Ford Super Duty (1999-2016) :: F250 Cranking Good But Just Won't Start
Nov 30, 2015
I'm in a real jam because my work truck won't start. 1999 F250 7.3 Diesel 157k mi. - Air and fuel filters were replaced in the last 500 miles. This pup ran fine when I parked it last Wednesday before the holiday.
Checked for start last night because I'd been having battery issues, Both were replaced the previous week. It's cranking good but just won't start, not even a bit. No wait to start light, oil level is good, can not get obd reader to link.
View 8 Replies
Advertisement
I drive a 2002 F-250 7.3l and have been having a lot of issues. The most recent one is that my truck won't crank unless I've had the block heater plugged in. Like I said in the title, the batteries are supposedly fine. They've been tested by a mechanic and Advanced Auto Parts. But when I crank the truck, it will only turn over for 10 seconds or so before it loses enough juice to even turn over. So it's kind of cold, but only 40-50 degrees, so I didn't think the truck would have that much of a problem starting. I'm wondering if my issues are a combination of an electrical problem and a heating issue.
View 8 Replies
I have a 2003 F250 with 157,000 mile. Left the house last week and got about a mile down the road when I realized I had forgotten something. Pulled off to turn around and had no power to get back onto the road. RPMs wouldn't go over about 1500. Finally got it on the road and it completely shut off. Was able to get it home and have been tinkering with it. Stats from Scangauge are as follows:
Key on not cranking.
IPR 14.81%
FICM 47.6-48.0
Sync=0
ICP 32
Data while cranking.
IPR 43-47%
FICM 38-42
Sync=1
ICP 1532
I'm leaning towards a bad FICM but the ICP pressure seems to be high to me.
View 5 Replies
The engine was just rebuilt, 7.3L diesel. New bottom end, cam and turbo also new harness for valve covers and injectors, new #8 injector(#8 cylinder lost compression). The engine cranks and idles great. Run it up to 1800rpm - 2200rpm and you get a miss or skip. Almost like the engine turns off and back on very quick, and it makes a clank noise. No codes, reading it with a OTC Genisys 4.0. I also swapped the PCM and IDM with another truck and it still does same thing. Other truck runs fine. Year model 2000 w/ 230,000 miles
View 1 Replies
My 2003 F-250 (gas V8) will always start right up when it is cold. However, once it has warmed up, it often will not start. Cranks fine, but not even wanting to start (like someone pulled all the plug wires) and has left me stranded until I wait for 3+ hours for it to cool back down. Doesn't trip the check engine light, but seems to be due to the engine being hot. What this could be?
View 7 Replies
So, back in July I had some issues with my V10 F250 not cranking after a bad rain storm. (New battery was installed May 2011) and ended up recharging the battery & replacing the alternator. Have not had any problems since until yesterday as I was going to use the pickup. I drove it on Thursday with no problem and Friday Tropical Storm Lee came in with TONS of rain. Now NOTHING AGAIN. I also noticed a drop of water coming from overhead console (trip computer module that has not worked since I've had it).
So I pulled the overhead console out and water was beaded around the center overhead clearance light opening. I dried that one with a paper towel and looked under the headliner and others were slowly leaking. After looking the center one already had a drop beaded again. Would this cause a short that would drain the battery? Also having the battery drained so bad twice in 2-3 months is this going to degrade the capacity of my 5 month old battery?
View 14 Replies
Dealing with a 02 f350 7.3 powerstroke . The engine cranks fine . It fires but won't start smoke coming from exhaust while cranking and firing so seems to have good fuel . When it does start it misses for a few minutes and blue/white smoke . When the miss ends so does the smoke and starts fine after that and runs great until it sits for 12 or more hrs . Then back to same start issues . Fresh oil ,new glow plugs, new cover gaskets , glow plugs test at 1.3 ohm across all 8 of them , no voltage drop through glow plug relay , good voltage to each glow plug when tested right at glow plug terminal on each feed right at glow plug , fuel filter housing stays full doesn't seem to bleed back , high pressure oil pump pressure test was high enough to trash a 1000 lbs gauge in 2 to 3 revalutions of engine when cranking . Tested at presure sensor port .
