Ford Super Duty (1999-2016) :: F250 - 1 To 2 Will Not Shift Until 2800 Rpm
May 21, 2016
My two oldest sons and I have a 1999 SD F250 4x4 with the V10 automatic. My boys burnt the trans. We had a spare that was pulled from the same year truck with the same motor. The boys installed it without me. Everything seems to work as it should, EXCEPT! 1-2 will not shift until 2800 rpm. 2-3 is the same. When I checked the install I found that the new trans has a speed input sensor on top of the housing behind the bell housing. It is Not plugged in, my harness does not have that plug. Old trans does not have that sensor. Is this the cause of the high rpm shifting?
View 14 Replies
Advertisement
So I am not getting anywhere solving this problem. my 99 f350 psd air condition wont start until you hit around 2800 rpm. Then the clutch engages and it blows ice cold air.The truck will sit and idle once the clutch has been engaged and stays engaged. Turn of the air and it wont start again till it sees 2800 rpm. Put power to the clutch with the engine off and it works fine. Cant see it being a pressure problem because without the clutch engaged nothing changes in the air conditioning system so why does it take 2800ish rpm to have it engage.
View 3 Replies
Friend parked his well working truck and when starting it up after sitting a few days it won't shift into any gear. Lever moves as normal but the truck won't move. A soft clicking sound is the only difference to be noticed when shifting the lever. where to start? Temps are below freezing here if that matters.
View 11 Replies
I may be going to look at a 2001 F250, 4x4 with a V10 engine tomorrow. I think it is a shop truck for a business. The owner said that the mechanics told him that the trans won't shift out of low gear. It is an automatic. Maybe something as simple as a modulator valve (do they still use them)?
View 4 Replies
I tried searching and googling but came to no results, unless its like similar trucks. How do the 4x4 shift remove? I have an 04 F250 and someone decided to put the shift on sideways so the 4HI and etc read upside down before I purchased the truck. Do I just rip the thing off?
View 1 Replies
I have a 93 f250 4x4 with a 5.8 liter with 69 thousand miles.. the problem I'm having Is if I put It in drive it won't shift out of first but if I manually shift it from 1st to 2nd to drive it works but shifts very hard. Sometimes it will shift in drive but It shifts really hard. I don't know what It could be. We just put the transmisson back into the truck due to having to change a broken flywheel. It just don't Seem like it has any power...
View 5 Replies
I have a 02 F250 Super Duty XLT with a triton V8 with a automatic transmission . and when I shift into reverse after driving for a while the starter engages . It does not happen all the time . If i start up the truck and shift through or into reverse it doesn't happen . the only time it happens is when i've been driving for awhile and want to back up or park it will only do it once or twice after each drive so trying to get it to happen while in the shop is almost impossible . could this be caused by the transmission range sensor . I just had the code P0705 (transmission range sensor , A circuit input ) come on but the problem has been happening for a few weeks before that code came up .
View 6 Replies
I have a 2006 F250 with the 6.0 PowerStroke and automatic transmission. I just purchased this truck at an auction about a month ago.
Today I notice the transmission is not shifting into overdrive. No warning lights. If I press the tow/haul button in no change but the tow/haul light does come on. If I press it again (to turn it off) the tow/haul light goes out but still the transmission will not shift into overdrive.
This leaves me at about 2000 RPM at 68 MPH. I just had a Ford dealer perform Transmission service last week. (20,000 miles after the last recorded service.)
I am already not happy with the service I received at the dealer so I am really hesitant to take it back to them if it is something not related to the transmission service they performed.
View 5 Replies
I was driving down the freeway the other day and when I hit a rough patch of road, nothing major, the truck sputtered and the 4x4 Low light blinked a few times on the console. I was driving in 2wd at the time. I kept driving and every bump I hit the truck sputtered as though trying to shift and the light blinked. On smooth road it didn't happen.
Today I drove to work at 6:30AM (40 miles), no issue. At noon I drove home and the issue started again. Every bump I hit the light came on and the truck seemed to want to try and shift into 4x4 low.
I got home, parked the truck for a few hours, then went out again, no issue. But about 20 minutes later it started again. I pulled over shifted to 4x4 high, drove it, was fine, went into 4x4 low seemed fine, went back to 2wd drove it some more issue came back. I've read tons of online threads regarding 4x4 lights etc, none like this and none on F250 Super Duty (2008).
