Ford Super Duty (1999-2016) :: F250 - Dead Battery - Low Clicking Noise In Cab
Oct 14, 2015
My 1999 f-250 7.3 has been sitting for months, and I went to start it and both batteries are dead. Replaced both batteries and at first the alarm went off like normal. Turned the alarm off, hit the unlock button and it beeped like normal. Got in and stuck the key in the ignition and tried to turn it over. Completely dead. Now I cant even get the alarm to go off, showing no signs that its even getting any power. And all I'm hearing is a low clicking noise in the cab.
View 5 Replies
Advertisement
Like the title says, if it sits over night the battery will be about dead. The cables were replaced 6 months ago and are in good shape. I could not find and bad spots on the wires I can get to. One odd thing to note, with the key out of the switch I opened the passenger door to check the glove box light and the truck started chiming like I had opened the drivers door with the key still in the switch. Would that indicate maybe the key switch could be the issue?
View 14 Replies
So, yesterday when I got home I stopped at the barn to unload a few bails of hay and when I got back in to crank it, nothing happened. I turned the key and nothing, so I figured I would just worry about it today. However, when I turned the key back to off and started to take it out all sorts of stuff started to happen. There was a clicking noise and a dinging, not like when the door is open. It was quicker. Also, when I turned my key back on none of my dash lights or radio came on. Nothing happens now, except the strange clicking when the key is off or out. The first thing I thought of was the GEM or fuse box.
View 3 Replies
Ok, I know the problem is the blend door, but not which one. I hear a clicking constantly whether the truck is started or not near the center of the passenger side. I can adjust the temp to be 65-70 on the driver side and be fine, but the passenger side is hot. I've looked for TSB's for 2010 and have come up empty. I bought the truck used, and bought an extended warranty, but not sure it will cover this repair.
Is there a TSB for this? If you had this done at the dealer, how much did it cost to repair? Would you attempt the repair yourself? I've taken the dash apart to find the problem, but then determined it might be too involved for me to do and I wasn't comfortable disconnecting the air bags.....
View 1 Replies
2004 F-250 FX4 SB 5.4 V8 140k
Issue: rattling/clicking noise from passenger front wheel area at speeds lower than 15MPH, made worse under light braking and/or turns to the right.
Clicking sound is speed dependant.
Spindle? Hub? Balljoint? Sway joint? Rotor Issue?
View 14 Replies
My trouble is upon turning key to start everything goes dead (no power to anything). Does not always happen, sometimes she starts just fine.
After the power cut out if I turn key off, wait a minute, then back to on position she will sometimes come back as normal or sometimes the on "ding" will chatter and dash lights will be dim.
I have checked batt connections, starter/solenoid connections, block ground connection. All seems fine. Get same problem when I jump starter with screwdriver. Been suggested to me ignition switch to blame.
View 5 Replies
I have 2002 F250 4x4 with 5.4 V8. It has auto locking hubs. If I haven't used the 4wd lately I have to manually lock the hubs in, right side sticks, so I have to use pliers to lock into place. After a few times it works in auto fine. Anyway my issue. I went to use my 4wd so I manually locked the hubs, hopped in the truck and flipped it into 4wd. When I did the instrument cluster died. Radio, power windows and locks, turn signals all work. I just don't have any speedo, tach, fuel gauge, water temp, battery, no odometer. All went blank. I checked some of the fuses that I thought it could be from the owners manual but still no luck.
View 3 Replies
I pushed the Tow/Haul button on the gear shift and my instrument cluster went DEAD. Have checked the 3 fuses labeled instrument panel (F4,F35,F41) and they look OK.
2003 F250 6L diesel .....
View 11 Replies
I have a 2002 f250 7.3 with a dead pedal and gauges. This has happened to me once before checked fuse 45 and it was blown. I didn't know that the po used a 30 amp fuse when it should have had a 15 amp. I replaced it with a 30 not knowing. Well coming home the other night it happened again gauges dead and pedal. Checked fuses all were good. Found this site and read about the cause in the shifter. Took that apart and fixed the wire that was broken in half. My question is what else is fried now from having a 30 amp fuse in while it was shorting out since I have no gauges and gas pedal.
2002 f250 banks six gun
banks 4 inch exhaust
View 2 Replies
Did the blue spring upgrade today. The driver side battery was disconnected for 2 hours. After finishing the upgrade I reconnected the battery. When I touched the positive cable to the battery I heard a fuse blow. Now I have no lights, chimes, instruments, gauges, NOTHING, everything is dead. Cannot find any fuse blown. Is there a master fuse?
View 1 Replies
I picked up a 2013 F250 back in Sept. currently about 5k miles. I've had in the shop twice. Once for a loud moonroof vibration when idling and just recently another for a PCM update(Engine light came on).
Here's the problem...
Something odd happened when I drove about a 1/4 mile... The dashboard lit up like a christmas tree and gave every error known to man. All dashboard lights came on, parking break, engine light, etc. Then the computer dash gave an AdvanceTrac Error, Oil pressure low and something else I can't recall. All my gauges went dead, including the Speedometer. Mind you, this was while driving... The only gauge working was the fuel gauge.
Turned the truck off, back on, everything works as normal. The truck has not showed any issues since (2 days of short distance drives).
