Ford Super Duty (1999-2016) :: F250 - Reinstall Review Camera After Removing Tailgate
Aug 24, 2013
We got an F250 in June and had an ARE CX series cap installed on the truck yesterday. We didn't realize the installation of the cap would mean we lost the review camera when the tailgate was removed (DUH). We loved the review camera for hooking up our trailer and are wondering if there is any way to reinstall it on the cap. Or, purchase another camera and integrate it into the existing Ford screen......with the guidance lines?
View 2 Replies
Advertisement
I left town and accidentally left the tailgate on my 2011 F250 SuperDuty unlocked. It was stolen.
Found a replacement, replaced the broken handle, installed new key lock, transferred to camera and plugged it in. My rear-view mirror is not receiving the signal, just a blue screen. Is there something else I need to do to complete the process of connecting the camera.
View 7 Replies
I have a 2008 F250 that the tailgate has always been real easy to open and close until the other day I could not get it to latch so i slammed it and it did latch and it worked a few days but now it won't latch at all. I can open and close the latch with the tailgate down but nothing I do will make it latch in place. I've tried spraying with PB blaster it didn't work. Not sure if its out of adjustment or what.
View 2 Replies
I have a 2014 f250 with tailgate assist, How do I remove the tailgate from the truck?
View 14 Replies
I just bought a 'new to me' 2005 F250, Crew Cab with a v10. The Carfax showed up clean but after doing some detailing on it, I realized it had been resprayed and there was a little wrinkle in the bumper. I tried using the ignition key to lock the tailgate but it didn't work, so I'm assuming its been replaced. Need to confirm that the ignition key should be the key that works the tailgate lock or is the tailgate a different key that they guy never gave me?
View 8 Replies
I've got a 2005 F250, and I found a good deal on a 2013 tailgate in town. Just wanted to make sure a 2013 tailgate will fit a 2005 before I go through with this.
View 11 Replies
I'm trying to locate the part number (and a replacement) for the plastic piece that covers the top of the tailgate (when its shut) next to the step. It's about a 12 to 16 inch long piece of plastic which has some broken tabs on it, so everytime I drop the tailgate, it either flies out or starts to... I checked the fische online and I don't even see it in the picture. I did find some one-piece parts called "tailgate spoiler cap" but I didn't find any to fit a 2014 F-250 with the step on the tailgate. Should I just tell the wife to go hot-glue it ?
View 1 Replies
First tech post for my new truck. I just bought a hold-over but new 2015 F250 XL Supercab 2wd and love the simplicity of no unwanted options. That said, there are two features I am adding. The first is perfectly straightforward, cruise control (swap button cluster and have the function turned on by the dealer). The second is a tiny bit more involved, back-up camera, in mirror display with bluetooth hands-free (I like the simple AM/FM radio because I can work it all with gloves on).
So I basically need three things from the truck and my research has been inconclusive on a couple of things because most of the threads are for 2014 or earlier. I think I can pull switched 12V and ground (pin 1 and 4) plus reverse lights (center, or pin 7) all from the the trailer wiring harness. It appears these are not affected by the canbus load restrictions of other places to tap reverse signal (remember, XL so likely nothing in the overhead console for the auto-dimming rear view mirror). Are there any challenges with this when I do hook up my enclosed trailer or when it is not hooked up regarding the trailer brake controller/anti-sway?
I already found a good youtube video for how to route the wires so I think this is my primary challenge at this point.
View 14 Replies
Read about and want to clean my throttle body. Why have to remove it from the truck ? 2009 f-250 5.4 .....
View 5 Replies
Problem is two fold. First......my grill "Ford" emblem is chipping and fading. Second....there is rust along the inside edge of the tailgate near the weep holes. I have been told the rust must perforate the area in order for it to be covered by warranty. Truck is pretty close to pristine condition and two service reps said rust is coming from the inside of the tailgate. Doesn't make sense to me to wait for the rust to get really nasty before it being covered by warranty. I bet a new tailgate cost more than that!!!! Hey whats the deal with the eroding "Ford" emblem??? Looks like the coating is flaking off and letting the blue paint fade away. I don't think this is normal but that too doesn't seem to be covered by warranty !! Maybe I should think twice about my next vehicle !!!!! Comments ??????
