Ford Super Duty (1999-2016) :: F250 - Brake Shutter - Steering Has Dead Space?
Mar 1, 2016
I just bought a 99 f250 2wd with 290k on it and my only issues are brake shutter and steering play.
The steering has about an inch to two dead space at center while driving. The truck tracks straight and doesn't wander at all. I was wanting input on what i should look at first to fix the dead space in the wheel. Its a little iffy having to steer through dead area to get steering output.
I just need something good so I can do it once and not have warped rotors again.
View 2 Replies
Advertisement
My question is this...when my foot makes contact with the brake pedal there is about a quarter or half inch of "space" where I can push the pedal forward before you can feel whatever the pedal pushes against make contact and begin applying braking.
This dead space area will always activate the brake lighting but until you reach that next part under the dash somewhere no braking occurs.
I am quite used to driving my 2010 and this doesn't occur....can not remember if the 99 has always done that and i just realized it or if this is a new issue.
Brakes and stops great with and without load. No issues otherwise. Pedal pops out quickly and normally when taking your foot off.
View 1 Replies
Having trouble with a shutter upon take off in there drive train. It only happens when I am going straight. It does not do it when I am turning or anything. I just bought the truck used sat. It has around 18000 miles on it. I haven't had a chance to put a load on it yet to see if it does it then.
View 14 Replies
As the title states I just finished putting pads and rotors on the front of my 04' f250. I have had a terrible shutter almost a bouncing effect while braking over the last week or so, finally got around to doing the work and still no satisfaction! My question is where to go next? Wheel bearings and tires are good, I do get a pretty good wobble/vibration in the pedal while braking. Should I be looking at a brake booster or master cylinder? Or is it possible it's a caliper? Truck goes down the road fine until and brake is applied.
View 4 Replies
My trouble is upon turning key to start everything goes dead (no power to anything). Does not always happen, sometimes she starts just fine.
After the power cut out if I turn key off, wait a minute, then back to on position she will sometimes come back as normal or sometimes the on "ding" will chatter and dash lights will be dim.
I have checked batt connections, starter/solenoid connections, block ground connection. All seems fine. Get same problem when I jump starter with screwdriver. Been suggested to me ignition switch to blame.
View 5 Replies
Like the title says, if it sits over night the battery will be about dead. The cables were replaced 6 months ago and are in good shape. I could not find and bad spots on the wires I can get to. One odd thing to note, with the key out of the switch I opened the passenger door to check the glove box light and the truck started chiming like I had opened the drivers door with the key still in the switch. Would that indicate maybe the key switch could be the issue?
View 14 Replies
I have 2002 F250 4x4 with 5.4 V8. It has auto locking hubs. If I haven't used the 4wd lately I have to manually lock the hubs in, right side sticks, so I have to use pliers to lock into place. After a few times it works in auto fine. Anyway my issue. I went to use my 4wd so I manually locked the hubs, hopped in the truck and flipped it into 4wd. When I did the instrument cluster died. Radio, power windows and locks, turn signals all work. I just don't have any speedo, tach, fuel gauge, water temp, battery, no odometer. All went blank. I checked some of the fuses that I thought it could be from the owners manual but still no luck.
View 3 Replies
I pushed the Tow/Haul button on the gear shift and my instrument cluster went DEAD. Have checked the 3 fuses labeled instrument panel (F4,F35,F41) and they look OK.
2003 F250 6L diesel .....
View 11 Replies
I have a 2002 f250 7.3 with a dead pedal and gauges. This has happened to me once before checked fuse 45 and it was blown. I didn't know that the po used a 30 amp fuse when it should have had a 15 amp. I replaced it with a 30 not knowing. Well coming home the other night it happened again gauges dead and pedal. Checked fuses all were good. Found this site and read about the cause in the shifter. Took that apart and fixed the wire that was broken in half. My question is what else is fried now from having a 30 amp fuse in while it was shorting out since I have no gauges and gas pedal.
2002 f250 banks six gun
banks 4 inch exhaust
View 2 Replies
My 1999 f-250 7.3 has been sitting for months, and I went to start it and both batteries are dead. Replaced both batteries and at first the alarm went off like normal. Turned the alarm off, hit the unlock button and it beeped like normal. Got in and stuck the key in the ignition and tried to turn it over. Completely dead. Now I cant even get the alarm to go off, showing no signs that its even getting any power. And all I'm hearing is a low clicking noise in the cab.
View 5 Replies
I picked up a 2013 F250 back in Sept. currently about 5k miles. I've had in the shop twice. Once for a loud moonroof vibration when idling and just recently another for a PCM update(Engine light came on).
Here's the problem...
Something odd happened when I drove about a 1/4 mile... The dashboard lit up like a christmas tree and gave every error known to man. All dashboard lights came on, parking break, engine light, etc. Then the computer dash gave an AdvanceTrac Error, Oil pressure low and something else I can't recall. All my gauges went dead, including the Speedometer. Mind you, this was while driving... The only gauge working was the fuel gauge.