I called the Service Dept and spoke with my guy. He never heard of this before and kind of wrote it off... Said, they won't be able to figure out unless it happens while they have it. This doesn't sound right to me.
My nose is pointing at the PCM update or a possible grounding issue.
View 14 Replies
I'm having multiple electrical problems and not sure if all related or not but they started at the same time.
1) Occasionally (getting more frequent) truck acts like its almost dead and wont start, but if i remote start it cranks right up
2) Radio doesn't shut off when I open the door, but if i close it and open again it does
3) phone staying connected to bluetooth but its acting up when trying use phone for music
Pretty sure there is more but I cant think of them now.
View 2 Replies
I just bought a 99 f250 2wd with 290k on it and my only issues are brake shutter and steering play.
The steering has about an inch to two dead space at center while driving. The truck tracks straight and doesn't wander at all. I was wanting input on what i should look at first to fix the dead space in the wheel. Its a little iffy having to steer through dead area to get steering output.
I just need something good so I can do it once and not have warped rotors again.
View 2 Replies
I have a 2003 f250 5.4 with a couple of bad valves and low compression and a dead miss because of it... I just bought what appears to be a 2001 5.4 from an f150... I am worried now this engine wont work and cannot find anything online that can tell me yes or no....
View 12 Replies
I bought a 2005 F350 in January of 2012. At the time of purchase, I noticed that the truck seemed slow to turn over. I talked the dealer into installing 2 new 750 CCA Ford batteries at the time of sale.
I have put less than 7,000 miles on the truck since the day I bought it. In August of 2012, I went to start the truck and the batteries were completely dead. I charged them, started the truck, and the next day the truck was dead again.
I took the batteries out, and took them to the dealer. They replaced both of them under warranty. They said that after they charged them, each tested at less than 85 CCA.
In July of 2013, the same thing happened. I used the truck one day, and then the next day the batteries were completely dead. I had them tested at the dealer, and the passenger side battery failed the test. The driver's side passed. They replaced the passenger side under warranty, again. This time, they also cleaned all battery / ground connections and tested the charging system. Everything passed.
Last week, I went to start the truck. Same thing again. Took the truck to the dealer, and both batteries, after charging, failed the test. They replaced both batteries under warranty.This time, on each battery, the dealer had written with yellow paint pen on the batteries AND on the radiator shroud "BATTERY NOT UNDER WARRANTY."
I asked the dealer about this, and they said that since they have replaced 5 batteries in the truck, and since it has 152,000 miles on it, the warranty is no longer valid. I argued that since they have checked the truck thoroughly, and found no issues with the charging system, they can't void the warranty like that.
So, what is the reason why the batteries would fail like that, and that frequently?
View 7 Replies
As I am driving everything goes dead radio, windows, dash, alarms, everything then turns on a usually 30 seconds later. is it a ground? is it a sensor that's getting to warm? is it a loose wire? where should I start??
View 6 Replies
I have a 2008 f250 superduty with the v10. Just today I was driving and engine picked up.slight miss it's rainy. I thought coil pack, but it left me on side of road. Got fired limped home won't go more than 40mph. Runs rough, no power, checked codes and get P0340, p0357, p1336, and P2195.. Where to start.. My daily driver and have to get back on road.
View 1 Replies
160,000 miles and cylinder 7 is dead and 3 is dying, valves probably with rings right behind. Is it better to rebuild or buy a crate motor? Buying a crate motor, will a 5.0 fit? Should I spend the 5 or so grand beefing up this one, dropping in a 302 or putting it toward a newer model?
View 2 Replies
Basically I have a 2008 f250 (6.4l if that makes any difference) That wont engage into 4x4. When you go to turn the switch to engage the 4x4 all you get is a click click click click click. Is that a problem with the 4x4 shifting solenoid on the transfer case? Anything else to look for? The truck has 95k miles on it....
View 2 Replies
I've got a 2003 F250, SD, 5.4L Triton that I've owned since new. It has 205,000 kms on it and has run flawlessly since owning it.
Yesterday I went to use the truck after it sitting for about 2 weeks, which isn't uncommon for this time of year as I'm in the landscaping business. It never sits long, though as I make a point of using all the trucks, periodically, just to "blow the stink off" as my Dad would say.
Anyway, when I fired it up the gauge was drop-dead below "E" so I go to fill it up and it takes in fuel and it won't take a drop more. I got under the truck and knocked on the tank in various spots and the tank seems almost plum full.
When I power the truck off and back on, all the gauges come to life and settle on their appropriate readings, except for the fuel gauge. It powers up to full and then drops to below "E" as though I had turned the truck off again.
My question is, am I reasonably safe to assume my sending unit has bitten the dust? I figured that since the gauge comes to life upon startup and then drops to "E" after the rest of the gauges initialize, the fuel gauge itself probably isn't the problem?
Is there a chance that as I drive it over the next few days, and the tank empties, maybe the "sloshing" of fuel might dislodge a stuck part?
View 3 Replies
1999 ford F250 SD V10 ... When this goes on the truck misfires and tries to die. Usually I can key the ignition in nuetral and the clicking stops and the truck starts and runs better....
View 6 Replies