View 2 Replies
Bought 02 350 DRW, started hard first day, now not cranking. Seen a post on neutral transmission switch and mine is not lining up, but need to adjust the rod out of transmission also? I was able to match lines on switch but with flanges on fitting it will move back out of place when moving it to fit in bolts.
View 4 Replies
Found some oil and maybe coolant mix come out of one of my exhaust pipes. Trucks smoking pretty bad what is it?
View 13 Replies
My a/c compressor crapped out a summer or two ago. I ordered a new compressor and dryer, oiled up the compressor properly, hooked it all up, vacuumed out the system, filled it with fresh 134a and it worked just fine for about a year. Mid-late last summer, the a/c quit working, so I hooked up my gauges to check it out.
Everything reads in the proper range. The high side is only about 150, which isn't stellar, but not terrible either - certainly enough to cool things down. Anyways, when I was sitting at idle checking things out, my compressor was running all the time and not cycling on or off. Given that I was not overcharged (according to my HF gauges), I tried to add a little more to it. It would only take half a bottle and the compressor never started cycling on/off, so I stopped tinkering with it for a while to think on it. I noticed that when I had it on driving in town, I could hear the a/c kick on and off every couple seconds like it was still low, but my gauges didn't indicate that it was low and it wasn't taking a charge like it was low. This whole time, the air from the vents is not even cool - just straight outside air temp and the lines don't feel cold either.
I had hot-wired my compressor to stay on and same story. The gauges show it's compressing with the low side right where it's supposed to be and the high side a tad low at idle, but easily jumping up to within spec with mild revs. The whole time, the vents and a/c lines are no colder than ambient.
View 10 Replies
I have a 2000 F250 with a V10, that won't start or turn over. I replaced the solenoid on the fender well, auto store check the starter 3 times and said it was good, new battery installed and same issue of not starting.
Here is a video of what it does when attempting to start : F250 starting issue - YouTube....
Where and what to look at?
View 10 Replies
I have a 2000 f 250 that will not start... I have replaced many parts all electronic sensorsm the past week i have spent in the neighborhood of 1800.00 on this truck. Cps, icp, idm, ebps, fuel filter, new oil, hpop level good, gpr, all new need starting........
View 4 Replies
From reading some of the posts on here it seems this is an air bag warning. 5 chimes five times in a row. The fuze is fine and there are no warning lights on the dash.
View 5 Replies
I have a 2002 f-250 7.3 diesel, i straight piped it but only by cutting muffler off and welding a piece of pipe in its place, it is pretty loud but id like to hear the turbo more like more of a whistle, it has a pretty good whistle once i get past 1500 rpm, is there a slightly bigger turbo i could put on without putting too much strain on the 180,000 mile engine?
View 6 Replies
My trouble is upon turning key to start everything goes dead (no power to anything). Does not always happen, sometimes she starts just fine.
After the power cut out if I turn key off, wait a minute, then back to on position she will sometimes come back as normal or sometimes the on "ding" will chatter and dash lights will be dim.
I have checked batt connections, starter/solenoid connections, block ground connection. All seems fine. Get same problem when I jump starter with screwdriver. Been suggested to me ignition switch to blame.
View 5 Replies
I have a '99 F-250 super duty with a 5.4 L engine and I am having trouble starting it. Initially it wouldn't turn over at all, so I had the battery checked, it was fine, and after charging it the engine would turn over very, very slowly once or twice then stop. I then replaced the starter and now it turns over very erratically but wont start.
