Ford Super Duty (1999-2016) :: F250 Turns Over Very Erratically But Won't Start
Aug 19, 2016
I have a '99 F-250 super duty with a 5.4 L engine and I am having trouble starting it. Initially it wouldn't turn over at all, so I had the battery checked, it was fine, and after charging it the engine would turn over very, very slowly once or twice then stop. I then replaced the starter and now it turns over very erratically but wont start.
View 4 Replies
Advertisement
My dad has a 04 f250 5.4 auto. The motor turns over but very slow and will not start. He's put two new starters on. I went and looked at it and figured it was loose cables or corrosion, but it was fairly clean, and tight. We decided to pull the battery out of his van that he drives everyday, and I cleaned everything very good. Same thing. Pulled the belt to make sure nothing was lockup, same thing. Truck was running and starting great, then just did this one morning on him.
View 9 Replies
I recently caught up on some maintenance with my truck, changed the turbo pedestal seals, replaced both batteries, brakes, e-brake cable etc and installed new 10k hid headlights. its a single cab 250 with a 7.3 and zf6 4x4 with 133k. a couple days ago I turned on the headlights and the truck died, restarted no problem and would die the next 5 times I tried to turn them on, then it worked fine. yesterday I got in my truck to leave for work and got no wait to start light, no glow plug chatter, no fuel pump running. turns over just fine but no fire.
I got a ride to work and tried it when I got home, fired right up. I pulled the pCM, checked it out, no weird smells and my TS chip wasn't corroded or anything like that, worked fine. drove to 711 to get a 6 pack and it did the headlight thing again. I removed the HIDs because this all started after I installed them and reinstalled my silvanias and it didn't die when I turned them on. this morning went to leave for work, same no start condition. I disconnected both batteries for 30 seconds to reset anything and same problem. I was about ready to light it on fire this morning.
View 1 Replies
So a truck that was running fine Sat for 2 weeks. Battery died so i sent some coworkers to jump it. They tried using a welder which they didn't get turned down enough. Now the wiper motor stays on even without the key. Radio doesn't work but the dash light still comes on. With a new battery installed it turns over but doesn't start. I know something had to get fried but where to start. Thinking about replacing all fuses and relays...
View 7 Replies
My 2005 ford f250 fx4 won't activate when I turn the key the light illuminates then turns off but when I start the truck and select it it doesn't go into gear
View 2 Replies
As I am driving everything goes dead radio, windows, dash, alarms, everything then turns on a usually 30 seconds later. is it a ground? is it a sensor that's getting to warm? is it a loose wire? where should I start??
View 6 Replies
My truck is essentially stock except EGR DELETE. Lately I am seeing my coolant gauge in the cluster drop to zero instantly when the truck is warm. A quick glance to my edge monitor shows my ECT temp fluctuating wildly (but not stone cold) ranging from 65-190'ish degrees. The weird thing is even when it's showing low on the edge, Gauge showing nothing, it kicks my fan in. I would have thought that shouldn't happen because it's still showing a value ( very low yes) but maybe it pops into limp mode?
I am also having other gremlins like driving along all warmed up, come up to a hill and if I back out of the throttle, boost drops to zero and even with holding the pedal to retain the speed I am at, it just drops speed with no boost.. I then have to stomp on it and the boost will ramp back up. It will show something like 85% VGT but zero boost.. Is it normal to show zero boost with 66% vgt at idle in Park with no boost? Getting all sorts of codes lately. The coolant one is very intermittent (every drive several time but not every minute)..
View 1 Replies
I have a 2001 f250 5.4 triton. My cb antenna hole leaked water in cab, soaked my fuse block. Horn goes on and off, radio turns on without key in ignition, truck only starts when key is on and I bridge solenoid, and number 4 coil is not firing. I have let truck dry out, fixed the leak. Everything is bad to normal except starting issue and coil issue.
View 6 Replies
I recently bought a 2003 f350 7.3, I ordered a tuner for it and tried installing it, at one point while the ECM was still connected I did something and it sparked. Then the powertrain relay (302) started clicking really fast. It clicked in the on position. I switched it with another and it was also clicking. So since I sparke the ECM I figured I messed it up. I ordered another one and it's doing the same thing. Then I pulled fuse 45 (which was good) and put it back in. When I turned truck to on position it wouldn't click anymore, but it still won't start... What it could be? OV ruled out the ECM, powertrain relay (302) and fuse 45, I don't know what else to check.
View 2 Replies
I have a 96 f350 that I just replaced the batteries on and now when I go to start it does not hardly turn over. Starter just barely turns motor over and definitely not fast enough to start truck. Battery connections are tight and starter was replaced about 4 months ago.
View 4 Replies
I have a 2011 F350 Lariat diesel crew cab. All of a sudden my remote start will not work, sometimes i can do it 5 times and it will finally but most of the time I just hear a lot of clicking noises in the engine like relays or something. Also when I exit my vehicle, if I use either the key fob or the outside keypad on the door to lock the vehicle, the stereo system turns on and stays on. When I open the door it shuts off. The only other thing that might be related is the other day when I put my windshield wipers on, the worked in super super slow-motion, stopped and then started again but at like 1/4 of the normal speed.
View 2 Replies
I have a 2000 F250 with a V10, that won't start or turn over. I replaced the solenoid on the fender well, auto store check the starter 3 times and said it was good, new battery installed and same issue of not starting.