View 14 Replies
I'm putting a new double din stereo w/ backup camera in my truck, I have everything wired except the violet/white wire (from the stereo) that needs to be hooked to a wire (on the truck) that will activate the camera when you put it in reverse. I cannot figure where this wire is on the 2012 for the life of me.
View 3 Replies
So I have a 2004 F250 5.4 regular cab 4wd long bed that was bought used with a very heavy Western Pro plow. The truck only has 70K miles and it is equipped with the snow plow package and heavy GVWR package. Since I had no use for the plow, I removed it and all mounting hardware as soon as I got it home. The truck wanders and bounces down the road terribly.
It is tiring to drive and requires total attention. Reading posts on here about "wandering" left me thinking my steering box was probably worn out. I replaced this without any change. I figured that I must have other components needing fixed, but had not had time or money to dig deeper yet.
Now, this morning when leaving work, the truck had accumulated nearly an inch of very heavy, wet snow with a small layer of ice on the hood. Driving home was as if I were in another vehicle. Everything was tight and much less "hopping" when hitting small bumps. So, this leads me to my question. Do you think that simply adding some weight back to the front end, i.e.,: bumper, or brush guard, could be my answer? Or, is this simply covering up a more extensive problem?
View 10 Replies
My 2003 tailgate locks by itself sometimes, has been just annoying, but today I can't unlock it. It has no electronic lock. What to do?
View 9 Replies
07 Superduty, Oxford white. I have been looking all around NC pick a parts for a decent replacement tailgate. I know more recent years will fit, with hinge mods. Question is, what is the most recent year that will fit with hinge swaps only?? Looking for a source in SC/NC/VA for a replacement?
View 7 Replies
Looking to get rid of the step handle, I did this mod on mine and it was a direct fit...take off old liner and unbolt handle, then get a liner from a non-step tailgate and it is a direct fit:
View 7 Replies
Just replaced my recently stolen tailgate. What are the dimensions for the King Ranch emblem location for a 2015?
Also, any way to tie the tailgate into the alarm system (similar to the way the hood is). I'm guessing that you could possibly tap into the wiring under the hood and add a switch/contact at the tailgate... Also, how would this interfere with engine immobilizer, etc?
View 5 Replies
Odd thing happened. All of a sudden the factory emblem on my 2008 tailgate totally lost all of its blue and is now pure chrome. Happened just like that.
Anyway, is it screwed on and do I need to pull the panel on the tailgate to remove it? Here's the tailgate on my truck for reference.
View 11 Replies
My truck is a 99 Superduty, low miles and no rust, Id like to find a tailgate for it. There's a guy on CL selling one from a 2001 F150' claims it'll fit. I'd like to know.
View 7 Replies
Looking to sell my '12 F-250 turbo diesel Lariat. She's in great condition, and only 8000 miles. Her only sore point is some scratches and scuffs on the plastic cap on the top edge of the tailgate (see picture below). I think it's part # BC3Z-9940602-B.
How to remove this cap, preferably without breaking/scratching anything else. It looks like there are no external fasteners, so I'm guessing it's just held on with clips on its underside, or some such. It might be more obvious once I get and examine the replacement part, but just figured I'd ask.
View 6 Replies
I tried to take my tailgate off my 08 F-450 today.
Did it the same as every tailgate Ive taken off in the last 20 years...........it wouldn't come.
Is there a trick to it?
View 6 Replies
So I want to add a backup camera to my truck. Ive got a headunit that will do it but I dont like how any of the aftermarket one really look and I dont like most of the locations to mount or the angle they mount at. So my question is will a tailgate handle from say a 2010 that has the factory hole for a backup camera fit in the spot of my 2001 tailgate handle? I have to replace the handle anyways since it broke this past weekend, thought Id add the camera while I was at it if I can get it to work like I want.
View 7 Replies