View 4 Replies
Let me start out by saying that I have exhausted every option that I have read on every thread that I could find on the internet regarding my son's 2002 7.3L not starting. What I have is no 12v power to the starter solenoid at the starter when I crank the key. What we have done so far, had the starter and both batteries tested, all good. Swapped out the starter motor fuse and the starter relay. Tried a new ignition switch and a new trans position sensor. Found major corrosion in the fusible link junction box on the drivers inner fender so we cut out the fusible links and put in a temporary jumper wire, still no crank. I have power to the dash, power on the power cable at the starter. I can jump the terminals on the starter and the starter engages. I found the shifter linkage bolts loose under the dash and tightened them up also. We have been struggling with this for 3 days, out in the lovely Michigan weather, since it couldn't have died in his parking spot in our heated shop, and I am completely frustrated. Are we overlooking something glaringly obvious?
View 11 Replies
My '01 f250 7.3 has gotten hard to start. It seems to maybe be due to cooler weather, but not always. I have been told that there is some sort of valve in the fuel tank that could possibly cause this when the fuel gets around a 1/4 tank or so. But, it's doing it at any fuel level. But it doesn't do it all the time. I do notice it more in cooler weather. Anyway, when I try to crank it, I'll let the "wait to start" light go off and then wait a bit more. I'll turn it over and it almost as if the batteries are weak.
I'll stop and give it a few seconds and turn it again and it will normally start. But sometimes I'll do this 5 or 6 times and it will finally fire. But the more I have to try, it's like fuel builds in the cylinders and it smoke like a coal train for a minute or so. Almost like gas motor that has been flooded. But the smoke burns off and it runs like a top. I was thinking the batteries may be weak , but sometimes the starter will spin the motor with no trouble at all. I'm at a loss. Is it possible for fuel to drain from the system causing it to have to reprime itself? Here lately the smoking has me concerned even though it clears up.
View 7 Replies
The truck starter and radio would magically turn on and off after the first rain, it was hard on the starter and I had to replace the starter and the cause of that problem was the vacuum line coming from the brake booster running over the top of the wires in the 4 plugs attached to the driver side fender. It rubbed through exposing the wires and got wet connecting them. I cleaned them and put the electrical tape silicone and then it has been working fine for a couple months.
Now every time I try to start fuse #20 blows. So far I have traced the wire that goes through fuse 20 through the firewall being the blue wire with a orange stripe on it it goes through the top plug upper left most wire. From there I followed it through the 4 wheel fender plugs the furthest plug from the firewall still being the blue with orange stripe. If I unplug that plug and try to start the truck it won't start but the fuse does not blow.
I then followed that wire all the way to the neutral safety switch. I hate tracing wires. (About 8 hours so far). I am thinking neutral safety switch. Also another thing I am thinking is weird is that blue wire with the orange stripe is grounded when the safety switch is plugged into the transmission and if it is unplugged is is not grounded. And I don't think it is supposed to be grounded because that is the hot wire when the key is in the start position.
Details about the truck : 1999 f250 diesel 7.3 super duty automatic 4x4 dated 4/99
I have taken pictures of the plugs and wires I was going to post it but don't remember how.
View 8 Replies
I have a 2002 f250 superduty 5.4 4x4 around 317xxx original motor and trans. When it's cold out it won't start at all I have to use starting fluid but once started it will start right back up. Did the plugs fuel filter cleaned the intake and sensors still have a problem plenty of fuel pressure plenty of cranking amps brand new battery and Alternator. It just cranks and cranks when it's warm out fires right up. Runs smooth no lack of power or misfire no codes are being thrown also.
View 14 Replies
So, when trying to start my vehicle it doesn't even turn over. Just clicks continuously. Both of my batteries are putting out 12 Volts. I tried the old arcing my solenoid with a screw driver while key is in on position and I got a couple of turns, but it wouldn't completely turnover. My solenoid has power going to it. Checked all fuses that could coincide with this issue. Not sure where to go from here. I have an 05 Ford F-250 XLT.
View 7 Replies