Turned the truck off, back on, everything works as normal. The truck has not showed any issues since (2 days of short distance drives).
I called the Service Dept and spoke with my guy. He never heard of this before and kind of wrote it off... Said, they won't be able to figure out unless it happens while they have it. This doesn't sound right to me.
My nose is pointing at the PCM update or a possible grounding issue.
View 14 Replies
I'm having multiple electrical problems and not sure if all related or not but they started at the same time.
1) Occasionally (getting more frequent) truck acts like its almost dead and wont start, but if i remote start it cranks right up
2) Radio doesn't shut off when I open the door, but if i close it and open again it does
3) phone staying connected to bluetooth but its acting up when trying use phone for music
Pretty sure there is more but I cant think of them now.
View 2 Replies
I have a 2003 f250 5.4 with a couple of bad valves and low compression and a dead miss because of it... I just bought what appears to be a 2001 5.4 from an f150... I am worried now this engine wont work and cannot find anything online that can tell me yes or no....
View 12 Replies
As I am driving everything goes dead radio, windows, dash, alarms, everything then turns on a usually 30 seconds later. is it a ground? is it a sensor that's getting to warm? is it a loose wire? where should I start??
View 6 Replies
I have a 2008 f250 superduty with the v10. Just today I was driving and engine picked up.slight miss it's rainy. I thought coil pack, but it left me on side of road. Got fired limped home won't go more than 40mph. Runs rough, no power, checked codes and get P0340, p0357, p1336, and P2195.. Where to start.. My daily driver and have to get back on road.
View 1 Replies
160,000 miles and cylinder 7 is dead and 3 is dying, valves probably with rings right behind. Is it better to rebuild or buy a crate motor? Buying a crate motor, will a 5.0 fit? Should I spend the 5 or so grand beefing up this one, dropping in a 302 or putting it toward a newer model?
View 2 Replies
I've got a 2003 F250, SD, 5.4L Triton that I've owned since new. It has 205,000 kms on it and has run flawlessly since owning it.
Yesterday I went to use the truck after it sitting for about 2 weeks, which isn't uncommon for this time of year as I'm in the landscaping business. It never sits long, though as I make a point of using all the trucks, periodically, just to "blow the stink off" as my Dad would say.
Anyway, when I fired it up the gauge was drop-dead below "E" so I go to fill it up and it takes in fuel and it won't take a drop more. I got under the truck and knocked on the tank in various spots and the tank seems almost plum full.
When I power the truck off and back on, all the gauges come to life and settle on their appropriate readings, except for the fuel gauge. It powers up to full and then drops to below "E" as though I had turned the truck off again.
My question is, am I reasonably safe to assume my sending unit has bitten the dust? I figured that since the gauge comes to life upon startup and then drops to "E" after the rest of the gauges initialize, the fuel gauge itself probably isn't the problem?
Is there a chance that as I drive it over the next few days, and the tank empties, maybe the "sloshing" of fuel might dislodge a stuck part?
View 3 Replies
I have a 2001 F250 SD V10 and when at a dead stop and with the brakes applied, steering becomes very stiff and almost impossible to turn the wheels. If I let off of the brakes and move a little the steering is just fine. I hate like hell to spend the money on a new power steering pump if it isn't going to fix the problem. Simply put, deap stop, brakes on, wheels don't want to steer. How do I fix it?
View 10 Replies
The problem is I haven't seen one for a recent (2011+) SD. I don't see anything that resembles a rear drum. They look like 2 huge regular disc brakes.
I live on a hill. My old man taught me to put the trans in neutral, autos and manuals, put the ebrake on and make sure it holds the vehicle, then put the trans into park or 1st gear. This way the weight of the vehicle doesn't rest on the transmission.
How do I adjust the Ebrake? It's ALMOST holding the truck, just needs a minor tweak. I don't see the dust cover the write ups described at all. The one that reveals the Star Wheel. Are they different on these years then prior SD's?
View 14 Replies
I am experiencing what feels like a "bump in the rear" when initially starting from a dead stop. It feels like a car behind me tapped the bumper or that the truck "hunkers down" first, then moves. Tranny seems fine also. Once moving, there is no problem whatsoever. There atre no noises, leaks, or other symptoms. Also, when coming to a stop, it feels the same way just before the truck completely stops. If I drift forward a little, then apply the accelerator, it does not "slip" or hunker down.
Took it to the dealer and they claim that they can't find anything wrong and may just be the suspension releasing? The truck does this whether loaded or not?
2001 F250 CC Lariat SB 7.3
View 14 Replies
Is there a steering stabilizer for a 92 Ford F-250 custom 2wd? and what's the difference between a f250 custom and a f250 heavy duty?
View 2 Replies