View 14 Replies
I have an 01 f250 with a 4r100. Trans has not been slipping at all and yesterday it started a rough shift between 1st and 2nd. (3-4K Rpms) At the same time 4th gear stopped engaging. Shifts out of 3rd but does not go into 4th. I can hit my od button and it will shift back into 3rd and start pulling. Still no slipping just doesn't want to change 1-2 or engage 4th. I have done a full trans fluid change including new filter and tc. Old fluid looked fine with no metal flakes or garbage in it. So all new fluid still same problem. I was thinking of changing my shift solenoid.
View 9 Replies
2007 f250 4x4 shift on fly will not work. switch to 4x4 high light will not illuminate and it will not go into 4x4. i have tried in park, in neutral, rolling are stopped. both lights work when you turn ignition key to on.
View 12 Replies
My 2011 f250 is stuck in park and the brake lights do not work. I have changed the brake switch but still wont shift out of park.
View 4 Replies
I have a 99 f250 with some procomp (325s) that are 12.5 wide with a 6in lift my superchip tuner can change the trannys shift points but I am pretty sure a new gear ratio is needed. I dont do a whole lot of off roading with it its mainly my driving around and highway rig whats a good gear ratio that would work for me
View 9 Replies
I go out of town for work for a week and come back and my 1999 F250 V10 GAS, is acting up. It started when i tried to drive it and it didn't want to shift, it would rev up to 3000+ RPMs and finally shift really hard into gear along with the speed odo not keeping up and bouncing around not wanting to work. I also had my entire gauge cluster lit up with no key and door closed. all the lights were on and it was "dinging" like the door was open and it wasn't. you would hear it when you put your ear up to the door.
So my first thought was to change the VSS (which I did) no luck. So I started wiggling wire loops under the fuse box in the cab and the "dinging" quit.. i took it for a drive and it works like nothing ever happened. Obviously I am guessing there's a short so i brought it to my mechanic and hes saying he couldn't find anything by the fuse box but he thinks its closer or even attached to the gauge cluster itself. could this be true? Why would the gauge cluster loop throw off the shift points?
View 5 Replies
I have a '99 F250 SuperDuty Diesel with an Automatic Transmission. There is a button on the end of the gear shift which allows you to turn off overdrive -- in other words the transmission won't shift into overdrive once you press the button.
Here's my problem. I start off driving normally. I've not done nothing to the overdrive button and the truck shifts normally into overdrive. 10-15 minutes down the road, the overdrive light (which indicates the state of the overdrive button) is FLASHING. Pressing the button doesn't stop the flashing. Once this flashing starts, the only thing I notice is a much more abrupt shift from 1 -> 2 gear.
View 14 Replies
I have a 2008 for 250 6.4 powerstroke. Issue I am having is occasionally when I shift from drive to reserve it will slam when I shift to reverse. It is an intermittent issue. What causes this and what to do?
View 1 Replies
Is there truely no cure for exhaust flutter on a 2002 f250 V10, bedsides putting on headers??? I have the the sound at shift points around 1800-2200 rpms. Sounds great before and after these points....
View 14 Replies
I have a hard shift between 2-3 that is somewhat violent. It doesn't matter the rpms or how hard I'm accelerating, it will always do it. At wot, it sometimes throws a code that stays on for a few minutes, then goes away. When I hook up a code reader, it shows no record of it and it never throws a blinking OD light ever.
It has an ATS transmission, but I don't know how the controller works, if it is wired correctly, or if it could even cause this issue. Currently the truck has 210k and unknown on ATS.
View 2 Replies
So it appears as though my shift lever (automatic) will not shift into the 1st gear position? However when I drive the vehicle, the transmission seems to shift through 4 gears, then into Overdrive? What could be the issue?
View 3 Replies
I have a 2003 F350 Super Duty 6.0 L with the dash mounted 2H-4H-4L switch. I was using 4wd and the light went out by itself and now I cannot shift it out of 4wd. Fuse 31 has no power to it, and the drivers book says it is the fuse for 4x4. Where the power for that fuse comes from? There is no power to the switch as well, of course.
View 5 Replies
2004 Excursion 6.0... What might be cause of my "shift on fly" 4x4 not working? No lights on dash, no mechanical noise, fuse appears Ok.
View 3 Replies
