Ford Super Duty (1999-2016) :: F250 - Both Motors Moving Mirrors Run At Same Time?
Jul 26, 2015
I have a 1999 F250 Superduty with power tow mirrors. Both mirrors are having this issue. It seems both motors moving the mirrors are trying to run at the same time. I tried replacing the control switch since both mirrors are having the issue, but got the same results. Holding the switch to move the mirrors out causes it to move down and out. Moving it in and it goes up and in. I know from experience with electric on a vehicle that when funny things happen, its usually because it lost the ground.
View 1 Replies
Advertisement
I'm replacing tow mirrors on my 2004 F250 with 2008 mirrors. Both are factory Ford mirrors. Need wiring diagram since connectors and wires are different. They both have power mirrors, turn signals, heated mirrors, but are not power retract or fold.
View 1 Replies
While cleaning the door handles the switch to extend and retract the side view mirrors hung was depressed and evidently got stuck as it was still pressed in. My hope is that this just blew a fuse and not burn up anything. The mirrors still fold and can be adjusted just not extended. Is there a fuse specific for this that may be blown?
View 2 Replies
How to remove the side mirrors (top and bottom) on my 2016 F250? I don't need to remove the entire assembly (off the door), just need to get behind the mirrors themselves.
View 5 Replies
How to disassemble the power fold mirrors on my 2011 F250.
The mirrors work in every way except they will not fold in or out. You can hear the motor start but then stops right away. It does not sound like the gear is stripped just that the motor is stuck some home. It happened to both mirrors about the same time.
I was going to take one apart and see if there is a issue. I can't see there being a electrical issue, but maybe, since the driver side starts then stops within 1 second. It's hard to tell about the passenger side since the switch is on the drivers side.
View 10 Replies
I just got my truck recently, when I purchased it the power mirrors do not work. Already checked the 5A fuse and it is good. Tried putting in a new switch from O'Reilly's and still did not work. Are these switches supposed to light up like the window and lock switch? Thinking it might be a break in the wiring or motors are seized but I've read that is not as common.
View 1 Replies
The power mirrors on my F-250 works halfway. I can get them to move inward but not outward. They also will upward but not down. These are both mirrors. Could it be the switch?
View 3 Replies
I was driving home the other day when all of a sudden all of my electronics in my truck turned off. Turned out when I got home my battery terminal was loose so it ended up shorting out. (fixed that) but when that happened my fuel was just under half way. The next day I filled up and was pulling a 3,000 pound trailer. My gas gauge didn't move at all, all weekend it was stuck at full until I actually went over a bump and it started moving down to a quarter. I knew here was no way I could go all weekend pulling a trailer and only lose a quarter of gas so I filled up again and was only be able to fill up 14 gallons.
View 4 Replies
I'm having an issue on my 2008 f250 power stroke. My telescoping mirrors are causing the fuse to blow instantly when I hit the button. Where to start looking for a short?
View 2 Replies
I just bought a 2001 F250 XLT and it came with the standard power paddle mirrors. I would love to add the towing mirrors (preferably heated with signals), but what I am wondering is if the connectors for the mirrors are the same. Also would my truck that came with the standard paddle mirrors be wired for turn signals and heated options? How would I test for this? Also do all XLT's come prewired for the hardwire keyless entry pad if they have keyless entry?
View 1 Replies
Actually a couple of questions. I've had one oil change in my F250 6.7. Getting close to the second one. So, my question is, what is the computer using to decide when to tell you that you should change the oil? And, if you changed to a synthetic oil, could you go longer between changes? And, if so, would the truck's sensors be able to tell the difference in the type of oil being used?
View 4 Replies
I have a 2008 Ford F250 with 6.4. Having alot of problems with the 4X4. Went to put the truck in 4 wheel drive one day and noticed the light on the dash never came on to engage 4X4. Of course we had a big snow storm coming and I didn't have 4 wheel drive. I drove the truck across town and decided to just try 4x4 again and it worked that time. I got the light on the dash and could hear the transfer case shift motor engage. Came out a little later and tried it and it wasn't working again. Took truck to shop where they replaced transfer case shift motor with a remaned motor from oriellys.
4x4 worked for a few weeks then just started doing the same thing again. We thought maybe that motor had problems also so had it replaced too. Truck is still doing the same stuff. Sometimes it works sometimes it doesn't. Figured out that if its not working and I leave it in 4x4 and unhook power to shift motor then plug it back in it will engage 4x4. I've seen some post on here but sounds like everyone i've seen their motor just stops and doesn't work at all.
View 8 Replies
My 2005 F-250 6.0 liter Diesel FX4 Lariat is blowing AC through defrost only all the time. I have manual locking hubs and when I engage 4x4 it works perfectly through the ESOF switch. So I am assuming the vacuum pump and lines to the hubs are in good working order but there is possibly a cracked line or fuse blown? I've only had the truck for 2 days and it just happened after purchase. I'm a little unfamiliar with checking vacuum but have done reading and I believe I can do it. I am going to get a manual hand pump and pump to 20lbs and loss shouldn't exceed 1lb per minute. I just need to know which direction to look. Everyone else had their 4x4 not working and I seem to be the only one posting that has ESOF 4x4 capability when the defrost only issue is on.
View 11 Replies
The tach in my 01 F250 PSD has become intermittent. It works properly some of the time, not at all some of the time, and jumps up and down some of the time.
Does it get it's signal from the CPS? It has a blue CPS that's about a year old and the truck runs fine?
View 6 Replies
Looking for some info on wiring up some Day Lights Running Lights on a 2016 F250 with diesel engine? Thinking of adding LED lights to front of vehicle for day time use.
View 13 Replies
My 2005 Ford F250 6.0 diesel CLIMATE CONTROL DEFAULTS TO DEFROST mode all the time now. For some reason I'll turn on the AC and it is either already in defrost or changes to it no matter what I do. Is the head unit in the dash the problem or is it a vacuum leak or an electrical issue?
View 2 Replies
I just bought this truck,2013 f250 CC Lariat 4x4. The sliding rear windows opened and closed 1 time and has never done it again. I have read about the motor and cable setup breaking and needing to be replaced. I do not think that is the issue. I have also read that the channel the window runs in needs to be lubricated on a regular basis. I was going to try that first. What is the recommended lube for these window channels?
View 2 Replies
I have a 2000 Ford F-350, I can only adjust the mirrors (both) in one direction, (to the left only) the up and down movement works also.
View 14 Replies
I can move the mirror adjuster switch and I can see the mirror trying to move and can hear clicking, but it won't move. It's like when the mirror has gone all the way in one direction and can't move anymore. But it does it in any position. I have hand-moved them to different positions and no matter where they are, the switch can't make 'em move into a different position. This happens with both mirrors. In case it matters, they are the power towing mirror that have the turn signal integrated on them and also they are heated.
View 5 Replies
I love the power folding mirrors on my 2014 F250 Lariat, really makes a difference in parking lots. Is it possible to make them fold automatically when turning off the vehicle? I know it is a lazy person question but with automatic seats and mirror/peddle position wouldn't automatic folding also be a good idea?
View 4 Replies
Did the upgrade to the new style mirrors the question I have is.where does the heat wire go to on the new factory switch.its a 8pin switch the pigtale from ford are all green wires so I don't know winch one to tie into and don't want to add another switch Also my 2005 was wired with heat.
View 2 Replies
