Same thing it might last a second or so. Sometimes it might happen 4-5 times in a row over a few minutes and might not happen again for a day. Truck does not stall when this happens. It just does not go like it should.
View 1 Replies
Just started having this issues on my 2012 F250 6.7 with 71K. Turn the key and no problems. Once I start my truck service advance track pops up, along with the e-brake light and some other lights before all shutting off. I then loose all functions in my instrument cluster, window controls, AC/heat controls. The truck still runs and drives with no problems I just have no dash functions. My blinkers and headlights still work (with no cluster indicating). Fog lights do not work. Turn the truck on and off and the problem repeats itself.
I did get stuck in a massive rain storm with some big puddles last night. Went to dinner and started having the problems on the way home. The functions were temperamental last night but seem to be worse today.
View 3 Replies
I have and 07 F250 and the #2 speed for the blower motor don't work (hasn't since I bought it) I read that the most common cause of this is the resistor under the hood on the firewall so I replaced that and still no 2nd speed??? Where I look next? Motor itself maybe?
View 11 Replies
My HVAC blower motor stopped today while the wife was driving the F250. I thought I should swap relays (with the heated mirror relay - same Ford Part Number) to rule it out or identify it as the culprit. However, since these are close to the firewall, I have a hard time getting the grip and leverage to pull the relay out of the Battery Junction Box (BJB). How to make this a bit easier?
View 5 Replies
My blower works half of the time...from what I have researched it is more than likely the resistor. The thing is I can't find it..all the videos and pictures looks like they are the **** control control. Where this is located for the dual climate control?
View 3 Replies
What will make a loud blower sound cycle on and off constantly when towing if i turn the ac off it stops....
View 7 Replies
Recently got a 2003 f 250 6.0 that has had a little work done on it. Absolutely love it with 1 exception. When I turn on the ac or heat It blows a 10 amp fuse that goes to the blower relay. It was occasionally now it's all the time.Blower ok, fan speed resistor ok. What or where to look.
View 8 Replies
I've got a 2006 f250 with 160,000 miles, trans was rebuilt by previous owner about 10,000 miles ago. The tow/haul light started blinking yesterday, only blinks for first couple of minutes of driving and then stops. Service engine light popped on today as well. Won't have access to a code reader until tomorrow, but looking for some preliminary info...
View 3 Replies
I have a 99 F350 V10 that has started with shift issues. While driving in drive it will down shift to first for no apparent reason and not shift back up. If I drop the shifter to second it will go back into second from first. I can then shift back to drive and it goes back to drive. It will last a few minutes and then down shift again. It's a dually dumper if it matters..
View 2 Replies
On my '99 F250 PSD 4x4 the speedometer climbs very smoothly (normal) until I hit 54mph and then it just stops going up. Reviewing other posts I have changed the DSS (differential speed/ABS sensor) and the VSS (tranny speed sensor). Disconnected both batteries for several hours to see if it would clear.
Doesn't bounce, peg, go to 0, just won't go past 54mph. No power loss. Tach continues to climb and speed continues to increase. No strange symptoms except this 54mph thing. It is completely repeatable. All fuses under the dash and hood check out ok.
View 8 Replies
I bought a 1999 Superduty 7.3 6 speed and went out to drive it yesterday and noticed my speedometer stops working at 40mph. I saw many posts about this but no fixes. Bad cluster or vss? No abs light on dash. Still runs and shifts good. Only one yellow airbag light illuminated on dash...
View 9 Replies