Here is a video of what it does when attempting to start : F250 starting issue - YouTube....
Where and what to look at?
View 10 Replies
I have a 2000 f 250 that will not start... I have replaced many parts all electronic sensorsm the past week i have spent in the neighborhood of 1800.00 on this truck. Cps, icp, idm, ebps, fuel filter, new oil, hpop level good, gpr, all new need starting........
View 4 Replies
From reading some of the posts on here it seems this is an air bag warning. 5 chimes five times in a row. The fuze is fine and there are no warning lights on the dash.
View 5 Replies
My trouble is upon turning key to start everything goes dead (no power to anything). Does not always happen, sometimes she starts just fine.
After the power cut out if I turn key off, wait a minute, then back to on position she will sometimes come back as normal or sometimes the on "ding" will chatter and dash lights will be dim.
I have checked batt connections, starter/solenoid connections, block ground connection. All seems fine. Get same problem when I jump starter with screwdriver. Been suggested to me ignition switch to blame.
View 5 Replies
Let me start out by saying that I have exhausted every option that I have read on every thread that I could find on the internet regarding my son's 2002 7.3L not starting. What I have is no 12v power to the starter solenoid at the starter when I crank the key. What we have done so far, had the starter and both batteries tested, all good. Swapped out the starter motor fuse and the starter relay. Tried a new ignition switch and a new trans position sensor. Found major corrosion in the fusible link junction box on the drivers inner fender so we cut out the fusible links and put in a temporary jumper wire, still no crank. I have power to the dash, power on the power cable at the starter. I can jump the terminals on the starter and the starter engages. I found the shifter linkage bolts loose under the dash and tightened them up also. We have been struggling with this for 3 days, out in the lovely Michigan weather, since it couldn't have died in his parking spot in our heated shop, and I am completely frustrated. Are we overlooking something glaringly obvious?
View 11 Replies
My '01 f250 7.3 has gotten hard to start. It seems to maybe be due to cooler weather, but not always. I have been told that there is some sort of valve in the fuel tank that could possibly cause this when the fuel gets around a 1/4 tank or so. But, it's doing it at any fuel level. But it doesn't do it all the time. I do notice it more in cooler weather. Anyway, when I try to crank it, I'll let the "wait to start" light go off and then wait a bit more. I'll turn it over and it almost as if the batteries are weak.
I'll stop and give it a few seconds and turn it again and it will normally start. But sometimes I'll do this 5 or 6 times and it will finally fire. But the more I have to try, it's like fuel builds in the cylinders and it smoke like a coal train for a minute or so. Almost like gas motor that has been flooded. But the smoke burns off and it runs like a top. I was thinking the batteries may be weak , but sometimes the starter will spin the motor with no trouble at all. I'm at a loss. Is it possible for fuel to drain from the system causing it to have to reprime itself? Here lately the smoking has me concerned even though it clears up.
View 7 Replies
I'm in a real jam because my work truck won't start. 1999 F250 7.3 Diesel 157k mi. - Air and fuel filters were replaced in the last 500 miles. This pup ran fine when I parked it last Wednesday before the holiday.
Checked for start last night because I'd been having battery issues, Both were replaced the previous week. It's cranking good but just won't start, not even a bit. No wait to start light, oil level is good, can not get obd reader to link.
View 8 Replies
The truck starter and radio would magically turn on and off after the first rain, it was hard on the starter and I had to replace the starter and the cause of that problem was the vacuum line coming from the brake booster running over the top of the wires in the 4 plugs attached to the driver side fender. It rubbed through exposing the wires and got wet connecting them. I cleaned them and put the electrical tape silicone and then it has been working fine for a couple months.
Now every time I try to start fuse #20 blows. So far I have traced the wire that goes through fuse 20 through the firewall being the blue wire with a orange stripe on it it goes through the top plug upper left most wire. From there I followed it through the 4 wheel fender plugs the furthest plug from the firewall still being the blue with orange stripe. If I unplug that plug and try to start the truck it won't start but the fuse does not blow.
I then followed that wire all the way to the neutral safety switch. I hate tracing wires. (About 8 hours so far). I am thinking neutral safety switch. Also another thing I am thinking is weird is that blue wire with the orange stripe is grounded when the safety switch is plugged into the transmission and if it is unplugged is is not grounded. And I don't think it is supposed to be grounded because that is the hot wire when the key is in the start position.
Details about the truck : 1999 f250 diesel 7.3 super duty automatic 4x4 dated 4/99
I have taken pictures of the plugs and wires I was going to post it but don't remember how.
View 8 Replies
I have a 2002 f250 superduty 5.4 4x4 around 317xxx original motor and trans. When it's cold out it won't start at all I have to use starting fluid but once started it will start right back up. Did the plugs fuel filter cleaned the intake and sensors still have a problem plenty of fuel pressure plenty of cranking amps brand new battery and Alternator. It just cranks and cranks when it's warm out fires right up. Runs smooth no lack of power or misfire no codes are being thrown also.
View 14 Replies
So, when trying to start my vehicle it doesn't even turn over. Just clicks continuously. Both of my batteries are putting out 12 Volts. I tried the old arcing my solenoid with a screw driver while key is in on position and I got a couple of turns, but it wouldn't completely turnover. My solenoid has power going to it. Checked all fuses that could coincide with this issue. Not sure where to go from here. I have an 05 Ford F-250 XLT.
View 7 Replies